• Energy Research
• Restricted close
• 11. Sustainability close
• CN close
• CA close

Using recycled rubber crumbs as drainage layer in extensive green roofs have high potential to reduce the heating and cooling loads in buildings over traditional materials used as drainage layer, such as pozzolana gravel. However, the environmental impact due to the life cycle should be analyzed to assess its environmental benefit. This paper evaluates the environmental performance of green roofs in which the drainage layer is made of rubber crumbs, a recycled material the use of which is still experimental for this purpose. In this paper Life Cycle Assessment (LCA) is applied to compare the environmental impact of four constructive systems, two extensive green roofs without insulation layer and with different drainage materials, e a recycled material, rubber crumbs, and a conventional one, pozzolana gravel -, in front of two conventional flat roofs, with and without thermal insulation (polyurethane), built in an experimental set-up consisting of four monitored house-like cubicles, located in Mediterranean continental climate (Lleida, Spain). The LCA considered the production, construction, operational, and disposal phases of the roofs, according to UNE-EN 15643-2. The operational phase was carried out using data measured in the experimental set-up, considering heating and cooling energy consumptions in the winter and summer period, respectively.

Abstract This review summarizes and organizes the literature on life cycle assessment (LCA), life cycle energy analysis (LCEA) and life cycle cost analysis (LCCA) studies carried out for environmental evaluation of buildings and building related industry and sector (including construction products, construction systems, buildings, and civil engineering constructions). The review shows that most LCA and LCEA are carried out in what is shown as “exemplary buildings”, that is, buildings that have been designed and constructed as low energy buildings, but there are very few studies on “traditional buildings”, that is, buildings such as those mostly found in our cities. Similarly, most studies are carried out in urban areas, while rural areas are not well represented in the literature. Finally, studies are not equally distributed around the world.

Low temperature sensitive products transport and storage is an issue worldwide due to changes of the lifestyle population increase. Thermal energy storage (TES) is nowadays one of the most feasible solutions in facing the challenge of achieving energy savings. Many researchers have investigated energy efficiency of different cold units by applying TES systems using phase change materials (PCM). This paper provides an overview of the existing Spanish and European potential energy savings and CO2 mitigation by incorporating TES systems to cold storage and transportation systems. Data on energy savings were compiled from different case studies. Results depend on the scenarios studied and the extent of TES systems implementation; in the case of Europe for instance, yearly CO2 emissions may be cut down between 5% and 22% in reference to 2008 CO2 emissions from cold production considering that the proposed implementation of PCM TES in the case studies found in the literature is done.

Abstract In this study, we investigate the driving forces behind the changes in residential energy consumption (REC) in China’s urban and rural areas over the 2001–2012 period. Based on the logarithmic mean Divisia index method, the REC changes are decomposed into seven driving forces, which are climate change, energy price, energy expenditure mix, energy cost share (in total expenditure), expenditure share (in income), per capita income and population effects. According to the results, climate effect due to increasing days with abnormal temperature, energy cost share effect characterized by more expenditure to be paid for energy use, income effect describing constant income growth in the residential sector definitely increase REC in both urban and rural areas. In contrast, energy prices and energy expenditure mix effects negatively contribute to the REC increase, respectively because of the increase in energy prices and the transition from the low-priced energy to high-priced energy. Expenditure share and population effects play opposite roles in urban and rural areas, and the reasons and implications are analysed in depth.

China has achieved impressive rapid economic growth over the past 30 years but accompanied by significant extreme weather events and environmental changes caused by global change and overfast urbanization. Using the absolute hazards index (AHI), we assessed the spatial distribution patterns and related health effects of 4 major extreme natural disasters, including drought, floods (landslides, mudslides), hails, and typhoons from 2000 to 2011 at the provincial level in China. The results showed that (1) central and south China were the most affected by the 4 natural disasters, and north China suffered less; (2) the provinces with higher AHI suffered most from total death, missing people, collapse, and emergently relocated population; (3) the present health emergency response system to disasters in China mainly lacks a multidisciplinary approach. In the concluding section of this article, suggestions on preparedness and rapid response to extreme health events from environmental changes are proposed.

