• Energy Research
• 7. Clean energy close
• 11. Sustainability close
• CN close
• DE close
• Energy Procedia close

AbstractSwitchable exhaust air (SEA) window allows the exhaust air from HVAC system to be ventilated through the cavity of the window to ambient. It can be regarded as an exhaust air heat recovery device in buildings. The annual energy requirement of the window has been calculated in Wuhan, China. The energy requirements for conditioning fresh air with and without the total heat recovery ventilators (THRVs) are also investigated. Heat recovery performance of the SEA window and the THRVs is compared. Results show that the SEA window can potentially provide alternative solution for recovering the low-grade energy from air-conditioning exhaust air.

AbstractAlthough the road-map of the oxy-fuel process seems to be very advanced, there are still plenty of open questions. One of the significant ones is the corrosive behaviour of the heat exchanger surfaces. The Institute of Combustion and Power Plant Technology, University of Stuttgart, performs research on the fireside corrosion under oxy-fuel and conventional combustion conditions for the current and supercritical power plants considering the influence of combustion modus, gas atmosphere and fly ash deposits on the waterwall and superheater surfaces. Since the oxy-fuel-combustion atmosphere is composed of recirculated flue gases and pure oxygen, significantly higher concentrations of CO2, SO2 and H2O are present compared to the conventional combustion of coal with air as an oxidizer. In the here presented study the influence of an oxy-fuel combustion of a hard-coal on the surface of selected superheater materials is discussed and compared to the results obtained for lignite. Especially the interactions between the flue gas atmosphere, ash deposits and heat exchanger materials are studied in detail. The investigation encompassed in this paper has been focused on impacts of oxide-scale growth, carbon enrichment of the materials and sulphur-induced corrosion.Increased sulphur-induced corrosion has been observed in samples exposed to the oxy-combustion atmosphere. The noticed higher depth of corrosive attack of the oxy-fuel samples might be explained by a higher partial pressure of SO2 which is characteristic for oxy-fuel process. Moreover in certain cases the sulphur might be released by the deposits. Beside that, the oxy-fuel samples were exposed to much higher partial pressures of carbon dioxide comparing to the air-case leading apparently to rapid and massive internal carbon enrichment in the oxide scale. Moreover dependence between the chromium content and oxidation ability of the austenitic materials surfaces was noticed under oxy-fuel conditions.

AbstractThe future European energy supply system will have a high share of renewable energy sources (RES) to meet the greenhouse gas emission policy of the European Commission. Such a system is characterized by the need for a strongly interconnected energy transport grid as well as a high demand of energy storage capacities to compensate the time fluctuating characteristic of most RE generation technologies. With the RE generators at the location of high harvest potential, the appropriate dimension of storage and transmission system between different regions, a cost efficient system can be achieved. To find the preferred target system, the optimization tool GENESYS (Genetic Optimization of a European Energy System) was developed. The example calculations under the assumption of 100% self-supply, show a need of about 2,500 GW RES in total, a storage capacity of about 240,000 GWh, corresponding to 6% of the annual energy demand, and a HVDC transmission grid of 375,000 GWkm. The combined cost for generation, storage and transmission excluding distribution, was estimated to be 6.87 ct/kWh.

Abstract Uncertainties of cooling load may make cooling system oversized. Most of previous studies implement probabilistic-based uncertainty analysis, intending to achieve optimization and reliability simultaneously. However, how to reduce the load uncertainty has received little attention. This paper investigates the impact of water storage on the design of cooling system considering load uncertainty. Information entropy is used as a convergence index of load uncertainty and used to determine how many random simulations should to be performed. A cooling system configured with water storage (system B) and another system without water storage (system A as a comparation system) are investigated in this paper. In this paper, the configure of system A and system B are optimized respectively. The result shows that the capacity distribution of system A is consistent with the distribution of extreme loads. But, the capacity distribution of system B is more concentrated as the water storage can reshape the load curve. Water storage improves the flexibility of system B. Therefore, system B is more reliable and economical than system A.

The European Geosciences Union (EGU) brings together geoscientists from all over the world covering all disciplines of the Earth, planetary and space sciences. This geoscientific interdisciplinarity is needed to tackle the challenges of the future. One major challenge for humankind is to provide adequate and reliable supplies of affordable energy and other resources in efficient and environmentally sustainable ways. This Energy Procedia issue provides an overview of the contributions of the Division on Energy, Resources & the Environment (ERE) at the EGU General Assembly 2017.

Abstract This research is conducted to determine the limiting values of the geometric concentration when used with solar thermal system (thermoelectric generator) (TEG) to maintain desired hot and cold side temperatures for power generation. Experiments were conducted to determine the optimum solar concentration (aperture area/target area) using a thermoelectric generator sandwiched between the target plate and passive heat sink. A computer model is developed to solve the energy balance equations and find the optimum values for geometric concentration. It was observed that for the single configuration of heat sink and thermoelectric generator in a system, the trend of temperature difference between the hot and cold sides remain the same at different geometric concentrations. The optimum geometric concentration is determined for heat sinks in study. It is observed that with solar radiation intensity of 800 W/m2 and heat sink fin length of 0.15m the optimum geometric concentration is 13.

AbstractState of the art technologies like air-to-water heat pumps have become popular because of their high efficiencies and their supply by electricity rather than by gas or oil. As a direct result of this supply substitution and due to high load- shifting potential, electricity demand of heat pumps have to be taken into account into energy management strategies of the overall building. In this paper a new controller is discussed, which has predictive and adaptive properties and is able to optimize the running-times of non-modulating heat pumps.

Abstract Global primary energy consumption will continue to increase with a high rate to 2050, which will be a big challenge for countries to meet both global and regional energy demand. Pumped storage stations (PSS) integrated to a hybrid power system (HPS) with solar and wind power for China are under construction to tussle with this challenge. Historically, modeling of a PSS integrated HPS has been ignored the interaction effect between the shaft vibration and the governing strategies, which will increase the dynamic risk of PSS disconnected immediately to HPS. Here we unify the models of the hydro-turbine governing system and hydro-turbine generator units with a novel expression of hydraulic forces. We quantize all the parameter’s interaction contributions of PSS integration to HPS and validate this model with the existing models. Finally, we show the feasibility of PSS’s model in integrating of a HPS under steady and fault scenarios.