• Energy Research
• Open Access close
• 12. Responsible consumption close
• 1. No poverty close
• CN close
• CA close

A new environmental ban has forced the restructure of open dumps in China since 1 July 2011. A technical process was established in this study that is feasible for the upgrade of open dumps through restructuring. The feasibility of restructuring and the benefit of greenhouse gas emission reductions were assessed according to field surveys of five landfills and four dumps in Nanjing. The results showed that the daily processing capacities of the existing landfills have been unable to meet the growth of municipal solid waste (MSW), making restructuring of the landfills imperative. According to an assessment of the technical process, only four sites in Nanjing were suitable for upgrading. Restructuring the Jiaozishan landfill effectively reduced the leachate generation rate by 5.84% under its scale when expanded by 60.7% in 2015. CO2 emissions were reduced by approximately 55,000–86,000 tons per year, in which biogas power generation replaced fossil fuels Fossil fuels accounted for the largest proportion, up to 45,000–60,000 tons. Photovoltaic power generation on the overlying land has not only reduced CO2 emissions to 26,000–30,000 tons per year but has also brought in continuing income from the sale of electricity. The funds are essential for developing countries such as China, which lack long-term financial support for landfill management after closure.

Production of biodiesel from yellow grease (waste cooking oil and waste animal fats) is fast emerging as a promising alternative to address the twin challenges before the biodiesel industry today-fluctuation in prices of vegetable oil and the food versus fuel debate. Yellow grease has a high percentage of free fatty acids (FFA) and proves to be an unsuitable feedstock for biodiesel production from commercially viable alkali-catalyzed production systems due to saponification problems.“Green” methodologies based on heterogeneous solid acid catalyzed reactions have the potential to simultaneously promote esterification and transesterification reactions of yellow grease to produce biodiesel without soap formation and offer easy catalyst separation without generation of toxic streams. This paper presents kinetic studies for the conversion of model yellow grease feeds to biodiesel using a heteropolyacid supported on alumina (HSiW/Al2O3) using a batch autoclave. Three model yellow grease feeds were prepared using canola oil with added FFA such as palmitic, oleic and linoleic acid. A pseudo homogeneous kinetic model for the parallel esterification and transesterification was developed. The rate constants and activation parameters for esterification and transesterification reactions for the model yellow grease feeds were determined. The rate constants for esterification are higher than the transesterification rate constants. The kinetic model was validated using the experimental biodiesel data obtained from processing a commercial yellow grease feed. The kinetic model could be used to design novel processes to convert various low-value waste oils, fats and non-food grade oils to sustainable biodiesel. Keywords: Yellow grease, Canola oil, Free fatty acids, Heteropolyacid, Kinetics for esterification and transesterification

In this study, we investigated the influence of overall financial development and its components on energy consumption using the panel data of 120 countries and the generalized method of moments (GMM). By dividing the sample into developed and developing countries, we further examined the national differences of the impact of financial development on energy consumption. The empirical results indicate that the overall financial development significantly positively impacts energy consumption from a worldwide perspective, and its two components (financial institution and the financial market) have the same effect. The analysis of national differences indicates that the financial development also positively impacts energy consumption in developing countries but with no obvious effect in developed countries. The results also suggest that financial development cannot be used to restrain the increase in energy consumption from the global perspective, and policymakers in developing countries must balance the relationship between the development of the financial sector and energy consumption.

The benefits of aluminum lamination in improving the physical and mechanical properties of wood-based composites is now well documented. This paper shows the contribution of life cycle assessment (LCA) as a tool to assess and compare the environmental footprint in the development of laminated panels. SimaPro 9.0 software, using Ecoinvent database was used to analyze the environmental impacts associated with the manufacturing of wood aluminum-laminated (WAL) panels and aluminum honeycomb panel (AHP). The impact 2002+ method was used to estimate environmental impacts. The LCA results show that the WAL panels manufacturing had a lower environmental impact than AHP manufacturing. In term of product, wood-based composites were the best choice as a core in laminated panel manufacturing. Wood-based composite manufacturing showed environmental advantages in all damage categories except in ecosystem quality. Aluminum alloy sheets manufacturing played an important role in the generation of environmental impacts for laminated panel development.

