• Energy Research
• Closed Access close
• Open Source close
• 13. Climate action close
• AU close
• CA close
• BG close

Microalgae have tremendous potential for producing liquid renewable fuel. Many methods for converting microalgae to biofuel have been proposed; however, an economical and energetically feasible route for algal fuel production is yet to be found. This paper presents a review on the comparison of the most promising conversion pathways of microalgae to liquid fuel: hydrothermal liquefaction (HTL), wet extraction and non-destructive extraction. The comparison is based on important assessment parameters of product quality and yield, nutrient recovery, GHG emissions, energy and the cost associated with the production of fuel from microalgae, in order to better understand the pros and cons of each method. It was found that the HTL pathway produces more oil than the wet extraction pathway; however, higher concentrations of unwanted components are present in the HTL oil produced. Less nutrients (N and P) can be recovered in HTL compared to wet extraction. HTL consumes more fossil energy and generates higher GHG emissions than wet extraction, while the production cost of fuel from HTL pathway is lower than wet extraction pathway. There is considerable uncertainty in the comparison of the energy consumption and economics of the HTL pathway and the wet extraction pathway due to different scenarios analysed in the assessment studies. To be able to appropriately compare methodologies, the conversion methods should be analysed from growth to upgradation of oil utilising sufficiently similar assumptions and scenarios. Based on the data in available literature, wet oil extraction is the more appropriate system for biofuel production than HTL. However, the potential of alternative extraction/conversion technologies, such as, non-destructive extraction, need to be further assessed.

Abstract For 118 million residential housing units in the U.S., there is currently a gap between the potential energy savings that can be achieved through the use of existing energy efficiency technologies, and the actual level of energy savings realized, particularly for the 37% of housing units that are considered residential rental properties. Additional quantifiable benefits are needed beyond energy savings to help further motivate residential property owners to invest in energy efficiency upgrades. This research focuses on assessing the adoption of energy efficient upgrades in U.S. residential housing and the impact on rental prices. Ten U.S. cities are chosen for analysis; these cities vary in size across multiple climate zones, and represent a diverse set of housing market conditions. Data was collected for over 159,000 rental property listings, their characteristics, and their energy efficiency measures listed in rental housing postings across each city. Following an extensive data quality control process, over thirty different types energy efficient features were identified. The level of adoption was determined for each city, ranging from 5.3% to 21.6%. Efficient lighting and appliances were among the most common, with many features doubling as energy efficient and other desirable aesthetic or comfort improvements. Then using propensity score matching and conditional mean comparison methods, the relative impact on rent charged in each city was calculated, which ranged from a 6% to 14.1% increase in rent for properties with energy efficient features, demonstrating a positive economic impact of these features, particularly for property owners. This was further subdivided into five types of energy efficiency upgrade and three housing types. Single family homes generally demanded higher premiums with energy efficient features, however there was not a consistent pattern across the types of efficient upgrades. The results of this work demonstrate that investment in energy efficient technologies has quantifiable benefits for rental property owners in the U.S. beyond just energy savings. This methodology and results can also be used in other cities and by property owners, utility companies, or others, ultimately encouraging further investment and positive economic impact in residential energy efficiency and in turn improving energy and resource conservation in the building sector.

Abstract This study develops a novel sustainability assessment methodology for energy systems using life-cycle emission factors and sustainability indicators. Here, the global warming and environmental impact dimensions of the sustainability assessment methodology are examined in detail. A comparative analysis shows that a wind-battery system produces fewer potential global warming, stratospheric ozone depletion, air pollution, and water pollution impacts compared to a gas-fired system. The wind-battery system generates 13% of the life-cycle GHG emissions and 22% of the life-cycle ozone-depleting substance emissions of a gas-fired power plant. Nitrous oxide contributes more than 90% of the stratospheric ozone depletion potential of gas-fired and wind-battery systems.

The Nigerian government is committed to sustaining rice production to meet national demand. Nevertheless, political tension and climate-induced stressors remain crucial constraints in achieving policy targets. This study examines whether climate change and political instability significantly threaten rice production in Nigeria. First, we employed nonparametric methods to estimate the country's rainfall and temperature trends between 1980Q1 and 2015Q4. Second, we employed the autoregressive distributed lag (ARDL) technique to examine the effects of climate change and political instability on rice production. The results show that while temperature has an increasing pattern, rainfall exhibits no significant trend. The findings from the ARDL estimate reveal that rice production responds negatively to temperature changes but is less sensitive to changes in rainfall. In addition, political instability adversely affects rice production in Nigeria. We argue that Nigeria's slow growth in rice production can be traced back to the impact of climate change and political tension in rice farming areas. As a result, reducing the overall degree of conflict to ensure political stability is critical to boosting the country's self-sufficiency in rice production. We also recommend that farmers be supported and trained to adopt improved rice varieties less prone to extreme climate events while supporting them with irrigation facilities to facilitate rice production.

Abstract In this paper, an exergoeconomic analysis and optimization of a combined solar and wind energy based system is proposed. The trigeneration system produces ammonia, hydrogen and electricity through integrated solar photovoltaic panels and wind turbines. Also, an ammonia fuel cell unit is utilized for generating power during insufficient available energy. The overall exergetic efficiency is found to be 29.7% and the corresponding energetic efficiency is 28.5% under design conditions. In addition, the total cost rate is obtained as 63,345 $/h. Moreover, multi-objective optimization is performed with various decision variables at different combinations of solar intensities and wind speeds, considering the maximization of exergy efficiency and minimization of total cost rates. The developed system provides better optimal operation points under high wind speeds. The optimal exergy efficiency is found to vary between 10.9% and 38.2% depending on the available solar and wind energy. The corresponding optimal total cost rates vary between 11,959 $/h and 59,755 $/h, respectively. Several parametric studies are also performed to determine the effects of changing system conditions on the thermodynamic and economic performance of the developed system.

