• Energy Research
• Closed Access close
• AU close

This study examined the effects of climate change on rice production in 30 Chinese provinces spanning 1998–2017. The study used the pooled mean group technique to capture the long-run and short-run effects of changing climatic conditions on rice production. It further employed the Dumitrescu–Hurlin panel causality test to examine the path of causality between the key variables and rice production. The study found that, in the long run, average temperature negatively influenced rice production, but average rainfall had a positive effect on rice production. The results indicated that the cultivated area and fertilizer usage were positively related to rice production in the long run. The short-run results accentuated that average temperature favourably influenced nationwide rice production, whereas average rainfall had no substantial effect on national rice production. The cultivated area had a significant positive short-term relationship with rice production, although the impact of fertilizer usage on rice production was negligible in the short run. Besides, the results established a bidirectional causality between rice output and the cultivated area, but there was a one-way causality running from fertilizer usage to rice output. Finally, the results indicated that, except for rainfall, a unidirectional causality exists between temperature and rice production. The study, therefore, recommends that in the case of crop failure due to weather conditions, policymakers could implement a new pricing policy to mitigate the deterioration of the farmers’ income. The government must also develop and implement an insurance scheme that compensates farmers for catastrophes induced by rainfall deficiency.

The ability to reuse winery wastewater would be of significant benefit to the wine industry, as it could potentially be a cost-effective method of wastewater management, whilst at the same time providing a valuable water resource. This study investigated the effects of different dilutions of a semi-synthetic winery wastewater on the growth and germination of four common crop species in a glasshouse study; barley (Hordeum vulgare), millet (Pennisetum glaucum), lucerne (Medicago sativa) and phalaris (Phalaris aquatica). The wastewater caused a significant delay in the germination of lucerne, millet and phalaris, although overall germination percentage of all species was not affected. Vegetative growth was significantly reduced in all species, with millet being the most severely affected. The germination index of barley correlated very highly (r(2)=0.99) with barley biomass, indicating that barley seed germination bioassays are highly relevant to plant growth, and therefore may be of use as a bioassay for winery wastewater toxicity.

The development of perennial wheat could have a number of advantages for improving the sustainability of Australian dryland agricultural systems. The profitability that might be expected from perennial wheat of different types was investigated using MIDAS (Model of an Integrated Dryland Agricultural System), a bioeconomic model of a mixed crop/livestock farming system. Although perennial wheat may produce a lower grain yield and quality than annual wheat, it is expected inputs of fertiliser, herbicide and sowing costs will be lower. Perennial wheat used solely for grain production was not selected as part of an optimal farm plan under the standard assumptions. In contrast, dual-purpose perennial wheat that produces grain and additional forage during summer and autumn than annual wheat can increase farm profitability substantially (AU$20/ha over the whole farm) and 20% of farm area was selected on the optimal farm plan under standard assumptions. Forage from perennial wheat replaced stubble over summer and grain supplement at the break of season and increased farm stock numbers. The additional value added by grazing also reduced the relative yield required for perennial wheat to be profitable. This analysis suggests perennial wheat used for the dual purposes of grain and forage production could be developed as a profitable option for mixed crop/livestock producers.

Abstract Thermal conductivity of bricks is an important parameter as it directly influences the heat losses from buildings and thus increases the energy consumption. The main focus of this study was to develop thermally efficient burnt clay bricks incorporating agricultural wastes on industrial scale. For this purpose, agricultural wastes (sugarcane bagasse ash (SBA) and rice husk ash (RHA)) were acquired from a sugar industry and a brick kiln. Burnt clay bricks were manufactured in an industrial kiln by incorporating SBA and RHA in various dosages (i.e. 5%, 10% and 15%) by clay weight. Physico-mechanical and thermal properties of brick specimens incorporating agricultural wastes were studied. It was observed that lighter weight bricks can be produced using agricultural wastes, which are helpful in reducing both the cost and overall weight of the structure. Addition of agricultural wastes in burnt clay bricks resulted into reduced compressive strength. However, brick specimens incorporating SBA and RHA up to 15% satisfied the minimum requirement for compressive strength according to different standards for masonry construction. Increase in apparent porosity with decrease in thermal conductivity was also observed with increasing content of SBA and RHA in burnt clay bricks. Substitution of clay by 15% SBA and RHA in the production of burnt clay bricks reduced the thermal conductivity by 31% and 29%, respectively. Microscopic images also showed the presence of interconnected and irregular shaped open pores after addition of agricultural wastes in burnt clay bricks. Based on this study, it can be concluded that the utilization of SBA and RHA (up to 15% by clay weight) in manufacturing of burnt clay bricks is not only helpful in landfill reduction but also leads towards the development of sustainable and thermally efficient construction material.

Abstract Heat has generally been successfully extracted from the lower convective zone (LCZ) of solar ponds by two main methods. In the first, hot brine from the LCZ is circulated through an external heat exchanger, as tested and demonstrated in El Paso and elsewhere. In the second method, a heat transfer fluid circulates in a closed cycle through an in-pond heat exchanger, as used in the Pyramid Hill solar pond, in Victoria, Australia. Based on the experiences at the El Paso and Pyramid Hill solar ponds, the technical specifications, material selection, stability control, clarity maintenance, salt management and operating strategies are presented. A novel method of extracting heat from a solar pond is to draw the heat from the gradient layer. This method is analysed theoretically and results of an experimental investigation at Bundoora East, RMIT, are presented. An in-pond heat exchanger made of polyethylene pipe has been used to extract heat for over 2 months. Results indicate that heat extraction from the gradient layer increases the overall energy efficiency of the solar pond by up to 55%, compared with conventional method of heat extraction solely from the LCZ. The experimental results are compared with the theoretical analysis. A close agreement has been found. From this small-scale experimental study, convection currents were found to be localised only and the density profiles were unaffected. An experimental study using an external heat exchanger for brine extraction and re-injection at different levels within the gradient layer still needs to be conducted to determine the effect of the heat extraction from the non-convective zone (NCZ) on the stability of the salinity gradient (both vertically and horizontally) and an economic analysis needs to be conducted to determine the economic gains from increased thermal efficiency.

