• Energy Research
• PL close
• AT close
• Energy Research close

AbstractDecarbonising the energy system requires high shares of variable renewable generation and sector coupling like power to heat. In addition to heat supply, heat pumps can be used in future energy systems to provide flexibility to the electricity system by using the thermal storage potential of the building stock and buffer tanks to shift electricity demand to hours of high renewable electricity production. Bridging the gap between two methodological approaches, we coupled a detailed building technology operation model and the open-source energy system model Balmorel to evaluate the flexibility potential that decentral heat pumps can provide to the electricity system. Austria in the year 2030 serves as an example of a 100% renewable-based electricity system (at an annual national balance). Results show that system benefits from heat pump flexibility are relatively limited in extent and concentrated on short-term flexibility. Flexible heat pumps reduce system cost, CO2 emissions, and photovoltaics and wind curtailment in all scenarios. The amount of electricity shifted in the assessed standard flexibility scenario is 194 GWhel and accounts for about 20% of the available flexible heat pump electricity demand. A comparison of different modelling approaches and a deterministic sensitivity analysis of key input parameters complement the modelling. The most important input parameters impacting heat pump flexibility are the flexible capacity (determined by installed capacity and share of control), shifting time limitations, and cost assumptions for the flexibility provided. Heat pump flexibility contributes more to increasing low residual loads (up to 22% in the assessed scenarios) than decreasing residual load peaks. Wind power integration benefits more from heat pump flexibility than photovoltaics because of the temporal correlation between heat demand and wind generation.

The paper presents an experimental study on the formation process of burden surface texture on the blast furnace throat and its influence on the radial distribution of gas flow. The study was performed with the application of blast furnaces equipped with a bell-type charging device using radio-isotope means for the control of burden surface texture (profile) and burden surface level, i.e., gamma locators for burden surface texture. The study was carried out under the conditions of an operating blast furnace in an iron and steel plant using a unique GEOTAPS system for automated control of geometric and temperature parameters of burden material surface on the blast furnace throat. The influence of the surface texture on the gas flow distribution was also investigated. The possibility of a self-stabilization effect for burden surface texture and gas flow in an operating blast furnace under suitable conditions was experimentally proven. As a result of the experimental study performed, four ways of energy-saving technology implementation were determined for the control of blast furnace melting based on the data on the burden surface texture and previously unknown regularities of surface layer formation of burden material on the throat of an operating blast furnace with a bell-type charging device. The main idea of the paper is the development of automated control for the radial distribution of burden material and gas flow using actual or predicted surface texture parameters as important intermediate factors that both describe the process and have a significant simultaneous influence on it.

Abstract Socio-technical transformations towards low-carbon energy systems are on the way in developed countries. Conversely, developing countries tend to be locked in fossil fuels and foster coal-based energy structures, emphasizing reliable and cost-effective energy provision and sidelining environmental concerns. In this study, we identified and analysed the predominant factors related to coal-based power generation in Bangladesh. We applied a mixed-method approach, initially conducting a systematic literature review and, subsequently, semi-structured expert interviews to identify and validate relevant factors. We then assessed their relative importance using an Analytical Hierarchy Process based on expert judgments. The results of this assessment reveal that socio-economic aspects and environmental issues scored highest, while technological aspects and sector regulations were considered to be less relevant for large-scale coal power implementation. We conclude that future energy policies created in Bangladesh will need to use appropriate legal instruments and address issues such as human displacement and resettlement, low levels of public acceptance, health hazards and environmental pollution. Participative policy frameworks should be deployed in coal plant projects, and active monitoring systems are necessary to reduce the negative consequences associated with increased electrification and energy consumption. To address foreseeable structural challenges, it furthermore will be crucial to explore sustainable alternatives.

Abstract Additional experimental data concerning the kinetics of Ni-Mo codeposition were obtained by investigating cathodic polarization using a rotating disc electrode. The Ni-Mo alloys were deposited from an ammonium citrate bath. The alloy deposition was controlled by activation in the case of low values of the cathode potential and by diffusion in the case of higher values. The hydrogen discharge was found to be diffusion controlled. The inductive influence of nickel results in depolarization of the reduction of molybdenum which cannot be deposited separately. An increase in the disc rotation speed caused an increase in the maximum cathode efficiency and in the molybdenum content of the alloy.

This article examines land-use, market and welfare implications of lignocellulosic bioethanol production in Hawaii to satisfy 10% and 20% of the State's gasoline demand in line with the State's ethanol blending mandate and Alternative Fuels Standard (AFS). A static computable general equilibrium (CGE) model is used to evaluate four alternative support mechanisms for bioethanol. Namely: (i) a federal blending tax credit, (ii) a long-term purchase contract, (iii) a state production subsidy financed by a lump-sum tax and (iv) a state production subsidy financed by an ad valorem gasoline tax. We find that because Hawaii-produced bioethanol is relatively costly, all scenarios are welfare reducing for Hawaii residents: estimated between -0.14% and -0.32%. Unsurprisingly, Hawaii.s economy and its residents fair best under the federal blending tax credit scenario, with a positive impact to gross state product of $49 million. Otherwise, impacts to gross state product are negative (up to -$63 million). We additionally find that Hawaii-based bioethanol is not likely to offer substantial greenhouse gas emissions savings in comparison to imported biofuel, and as such the policy cost per tonne of emissions displaced ranges between $130 to $2,100/tonne of CO2e. The policies serve to increase the value of agricultural lands, where we estimate that the value of pasture land could increase as much as 150% in the 20% AFS scenario.

