• Energy Research
• Closed Access close
• Open Source close
• 13. Climate action close
• 6. Clean water close
• AU close
• BG close

Microalgae have tremendous potential for producing liquid renewable fuel. Many methods for converting microalgae to biofuel have been proposed; however, an economical and energetically feasible route for algal fuel production is yet to be found. This paper presents a review on the comparison of the most promising conversion pathways of microalgae to liquid fuel: hydrothermal liquefaction (HTL), wet extraction and non-destructive extraction. The comparison is based on important assessment parameters of product quality and yield, nutrient recovery, GHG emissions, energy and the cost associated with the production of fuel from microalgae, in order to better understand the pros and cons of each method. It was found that the HTL pathway produces more oil than the wet extraction pathway; however, higher concentrations of unwanted components are present in the HTL oil produced. Less nutrients (N and P) can be recovered in HTL compared to wet extraction. HTL consumes more fossil energy and generates higher GHG emissions than wet extraction, while the production cost of fuel from HTL pathway is lower than wet extraction pathway. There is considerable uncertainty in the comparison of the energy consumption and economics of the HTL pathway and the wet extraction pathway due to different scenarios analysed in the assessment studies. To be able to appropriately compare methodologies, the conversion methods should be analysed from growth to upgradation of oil utilising sufficiently similar assumptions and scenarios. Based on the data in available literature, wet oil extraction is the more appropriate system for biofuel production than HTL. However, the potential of alternative extraction/conversion technologies, such as, non-destructive extraction, need to be further assessed.

The Nigerian government is committed to sustaining rice production to meet national demand. Nevertheless, political tension and climate-induced stressors remain crucial constraints in achieving policy targets. This study examines whether climate change and political instability significantly threaten rice production in Nigeria. First, we employed nonparametric methods to estimate the country's rainfall and temperature trends between 1980Q1 and 2015Q4. Second, we employed the autoregressive distributed lag (ARDL) technique to examine the effects of climate change and political instability on rice production. The results show that while temperature has an increasing pattern, rainfall exhibits no significant trend. The findings from the ARDL estimate reveal that rice production responds negatively to temperature changes but is less sensitive to changes in rainfall. In addition, political instability adversely affects rice production in Nigeria. We argue that Nigeria's slow growth in rice production can be traced back to the impact of climate change and political tension in rice farming areas. As a result, reducing the overall degree of conflict to ensure political stability is critical to boosting the country's self-sufficiency in rice production. We also recommend that farmers be supported and trained to adopt improved rice varieties less prone to extreme climate events while supporting them with irrigation facilities to facilitate rice production.

AbstractCoral reefs across the world have been seriously degraded and have a bleak future in response to predicted global warming and ocean acidification (OA). However, this is not the first time that biocalcifying organisms, including corals, have faced the threat of extinction. The end‐Triassic mass extinction (200 million years ago) was the most severe biotic crisis experienced by modern marine invertebrates, which selected against biocalcifiers; this was followed by the proliferation of another invertebrate group, sponges. The duration of this sponge‐dominated period far surpasses that of alternative stable‐ecosystem or phase‐shift states reported on modern day coral reefs and, as such, a shift to sponge‐dominated reefs warrants serious consideration as one future trajectory of coral reefs. We hypothesise that some coral reefs of today may become sponge reefs in the future, as sponges and corals respond differently to changing ocean chemistry and environmental conditions. To support this hypothesis, we discuss: (i) the presence of sponge reefs in the geological record; (ii) reported shifts from coral‐ to sponge‐dominated systems; and (iii) direct and indirect responses of the sponge holobiont and its constituent parts (host and symbionts) to changes in temperature andpH. Based on this evidence, we propose that sponges may be one group to benefit from projected climate change and ocean acidification scenarios, and that increased sponge abundance represents a possible future trajectory for some coral reefs, which would have important implications for overall reef functioning.