Solar electric generation systems (SEGS) currently in operation are based on parabolic trough solar collectors using synthetic oil heat transfer fluid in the collector loop to transfer thermal energy to a Rankine cycle turbine via a heat exchanger. To improve performance and reduce costs direct steam generation in the collector has been proposed. In this paper the efficiency of parabolic trough collectors is determined for operation with synthetic oil (current SEGS plants) and water (future proposal) as the working fluids. The thermal performance of a trough collector using Syltherm 800 oil as the working fluid has been measured at Sandia National Laboratory and is used in this study to develop a model of the thermal losses from the collector. The model is based on absorber wall temperature rather than fluid bulk temperature so it can be used to predict the performance of the collector with any working fluid. The effects of absorber emissivity and internal working fluid convection effects are evaluated. An efficiency equation for trough collectors is developed and used in a simulation model to evaluate the performance of direct steam generation collectors for different radiation conditions and different absorber tube sizes. Phase change in the direct steam generation collector is accounted for by separate analysis of the liquid, boiling and dry steam zones.

Application of organic waste products as amendments has been proposed as a management option whereby soil quality of Vertisols could be improved. An incubation experiment was, therefore, conducted for 4 weeks under controlled temperature conditions (30°C) to identify those potential organic amendments that might improve the quality of a Vertisol. Twelve organic amendments were investigated: cotton gin trash from three sources, cattle manure from two sources, green waste compost, chicken manure from three sources including a commercial product, biosolids and two commercial liquefied vermicomposts. Except for the biosolids, no other organic amendments had any effect on soil microbial biomass and respiration. Compared with NO3-N levels in the control, there was a 50% decrease in soil amended with 10 t ha—1 green waste compost (65 µg g—1). The three different types of chicken manures increased the NO3-N concentration from 75% (228 µg g—1) to 226% (424 µg g— 1) over the control. Approximate recovery of P added by the amendment as resin-extractable soil P was 53% for cattle manure and 39% for chicken manure. Application of cattle manure resulted in a 22% increase in soil-exchangeable K over levels found in control. Organic amendments application also resulted in a significant increase in exchangeable Na concentration. Some of the organic wastes, viz. cotton gin trash (10 t ha— 1), cattle manure (10 t ha—1), biosolids (10 t ha—1) and composted chicken manure (3 t ha—1) have value as a source of nutrients to soil and hence showed potential to improve Vertisol properties.

Microbial fuel cell (MFC) is a green technology that converts the stored chemical energy of organic matter to electricity; therefore, it can be used for wastewater purification and energy production simultaneously. In this study, three kinds of dairy products, including milk, cheese water, and yogurt water, were mixed with Acid orange 7 (AO7) as the model wastewater and used as the anolyte of an MFC. The capability of the system in energy production and dye removal was also investigated. The FESEM images were used to investigate the biofilms attachment to the anodes. Moreover, the polarization curves, electrochemical impedance spectroscopy, cyclic voltammetry (CV), voltage-time profiles, and coulombic efficiency were used to evaluate the electrochemical activity of the MFCs. Based on the CV results, the biofilm formation significantly improved the electrochemical activity of the electrodes. Maximum power density, voltage, and coulombic efficiency were obtained as 44.05 mW.m-2, 332.4 mV, and 1.76%, respectively, for cheese water + AO7 anolyte, but the milk + AO7 MFC produced a stable voltage for a long time and its performance was similar to the cheese water + AO7 anolyte. Maximum COD removal and decolorization efficiencies were obtained equal to 84.57 and 92.18% for yogurt water + AO7 and cheese water + AO7 anolytes, respectively.

Many of the far-reaching impacts of climate change on ecosystem function will be due to alterations in species interactions. However, our understanding of the effects of temperature on the dynamics of interactions between species is largely inadequate. Inducible defences persist in prey populations because defensive traits increase survival in the presence of predators but are costly when they are absent. Large-scale changes in the thermal climate are likely to alter the costs or benefits of these defences for ectotherms, whose physiological processes are driven by environmental temperature. A shift in costs of defensive traits would affect not only predator-prey interactions, but also the strength of selection for inducible defences in natural populations. We investigate the effect of temperature on the costs of behavioural defences in larvae of the marine toad, Rhinella marinus. Larvae were reared in the presence or absence of predator cues at both 25 and 30 °C. When exposed to predation cues, larvae reduced activity and spent less time feeding. Exposure to predation cues also reduced metabolic rate, presumably as a by-product of reducing activity levels. Larvae exposed to predation cues also grew more slowly, were smaller at metamorphosis and were poorer jumpers after metamorphosis--three traits associated with fitness in post-metamorphic anurans. We found that the costs of behavioural defences, in terms of larval growth, post-metamorphic size and jumping performance, were exacerbated at cooler temperatures. The thermal sensitivity of costs associated with defensive traits may explain geographic variation in plasticity of defensive traits in other species and suggests that changes in environmental temperature associated with climate change may affect predator-prey interactions in subtle ways not previously considered.