• Energy Research
• Restricted close
• Embargo close
• 11. Sustainability close
• 2. Zero hunger close
• EU close
• BE close

Diesel engine exhausts from a common rail 3.0 L F1C diesel engine were analyzed at two different load conditions of the WLTC testing cycle downstream of both the diesel particulate filter (DPF) and selective catalytic reactor (SCR) to verify their effect on the characteristics of carbon particulate matter. An array of chemical, physical and spectroscopic techniques (gas chromatography coupled with mass spectrometry (GC-MS), mobility analyzer, UV-Visible absorption and fluorescence spectroscopy) was applied for characterizing polycyclic aromatic hydrocarbons (PAH), heavy aromatic compounds and soot, constituting the particulate matter (PM) sampled from the exhaust. The engine was operated in half load (HL) (188 Nm, representing the more common condition for engine in urban traffic) and full load (FL) (452 Nm, representing the best performance of the engine operation) conditions, at the same engine speed (2000 rpm). Soot formation was enhanced in HL condition, with respect to FL, but, just because of the much lower soot amount, the after-treatment systems in this last condition resulted to be less efficient in the soot abatement. Indeed, the abatement through DPF was about 40% lower in the FL condition with respect to HL condition, and any significant further concentration decrease was found after SCR, in both conditions. By contrast, PAH concentration after DPF abatement was found to be higher in the HL with respect to FL condition. A further PAH concentration decrease of about 30% was found after the SCR in the HL condition whereas in FL the reduction was only about 5-6%. Also the heavy aromatic compounds having molecular weight above the GC-MS detection limit (300 u), were mitigated by SCR. Therefore, SCR did not cause a further soot reduction, whereas it was effective in largely reducing PAH and heavy aromatics emissions, especially in the lower temperature condition featuring the half-load condition, when combustion efficiency is worse. Moreover, SCR system reduced the emission of small particles probably due to an enhanced agglomeration of particles, with beneficial effect on the harmfulness to human health.

It is recognised that several constraints such as the lack of knowledge and expertise of farmers, land users and policy makers concerning agroforestry systems establishment and management hamper the adoption of agroforestry systems (Camilli et al. 2017). AFINET project acts at EU level in order to direct research results into practice and promote innovative ideas to face challenges and solve practitioners' problems. AFINET proposes an innovative methodology based on the creation of a European Interregional Network, linking different Regional Agroforestry Innovation Networks (RAINs). RAINs represent different climatic, geographical, social and cultural conditions and enclose a balanced representation of the key actors with complementary types of expertise (farmers, policy makers, advisory services, extension services, etc.). The Italian RAIN is focused on the Extra-Virgin Olive Oil (EVOO) value chain, with the main aim to promote agroforestry management of local olive orchards. Olive trees are still managed traditionally, often in marginal sites, with minimal mechanization and relatively low external inputs such as chemical treatments in comparison to other crops. The presence of permanent crops (olive trees) guarantees a partially tree cover reducing hydrogeological risk. Soil management usually keeps natural grassing reducing soil carbon emission and increasing soil fertility (Bateni et al. 2017). Intercropping with cereals and/or fodder legumes and livestock can also be practiced in olive orchards, increasing the complexity of the olive tree multifunctional system. Moreover, olive orchards can be managed as agroforestry systems since they can be intercropped with arable crops (cereals, legumes) and/or combined with livestock (sheep, poultry). The RAIN process, involving local stakeholders, highlighted the main bottlenecks of the EVOO value chain related to communication and dissemination of knowledge, technical and management aspects, market and policy. In order to contrast bottlenecks and exploit opportunities of the olive oil supply chain, the identified innovations are: i) adoption of best practices: testing and experimenting innovative agroforestry systems introducing different crop/animals species and varieties; ii) improve the management of the olive orchards: encouraging and increasing the organic production; iii) valorisation of olive processing residues: identifying and testing innovative products (bio-materials, olive paste as example); iv) arise the awareness among consumers: educating people about the benefits of olive oil consumption, creating networks among stakeholders, improving marketing and commercialization. Creating a Bio-district, defined as a geographical area where farmers, citizens, tourist operators, associations and public authorities enter into an agreement for the sustainable management of local resources, emerged a powerful tool to implement the innovation in the local EVOO value chain.

Abstract The question whether coexistence of marine renewable energy (MRE) projects and marine protected areas (MPAs) is a common spatial policy in Europe and how a number of factors can affect it, has been addressed by empirical research undertaken in eleven European marine areas. Policy drivers and objectives that are assumed to affect coexistence, such as the fulfillment of conservation objectives and the prioritization of other competing marine uses, were scored by experts and predictions were crosschecked with state practice. While in most areas MRE-MPA coexistence is not prohibited by law, practice indicates resistance towards it. Furthermore expert judgment demonstrated that a number of additional factors, such as the lack of suitable space for MRE projects and the uncertainty about the extent of damage by MRE to the MPA, might influence the intentions of the two major parties involved (i.e. the MRE developer and the MPA authority) to pursue or avoid coexistence. Based on these findings, the interactions of these two players are further interpreted, their policy implications are discussed, while the need towards efficient, fair and acceptable MRE-MPA coexistence is highlighted.

