• Energy Research
• Closed Access close
• 6. Clean water close
• CA close
• AU close
• GB close
• JP close

Abstract A new formulation for the evaporation, flashing, condensation processes taking place in the effects of thermal desalination systems which simulates the operation of both forward and parallel/cross configurations is coupled with an exergo-economic model based on the SPECO method. The thermo-economic model uses accurate properties for the seawater, brine, pure water and vapour and is solved with an equation solver which does not require the development of a specific solution algorithm as in most previous studies. This flexible model is used to analyze the influence of the number of effects N and the temperature difference ΔT e between effects on the technical and economic performance of multi-effect desalination systems with ejector vapour compression. In particular, it is shown that the performance calculated by an earlier black-box approach is not attainable by technically and economically realistic systems. It is also shown that for each feed configuration and a given number of effects there exists an optimum value of ΔT e which minimizes the cost of the produced potable water. This last result forms the basis of a procedure that combines black-box results with the optimum value of ΔT e and can be used to select the appropriate system for any specific application.

Abstract: The dynamics of reformation and replacement of gas hydrates were studied under nonequilibrium conditions. It was found that the reformation of gas hydrates is largely affected by the state of the gas‐water system and the restarting temperature. This suggests that the effects are caused by changes in the structure of the aqueous solution at a molecular level. Pure samples of CH4 gas hydrate were synthesized from ice crystals and the dissociated solution using the reformation method. Replacement of CO2 gas hydrate is achieved within a short duration in the solid‐phase sample of CH4 gas hydrate, if the pressure and temperature is precisely controlled in a pressure vessel.

Abstract The 2013/2017 Nankai Trough (Japan) and 2017 Shenhu Area (China) offshore methane hydrate production tests showed the world the possibility and feasibility of the oceanic methane hydrate production by depressurization. However, the relatively low gas production rate still remained as one of the critical bottlenecks for the economical utilization. This study chose the Nankai Trough as a target area, and aimed at the gas recovery enhancement from the methane hydrate reservoir using vertical wells. A traditional single-vertical-well system and a new dual-vertical-well system were proposed, and special production strategies of the aggressive depressurization and permeability improvement were applied to these two systems for the effectiveness verification. Based on the 15-year simulation results, it was found that the middle low-permeability silt-dominated layers in the reservoir held the key to the gas recovery enhancement, and for the single-vertical-well system, the permeability improvement in this sublayer seemed more reliable and feasible than the aggressive depressurization. On the other hand, the dual-vertical-well system significantly exceeded the single-vertical-well system due to the synergistic effect of the two wellbores, and could raise the average gas production rate (9.5 × 103 m3/day) by one order of magnitude (to 7.9 × 104 m3/day). Moreover, if this new system was combined with the aggressive depressurization, the average gas production rate could be further raised by one order of magnitude (to 3.4 × 105 m3/day).

AbstractA bioreactor system composed of a stirred tank and three tubular bioreactors in series was established, and continuous ethanol fermentation was carried out using a general Saccharomyces cerevisiae strain and a very high gravity medium containing 280 g L−1 glucose, supplemented with 5 g L−1 yeast extract and 3 g L−1 peptone. Sustainable oscillations of glucose, ethanol, and biomass were observed when the tank was operated at the dilution rate of 0.027 h−1, which significantly affected ethanol fermentation performance of the system. After the tubular bioreactors were packed with 1/2″ Intalox ceramic saddles, the oscillations were attenuated and quasi‐steady states were achieved. Residence time distributions were studied for the packed bioreactors by the step input response technique using xylose as a tracer, which was added into the medium at a concentration of 20 g L−1, indicating that the backmixing alleviation assumed for the packed tubular bioreactors could not be established, and its contribution to the oscillation attenuation could not be verified. Furthermore, the role of the packing's yeast cell immobilization in the oscillation attenuation was investigated by packing the tubular bioreactors with packings with significant difference in yeast cell immobilization effects, and the experimental results revealed that only the Intalox ceramic saddles and wood chips with moderate yeast cell immobilization effects could attenuate the oscillations, and correspondingly, improved the ethanol fermentation performance of the system, while the porous polyurethane particles with good yeast cell immobilization effect could not. And the viability analysis for the immobilized yeast cells illustrated that the extremely lower yeast cell viability within the tubular bioreactors packed with the porous polyurethane particles could be the reason for their inefficiency, while the yeast cells loosely immobilized onto the surfaces of the Intalox ceramic saddles and wood chips could be renewed during the fermentation, guaranteeing their viability and making them more efficient in attenuating the oscillations. The packing Raschig rings without yeast cell immobilization effect did not affect the oscillatory behavior of the tubular bioreactors, further supporting the role of the yeast cell immobilization in the oscillation attenuation. Biotechnol. Bioeng. 2009;102: 113–121. © 2008 Wiley Periodicals, Inc.

Abstract There are instances in remote areas where heat is being wasted, e.g., in internal combustion, engines, etc. Some of this heat can be recovered to produce distilled water in solar stills. The solar still replaces the cooling tower, ponds, or radiators normally used to control the engine temperature. The diesel cooling water in such a system remains separate from the saline water in the solar still. The advantages of using such a system compared with a conventional solar still are: 1. (a) water costs are very much reduced 2. (b) the area occupied is much less, i.e., about 1 5 th 3. (c) production has much less seasonal variation 4. (d) the efficiency of the solar still is improved due to the higher operating temperatures. From experiments conducted at Highett using a Mk VI solar still fitted with a simple heat exchanger and a separate electrically-heated source of hot water to simulate the waste heat, design data are not available for application to working systems. The information required to match a solar still to a diesel's cooling requirement is: 1. (a) engine efficiency 2. (b) hourly fuel consumption 3. (c) hourly solar radiation 4. (d) hourly ambient temperatures. A by-product of this work has been the production of a “solar water heater” which costs less than that of the cheapest conventional system. This “solar” hot water system uses a heat exchanger similar to what is used to transfer the waste heat to the saline water. It is envisaged to have hot water productions approximately the same as the distilled water productions. The influence of hot water production on the output of the waste heat solar still is discussed.

