• Energy Research
• other engineering and technologies close
• CN close
• IT close
• AU close

Abstract In the current study, a new solar-driven triple cycle is proposed to allow power generation during low insolation periods. This triple cycle integrates the solar gas-turbine top cycle, the steam Rankine cycle, and the Kalina bottom cycle. During the top cycle of the proposed system, compressed air was heated to 1000 °C or higher in the solar tower receiver. The heated compressed air was then used to drive the gas turbine to generate electricity. A Rankine cycle with a back-pressure steam turbine was utilized to recover waste heat from the gas turbine, thereby generating electricity through the steam turbine. The bottom cycle is the Kalina cycle, which comprises another back-pressure turbine and utilizes ammonia–water mixture as working fluid. After driving the steam Rankine cycle, the flue gas from the gas turbine sequentially heats the ammonia–water mixture to produce power. A new operational strategy was presented to generate electricity during low insolation period without the backup of fossil fuel. In middle insolation periods, the air is heated by the solar field and then directly drives the steam Rankine cycle, bypassing the gas turbine. In low insolation periods, the heated air directly drive the Kalina cycle, bypassing the Brayton cycle and the steam Rankine cycle. The off-design performance was investigated and the irreversibility was disclosed with the aid of the energy-utilization diagram method. Thus, the proposed system can utilize low insolation to generate electricity. This study provides a possibility to improve the solar–electric efficiency.

With the integration of a high penetration of wind power into distribution system, the ability to cope with the voltage fluctuation issue arising from the intensified uncertainty should be improved. Energy storage system (ESS) with effective control strategies keeps a key role in smoothing the voltage fluctuation caused by the uncertainty of wind turbine generators (WTGs). Considering the constraints of state of charge (SOC), charge-discharge efficiency and continuous operation of ESS, this paper proposes a novel approach to determine the minimum capacity of ESS to satisfy the voltage fluctuation limit based on unbalanced three-phase interval power flow. An unbalanced forward-backward sweep interval power flow considering the constraints of ESS and the voltage fluctuation limit is proposed. The interval model of uncertain WTG output is established on basis of wind speed fluctuation curve. The interval model of the practical ESS output is obtained on basis of the present SOC, nominal capacity and comprehensive efficiency. The output voltages of power flow can directly demonstrate the voltage fluctuation rate due to their interval forms. Therefore, a feedback mechanism is established between the output voltage fluctuation rate and the input ESS practical power, which is used to determine the minimum capacity of ESS to satisfy the fluctuation limit. A modified IEEE 33-bus system with high penetration of WTGs is implemented to test the proposed method. Results demonstrate the validity and effectiveness of the proposed approach.

In order to improve the accuracy of the battery state of charge (SOC) estimation, in this paper we take a lithium-ion battery as an example to study the adaptive Kalman filter based SOC estimation algorithm. Firstly, the second-order battery system model is introduced. Meanwhile, the temperature and charge rate are introduced into the model. Then, the temperature and the charge rate are adopted to estimate the battery SOC, with the help of the parameters of an adaptive Kalman filter based estimation algorithm model. Afterwards, it is verified by the numerical simulation that in the ideal case, the accuracy of SOC estimation can be enhanced by adding two elements, namely, the temperature and charge rate. Finally, the actual road conditions are simulated with ADVISOR, and the simulation results show that the proposed method improves the accuracy of battery SOC estimation under actual road conditions. Thus, its application scope in engineering is greatly expanded.

Studying the influence of the demand response and dynamic characteristics of the battery energy storage on the configuration and optimal operation of battery energy storage system (BESS) in the Wind-Photovoltaic (PV)-Energy Storage (ES) hybrid microgrid. A demand response model that is based on electricity price elasticity is established based on the time-of-use price. Take the capital-operating cost and direct economic benefit of the BESS and the loss of abandoned photovoltaic and wind power as the optimization objective, an optimal configuration method that considers the dynamic characteristics of the BESS and the maximum absorption of photovoltaic and wind power is proposed while using particle swarm optimization to solve. The results show that the configuration results considering the demand side response of the microgrid BESS can obtain better economy and reduce the storage capacity requirement, and the result shows that the efficiency of BESS relates to the load of the system, the distributed generation (DG) characteristics, and the dynamic characteristics of BESS. Meanwhile, the capacity and power of the energy storage configuration increase as the DG permeability increases due to the reverse load characteristic of the wind power.