The acceptability, energy consumption, and environmental benefits of electric vehicles are highly dependent on travel patterns. With increasing ride-hailing popularity in mega-cities, urban mobility patterns are greatly changing; therefore, an investigation of the extent to which electric vehicles would satisfy the needs of ride-hailing drivers becomes important to support sustainable urban growth. A first step in this direction is reported here. GPS-trajectories of 144,867 drivers over 104 million km in Beijing were used to quantify the potential acceptability, energy consumption, and costs of ride-hailing electric vehicle fleets. Average daily travel distance and travel time for ride-hailing drivers was determined to be 129.4 km and 5.7 h; these values are substantially larger than those for household drivers (40.0 km and 1.5 h). Assuming slow level-1 (1.8 KW) or moderate level-2 (7.2 KW) charging is available at all home parking locations, battery electric vehicles with 200 km all electric range (BEV200) could be used by up to 47% or 78% of ride-hailing drivers and electrify up to 20% or 55% of total distance driven by the ride-hailing fleet. With level-2 charging available at home, work, and public parking, the acceptance ceiling increases to up to 91% of drivers and 80% of distance. Our study suggests that long range BEVs and widespread level-2 charging infrastructure are needed for large-scale electrification of ride-hailing mobility in Beijing. The marginal benefits of increased all electric range, effects on charging infrastructure distribution, and payback times are also presented and discussed. Given the observed heterogeneity of ride-hailing vehicle travel, our study outlines the importance of individual-level analysis to understand the electrification potential and future benefits of electric vehicles in the era of shared smart transportation.

Better prediction of turbulent airflow around urban trees is necessary because it impacts urban pollutant dispersion, outdoor thermal comfort, energy efficiency, pedestrian-level comfort and urban heat island mitigation. A major challenge is how to obtain an accurate numerical model of the turbulent flow field around trees and an improved parameterization of the turbulent momentum deficit using the drag coefficient (Cd). To address this challenge, we use wind tunnel tests and real trees to measure Cd for four common subtropical tree species: Ficus microcarpa, Mangifera indica, Michelia alba and Bauhinia blakeana. The results show that the Cd of the four trees ranges from 0.523 to 0.932, and that the negative relationship between Cd and wind speed (U) can be expressed by the exponential formula Cd=a*U−b. A three-dimensional model of wind modification by trees is proposed, and its accuracy is verified with wind tunnel measurements. With precise Cd and model, the predictability of the influence of trees on urban wind in subtropical areas is enhanced (root mean square error RMSE ranging from 2.89 m/s to 0.45 m/s). Future development and applications of the numerical model will help provide useful guidelines for urban landscape management and sustainable urban planning in terms of urban ventilation.

Various theories and approaches have been introduced in the debate on how to address sustainable consumption. In this study, we first discuss different theoretical perspectives on sustainable consumption, particularly developed in the fields of economics, social psychology and environmental sociology. We argue that neither an ‘individualist’ nor a system- or structural perspective alone is sufficient for understanding and analysing the transition towards sustainable consumption. Therefore, we propose to apply the Social Practices Approach (SPA) that combines both human agency and social structures to understand sustainable consumption issues. Following the SPA framework, we review and summarize research on sustainable consumption in China in particular on three consumption fields: food, housing energy and mobility. It is found that introducing more efficient production technology is commonly taken as the focal point in these sectors when sustainable consumption was introduced to China. Despite a rising interest in consumers' perceptions of products' sustainability in recent years, research has rarely paid any attention to consumers' behavioural change or to the transition dynamics towards sustainable consumption. In general, ‘individualist’ perspectives have largely dominated Chinese sustainable consumption research. This paper proposes to move attention to a better understanding of Chinese consumption issues by emphasizing the link between the provision of sustainable products and the diverse sustainable consumption practices. Also, images of food, energy, mobility and other consumption products that are undergoing transitions need to be considered in future research as these have consequences for socio-technical changes, material infrastructures and for ‘lifestyle’ innovations.