As a relatively mature technology, biomass molded fuel (BMF) is widely used in distributed and centralized heating in China and has received considerable government attention. Although many BFM incentive policies have been developed, decreased domestic traditional fuel prices in China have caused BMF to lose its economic viability and new policy recommendations are needed to stimulate this industry. The present study built a regionalized net present value (NPV) model based on real production process simulation to test the impacts of each policy factor. The calculations showed that BMF production costs vary remarkably between regions, with the cost of agricultural briquette fuel (ABF) ranging from 86 US dollar per metric ton (USD/t) to 110 (USD/t), while that of woody pellet fuel (WPF) varies from 122 USD/t to 154 USD/t. The largest part of BMF’s cost composition is feedstock, which accounts for up 50%–60% of the total; accordingly a feedstock subsidy is the most effective policy factor, but in consideration of policy implementation, it would be better to use a production subsidy. For ABF, the optimal product subsidy varies from 26 USD/t to 57 USD/t among different regions of China, while for WPF, the range is 36 USD/t to 75 USD/t. Based on the data, a regional BMF development strategy is also proposed in this study.

This study aims to explore the application of fractional order chaotic system (FOCS), based on the T-S fuzzy model, in the design of secure communication (SC) and this SC system’s role in the construction of efficiency evaluation system for dispatching operation of energy saving and power generation under a low carbon economy (LCE). First, the definition of fractional order differential equations and the stability theory of FOCS are discussed. T-S fuzzy control is introduced to analyse the stability of FOCS. Then, based on the adaptive synchronisation theory, the combined FOCS is designed for SC, and the performance of the system constructed here is analysed in a MATLAB environment. Next, an evaluation index system of the dispatching operation effect of energy saving and power generation under LCE is constructed. The confidential communication system constructed here is used to transmit the index data. The particle swarm optimisation (PSO) algorithm is then used to optimise the back propagation neural network (BPNN) model. The BPNN algorithm based on PSO (PSO-BPNN) is obtained, and the evaluation model is constructed. After training this model, it is applied to the evaluation of the dispatching operation effect for energy saving and power generation in 10 provinces in China. The simulation results show that the FOCS based on the T-S fuzzy model can acquire the criterion of system stability. Furthermore, the constructed SC system can effectively undertake the secure transmission of square and sine waves. The performance of the PSO-BPNN model seems to be better than other algorithms. After analysing the data on energy saving and power generation from 10 provinces in China using this model, the comprehensive evaluation value of province 5 is found to be the highest and good (0.802), while that of province 4 is the lowest and general (0.600). Summarising, the FOCS based on T-S fuzzy model constructed here is applied to the design of SC. This can improve the confidentiality of data transmission and reduce the transmission error. Moreover, the BPNN evaluation model based on PSO can effectively achieve the evaluation of the dispatching operation effect of energy saving and power generation under LCE.

Energy is consumed at every stage of the cycle of water production, distribution, end use, and recycled water treatment. Understanding the nexus of energy and water may help to minimize energy and water consumption and reduce environmental emissions. However, the interlinkages between water and energy have not received adequate attention. To address this gap, this paper disaggregates and quantifies the energy consumption of the entire water cycle process in Beijing. The results of this study show that total energy consumption by water production, treatment and distribution, end use, and recycled water reuse amounts to 55.6 billion kWh of electricity in 2015, or about 33% of the total urban energy usage. While water supply amount increased by only 10% from 2005 to 2015, the related energy consumption increased by 215% due to water supply structural change. The Beijing municipal government plans to implement many water saving measures in the area from 2016 to 2020, however, these policies will increase energy consumption by 74 million kWh in Beijing. This study responds to the urgent need for research on the synergies between energy and water. In order to achieve the goal of low-energy water utilization in the future, water and energy should be integrated in planning and management.

With the 2015 Paris Agreement pursuing efforts to limit global temperature increase to below 2°C above pre-industrial levels and the “energy trilemma” goals of energy security, energy equity and environmental sustainability, decarbonisation remains a priority across all of the United Kingdom (United Kingdom) energy system, not just electricity. Electricity and thermal energy storage technologies can offer a host of benefits across the energy value chain through the abilityS to capture, store and then release electricity or thermal energy over a period of time. These benefits include helping capture the full potential of renewable generation and providing services such as frequency response and reserve to Great Britain’s (GB) electricity system. In addition, with the aforementioned climate targets in mind, energy storage can also play a role in facilitating the decarbonisation of other activities and sectors. Here we delve deeper into how energy storage technologies can contribute to both energy sector transformation and more broadly, decarbonisation. Furthermore, we discuss the importance of ensuring a technology-agnostic approach to the development of policy and regulation with relevance to energy storage. This ensures that storage technologies with significant potential to contribute to the ‘energy trilemma’ goals are not precluded from entering the market due to unfavourable policy and regulatory frameworks.

