• Energy Research
• Closed Access close
• Restricted close
• Open Source close
• IT close
• AU close
• ES close

Ammonia increases buffer capacity of methanogenic medium in mesophilic anaerobic reactor thus increasing the stability of anaerobic digestion process. Optimal ammonia concentration ensures sufficient buffer capacity while not inhibiting the process. It was found out in this paper that this optimum depends on the quality of anaerobic sludge under investigation. The optimal concentrations for methanogens were 2.1, 2.6 and 3.1 g/L of ammonia nitrogen in dependence on inoculum origin. High ammonia nitrogen concentration (4.0 g/L) inhibited methane production, while low ammonia nitrogen concentration (0.5 g/L) caused low methane yield, loss of biomass (as VSS) and loss of the aceticlastic methanogenic activity. It was found out that negative effect of low ammonia nitrogen concentration on biomass is caused not only by low buffer capacity but also by insufficiency of nitrogen as nutrient. It was also found out that anaerobic sludge with higher ammonia nitrogen concentration (4.2 g/L) tolerates even concentration of volatile fatty acids (160 mmol/L) which causes inhibition of the process with low ammonia nitrogen concentration (0.2 g/L).

We report the effect of ethanol on monooxygenase activities in primary hamster hepatocyte cultures maintained on collagen-coated dishes. The addition of 50mM ethanol to cell cultures both from control and ethanol pretreated animals almost completely maintained, at least for 72hr, the P4502E1-dependent aniline hydroxylase (AnH) activity and the 2E1 immunodetectable apoprotein content at the levels of the corresponding 4-hr plated hepatocytes. On the contrary, other P450-dependent monooxygenase activities, as assayed by testosterone hydroxylases, kept decreasing falling-after 72hr of culture-to the levels of the 4-hr plated hepatocytes. In both cases, in the absence of ethanol, a rapid decline of AnH activities and 2E1 apoprotein contents were also observed, attaining undetectable levels at 72hr. The hybridizable 2E1 mRNA also rapidly declined in both cultures, but such decline was not significantly altered by the presence of 50mM ethanol in the culture medium. Furthermore, we show that P4502E1 in the liver possesses a rapid degradation phase with a half-life of about 6hr. Thus, in the hamster, P4502E1 appears regulated at post-translational level, as in rat, probably by a protein stabilization mechanism.

This study highlights how Chinese economic development detrimentally impacted water quality in recent decades and how this has been improved by enormous investment in environmental remediation funded by the Chinese government. To our knowledge, this study is the first to describe the variability of surface water quality in inland waters in China, the affecting drivers behind the changes, and how the government-financed conservation actions have impacted water quality. Water quality was found to be poorest in the North and the Northeast China Plain where there is greater coverage of developed land (cities + cropland), a higher gross domestic product (GDP), and higher population density. There are significant positive relationships between the concentration of the annual mean chemical oxygen demand (COD) and the percentage of developed land use (cities + cropland), GDP, and population density in the individual watersheds (p < 0.001). During the past decade, following Chinese government-financed investments in environmental restoration and reforestation, the water quality of Chinese inland waters has improved markedly, which is particularly evident from the significant and exponentially decreasing GDP-normalized COD and ammonium (NH4+-N) concentrations. It is evident that the increasing GDP in China over the past decade did not occur at the continued expense of its inland water ecosystems. This offers hope for the future, also for other industrializing countries, that with appropriate environmental investments a high GDP can be reached and maintained, while simultaneously preserving inland aquatic ecosystems, particularly through management of sewage discharge.