AbstractCoral reefs across the world have been seriously degraded and have a bleak future in response to predicted global warming and ocean acidification (OA). However, this is not the first time that biocalcifying organisms, including corals, have faced the threat of extinction. The end‐Triassic mass extinction (200 million years ago) was the most severe biotic crisis experienced by modern marine invertebrates, which selected against biocalcifiers; this was followed by the proliferation of another invertebrate group, sponges. The duration of this sponge‐dominated period far surpasses that of alternative stable‐ecosystem or phase‐shift states reported on modern day coral reefs and, as such, a shift to sponge‐dominated reefs warrants serious consideration as one future trajectory of coral reefs. We hypothesise that some coral reefs of today may become sponge reefs in the future, as sponges and corals respond differently to changing ocean chemistry and environmental conditions. To support this hypothesis, we discuss: (i) the presence of sponge reefs in the geological record; (ii) reported shifts from coral‐ to sponge‐dominated systems; and (iii) direct and indirect responses of the sponge holobiont and its constituent parts (host and symbionts) to changes in temperature andpH. Based on this evidence, we propose that sponges may be one group to benefit from projected climate change and ocean acidification scenarios, and that increased sponge abundance represents a possible future trajectory for some coral reefs, which would have important implications for overall reef functioning.

Abstract The expansion of Sargassum muticum in the Danish estuary Limfjorden between 1984 and 1997 was followed by a decrease in abundance of native perennial macroalgae such as Halidrys siliquosa. Although commonly associated with the expansion of exotic species, it is unknown whether such structural changes affect ecosystem properties such as the production and turnover of organic matter and associated nutrients. We hypothesized that S. muticum possesses ‘ephemeral’ traits relative to the species it has replaced, potentially leading to faster and more variable turnover of organic matter. The biomass dynamics of S. muticum and H. siliquosa was therefore compared in order to assess the potential effects of the expansion of Sargassum. The biomass of Sargassum was highly variable among seasons while that of Halidrys remained almost constant over the year. Sargassum grew faster than Halidrys and other perennial algae and the annual productivity was therefore high (P/B = 12 year−1) and exceeded that of Halidrys (P/B = 5 year−1) and most probably also that of other perennial algae in the system. The major grazer on macroalgae in Limfjorden, the sea urchin Psammechinus miliaris, preferred Sargassum to Halidrys, but estimated losses due to grazing were negligible for both species and most of the production may therefore enter the detritus pool. Detritus from Sargassum decomposed faster and more completely than detritus from Halidrys and other slow-growing perennial macrophytes. High productivity and fast decomposition suggest that the increasing dominance of S. muticum have increased turnover of organic matter and associated nutrients in Limfjorden and we suggest that the ecological effects of the invasion to some extent resemble those imposed by increasing dominance of ephemeral algae following eutrophication.

Abstract In this paper, energy and exergy analyses of the geothermal-based hydrogen production via thermochemical water decomposition using a new, four-step copper–chlorine (Cu–Cl) cycle are conducted, and the respective cycle energy and exergy efficiencies are examined. Also, a parametric study is performed to investigate how each step of the cycle and its overall cycle performance are affected by reference environment temperatures, reaction temperatures, as well as energy efficiency of the geothermal power plant itself. As a result, overall energy and exergy efficiencies of the cycle are found to be 21.67% and 19.35%, respectively, for a reference case.

Abstract This study evaluates the performance of 75 clear-sky global irradiance models against 75 ground stations worldwide covering five major Koppen-Geiger climate classifications and overall global performance. After quality control, clear-sky detection and data-availability criteria, there are 4.36 million 1-min valid global horizontal irradiance (GHI) data points for evaluation. This study represents the most encompassing evaluation of its kind in terms of number of models assessed, number of ground stations used, most consistent selection of input variables in terms of temporal and spatial resolution, also using the most rigorous and fair performance assessment criteria and suitable ranking system. A statistically rigorous Principal Component Analysis (PCA) ranking procedure is proposed to replace the conventional ordering method based on single and simple statistics. In particular, it is demonstrated that all 13 error metrics contribute to the variance of GHI estimation and thus must all be accounted for in the ranking procedure. The best performing models in each climate zone of equatorial, arid, temperate, cold and polar are REST2v9.1, REST2v9.1, MAC2, REST2v5 and CLS, respectively. Globally, the top three performing models are MAC2, REST2v5, and REST2v9.1. Many models appear to suffer from over-fitting empirical relationships to training data, resulting in inconsistent worldwide performance. Furthermore, six different formulations of the Linke Turbidity factor (TL) are evaluated through its application to five clear-sky models that require it as an input. The best globally performing TL formulations are either by Ineichen or Gueymard when combined with four of the five Linke-dependent clear-sky models, whilst the Grenier formulation performs best with the Ineichen & Perez model. Significant performance variation is observed depending on the TL formulation selected, hence, careful selection is required for an optimal application. The model codes are available in R [1].