• Energy Research
• 13. Climate action close
• GB close
• DE close
• CA close
• University of North Texas close

There is concern that mercury (Hg) in coal combustion by-products might be emitted into the environment during processing to other products or after the disposal/landfill of these by-products. This perception may limit the opportunities to use coal combustion by-products in recycle/reuse applications and may result in additional, costly disposal regulations. In this program, CONSOL conducted a comprehensive sampling and analytical program to include ash, flue gas desulfurization (FGD) sludge, and coal combustion by-products. This work is necessary to help identify potential problems and solutions important to energy production from fossil fuels. The program objective was to evaluate the potential for mercury emissions by leaching or volatilization, to determine if mercury enters the water surrounding an active FGD disposal site and an active fly ash slurry impoundment site, and to provide data that will allow a scientific assessment of the issue. Toxicity Characteristic Leaching Procedure (TCLP) test results showed that mercury did not leach from coal, bottom ash, fly ash, spray dryer/fabric filter ash or forced oxidation gypsum (FOG) in amounts leading to concentrations greater than the detection limit of the TCLP method (1.0 ng/mL). Mercury was detected at very low concentrations in acidic leachates from all of the fixated and more than half of the unfixated FGD sludge samples, and one of the synthetic aggregate samples. Mercury was not detected in leachates from any sample when deionized water (DI water) was the leaching solution. Mercury did not leach from electrostatic precipitator (ESP) fly ash samples collected during activated carbon injection for mercury control in amounts greater than the detection limit of the TCLP method (1.0 ng/mL). Volatilization tests could not detect mercury loss from fly ash, spray dryer/fabric filter ash, unfixated FGD sludge, or forced oxidation gypsum; the mercury concentration of these samples all increased, possibly due to absorption from ambient surroundings. Mercury loss of 18-26% was detected after 3 and 6 months at 100 F and 140 F from samples of the fixated FGD sludge. Water samples were collected from existing ground water monitoring wells around an active FGD disposal site (8 wells) and an active fly ash slurry impoundment (14 wells). These were wells that the plants have installed to comply with ground water monitoring requirements of their permits. Mercury was not detected in any of the water samples collected from monitoring wells at either site. A literature review concluded that coal combustion byproducts can be disposed of in properly designed landfills that minimize the potentially negative impacts of water intrusion that carries dissolved organic matter (DOM). Dissolved organic matter and sulfate-reducing bacteria can promote the transformation of elemental or oxidized mercury into methyl mercury. The landfill should be properly designed and capped with clays or similar materials to minimize the wet-dry cycles that promote the release of methylmercury.

This paper describes the economically optimal adoption and operation of distributed energy resources (DER) by a hypothetical California microgrid (μGrid) consisting of a group of commercial buildings over an historical test year, 1999. The optimization is conducted using a customer adoption model developed at Berkeley Lab and implemented in the General Algebraic Modeling System. A μGrid is a semiautonomous grouping of electricity and heat loads interconnected with the existing utility grid (macrogrid) but able to island from it. The μGrid minimizes the cost of meeting its energy requirements (consisting of both electricity and heat loads) by optimizing the installation and operation of DER technologies while purchasing residual energy from the local combined natural gas and electricity utility. The available DER technologies are small-scale generators (<500 kW), such as reciprocating engines, microturbines, and fuel cells, with or without combined heat and power (CHP) equipment, such as water and space heating and/or absorption cooling. By introducing a tax on carbon emissions, it is shown that if the μGrid is allowed to install CHP-enabled DER technologies, its carbon emissions are mitigated more than without CHP, demonstrating the potential benefits of small-scale CHP technology for climate change mitigation. Reciprocating engines with heat recovery and/or absorption cooling tend to be attractive technologies for the mild southern California climate, but the carbon mitigation tends to be modest compared to purchasing utility electricity because of the predominance of relatively clean central station generation in California.

