• Energy Research
• 7. Clean energy close
• 6. Clean water close
• CN close
• UA close
• Transport Research close

Car-sharing services are developing at an ever-increasing pace. Taking into account the reduction of carbon dioxide emissions and pursuit of the sustainable development of transport, implementing electric cars in car-sharing fleets is being proposed. On the one hand, these types of vehicles are referred to as emission-free, but on the other hand, their environmental friendliness is questionable due to the emission of carbon dioxide during the production of energy to power them. Although many scientific papers are devoted to the issue of reducing emissions through car sharing, there is a research gap concerning the real production of carbon dioxide by car-sharing vehicles during car-sharing trips. To fill this research gap, the objective of the article was to analyze the actual level of carbon dioxide emissions from combustion and electric vehicles from car-sharing systems produced when renting rides. The test results showed that the electric car turned out to be significantly less emitting. The use of electric vehicles in car-sharing fleets can reduce carbon dioxide emissions from 14% to 65% compared to using cars with internal combustion engines. However, the key role during car-sharing trips is played by the driving style of the drivers, which has been omitted from the literature to date. This should be properly regulated by service providers and focus on the proper use of energy from electric vehicle batteries, especially at low temperatures. The article provides support for operators planning to modernize their fleet of vehicles and fills the research gap concerning car-sharing emissions.

Project: GCOS Earth Heat Inventory - A study under the Global Climate Observing System (GCOS) concerted international effort to update the Earth heat inventory (EHI), and presents an updated international assessment of ocean warming estimates, and new and updated estimates of heat gain in the atmosphere, cryosphere and land over the period from 1960 to present. Summary: The file “GCOS_EHI_1960-2020_Earth_Heat_Inventory_Ocean_Heat_Content_data.nc” contains a consistent long-term Earth system heat inventory over the period 1960-2020. Human-induced atmospheric composition changes cause a radiative imbalance at the top-of-atmosphere which is driving global warming. Understanding the heat gain of the Earth system from this accumulated heat – and particularly how much and where the heat is distributed in the Earth system - is fundamental to understanding how this affects warming oceans, atmosphere and land, rising temperatures and sea level, and loss of grounded and floating ice, which are fundamental concerns for society. This dataset is based on a study under the Global Climate Observing System (GCOS) concerted international effort to update the Earth heat inventory published in von Schuckmann et al. (2020), and presents an updated international assessment of ocean warming estimates, and new and updated estimates of heat gain in the atmosphere, cryosphere and land over the period 1960-2020. The dataset also contains estimates for global ocean heat content over 1960-2020 for different depth layers, i.e., 0-300m, 0-700m, 700-2000m, 0-2000m, 2000-bottom, which are described in von Schuckmann et al. (2022). This version includes an update of heat storage of global ocean heat content, where one additional product (Li et al., 2022) had been included to the initial estimate. The Earth heat inventory had been updated accordingly, considering also the update for continental heat content (Cuesta-Valero et al., 2023).

Purpose. In modern conditions of energy consumption growth and a rapid increase in energy prices the actual problem is the development and implementation of energy efficiency programs and resource-saving conversion in to a source to provide the needs of industry and municipal power. The paper aims to solve the urgent problem of energy saving and efficient use of fuel-energy ones and heat supply system optimization on the basis of Uman National University of Horticulture (UNUH). Methodology. The work investigated the process of heating and hot water supply in the course of 2007-2015 years. Implementation of current problems of energy saving is grounded on the scientific-practical and efficient assurance of fuel and energy usage. At the same time energy-saving technologies are viewed as a priority direction of the energy sector development, reduction of man-induced impact on the environment and as a way of improving the competitiveness of the national economy. Findings. Statistical data acquisition and analyzing of gas flow and outside air temperature for nine years was carried out. On the basis of this analysis, the problem was identified and specific targets for its solutions were set. Originality. Scientific novelty lies in solving the problem of energy saving and efficient use of fuel resources in Ukraine through the use of a systematic approach, the methodology development of efficient use of different fuels and optimization of local heating operation, applying contemporary automation and control systems. Firstly it was in detail analyzed and conducted the comprehensive assessment of various factors influence on energy conservation. It takes into account the human factor, professionalism and responsibility of the operators of boilers and their superiors, as well as the relevant control services. Practical value. For UNUH campus hybrid use of solid fuel and gas boilers was carried out. Decentralization of the university heating system has been conducted through the restoration of 350 individual heating systems in residential buildings, remote departments and campus dormitories. The conclusions propose the list of activities upon the real economy of fuel and energy resources, and measures to overcome the economic and political crisis in the country.