Abstract The expansion of Sargassum muticum in the Danish estuary Limfjorden between 1984 and 1997 was followed by a decrease in abundance of native perennial macroalgae such as Halidrys siliquosa. Although commonly associated with the expansion of exotic species, it is unknown whether such structural changes affect ecosystem properties such as the production and turnover of organic matter and associated nutrients. We hypothesized that S. muticum possesses ‘ephemeral’ traits relative to the species it has replaced, potentially leading to faster and more variable turnover of organic matter. The biomass dynamics of S. muticum and H. siliquosa was therefore compared in order to assess the potential effects of the expansion of Sargassum. The biomass of Sargassum was highly variable among seasons while that of Halidrys remained almost constant over the year. Sargassum grew faster than Halidrys and other perennial algae and the annual productivity was therefore high (P/B = 12 year−1) and exceeded that of Halidrys (P/B = 5 year−1) and most probably also that of other perennial algae in the system. The major grazer on macroalgae in Limfjorden, the sea urchin Psammechinus miliaris, preferred Sargassum to Halidrys, but estimated losses due to grazing were negligible for both species and most of the production may therefore enter the detritus pool. Detritus from Sargassum decomposed faster and more completely than detritus from Halidrys and other slow-growing perennial macrophytes. High productivity and fast decomposition suggest that the increasing dominance of S. muticum have increased turnover of organic matter and associated nutrients in Limfjorden and we suggest that the ecological effects of the invasion to some extent resemble those imposed by increasing dominance of ephemeral algae following eutrophication.

Abstract This study evaluates the performance of 75 clear-sky global irradiance models against 75 ground stations worldwide covering five major Koppen-Geiger climate classifications and overall global performance. After quality control, clear-sky detection and data-availability criteria, there are 4.36 million 1-min valid global horizontal irradiance (GHI) data points for evaluation. This study represents the most encompassing evaluation of its kind in terms of number of models assessed, number of ground stations used, most consistent selection of input variables in terms of temporal and spatial resolution, also using the most rigorous and fair performance assessment criteria and suitable ranking system. A statistically rigorous Principal Component Analysis (PCA) ranking procedure is proposed to replace the conventional ordering method based on single and simple statistics. In particular, it is demonstrated that all 13 error metrics contribute to the variance of GHI estimation and thus must all be accounted for in the ranking procedure. The best performing models in each climate zone of equatorial, arid, temperate, cold and polar are REST2v9.1, REST2v9.1, MAC2, REST2v5 and CLS, respectively. Globally, the top three performing models are MAC2, REST2v5, and REST2v9.1. Many models appear to suffer from over-fitting empirical relationships to training data, resulting in inconsistent worldwide performance. Furthermore, six different formulations of the Linke Turbidity factor (TL) are evaluated through its application to five clear-sky models that require it as an input. The best globally performing TL formulations are either by Ineichen or Gueymard when combined with four of the five Linke-dependent clear-sky models, whilst the Grenier formulation performs best with the Ineichen & Perez model. Significant performance variation is observed depending on the TL formulation selected, hence, careful selection is required for an optimal application. The model codes are available in R [1].

In this chapter, turbulent flow of water-based optimization (TFWO) inspired based on whirlpools created in turbulent flow of water is used to solve the maximum power point tracking (MPPT) of photovoltaic systems in partial shading conditions. The TFWO is used to determine the optimal duty cycle of the DC/DC converter with the objective of maximizing the extracted power of the photovoltaic system. The capability of proposed method is evaluated in different patterns of partial shading to achieve global optimal power. The simulation results showed that TFWO is able to track the global maximum power point (GMPP), successfully in PSC and also fast climate changing. The TFWO has a better tracking capability with faster tracking speed and accuracy than particle swarm optimization (PSO) in obtaining the GMPP. Moreover, the results indicate that the use of buck–boost converter led to faster and more accurate access to the global optimal point than the system equipped with boost converter. The results showed that photovoltaic system with boost converter cannot obtain global maximum power in climate changing condition and limited the efficiency of the MPPT algorithm, while the photovoltaic system with buck–boost converter could be tracked GMPP due to its wider operating area.

