• Energy Research
• Closed Access close
• Open Source close
• 11. Sustainability close
• 6. Clean water close
• AU close
• FR close

A field study was conducted on two texturally different soils to determine the influences of biosolids application on selected soil chemical properties and carbon dioxide fluxes. Two sites, located in Manildra (clay loam) and Grenfell (sandy loam), in Australia, were treated at a single level of 70 Mg ha-1 biosolids. Soil samples were analyzed for SOC fractions, including total organic carbon (TOC), labile, and non-labile carbon contents. The natural abundances of soil δ13C and δ15N were measured as isotopic tracers to fingerprint carbon derived from biosolids. An automated soil respirometer was used to measure in-situ diurnal CO2 fluxes, soil moisture, and temperature. Application of biosolids increased the surface (0-15 cm) soil TOC by > 45% at both sites, which was attributed to the direct contribution from residual carbon in the biosolids and also from the increased biomass production. At both sites application of biosolids increased the non-labile carbon fraction that is stable against microbial decomposition, which indicated the soil carbon sequestration potential of biosolids. Soils amended with biosolids showed depleted δ13C, and enriched δ15N indicating the accumulation of biosolids residual carbon in soils. The in-situ respirometer data demonstrated enhanced CO2 fluxes at the sites treated with biosolids, indicating limited carbon sequestration potential. However, addition of biosolids on both the clay loam and sandy loam soils found to be effective in building SOC than reducing it. Soil temperature and CO2 fluxes, indicating that temperature was more important for microbial degradation of carbon in biosolids than soil moisture.

Much of New South Wales and southern Queensland suffered from extreme drought from 2017 to 2019. This study models drought and bushfires impacts using VU‐TERM, a multi‐regional, dynamic CGE model. Prolonged drought pushed national real GDP to 0.7 per cent or more below base in 2018–2019 and 2019–2020. NSW’s real GDP fell relative to forecast by 1.1 per cent or $6.9 billion in 2018–2019 and 1.6 per cent or $10.2 billion in 2019–2020. These impacts reflect a severe diminution of farm output, given that agriculture accounts for around 1.6 per cent of NSW’s income. Bushfires exacerbated 2019–2020 losses. We assume that there is a full recovery in seasonal conditions in 2020. However, prolonged drought and bushfire destruction deplete farm capital through depressed investment and diminished herd numbers. Consequently, the income earning capacity of farms in recovery remains below that of a no drought base. The net present value of the national welfare loss is $63 billion, split between $53 billion in losses from drought and $10 billion from bushfires. The latter excludes any valuation of human lives lost, flora, fauna or forestry destruction. In the longer term, adaptation and policy responses will need to reflect the expectation of increased frequency of adverse climatic events.

Use of a pilot-scale fixed-film bioreactor was investigated for remediation of bromate contamination within groundwater. Bromate reduction with stoichiometric production of bromide was observed, providing supporting evidence for complete reduction of bromate with no production of stable intermediates. Reduction of 87-90% bromate from an influent concentration of 1.1 mg L(-1) was observed with retention times of 40-80 h. Lower retention times led to decreases in bromate reduction capability, with 11.5% removal at a 10 h retention time. Nitrate reduction of 76-99% from a 30.7 mg L(-1) as NO(3)(-) influent was observed at retention times of 10-80 h, although an increase in nitrite production to 2.7 mg L(-1) occurred with a 10 h retention time. Backwashing was not required, with the large plastic packing media able to accommodate biomass accumulation without decreases in operational efficiency. This study has provided proof of concept and demonstrated the potential of biological bromate reduction by fixed-film processes for remediation of a bromate contaminated groundwater source.

AbstractWarming of freshwaters as a result of climate change is expected to have complex interactions with the toxicity of contaminants to aquatic organisms. The present study evaluated the effects of temperature on the acute toxicity of endosulfan, chlorpyrifos, and phenol to 3 warm water species of fish—silver perch, rainbowfish, and western carp gudgeon—and 1 cold water species, rainbow trout. Endosulfan was more toxic to silver perch at 30 °C and 35 °C than at 15 °C, 20 °C and 25 °C during short exposures of 24 h, but at 96 h, temperature had no effect on toxicity. Toxicity to rainbow trout increased with increasing temperature, whereas warm water species exhibited maximum toxicity at around 30 °C, decreasing again toward 35 °C. Chlorpyrifos became more toxic to all species with increasing temperature. Phenol toxicity to all species decreased at low to intermediate temperatures; but as temperatures increased further toward the upper thermal limit, phenol became more toxic. Increasing toxicity in the upper thermal range of cold water species may contribute to upstream range contraction in rivers with high toxicant loads. In contrast, warm water species may not exhibit a range shift within rivers as a result of interactions between temperature and toxicity. Catchment management to offset global warming at local scales may present opportunities to mitigate increased toxicity of contaminants to fish. Environ Toxicol Chem 2015;34:1809–1817. © 2015 SETAC