In light of the increasing number of electric vehicles (EV), disorderly charging in mountainous cities has implications for the stability and efficient utilization of the power grid. It is a roadblock to lowering carbon emissions. EV aggregators are a bridge between EV users and the grid, a platform to achieve energy and information interoperability, and a study of the orderly charging of EVs to reach carbon emission targets. As for the objective function, the EV aggregator considers the probability of EV charging access in mountainous cities, the SOC expectation of EV users, the transformer capacity constraint, the charging start time, and other constraints to maximize revenue. Considering the access probability of charging for users in mountainous cities, the optimized Lagrange relaxation method is used to solve the objective function. The disorderly charging, centralized optimized charging, and decentralized optimized charging modes are investigated using simulation calculations. Their load profiles, economic benefits, and computational efficiency are compared in three ways. Decentralized optimal charging using the Lagrange relaxation method is shown to be 50% more effective and to converge 279% faster than centralized optimal charging.

The paper represents the analysis, which has helped to establish the usage of gas hydrate technologies in the methane conversion. This gas could be obtained in different ways. Possibilities and sources for the gas obtaining have been demonstrated. Use of other environmentally friendly sources to support operation in such systems in terms of joint energy complex has been considered. The necessary kinetic connections to provide operational sustainability of all the constituents have been given. The approach helps evaluate quantitatively the priority of its physicochemical transformations to obtain gas hydrates artificially. It is possible to transport methane at considerable distances when it is solidified. Actually, in this case there is no necessity to build costly compressor stations and pipelines for its transportation to consumers. The approach is extremely important for mining regions as it helps prolong the operating period and working out of the abandoned and off-balance coal reserves. In this case, it is proposed to apply special gasification technologies tending to maximum methane recovery. The proposed solutions give the possibility to define the trends of our further research. They will be highlighted in the following authors’ studies.

To take advantage of the high tidal current velocity near the free surface, the horizontal axis turbine is installed, which inevitably causes hydrodynamic characteristics to effect the turbine by the waves. In this article, we established a numerical calculation method for the hydrodynamic load of a horizontal axis turbine under wave-current conditions. Based on the numerical calculation results, the hydrodynamic loads were decomposed and the influence rules of wave parameters and blade tip immersion depth on the hydrodynamic load were obtained. The study found the following: (1) the multi-frequency fluctuations based on the rotation frequency and incident wave frequency occurred in instantaneous values of the axial load coefficients and energy utilization ratios, and the fluctuation amplitude decreased with the increase of the blade tip immersion depth; (2) the fluctuation amplitude, according to rotation frequency, changed less with the increase of wave period and wave height, and was smaller according to wave frequency; (3) the fluctuation amplitude based on wave frequency increased linearly with the increase of wave height and wave period. The research results can provide the basis and reference for the design and engineering application of tidal current power station.

The power coupling equation and energy consumption model for enhancing the fuel economy and power performance of plug-in hybrid electric trucks (PHETs) are proposed based on the economic velocity planning strategy (EVPS-DSIDP), which takes into account the driving style and an improved dynamic programming (IDP) algorithm. This strategy employs a fuzzy controller to identify the driving style, and optimizes the efficiency and accuracy of the conventional dynamic programming (DP) algorithm by associating decision variables, dynamically adjusting the discretization step size, and restricting the state space. Additionally, a penalty function is introduced to enhance the robustness of the DP algorithm. Under our EVPS-DSIDP, the variation of velocity is liberated from the constraints of fixed driving conditions, and directly correlates with road information and driving styles, which is of significant importance for addressing energy management issues in real-time traffic conditions. Moreover, the proposed IDP algorithm can improve computational efficiency while ensuring calculation accuracy, thereby greatly enhancing the potential for the practical application of this algorithm in real-world vehicle scenarios. The simulation results demonstrate that compared to the rule-based control strategy, the application of the proposed EVPS-DSIDP in the economy velocity planning strategy can achieve an average reduction of 2.88% in economic costs and 10.6% in travel time across different driving styles. This approach offers a more comprehensive optimization of both fuel economy and power performance.