Abstract There are instances in remote areas where heat is being wasted, e.g., in internal combustion, engines, etc. Some of this heat can be recovered to produce distilled water in solar stills. The solar still replaces the cooling tower, ponds, or radiators normally used to control the engine temperature. The diesel cooling water in such a system remains separate from the saline water in the solar still. The advantages of using such a system compared with a conventional solar still are: 1. (a) water costs are very much reduced 2. (b) the area occupied is much less, i.e., about 1 5 th 3. (c) production has much less seasonal variation 4. (d) the efficiency of the solar still is improved due to the higher operating temperatures. From experiments conducted at Highett using a Mk VI solar still fitted with a simple heat exchanger and a separate electrically-heated source of hot water to simulate the waste heat, design data are not available for application to working systems. The information required to match a solar still to a diesel's cooling requirement is: 1. (a) engine efficiency 2. (b) hourly fuel consumption 3. (c) hourly solar radiation 4. (d) hourly ambient temperatures. A by-product of this work has been the production of a “solar water heater” which costs less than that of the cheapest conventional system. This “solar” hot water system uses a heat exchanger similar to what is used to transfer the waste heat to the saline water. It is envisaged to have hot water productions approximately the same as the distilled water productions. The influence of hot water production on the output of the waste heat solar still is discussed.

A detailed pollen record from the Ocean Drilling Program Site 820 core, located on the upper part of the continental slope off the coast of northeast Queensland, was constructed to compare with the existing pollen record from Lynch's Crater on the adjacent Atherton Tableland and allow the production of a regional picture of vegetation and environmental change through the last glacial cycle. Some broad similarities in patterns of vegetation change are revealed, despite the differences between sites and their pollen catchments, which can be related largely to global climate and sea-level changes. The original estimated time scale of the Lynch's Crater record is largely confirmed from comparison with the more thoroughly dated ODP record. Conversely, the Lynch's Crater pollen record has assisted in dating problematic parts of the ODP record. In contrast to Lynch's Crater, which reveals a sharp and sustained reduction in drier araucarian forest around 38,000 yrs BP, considered to have been the result of burning by Aboriginal people, the ODP record indicates, most likely, a stepwise reduction, dating from 140,000 yrs BP or beyond. The earliest reduction shows lack of a clear connection between Araucaria decline and increased burning and suggests that people may not have been involved at this stage. However, a further decline in araucarian forest, possibly around 45,000 yrs BP, which has a more substantial environmental impact and is not related to a time of major climate change, is likely, at least partially, the result of human burning. The suggestion, from the ODP core oxygen isotope record, of a regional sea-surface temperature increase of around 4 degrees C between about 400,000 and 250,000 yrs BP, may have had some influence on the overall decline in Araucaria and its replacement by sclerophyll vegetation. (C) 2000 Elsevier Science B.V. All rights reserved.

Electricity generation systems have traditionally been evaluated using only a limited number of economic or environmental indicators, for example capital investment, generation cost or carbon dioxide emissions. Moreover, the evaluations have generally been restricted to performance within the geographic boundary of the power station. This paper reports a sustainability assessment of power generation from Australian fossil fuels, notably black coal, brown coal and natural gas. A range of key sustainability indicators incorporating environmental, economic and social performance are included. The system boundary incorporates fuel extraction, fuel transport to the power station, generation of power, and transmission of electricity to the point of use. Most commonly employed existing technologies and some promising advanced technologies for power generation are considered. The cases of exporting Australian LNG and black coal to Japan for power generation in that country have also been considered. No one fuel or technology system was superior or inferior for every indicator. However the following generalizations can be made: Natural gas combined cycle systems have advantages for the majority of environmental and economic indicators, brown coal has an advantage in terms of value added, and black coal has relatively poor safety performance.