Progress in science often follows or parallels the development of new techniques. The optical microscope helped convert medicine and biology from a speculative activity in old times to today's sophisticated scientific disciplines. The telescope changed the study and interpretation of heavens from mythology to science. X-ray diffraction enabled the flourishing of solid state physics and materials science. The technique object of this review, Ambient Pressure Photoelectron Spectroscopy or APPES for short, has also the potential of producing dramatic changes in the study of liquid and solid surfaces, particularly in areas such as atmospheric, environment and catalysis sciences. APPES adds an important missing element to the host of techniques that give fundamental information, i.e., spectroscopy and microscopy, about surfaces in the presence of gases and vapors, as encountered in industrial catalysis and atmospheric environments. APPES brings electron spectroscopy into the realm of techniques that can be used in practical environments. Decades of surface science in ultra high vacuum (UHV) has shown the power of electron spectroscopy in its various manifestations. Their unique property is the extremely short elastic mean free path of electrons as they travel through condensed matter, of the order of a few atomic distances in the energy rangemore » from a few eV to a few thousand eV. As a consequence of this the information obtained by analyzing electrons emitted or scattered from a surface refers to the top first few atomic layers, which is what surface science is all about. Low energy electron diffraction (LEED), Auger electron spectroscopy (AES), X-ray photoelectron spectroscopy (XPS), Ultraviolet photoelectron spectroscopy (UPS), and other such techniques have been used for decades and provided some of the most fundamental knowledge about surface crystallography, composition and electronic structure available today. Unfortunately the high interaction cross section of electrons with matter also prevents them from traveling long distances unscattered in gas environments. Above the millibar pressure range this distance is reduced to less that a millimeter, effectively preventing its use in the most relevant environments, usually between millibars and atmospheric pressures. There is therefore a large gap of several orders of magnitude where information about surfaces is scarce because these powerful electron spectroscopies cannot operate. One characteristic of surfaces in ambient pressure environments is that they are covered by dense layers of molecules, even when their binding energy is weak. Water for example is known to form layers several molecules thick at room temperature in humid environments. Metals readily form oxide films several layers thick in oxygen atmospheres. Dense layers of adsorbed molecules can also be produced in ultra high vacuum, often by the simple and expedient method of cooling the sample to cryogenic temperatures. A large amount of data has been obtained in the past in UHV by surface scientists using this method. While this has provided valuable information it begs the question of whether the structures formed in this manner represent equilibrium structures or metastable ones, kinetically trapped due to high activation energies that cannot be overcome at low temperature. From a thermodynamic point of view is interesting to consider the entropic contribution to the Gibbs free energy, which we can call 'the pressure factor', equal to kT.logP. This factor amounts to a sizeable 0.3 eV difference at room temperature between UHV (<10{sup -8} Pascal) and atmospheric pressures. Such change if free energy can definitely result in changes in surface structure and stability. Entire areas of the phase diagram are out of reach due to the pressure gap. Even when cooling is not necessary, many surface treatments and most chemical reactions necessitate the presence of gases at pressures ranging from millibar to bars. What is the structure and chemical nature of the species formed on the surface in equilibrium with such gases? As we shall illustrate in this review, APPES provides a much needed electron spectroscopy to analyze surface electronic structure and composition in equilibrium with gases.« less

Distributed energy resources (DER) technologies, such as gas-fired reciprocating engines and microturbines, can be economically beneficial in meeting commercial-sector energy loads. Even with a lower electric-only efficiency than traditional central stations, combined heat and power (CHP) applications can increase overall system energy efficiency. From a policy perspective, it is useful to have good estimates of penetration rates of DER under different economic and regulatory scenarios. We model the diffusion of DER in the US commercial building sector under various technical research and technology outreach scenarios. Technology market diffusion is assumed to depend on the system's economic attractiveness and the developer's knowledge about the technology. To account for regional differences in energy markets and climates, as well as the economic potential for different building types, optimal DER systems are found for several building types and regions. Technology diffusion is predicted via a baseline and a program scenario, in which more research improves DER performance. The results depict a large and diverse market where the West region and office building may play a key role in DER adoption. With the market in an early stage, technology research and outreach programs may shift building energy consumption to a more efficient alternative.