AbstractPlant species exert a dominant control over the nitrogen (N) cycle of natural and managed grasslands. Although in intensively managed systems that receive large external N inputs the emission of the potent greenhouse gas nitrous oxide (N2O) is a crucial component of this cycle, a mechanistic relationship between plant species and N2O emissions has not yet been established. Here we use a plant functional trait approach to study the relation between plant species strategies and N2O emissions from soils. Compared to species with conservative strategies, species with acquisitive strategies have higher N uptake when there is ample N in the soil, but also trigger N mineralization when soil N is limiting. Therefore, we hypothesized that (1) compared to conservative species, species with acquisitive traits reduce N2O emissions after a high N addition; and (2) species with conservative traits have lower N2O emissions than acquisitive plants if there is no high N addition. This was tested in a greenhouse experiment using monocultures of six grass species with differing above‐ and below‐ground traits, growing across a gradient of soil N availability. We found that acquisitive species reduced N2O emissions at all levels of N availability, produced higher biomass and showed larger N uptake. As such, acquisitive species had 87% lower N2O emissions per unit of N uptake than conservative species (p < .05). Structural equation modelling revealed that specific leaf area and root length density were key traits regulating the effects of plants on N2O emission and biomass productivity. These results provide the first framework to understand the mechanisms through which plants modulate N2O emissions, pointing the way to develop productive grasslands that contribute optimally to climate change mitigation.

The existing building stock requires substantial interventions to meet the energy performance criteria imposed by the current standards. The installation of a new insulating layer into the building envelope is the most common energy retrofit measure. This strategy is usually focused only on steady state thermal conditions while it influences also the transient thermal behavior. However the on - site characterization of the building dynamic behavior is partially or totally neglected, due to the lack of a feasible investigation procedure. This may lead to a negative thermal performance of the building, paving the way to litigations between the contractor and the tenants. A novel measurement technique, based on infrared thermography, is proposed to investigate the dynamic behavior of the wall. Several wall samples are tested in laboratory with an experimental layout that resembled an outdoor installation, where a sinusoidal thermal stimulus is imposed on the back of the specimen. The surface temperature evolution over time is recorded with an infrared camera both on the front and on the back surfaces of the specimen, in order to measure the time-shift on a broad wall area. A key aspect of the proposed experimental procedure is that it could be applied to the on-site building survey, significantly improving the evaluation of the actual energy performance of the building. The obtained results are compared with a mathematical model showing good agreement.

Corn silage, its water unextractable solids (WUS) and enzyme recalcitrant solids (ErCS) and an industrial corn silage-based anaerobic fermentation residue (AFR) represent corn substrates with different levels of recalcitrance. Compositional analysis reveals different levels of arabinoxylan substitution for WUS, ErCS and AFR, being most pronounced regarding acetic acid, glucuronic acid- and arabinose content. By screening for enzymatic degradation of WUS, ErCS and AFR, enzyme preparations exhibiting high conversion rates were identified. Furthermore significant synergistic effects were detected by blending Aspergillus niger/Talaromyces emersonii culture filtrates with various enzymes. These findings clearly highlight a necessity for a combinatorial use of enzyme preparations towards substrates with high recalcitrance characteristics to reach high degrees of degradation. Enzyme blends were identified, outperforming the individual commercial preparations. These enzyme preparations provide a basis for new, designed enzyme mixtures for corn polysaccharide degradation as a source of necessary, accessory enzyme activities.

Research and development of cost-effective, high-performance thermal insulation materials for the construction sector has to be focused on their final application. In particular, solutions for refurbishing historic buildings, which represent 40% of the European building stock, have to offer a good compromise between environmental quality, energy efficiency and conservation aspects. In this paper, the experimental assessment of an insulation material based on aerogel technology, recently developed in the European project EFFESUS, is presented with regard to the material's thermal performance, compatibility with historic fabric and reversibility. The overall results obtained in laboratory testing on a real-size mock-up and in a real-world case application indicate that the new material is a promising solution for retrofitting historic buildings, thanks to its thermal properties, easy application, reversibility and material compatibility.

Aquifer thermal energy storage (ATES) is a cost-effective technology that enables the reduction of energy use and CO2 emissions associated with the heating and cooling of buildings by storage and recovery of large quantities of thermal energy in the subsurface. Reducing the distance between wells in large-scale application of ATES increases the total amount of energy that can be provided by ATES in a given area. However, due to thermal interference the performance of individual systems can decrease. In this study a novel method is presented that can be used to (a) determine the impact of thermal interference on the economic and environmental performance of ATES and (b) optimize well distances in large-scale applications. The method is demonstrated using the hydrogeological conditions of Amsterdam, Netherlands. Results for this case study show that it is cost-effective to allow a limited amount of thermal interference, such that 30–40% more energy can be provided in a given area compared to the case in which all negative thermal interference is avoided. Sensitivity analysis indicates that optimal well distance is moderately insensitive to changes in hydrogeological and economic conditions. Maximum economic benefit compared to conventional heating and cooling systems on the other hand is sensitive, especially to changes in the gas price and storage temperatures.