The phosphate (P) fertilizer industry generates a highly hazardous and acidic wastewater. The present study reports the evaluation of an integrated precipitation and Enhanced Biological Phosphorus Removal (EBPR) process for the treatment of fertilizer plant wastewater and effluent detoxification, assessed by microtoxicity and seed germination tests. Effluent samples were collected from a local P fertilizer industry and were characterized by their high fluoride and P content. First, the samples were pre‐treated by precipitation of P and fluoride ions using hydrated lime. The resulting low‐fluoride and phosphorus effluent was then treated with the EBPR process to monitor the simultaneous removal of carbon, nitrogen, and phosphorus. Phosphorus removal included a two‐stage anaerobic/aerobic system operating under continuous flow. Pre‐treated wastewater was added to the activated sludge and operated for 160 days in the reactor. The operating strategy included increasing the organic loading rate from 0.3 to 1.2 g chemical oxygen demand (COD)/L day. The stable and high removal rates of COD, NH4+‐N, and PO43−‐P were then recorded. The mean concentrations of the influent were approximately 3600 mg COD/L, 60 mg N/L and 14 mg P/L, which corresponded to removal efficiencies of approximately 98%, 86%, and 92%, respectively. The microtoxicity of the treated wastewater was then monitored by LUMIStox and its phytotoxicity was investigated on cress, tomato, wheat, maize, ryegrass, and alfalfa seed germination. LUMIStox tests showed that treatment allowed a significant toxicity removal. Moreover, the untreated wastewater inhibited the species germination even when diluted 10 times, whereas a positive effect of treated wastewater was noticed. © 2013 American Institute of Chemical Engineers Environ Prog, 33: 463–471, 2014

In this work we assess the pathways for environmental improvement by the coal utilization industry for power generation in Australia. In terms of resources, our findings show that coal is a long term resource of concern as coal reserves are likely to last for the next 500 years or more. However, our analysis indicates that evaporation losses of water in power generation will approach 1000 Gl (gigalitres) per year, equivalent to a consumption of half of the Australian residential population. As Australia is the second driest continent on earth, water consumption by power generators is a resource of immediate concern with regards to sustainability. We also show that coal will continue to play a major role in energy generation in Australia and, hence, there is a need to employ new technologies that can minimize environmental impacts. The major technologies to reduce impacts to air, water and soils are addressed. Of major interest, there is a major potential for developing sequestration processes in Australia, in particular by enhanced coal bed methane (ECBM) recovery at the Bowen Basin, South Sydney Basin and Gunnedah Basin. Having said that, CO2 capture technologies require further development to support any sequestration processes in order to comply with the Kyoto Protocol. Current power generation cycles are thermodynamic limited, with 35-40% efficiencies. To move to a high efficiency cycle, it is required to change technologies of which integrated gasification combined cycle plus fuel cell is the most promising, with efficiencies expected to reach 60-65%. However, risks of moving towards an unproven technology means that power generators are likely to continue to use pulverized fuel technologies, aiming at incremental efficiency improvements (business as usual). As a big picture pathway, power generators are likely to play an increasing role in regional development; in particular EcoParks and reclaiming saline water for treatment as pressures to access fresh water supplies will significantly increase.

Two chickpea genotypes viz. Bhakar-2011 (desi) and Noor-2013 (kabuli) were sown in soil filled pots supplied with low (0.3 mg kg-1) and high (3 mg kg-1 soil) zinc (Zn) under control (70% water holding capacity and 25/20 °C day/night temperature), drought (35% water holding capacity) and heat (35/30 °C day/night temperature) stresses. Drought and heat stresses reduced rate of photosynthesis, photosystem II efficiency, plant growth and Zn uptake in chickpea. Low Zn supply exacerbated adverse effects of drought and heat stresses in chickpea, and caused reduction in plant biomass, carbon assimilation, antioxidant activity, impeded Zn uptake and enhanced oxidative damage. However, adequate Zn supply ameliorated adverse effect of drought and heat stresses in both chickpea types. The improvements were more in desi than kabuli type. Adequate Zn nutrition is crucial to augment growth of chickpea plants under high temperature and arid climatic conditions.