Progressive urban density affects city centers especially and results in growing congestion, lack of parking spaces, and increasing environmental costs of transportation, causing increased air pollutant emissions and noise. These phenomena reduce the attractiveness of the city and result in a degradation of the quality of life for its residents. In light of these phenomena, there is a clear need for intelligent management of urban space using new technologies that would be complementary to existing intelligent transportation systems. Expanding information resources obtained from mobile cameras will have a positive impact on increasing the efficiency of transportation management and use of limited space in city centers. It will also have an impact on reducing external transport costs and increasing the quality of logistics services provided in the city. The main aim of the paper is to develop a concept of a transport management system in cities using mobile vision systems mounted on unmanned aerial vehicles. The model will concern the cases of lane occupation by freight vehicles and the analysis of parking spaces in the city in order to improve their management. The results of the developed model will contribute to the automation of the parking space management process and increase the efficiency of the use of city parking space resources.

New transparent optodes for life-time based microscopic imaging of O₂ were developed by spin-coating a μm-thin layer of a highly luminescent cyclometalated iridium(III) coumarin complex in polystyrene onto glass cover slips. Compared to similar thin-film O₂ optodes based on a ruthenium(II) polypyridyl complex or a platinum(II) porphyrin, the new planar sensors have i) higher brightness allowing for much shorter exposure times and thus higher time resolution, ii) more homogeneous and smaller pixel to pixel variation over the sensor area resulting in less noisy O₂ images, and iii) a lower temperature dependency simplifying calibration procedures. We used the new optodes for microscopic imaging of the spatio-temporal O₂ dynamics at the base of heterotrophic biofilms in combination with confocal imaging of bacterial biomass and biofilm structure. This allowed us to directly link biomass distribution to O₂ distribution under both steady state and non-steady state conditions. We demonstrate that the O₂ dynamics in biofilms is governed by a complex interaction between biomass distribution, mass transfer and flow that cannot be directly inferred from structural information on biomass distribution alone.

Structure of energy carriers in Poland used for electricity differs from that in highly developed countries significantly. Currently almost 95% of electricity in our country is produced from coal and lignite. An increasing demand for electricity as well as European law result in the need of making more use of other energy resources including renewable energy sources (OZE). In 2010 the largest part of energy was produced from biomass (53,1%), followed by water (26,8%) and wind (16,7%). When it comes to energy production from biogas, its significance is low. In the analyzed year this kind of energy represented only 3,3% of the whole energy produced with OZE. Currently, the lowest cost of electricity production (370 PLN/MWh) characterizes coal power stations. Production of electricity using renewable sources of energy is a little bit more expensive (approximately 400 PLN/MWh). Energy produced by the coal power stations will meet more and more difficulties caused by the acquisition of rights to emit the carbon dioxide. As a result, there is a prospect of production of energy using its renewable sources. Power sector based on these resources does not produce waste, does not destroy environment and besides has a positive impact on local development. Production of energy using biogas is especially important. It follows from the fact that these power stations use in energy production both municipal, food industry and agricultural production waste, and support pro-ecological policy of European Union. In addition they both directly and indirectly reduce pollution. There are 34 bio-mass power stations currently operating in Poland with total capacity of almost 40MWh ; Struktura nośników energii w Polsce wykorzystywanych do energii elektrycznej znacznie rożni się od tej w wysoko rozwiniętych państwach. Aktualnie prawie 95% energii elektrycznej w naszym kraju produkowane jest z węgla kamiennego i brunatnego. Wzrastające zapotrzebowanie na energię elektryczną oraz przepisy unijne sprawiają, że istnieje konieczność większego ...

In biomedical scientific investigations, expositions of findings are conceptually simplest when they comprise comparisons of discrete groups of individuals or involve discrete features or characteristics of individuals. But the descriptive benefits of categorization become outweighed by their limitations in studies involving dose-response relationships, as in many teratogenic and environmental exposure studies. This article addresses a pair of categorization issues concerning the effects of prenatal alcohol exposure that have important public health consequences: the labeling of individuals as fetal alcohol syndrome (FAS) versus fetal alcohol effects (FAE) or alcohol-related neurodevelopmental disorder (ARND), and the categorization of prenatal exposure dose by thresholds. We present data showing that patients with FAS and others with FAE do not have meaningfully different behavioral performance, standardized scores of IQ, arithmetic and adaptive behavior, or secondary disabilities. Similarly overlapping distributions on measures of executive functioning offer a basis for identifying alcohol-affected individuals in a manner that does not simply reflect IQ deficits. At the other end of the teratological continuum, we turn to the reporting of threshold effects in dose-response relationships. Here we illustrate the importance of multivariate analyses using data from the Seattle, Washington, longitudinal prospective study on alcohol and pregnancy. Relationships between many neurobehavioral outcomes and measures of prenatal alcohol exposure are monotone without threshold down to the lowest nonzero levels of exposure, a finding consistent with reports from animal studies. In sum, alcohol effects on the developing human brain appear to be a continuum without threshold when dose and behavioral effects are quantified appropriately.