Abstract In this paper, a general mathematical model for the dynamic simulation of a single-effect LiBr/water absorption chiller is presented. The model is based on mass and energy balances applied to the internal components of the machine, and it accounts for the non-steady behaviour due to thermal and mass storage in the components. The validation of the mathematical model is performed through experimental data collected on a commercial small-capacity water-cooled unit. Due to the peculiar technology adopted in the real chiller, a special effort was made to identify the appropriate values of the main physical parameters. The validation of the model is based on the values of the water temperature at the outlet of the machine, as no measurement inside the machine was possible; anyway, a consistency analysis applied to the internal parameters is also presented. The agreement between experimental and simulated results is very good, both on a daily and on a seasonal basis.

Abstract Numerical simulations with detailed homogeneous (gas phase) and heterogeneous (catalytic) chemistries of premixed hydrogen–oxygen mixture were performed inside a rectangular micro-combustor. The effects of catalytic walls on the homogeneous combustion were investigated via varying catalyst segment layouts and sizes. The interactions between heterogeneous and homogeneous reactions were discussed. It was shown that the heterogeneous reactions become weak when the catalyst disposition is shifted toward the outlet along the streamwise. The homogeneous combustion also becomes obviously weakened downstream behind the catalyst segmentation, except the exit. Moreover, with increasing catalyst segment size, the hydrogen conversion ratio increases and the mean outlet temperature reduces. The competition of the fresh fuel between the heterogeneous and homogeneous reactions result in the inhibition of heterogeneous reactions on homogeneous combustion. In summary, the heterogeneous reactions can obviously improve the combustion efficiency in a micro catalytic combustor. As expected, the effects of catalytic walls were more pronounced for the micro combustor systems.

Low-salinity water injection emerges to be a cost-effective and environmentally friendly enhanced oil recovery technique. Furthermore, additives, such as the surfactant and nanoparticles in combina...

SummaryNumerous wind turbines form large‐scale wind farms, which are complex nonlinear systems with uncertain parameters. The issue of maximum wind energy capture and coordinated control has always been a research hotspot. In this article, under the condition of limited input and uncertain parameters, the preset controller and the adaptive cooperation control are designed to realize the maximum wind energy capture for every wind turbine and the adaptive cooperation control of multiple wind turbines. The research gap lies in that the Hamilton model of wind power generation system is established with uncertain parameters, and the preset controller (method) is designed to capture the maximum wind energy. Under the hypothesis that the uncertain part can be expressed as a linear form about unknown parameter, and using the saturation function processing method in the diagonal matrix, an adaptive feedback controller with limited input is designed to realize the adaptive cooperation control of multiple wind turbines. The simulation results show that under the conditions such as variable wind speed, limited input and uncertain parameters, the wind turbine remain normal operation at the desired angular velocity. It can be concluded that not only the maximum wind energy capture is realized under the condition of variable wind speed, in which the wind turbine can operate on the optimal power curve to improve the utilization of wind energy, but also the adaptive cooperation control of multiple wind turbines can be achieved with limited input and parameter perturbation.

Abstract This paper aims to present a feasibility study of the innovative plant for methanol synthesis from carbon dioxide-sequestered by fossil fuel power plant and hydrogen, which is produced by water electrolyzer employing the over-production on the electrical grid. The thermo-economic analysis is performed in the framework of the MefCO2 H2020 EU project and it is referred to the German economic scenario, properly taking into account the real market costs and cost functions for different components of the plant. Three different plant capacities for methanol production (4000 10,000 and 50,000 ton/year) have been investigated, assuming an average cost for electrical energy to feed electrolysers and analyzing the influence of the most significant parameters (oxygen selling option, methanol selling price and electrolysers’ capital cost) on the profitability of the plant. The analysis has been performed in W-ECoMP, software for the thermo-economic analysis and plant optimization developed by the University of Genoa.