In the last decade, many malaria-endemic countries, like Zambia, have achieved significant reductions in malaria incidence among children <5 years old but face ongoing challenges in achieving similar progress against malaria in older age groups. In parts of Zambia, changing climatic and environmental factors are among those suspectedly behind high malaria incidence. Changes and variations in these factors potentially interfere with intervention program effectiveness and alter the distribution and incidence patterns of malaria differentially between young children and the rest of the population. We used parametric and non-parametric statistics to model the effects of climatic and socio-demographic variables on age-specific malaria incidence vis-à-vis control interventions. Linear regressions, mixed models, and Mann-Kendall tests were implemented to explore trends, changes in trends, and regress malaria incidence against environmental and intervention variables. Our study shows that while climate parameters affect the whole population, their impacts are felt most by people aged ≥5 years. Climate variables influenced malaria substantially more than mosquito nets and indoor residual spraying interventions. We establish that climate parameters negatively impact malaria control efforts by exacerbating the transmission conditions via more conducive temperature and rainfall environments, which are augmented by cultural and socioeconomic exposure mechanisms. We argue that an intensified communications and education intervention strategy for behavioural change specifically targeted at ≥5 aged population where incidence rates are increasing, is urgently required and call for further malaria stratification among the ≥5 age groups in the routine collection, analysis and reporting of malaria mortality and incidence data.

AbstractA natural laboratory is a place supporting the conditions for hypothesis testing under non-anthropogenic settings. Located at the southern end of the Magellanic sub-Antarctic ecoregion in southwestern South America, the Cape Horn Biosphere Reserve (CHBR) has one of the most extreme rainfall gradients in the world. Subject to oceanic climate conditions, it is also characterized by moderate thermal fluctuations throughout the year. This makes it a unique natural laboratory for studying the effects of extreme rainfall variations on forest bird communities. Here, we monitor the bird species richness in the different forest types present in the CHBR. We found that species richness decreased with increasing precipitation, in which an increase of 100 mm in average annual precipitation showed about 1% decrease in species richness. Similar patterns were found among different forest types within the CHBR. These results provide a baseline to investigate the interactions between physical and biotic factors in a subpolar region that climatically contrasts with boreal forests, which is subject to continental climatic conditions. This research highlights the importance of ecological and ornithological long-term studies in the CHBR, which can contribute both to a higher resolution of the heterogeneity of climate changes in different regions of the world, and to orient conservation policies in the Magellanic sub-Antarctic ecoregion in the face of growing development pressures.

An analysis was made of siting issues in the coastal zone, one of the nation's most critical natural resource areas and one which is often the target for energy development proposals. The analysis addressed the changing perceptions of citizens toward energy development in the coastal zone, emphasizing urban communities where access to the waterfront and revitalization of waterfront property are of interest to the citizen. The findings of this analysis are based on an examination of energy development along New Jersey's urban waterfront and along the Texas-Louisiana Gulf Coast, and on redevelopment efforts in Seattle, San Francisco, Boston, and elsewhere. The case studies demonstrate the significance of local attitudes and regional cooperation in the siting process. In highly urbanized areas, air quality has become a predominant concern among citizen groups and an influential factor in development of alternative energy facility siting strategies, such as consideration of inland siting connected by pipeline to a smaller coastal facility. The study addresses the economic impact of the permitting process on the desirability of energy facility investments, and the possible effects of the location selected for the facility on the permitting process and investment economics. The economic analysis demonstrates the importance of viewing energymore » facility investments in a broad perspective that includes the positive or negative impacts of various alternative siting patterns on the permitting process. Conclusions drawn from the studies regarding Federal, state, local, and corporate politics; regulatory, permitting, licensing, environmental assessment, and site selection are summarized. (MCW)« less

This report addresses the Asia-Pacific Economic Cooperation (APEC) organization’s desire to minimize the learning time required to understand the implications of smart-grid concepts so APEC members can advance their thinking in a timely manner and advance strategies regarding smart approaches that can help meet their environmental-sustainability and energy-efficiency policy goals. As significant investments are needed to grow and maintain the electricity infrastructure, consideration needs to be given to how information and communications technologies can be applied to electricity infrastructure decisions that not only meet traditional needs for basic service and reliability, but also provide the flexibility for a changing the mix of generation sources with sensitivity to environmental and societal impacts.