• Energy Research
• Open Access close
• Closed Access close
• Restricted close
• natural sciences close
• BE close

This paper focuses on the specific growth rate estimation problem in a Polyhydroxybutyrate bioplastic production process by industrial fermentation. The kinetics of the process are unknown and there are uncertainties in the model parameters and inputs. During the first hours of the growth phase of the process, biomass concentration can be measured online by an optical density sensor, but as cell density increases this method becomes ineffective and biomass measurement is lost. An asymptotic observer is developed to estimate the growth rate for the case without biomass measurement based on corrections made by a pH control loop. Furthermore, an exponential observer based on the biomass measurement is developed to estimate the growth rate during the first hours, which gives the initial condition to the asymptotic observer. Error bounds and robustness to uncertainties in the models and in the inputs are found. The estimation is independent of the kinetic models of the microorganism. The characteristic features of the observer are illustrated by numerical simulations and validated by experimental results.

AbstractThe solubility of polyamide 6 (PA6) in water under pressure has been reported recently and is explored further here using a pressurized differential scanning calorimeter equipped with a pressure regulator, enabling operation at constant pressure. The optimum parameters for solubility (temperature, pressure, concentration) were determined. Crystallization and melting temperature depressions of a maximum of 60 °C were found. The minimum water concentration needed to reach the maximum temperature depression was found to be approximately 30 mass%. Because in such a case the end melting/dissolution temperature for PA6 in water is approximately 165 °C, the pressure level has to be high enough to prevent water from evaporating, i.e. above 8 bar (0.8 MPa). The expected industrial uses of the water solubility of polyamides under pressure are to ease the processing of polyamides by extrusion; to make polyamide composites; to disperse temperature‐sensitive fillers in polyamides; and, in general, to realize ‘green’ routes for the formation of polyamides. Copyright © 2010 Society of Chemical Industry

During the Engineering Validation and Engineering Design Activities (EVEDA) phase (2007-2014) of the International Fusion Materials Irradiation Facility (IFMIF), an advanced engineering design of the High Flux Test Module (HFTM) has been developed with the objective to facilitate the controlled irradiation of steel samples in the high flux area directly behind the IFMIF neutron source. The development process addressed included manufacturing techniques, CAD, neutronic, thermal-hydraulic and mechanical anal- yses complemented by a series of validation activities. Validation included manufacturing of 1:1 parts and mockups, test of prototypes in the FLEX and HELOKA-LP helium loops of KIT for verification of the thermal and mechanical properties, and irradiation of specimen filled capsule prototypes in the BR2 test reactor. The prototyping activities were backed by several R&D studies addressing focused issues like han- dling of liquid NaK (as filling medium) and insertion of Small Specimen Test Technique (SSTT) specimens into the irradiation capsules. This paper provides an up-todate design description of the HFTM irradiation device, and reports on the achieved performance criteria related to the requirements. Results of the vali- dation activities are accounted for and the most important issues for further development are identified.

Abstract. The assessment of wind conditions in complex terrain requires the use of Computational Fluid Dynamics (CFD) simulations incorporating an accurate parameterization of forest canopy effects and variable thermal stability effects. This study aims to investigate how incorporating the presence of trees can improve flow predictions. A three-dimensional steady Reynolds-averaged Navier-Stokes (RANS) equations model is set up using OpenFOAM to simulate the flow over a complex terrain site comprising two parallel ridges located near Perdigão, Portugal. A 7.5 km × 7.5 km terrain of the Perdigao site is constructed from elevation data centered around a 100 m met-mast located on the northeast ridge. A 30-min averaged stationary period corresponding to near-neutral conditions on a single met-mast tower is simulated. The impact of incorporating different source terms is studied such as forest canopy, Coriolis forces as well as also buoyancy forces. The prediction capability of the models is analyzed for different groups of towers on the South-West ridge, inside the valley, and on the North-East ridge based on the flow topology. The inclusion of a canopy model is shown to improve predictions close to the ground for most of the towers, while reducing prediction accuracy on top of the ridges, illustrating the need to represent terrain heterogeneity.

Nature-based solutions may actively reduce hydro-meteorological risks in urban areas as a part of climate change adaptation. However, the main reason for the increasing uptake of this type of solution is their many benefits for the local inhabitants, including recreational value. Previous studies on recreational value focus on studies of existing nature sites that are often much larger than what is considered as new NBS for flood adaptation studies in urban areas. We thus prioritized studies with smaller areas and nature types suitable for urban flood adaptation and divided them into four common nature types for urban flood adaptation: sustainable urban drainage systems, city parks, nature areas and rivers. We identified 23 primary valuation studies, including both stated and revealed preference studies, and derived two value transfer functions based on meta-regression analysis on existing areas. We investigated trends between values and variables and found that for the purpose of planning of new NBS the size of NBS and population density were determining factors of recreational value. For existing NBS the maximum travelling distance may be included as well. We find that existing state-of-the-art studies overestimate the recreational with more than a factor of 4 for NBS sizes below 5 ha. Our results are valid in a European context for nature-based solutions below 250 ha and can be applied across different NBS types and sizes.

A method has been developed for the direct (no sample pretreatment and/or isolation of the target element from the sample matrix) Pb isotopic analysis of bioethanol via multi-collector ICP-mass spectrometry (MC-ICP-MS).

Efforts to protect tropical ecosystems aim at implementing biological corridors across the national territory of Costa Rica. However, potential near-future climate change challenges the effectiveness of such conservation measures. For this purpose, we developed near-future climate change scenarios at high spatial resolution using open-access global data from the Copernicus Climate Data Store (CDS). These projections resulted from downscaling (to a 1km2 national grid) and quantile-mapping bias-correction of the Essential Climate Variables Global Circulation Model (ECV_GCM) ensemble mean from the CDS using a moderate Representative Concentration Pathway 4.5 (RCP4.5). Projections were evaluated with limited local station data and applied to generate future ecosystem indicators (Holdridge Life Zones, HLZs). We show significantly increasing temperatures of 2.6°C with a spatial variability of ± 0.4°C for Costa Rica until 2040 with local differences (higher temperatures projected for the southern Costa Rican Caribbean). The future mean annual precipitation showed slightly wetter conditions (120 ± 43 mm/year) and most prominently in the Costa Rican Caribbean and south Pacific, but no significant drying in the north of Costa Rica by 2040. The bias-corrected climate data were aggregated to decadal and 30-year average (1971–2040) life zone ecosystem indicators that could potentially show ecosystem shifts. Changes in the life zones are most likely due to warmer temperatures and to a lesser extent caused by projected wetter conditions. Shifts are more likely to occur at higher elevations with a potential loss of the sub-tropical rainforest ecosystem. The projections support diminishing tropical dry forests and slightly increasing tropical rain and wet forests in the biological corridors of the driest and wettest regions, respectively. A countrywide spatial uniformity of dominating tropical moist forests (increase from 24% to 49%) at the expense of other HLZs was projected by 2040.