Purpose.The railways of Ukraine have been operated the locomotives, which are both morally and physically obsolete. Therefore, to ensure the competitiveness of rail transport it is necessary to update the locomotive fleet, and first of all the fleet of electric locomotives, because electrified railways provide the greater part of passenger and freight traffic. In this connection it is of special importance to determine the optimum parameters of the nominal mode of electric rolling stock. The purpose of the work is to examine the features of solution of these problems with respect to electric locomotives. Methodology. Assuming that the limit values of traction force are determined by the conditions of wheel-rail grip, then the power of the nominal mode can be represented as the product of rated speed, estimated friction coefficient, train weight and the coefficients that represent the ratio of the estimated (starting) value of traction force to value of traction force the nominal mode and the ratio of the mass of the locomotive to the train weight. Since the mass of the train is not a constant value, there is always a surplus power of the locomotive fleet required for the mastering of a predetermined volume of transportations. Reduced overcapacity of the locomotive fleet can be achieved by introduction of the locomotives of different power, designed for driving trains of different weight that will result in increased completeness of the power use but also in difficulty in selecting of locomotives for trains in operation. The paper shows the method of calculating the optimum values of power, speed and traction force of the nominal mode. It presents the mathematical model of the relationship of traction rate, excessive capacity and power of the traction unit. Findings.It is proved that the power of the traction unit, the total fleet power requirement and the excess of power in absolute units are proportional to the speed of the nominal mode. To reduce the total power of the fleet when selecting the optimum power of the traction unit it is necessary to take into consideration the speed of the nominal mode, defined by the condition of minimization of power consumption for traction, i.e. the smallest value that enables the implementation of the given running speed and the powerredundancy level required for operation. Originality. It consists in the development of a unified algorithm for determining the optimal parameter values of the nominal mode of passenger, freight and freight-passenger electric locomotives. Practical value. The authors determined the minimization costs during production, acquisition and maintenance of electric locomotives, whose nominal mode parameters are designed according to the above procedure.

Abstract Vehicular velocity prediction is of great significance to intelligent transportation system, as it provides a possible future velocity sequence for vehicle's decision‐making system. A velocity prediction method via meta learning is proposed, which provides an adaptive and generative framework for multiple‐driving cycles. The prediction model is devised using a deep neural network structure. The model's training is performed by the recently proposed meta‐supervised learning, which ensures that one trained model could meet the adaptability to multiple driving cycles. The complete framework consists of three parts: Pre‐training, fine‐tune‐training and real‐time prediction, which is tested to predict the hybrid electric city buses’ future velocity in a variable traffic scenario. The average prediction accuracy of 3, 5 and 10 s horizons is 0.51, 0.63 and 0.88 m s−1, which is 25.9%, 16.78% and 7.47% higher than that trained by the conventional supervised learning method. As suggested, the proposed prediction method is effective and could meet the requirement of energy‐saving control for hybrid electric city buses. With further study, potential application of this method may also exist in the field of driving behaviour prediction and transportation mode recognition.

The private motor vehicles are significantly important means of transportation in modern lifestyle, however, these also contribute to a large proportion of the total air pollution and primary energy consumption. In order to develop green transportation system, it becomes imperative to use integrated technologies to achieve reduced emissions and utilize renewable energy. Electric vehicles (EVs) have been considered as one of these technologies to transform the traditional vehicle mix. However, the uptake of EV has been debated on factors like cost, performance (autonomous mileage), charging point infrastructure construction, energy saving, policy and end users’ adaptation. Present study investigates the technology feasibility (which usually refer to EVs’ cost, EV charging, supplier’s customer services quality, EV travel performance) and users’ adaptation of EV in Beijing, which is a key driver for the EV uptake into the Beijing transportation system. The relevant data have been collected and analyzed in the form of questionnaire survey around all of these factors. While considering the user perception and satisfaction, safety of charging and energy bills have also been investigated. According to the data analysis, it has been found the policy of ‘No traffic restrictions for EVs’ (the traffic restrictions means for certain date, from Monday to Friday the motor vehicles with the last register number of 1 and 6, 2 and 7, 3 and 8, 4 and 9, 5 and 0, are restricted to travel, respectively), the availability of the charging infrastructure and technical support are the most significant factors affecting the users’ opinions on using EVs.