• Energy Research
• 2016-2025close
• Open Access close
• Restricted close
• Open Source close
• DE close
• CA close

To mitigate the temperature increase in urban environments and reduce its impact on energy consumption and the quality of the environment, urban retrofitting technologies have been developed and applied worldwide. High albedo in urban surfaces and additional vegetation are the most efficient strategies to accomplish these goals. The objective of this study is to estimate the weight of these strategies, both individually and integrated, on the cooling potential of two Latin American cities. To do this, 36 low and high urban density scenarios were simulated with the ENVI-Met software. The simulation models were calibrated using air temperature curves which were monitored during the summer periods from 2010 to 2013. A Principal Components Analysis was carried out to establish possible associations between the proposed mitigation strategies and then the weight of anthropogenic heat was evaluated according to the configuration. The results show that the integrated mitigation strategies in urban areas -i. e. increase vegetation and albedo on horizontal surfaces- has a great potential to mitigate urban warming, showing a more significant impact on low-density urban configuration. The contribution of anthropogenic heat mainly produced by motorized transport and air conditioning systems, is a crucial input data for the urban microclimate simulations. Its impact on the urban densification processes may cancel out the benefits derived by the application of the mitigation strategies considered.

Abstract This paper uses research-quality, ground measurements of irradiance and temperature that are accurate to ±2% to estimate the electric energy yield of fixed solar modules for utility-scale solar power plants at 18 sites in Saudi Arabia. The calculation is performed for a range of tilt and azimuth angles and the orientation that gives the optimum annual energy yield is determined. A detailed analysis is presented for Riyadh including the impact of non-optimal tilt and azimuth angles on annual energy yield. It is also found that energy yield in March and October are higher than in April and September, due to milder operating temperatures of the modules. A similar optimization of tilt and azimuth is performed each month separately. Adjusting the orientation each month increases energy yield by 4.01% compared to the annual optimum, but requires considerable labour cost. Further analysis shows that an increase in energy yield of 3.63% can be obtained by adjusting the orientation at five selected times during the year, thus significantly reducing the labour requirement. The optimal orientation and corresponding energy yield for all 18 sites is combined with a site suitability analysis taking into account climate, topography and proximity to roads, transmission lines and protected areas. Six sites are selected as having high suitability and high energy yield: Albaha, Arar, Hail, Riyadh, Tabuk and Taif. For these cities the optimal tilt is only slightly higher than the latitude, however the optimum azimuth is from 20° to 53° west of south due to an asymmetrical daily irradiance profile.

Recycled polylactic acid (PLAr) was reinforced with treated nanocellulosic hemp fibers for biocomposite fabrication. Cellulosic fibers were extracted from hemp fibers chemically and treated enzymatically. Treated nanocellulosic fibers (NCF) were analyzed by Fourier-transform infrared spectroscopy, X-ray diffraction, and scanning electron microscopy. Biocomposite fabrication was done with PLAr and three concentrations of treated NCF (0.1%, 0.25%, and 1% (v/v)) and then studied for thermal stability and mechanical properties. Increased thermal stability was observed with increasing NCF concentrations. The highest value for Young’s modulus was for PLAr + 0.25% (v/v) NCF (250.28 ± 5.47 MPa), which was significantly increased compared to PLAr (p = 0.022). There was a significant decrease in the tensile stress at break point for PLAr + 0.25% (v/v) NCF and PLAr + 1% (v/v) NCF as compared to control (p = 0.006 and 0.002, respectively). No significant difference was observed between treatments for tensile stress at yield.

This deliverable includes the methodology in EnergyPROSPECTS for an in-depth study of energy citizenship. It features the criteria used for selecting the cases for indepth study, the list of cases selected for in-depth study as well as key research foci and empirical research questions.

Lithium-ion batteries exhibit a dynamic voltage behaviour depending nonlinearly on current and state of charge. The modelling of lithium-ion batteries is therefore complicated and model parametrisation is often time demanding. Grey-box models combine physical and data-driven modelling to benefit from their respective advantages. Neural ordinary differential equations (NODEs) offer new possibilities for grey-box modelling. Differential equations given by physical laws and NODEs can be combined in a single modelling framework. Here we demonstrate the use of NODEs for grey-box modelling of lithium-ion batteries. A simple equivalent circuit model serves as a basis and represents the physical part of the model. The voltage drop over the resistor–capacitor circuit, including its dependency on current and state of charge, is implemented as a NODE. After training, the grey-box model shows good agreement with experimental full-cycle data and pulse tests on a lithium iron phosphate cell. We test the model against two dynamic load profiles: one consisting of half cycles and one dynamic load profile representing a home-storage system. The dynamic response of the battery is well captured by the model.

Abstract Electricity markets in Europe become increasingly interconnected due to new grid connections and market coupling regulations. This paper examines the interdependencies between the Swiss electricity market and those of neighbouring countries. The Swiss market serves as a good example for a smaller electricity market which is increasingly affected by developments in the large neighbouring countries. To study these cross-border effects, especially those on Swiss electricity prices, we apply two different methodologies, an econometric and a Nash-Cournot equilibrium model. The analyses show that the Swiss electricity price correlates strongly with the German electricity price in the summer, but tends to follow the French electricity price in the winter. Another finding is that gas prices and the electricity load of neighbouring countries have a significant influence on prices. In particular, the load of France and Italy is driving up Swiss prices in the winter, while the German electricity demand and renewable energy generation have a larger influence on Swiss prices in the summer.

This article makes the central argument that basic democratic values such as justice, autonomy and participation run the risk of being neglected when designing ‘nudges’ (i.e., indirect suggestions to influence individual behaviour) for sustainable behaviour change in the context of food governance, potentially complicating a democratisation of the food system. ‘Nudges’ uphold freedom of choice while simultaneously advocating a non-coercive soft force of paternalism to help people realise their preferences, maximise societal well-being and meet macro-sustainability goals. While the promises of the ‘nudge’ approach are widely echoed, nudging is also being contested because of its possible anti-democratic effects, such as individualisation, depoliticization and the emphasis of the status of citizens as ‘consumer-citizens.’ From a food democracy perspective, these dangers may undermine efforts to organise collective political action and impede alternative visions of a future food system. Empirically, the article examines specifically how behavioural-economic approaches imagine transitions to a more sustainable food system. By using the “COOP Supermarket of the Future” as a case study, the following analysis will illustrate how private actors are increasingly involved in steering consumer choice towards socially desirable actions. The analysis suggests that the design of choice environments may under specific circumstances increase the susceptibility of individuals to the influence of corporate preferences and simultaneously decrease the prospects for democratic legitimation and decision-making. The article therefore critically assesses whether reforming the food system by altering consumers’ choice-sets and the attribution of personal responsibility, may in fact point towards implicit anti-democratic tenets underlying the ‘will to nudge’ citizens.

Since the invention of fluorescent light sources, there is strong interest in Eu3+ activated phosphors as they are able to provide a high color rendering index (CRI) and luminous efficacy, which will also hold for phosphor converted light emitting diodes. Due to an efficient U6+ to Eu3+ energy transfer in Gd3Li3Te2O12:U6+,Eu3+, this inorganic composition shows red photoluminescence peaking at 611 nm. That means Eu3+ photoluminescence can be nicely sensitized via excitation into the U6+ excitation bands. Therefore, photoluminescence properties, such as temperature dependent emission and emission lifetime measurements, are presented. Charge transfer bands were investigated in detail. Additionally, density functional theory calculations reveal the band structure of the pure, i.e., non-doped host material. Obtained theoretical results were evaluated experimentally by the aid of diffuse UV reflectance spectroscopy.