This paper describes anaerobic thermophilic sludge digestion (55 °C) in a continuously stirred tank reactor (CSTR) on a pilot-plant scale (150 L). The experimental protocol was defined to examine the effect of the increase in the organic loading rate on the efficiency of the digester and to report on its steady-state performance. The reactor was subjected to a programme of steady-state operation over a range of solids retention times (SRTs) of 75, 40, 27, 20 and 15 days and organic loading rates (OLR) in the range 0.4–2.2 kg VS/(m3 day). The digester was fed with raw sludge (containing approximately 35 kg/m3 volatile solids (VS)) once daily during the 75-day SRT period, twice daily during the 40-day SRT period and three times a day during the 27-, 20- and 15-day SRT periods. The reactor was initially operated with an organic loading rate of 0.4 kg VS/(m3 day) and an SRT of 75 days. The volatile solids removal efficiency in the reactor was found to be 73%, while the volumetric methane production rate produced in the digester reached 0.02 m3/(m3 day). Over a 338-day operating period, an OLR of 2.2 kg VS/(m3 day) was achieved with 49.1% VS removal efficiency in the pilot sludge digester, at which time the volumetric methane production rate content of biogas produced in the digester reached 0.4 m3/(m3 day). The chemical oxygen demand (COD) mass balance obtained indicated that COD used for methane generation increased when the SRT was decreased or when the influent organic loading rate was increased. This implies that the amount of COD used in the anabolism route decreased with SRT due the microbial population becoming adapted to new operational conditions and more COD being used to generate methane.

Abstract Food waste (FW), primary sludge (PS) and waste activated sludge (WAS) were characterized and found to be complementary in the concentrations of carbohydrates, total Kjeldahl nitrogen (TKN), PO4–P and some metal for biological hydrogen production. Moreover, FW was found to have low pH buffering capacity while the values for PS and WAS were relatively higher. An anaerobic toxicity analysis (ATA) derived from a methanogenic ATA protocol showed that these waste materials had no toxicity to hydrogen production. Adding phosphate buffer to the FW significantly improved hydrogen production while initial pH was 7.0. Co-digestion of FW and sewage sludge was studied using a batch respirometric cultivation system. All combinations of the feedstocks (FW+PS, FW+WAS and FW+PS+WAS) showed enhanced hydrogen production potential as compared with the individual wastes. A mixing ratio of 1:1 was found to be the best among the ratios tested for all three co-digestion groups. A hydrogen yield of 112 mL/g volatile solid (VS) added was obtained from a combination of FW, PS and WAS. This yield was equivalent to 250 mL/g VS added if only FW contributed to hydrogen production. The reason for the enhancement of hydrogen production was postulated to be multifold in which the increase in buffer capacity in the co-digestion mixture was verified.

Abstract Algae have been considered as a promising biodiesel feedstock. One of the major factors affecting large-scale algae technology application is poor wintering cultivation performance. In this study, an integrated approach is investigated combining freshwater microalgae Chlorella zofingiensis wintering cultivation in pilot-scale photobioreactors with artificial wastewater treatment. Mixotrophic culture with the addition of acetic acid (pH-regulation group) and autotrophic culture (control group) were designed, and the characteristics of algal growth, lipid and biodiesel production, and nitrogen and phosphate removal were examined. The results showed that, by using acetic acid three times per day to regulate pH at between 6.8 and 7.2, the total nitrogen (TN) and total phosphate (TP) removal could be increased from 45.2% to 73.5% and from 92.2% to 100%, respectively. Higher biomass productivity of 66.94 mg L−1 day−1 with specific growth rate of 0.260 day−1 was achieved in the pH-regulation group. The lipid content was much higher when using acetic acid to regulate pH, and the relative lipid productivity reached 37.48 mg L−1 day−1. The biodiesel yield in the pH-regulated group was 19.44% of dry weight, with 16–18 carbons as the most abundant composition for fatty acid methyl esters. The findings of the study prove that pH adjustment using acetic acid is efficient in cultivating C. zofingiensis in wastewater in winter for biodiesel production and nutrient reduction.

AbstractAgricultural organic wastes (AOW) have the potential to provide bioenergy particularly found in biogas by anaerobic digestion (AD). In this study, the biogas production (BP) of AOW was obtained by batch AD with anaerobic digesters (500 mL) at 35°C incubator. The results showed that BP values in terms of volatile solids (VS) from rice husk, rice straw, flower residues, fruit and vegetable residues, wasted oyster shell residue (WOSR), fishery residues, livestock and poultry manures, livestock and poultry slaughter wastes (LPSW), and eight equally mixed wastes (EEMW) were 84.03, 193.36, 153.32, 76.27, 150.48, 63.26, 169.63, 615.74, and 172.83 mL/g VS, respectively. LPSW showed the highest μm of 16.99 mL/g VS‐d, the highest BP of 615.74 mL/g VS and the highest bioconversion efficiency of 65.98% compared to the other organic wastes. BP from the most AOW in Taiwan by AD was estimated to be 768,567,753 (743,522,223, excluding WOSR) m3/year. The annual BP of 768,567,753 m3/year of the eight total major AOW by AD was lower (∼20.11%) than 961,989,781 m3/year of the EEMW by anaerobic co‐digestion. Result also showed that modified Gompertz equation was suitable to describe BP accumulation and BP rate.