In the present work the influence of accelerated mineral carbonation on the leaching behaviour of basic oxygen furnace steel slag was investigated. The environmental behaviour of the material as evaluated through the release of major elements and toxic metals under varying pH conditions was the main focus of the study. Geochemical modelling of the eluates was used to derive a theoretical description of the underlying leaching phenomena for the carbonated material as compared to the original slag. Among the investigated elements, Ca and Si were most appreciably affected by carbonation. A very clear effect of carbonation on leaching was observed for silicate phases, and lower-Ca/Si-ratio minerals were found to control leaching in carbonated slag eluates as compared to the corresponding untreated slag sample as a result of Ca depletion from the residual slag particles. Clear evidence was also gained of solubility control for Ca, Mg and Mn by a number of carbonate minerals, indicating a significant involvement of the original slag constituents in the carbonation process. The release of toxic metals (Zn, V, Cr, Mo) was found to be variously affected by carbonation, owing to different mechanisms including pH changes, dissolution/precipitation of carbonates as well as sorption onto reactive mineral surfaces. The leaching test results were used to derive further considerations on the expected metal release levels on the basis of specific assumptions on the relevant pH domains for the untreated and carbonated slag.

In this paper, a comparison of power system frequency response is conducted for a simple modelled power system with primary frequency control being provided either by synchronous generators or by inverter-based Battery Energy Storage (BES) systems. Mathematical models of conventional governor and turbine are developed, representing conventional synchronous generator frequency control, and are used to illustrate system frequency response for a range of typical conventional generating units. A mathematical model of a power-electronics interfaced Li-ion BES system is developed and used to represent a non-synchronous inverter-based generator with primary frequency control capabilities. MATLAB/Simulink is used to build a model of a small power system, and simulations are carried out with at a range of typical conventional synchronous generating units with a nonsynchronous generating unit in the power system. The simulation results demonstrate that the BES can be used for primary frequency control providing a faster and better response. BES is also capable of almost eliminating frequency overshoot and reducing 70% of settling time while providing primary frequency control in power system with various types of conventional synchronous generating units and a nonsynchronous generating unit.

Abstract To improve the conversion efficiency of thermophotovoltaic devices, we designed a thermophotovoltaic system based on an InAs/InGaAsSb/GaSb three-junction tandem cell. The tandem cell can recover photons in the wavelength range of 200–3650 nm and therefore enhance the output power of the system. To further improve system performance, we designed a multilayer circular truncated cone metamaterial emitter matching the tandem cell. Existing TPV systems based on multi-junction tandem PV cells can achieve conversion efficiencies of 33.3%–41%, while the thermophotovoltaic system coupled with the multilayer circular truncated cone metamaterial can recover more photons of 1.44 mol/(m2·s) and achieve a higher conversion efficiency of 52.8% at 1773 K. The thermophotovoltaic system designed here demonstrates an extremely high energy conversion efficiency and has good application prospects.

In recent years, deregulation in the power generation market worldwide combined with significant variation in fuel prices and a need for flexibility in terms of power augmentation specially during periods of high electricity demand (summer months or noon to 6 PM) has forced electric utilities, cogenerators and independent power producers to explore new power generation enhancement technologies. In the last 5–10 years, inlet fogging approach has shown more promising results to recover lost power output due to increased ambient temperature compared to the other available power enhancement techniques. This paper presents the first systematic study on the effects of both inlet evaporative and overspray fogging on a wide range of combined cycle power plants utilizing gas turbines available from the major gas turbine manufacturers worldwide. A brief discussion on the thermodynamic considerations of inlet and overspray fogging including the effect of droplet dimension is also presented. Based on the analyzed systems, the results show that high pressure inlet fogging influences performance of a combined cycle power plant using an aero-derivative gas turbine differently than with an advanced technology or a traditional gas turbine. Possible reasons for the observed differences are discussed.

Abstract The use of organic additives in zinc electroplating is reviewed with particular emphasis on the types of compounds used, the bath type for which they are most suited, and their function with respect to brightening and levelling action. Fundamental studies of the mode of action of these additives are also reviewed and comparisons are made with similar studies of nickel and copper electrodeposition. It is concluded that much more fundamental studies are required to fully explain the effects of additives. Further, the effect of codeposition of organic impurities on the corrosion resistance of electrodeposited zinc requires urgent study.