• Energy Research
• 7. Clean energy close
• CN close
• AU close
• NL close
• Energy Procedia close

AbstractSwitchable exhaust air (SEA) window allows the exhaust air from HVAC system to be ventilated through the cavity of the window to ambient. It can be regarded as an exhaust air heat recovery device in buildings. The annual energy requirement of the window has been calculated in Wuhan, China. The energy requirements for conditioning fresh air with and without the total heat recovery ventilators (THRVs) are also investigated. Heat recovery performance of the SEA window and the THRVs is compared. Results show that the SEA window can potentially provide alternative solution for recovering the low-grade energy from air-conditioning exhaust air.

Abstract Uncertainties of cooling load may make cooling system oversized. Most of previous studies implement probabilistic-based uncertainty analysis, intending to achieve optimization and reliability simultaneously. However, how to reduce the load uncertainty has received little attention. This paper investigates the impact of water storage on the design of cooling system considering load uncertainty. Information entropy is used as a convergence index of load uncertainty and used to determine how many random simulations should to be performed. A cooling system configured with water storage (system B) and another system without water storage (system A as a comparation system) are investigated in this paper. In this paper, the configure of system A and system B are optimized respectively. The result shows that the capacity distribution of system A is consistent with the distribution of extreme loads. But, the capacity distribution of system B is more concentrated as the water storage can reshape the load curve. Water storage improves the flexibility of system B. Therefore, system B is more reliable and economical than system A.

The European Geosciences Union (EGU) brings together geoscientists from all over the world covering all disciplines of the Earth, planetary and space sciences. This geoscientific interdisciplinarity is needed to tackle the challenges of the future. One major challenge for humankind is to provide adequate and reliable supplies of affordable energy and other resources in efficient and environmentally sustainable ways. This Energy Procedia issue provides an overview of the contributions of the Division on Energy, Resources & the Environment (ERE) at the EGU General Assembly 2017.

Abstract This research is conducted to determine the limiting values of the geometric concentration when used with solar thermal system (thermoelectric generator) (TEG) to maintain desired hot and cold side temperatures for power generation. Experiments were conducted to determine the optimum solar concentration (aperture area/target area) using a thermoelectric generator sandwiched between the target plate and passive heat sink. A computer model is developed to solve the energy balance equations and find the optimum values for geometric concentration. It was observed that for the single configuration of heat sink and thermoelectric generator in a system, the trend of temperature difference between the hot and cold sides remain the same at different geometric concentrations. The optimum geometric concentration is determined for heat sinks in study. It is observed that with solar radiation intensity of 800 W/m2 and heat sink fin length of 0.15m the optimum geometric concentration is 13.

Abstract Global primary energy consumption will continue to increase with a high rate to 2050, which will be a big challenge for countries to meet both global and regional energy demand. Pumped storage stations (PSS) integrated to a hybrid power system (HPS) with solar and wind power for China are under construction to tussle with this challenge. Historically, modeling of a PSS integrated HPS has been ignored the interaction effect between the shaft vibration and the governing strategies, which will increase the dynamic risk of PSS disconnected immediately to HPS. Here we unify the models of the hydro-turbine governing system and hydro-turbine generator units with a novel expression of hydraulic forces. We quantize all the parameter’s interaction contributions of PSS integration to HPS and validate this model with the existing models. Finally, we show the feasibility of PSS’s model in integrating of a HPS under steady and fault scenarios.

AbstractPre-drying is a potential way to improve the electric generation efficiency of lignite-fired power plant, and steam is a main kind of drying heat source. In conventional pre-dried lignite-fired power system, the steam extraction of regenerative system is led to the dryer directly. The steam extraction must be used by the dryer after throttling, if the energy mismatch exists between the supply of steam extraction and the need of dryer. Two systems of energy supply for the dryer, that the energy of the steam extraction is supplied to the dryer via compressor or ejector, were proposed in this paper to further increase the energy utilization efficiency. These systems were thermodynamic analyzed, and the electric generation efficiencies of these systems were compared. The energy saving boundary was gotten.

Abstract In order to further promote the development of the new energy vehicle industry, Parallel Management regulation for corporate average fuel consumption and new energy vehicle credits for passenger vehicles (dual-credit scheme) have been proposed by Ministry of Industry and Information Technology in September 2017. This study attempted to investigate the impact of dual-credit scheme on the penetration of new energy vehicles and the short-term strategies of the automotive industry. For this purpose, a market analysis model is proposed based on game theory and the credit market equilibrium to quantify the effects of the credit trading mechanism. Four categories of automakers are considered. The obtained results show that: (i) The dual-credit scheme is indeed an effective policy solution that enables the expansion of the volume of NEV market. (ii) The dual-credit scheme can accelerate the elimination of outdated technologies with lower driving mileage, and it can also promote the adoption of technologies with longer driving mileage. (iii) The dual-credit scheme allows all automakers to achieve their targets in a market efficient manner.

Reverse electrodialysis (RED) is a technology to generate power from mixing waters with different salinity. The net power density (i.e. power per membrane area) is determined by 1) the membrane potential, 2) the ohmic resistance, 3) the resistance due to changing bulk concentrations, 4) the boundary layer resistance and 5) the power required to pump the feed water. Previous power density estimations often neglected the latter three terms. This paper provides a set of analytical equations to estimate the net power density obtainable from RED stacks with spacers and RED stacks with profiled membranes. With the current technology, the obtained maximum net power density is calculated at 2.7 W/m2. Higher power densities could be obtained by changing the cell design, in particular the membrane resistance and the cell length. Changing these parameters one and two orders of magnitude respectively, the calculated net power density is close to 20 W/m2