Car-sharing services are developing at an ever-increasing pace. Taking into account the reduction of carbon dioxide emissions and pursuit of the sustainable development of transport, implementing electric cars in car-sharing fleets is being proposed. On the one hand, these types of vehicles are referred to as emission-free, but on the other hand, their environmental friendliness is questionable due to the emission of carbon dioxide during the production of energy to power them. Although many scientific papers are devoted to the issue of reducing emissions through car sharing, there is a research gap concerning the real production of carbon dioxide by car-sharing vehicles during car-sharing trips. To fill this research gap, the objective of the article was to analyze the actual level of carbon dioxide emissions from combustion and electric vehicles from car-sharing systems produced when renting rides. The test results showed that the electric car turned out to be significantly less emitting. The use of electric vehicles in car-sharing fleets can reduce carbon dioxide emissions from 14% to 65% compared to using cars with internal combustion engines. However, the key role during car-sharing trips is played by the driving style of the drivers, which has been omitted from the literature to date. This should be properly regulated by service providers and focus on the proper use of energy from electric vehicle batteries, especially at low temperatures. The article provides support for operators planning to modernize their fleet of vehicles and fills the research gap concerning car-sharing emissions.

Household Surveys performed in four villages selected from Oromia, Amhara and Southern Nations, Nationalities, and Peoples’ Region (SNNPR) following from the ‘Ethiopian Rural Household Survey’ (ERHS) conducted in 2004.It contains detailed data on household consumption and expenditures, assets, income, agricultural activities, land allocation, demographic characteristics, and other variables. From September 2011 to January 2012 another survey of 221 households was conducted in three major regions of central and southern Ethiopia. At the time of this latest survey effort the most recent ERHS survey data available was from 2004. The selection of respondents, determination of sample size, and apportionment of the sample were based on a proportional sampling technique.In addition to addressing important questions from the ERHS survey data, the field survey was designed to generate detailed information on household biomass energy production and consumption practices; as well as farming activities; labour and land allocation; economic and demographic characteristics; and expenditures on food, non-food items, and energy. The 2011 survey effort collected detailed household biomass energy use data. The measurement of household biomass energy use was obtained in traditional units and later converted into kilograms. The conversion factors for each of the biomass were collected from the closest urban centre of each of the study areas. Information obtained on household biomass energy use was collected for a time period of one week before the survey was conducted. It was then aggregated into annual figures, although household biomass energy use may vary seasonally. Quality/Lineage: The data was collected by qualified enumerators who had participated in previous ERHS survey. In addition to myself I recruited assistant supervisor to check the accuracy and quality of data on daily basis and followup interview process closely. Before the survey commenced a pilot survey was conducted in each of the study areas to identify the different types of energy households are using and other critical variables of interest for the research. This information was used to revise and improve questionnaire. Moreover, a one day in-depth training was given to enumerators and assistant supervisor to enrich their deeper understanding of each the question in the survey and to further improve questionnaire from their earlier experiences in those villages. Purpose: Over 90% of Ethiopian rural population rely on biomass energy. However, biomass energy utilization is linked to household livelihood as in rural households produce and consume biomass energy simultaneously with other (on and off-farm)activities. With the rampant rate of deforestation that Ethiopia is facing it is important to investigate the effect of deforestation or fuelwood scarcity which is assumed affect household welfare through influence on wage and price. In light of this, the survey effort collected information on household use of biomass energy sources, expenditure and labour allocation choices and amount of labour time used for each activities.This helped me to investigate the effect of fuelwood scarcity on household welfare from three aspects: labour allocation decision, energy expenditure and fuel choice and biomass energy consumption behavior to better understand the related linkage of household production and utilization of biomass with livelihoods or food security. This dataset was first published on the institutional Repository "Zentrum für Entwicklungsforschung: ZEF Data Portal" with ID={c08e08aa-3055-4651-801b-0383610c1987}.