Mercury (Hg) represents a growing environmental and health major concern. It originates from natural sources and mainly from anthropogenic processes and it is widely distributed in the natural media. According to the last Global Mercury Assessment (2013), annual global emissions from both sources were estimated to be from 5,000 to 8,000 metric tons per year. Among the different mercury species released to the environment, methylmercury (MeHg) is considered as the most toxic form due to its ability to bioaccumulate, being then threatening even at very low concentrations.Its presence depends onHg(II) bioavailability and global amount.This explains the urgent need to ensure a continuous Hg(II) monitoring. Many efforts have been made in order to develop reliable systems able to deliver quick data and to comply with low detection limits, in accordance with the threshold value delivered by the World Health Organization (1µg L-1/ 5 nM). Spectroscopic techniques such as CV-AFS and CV-AAS are routinely used for Hg(II) determination. Although these methods can afford good sensitivity and low concentrations determination, they require sample preparation step, complex procedures and expensive material, which limits their use for on-site measurements. In this context, electrochemical sensors present excellent candidates for in situ Hg(II) trace analysis, taking in account their numerous advantages compared to spectroscopic techniques: easier handling, simple procedure, low energy consuming, low cost material and portability. In this work, we will propose a new electrochemical approach aiming to conceive and optimize an electrochemical Hg(II) sensor. The method consists in the functionalization of a glassy carbon electrode (GC) with gold nanoparticles (AuNPs) and Diazonium Salts. The main idea is to combine the interesting properties of both AuNPs and Diazonium salts. AuNPs were chosen for their electrocatalytic effect, large surface area, mass transport enhancement and for the strong affinity to mercury which will improve the sensor sensitivity. On the other hand, diazonium salts are used to improve the sensor stability by anchoring the AuNPs to the GC surface. First, nanometricorganic layer were grafted of the polished GC surface, by electrochemical reduction of 1.5 mM4-thiophenol diazonium (SH) using Constant Potential Electrolysis (CPE) in 0.1 M HCl solution at -0.55 V for 300 seconds. Electrochemical characterization performed by Cyclic Voltammetry (CV) and redox probes (ferricyanide and hexaamineruthenium(III)) revealed a total suppression of the signal, confirming the formation of a continuous blocking layer. This was confirmed by Atomic Force Microscopy (AFM)used to estimate the layer thickness, which was found to be 4 nm. Second, AuNPs were electrodeposited, for the first time, onto the diazonium multilayer by CPE in NaNO3 solution containing 0.25 mM HAuCl4for 300 seconds. Once more, redox probes were used to characterize the resulting interface and a total signal restauration and enhancement was observed after AuNPs electrodeposition, which highlights the effective AuNPs onto the organic layers. Field emission gun scanning microscopy (FEG-SEM) was used to provided further evidence and to quantify particle size and density of the AuNPs deposits. Both size and density are dependent on the CPE duration. Small homogeneous AuNPs with 27±3 nm average diameter and 158 NPs/µm2density were observed when the CPE was carried out during 300 seconds, while larger particles with 63±6 nm average diameter and lower density (63 NPs/µm2) were obtained when a longer CPE duration (600 seconds) is used. Finally, AuNPs were activated by cyclic voltammetry in H2SO4 prior to Hg(II) detection in order to homogenize the surface and to rearrange the crystallographic plans of the AuNPs. Herein, the well-known gold oxides reduction peak was observed and used to calculate the electroactive surface area (ESA) of the functionlized electrode. The electrochemical response of the final generated GC/SH/AuNPs interface towards Hg(II) was recorded by Square Wave Anodic Stripping Voltammetry (SWASV) in 0.01 M HCl solution containing different amounts of Hg(II). The SWASV procedure consists on the Hg(II) preconcentration at the electrode surface followed by the preconcentrated Hg(0) reoxidation in Hg(II). Under optimized conditions, and for a preconcentration time of 300 seconds, a well-defined peak, corresponding to Hg(0) reoxidation, was observed around 0.5 V/ECS. The sensor showed a linearity range from 1 up to 10 nM and allowed to reach picomolar level. The stability in HCl, phosphate buffer and air was also studied over several weeks: Once a week, the activation procedure was performed and followed by Hg(II) determination in order to evaluate the analytical performances of the sensor over time. Finally, Hg(II) detection assays were conducted in natural water samples collected from different sampling points. Figure 1

Abstract With emphasis on application in the built environment, this paper analyses meanings of the term ‘solar energy use’. It shows that failure to address the inherently vague and context dependent nature of the concept leads to much confusion, especially when attempts at absolute quantification are made. The paper argues that meaningful absolute quantification of solar energy use is impossible, and that misplaced attempts at this quantification have serious implications, especially in relation to decisions at the level of government policy. To avoid confusion, solar energy should not be considered as a component of conservation, energy-efficiency, or renewables, and definition and quantification of solar energy use should be qualified regarding purpose of quantification, type of energy, definition of use, baselines and context.