• Energy Research
• Open Access close
• Restricted close
• Embargo close
• DE close
• EU close

AbstractDecarbonising the energy system requires high shares of variable renewable generation and sector coupling like power to heat. In addition to heat supply, heat pumps can be used in future energy systems to provide flexibility to the electricity system by using the thermal storage potential of the building stock and buffer tanks to shift electricity demand to hours of high renewable electricity production. Bridging the gap between two methodological approaches, we coupled a detailed building technology operation model and the open-source energy system model Balmorel to evaluate the flexibility potential that decentral heat pumps can provide to the electricity system. Austria in the year 2030 serves as an example of a 100% renewable-based electricity system (at an annual national balance). Results show that system benefits from heat pump flexibility are relatively limited in extent and concentrated on short-term flexibility. Flexible heat pumps reduce system cost, CO2 emissions, and photovoltaics and wind curtailment in all scenarios. The amount of electricity shifted in the assessed standard flexibility scenario is 194 GWhel and accounts for about 20% of the available flexible heat pump electricity demand. A comparison of different modelling approaches and a deterministic sensitivity analysis of key input parameters complement the modelling. The most important input parameters impacting heat pump flexibility are the flexible capacity (determined by installed capacity and share of control), shifting time limitations, and cost assumptions for the flexibility provided. Heat pump flexibility contributes more to increasing low residual loads (up to 22% in the assessed scenarios) than decreasing residual load peaks. Wind power integration benefits more from heat pump flexibility than photovoltaics because of the temporal correlation between heat demand and wind generation.

The adenine nucleotide translocation in mitochondria has previously been established as an exchange between exogenous and endogenous adenine nucleotides across the inner membrane. The specificity and the control of the exchange are examined with the following major results: The adenine nucleotide translocation is relatively specific for exogenous ADP and ATP, AMP being nearly inactive. Among other nucleotides tested, only dADP and dATP exchange with a noticeable activity. In the controlled state ADP exchanges 2–4 times faster than ATP. If simultaneously added, ADP and ATP compete for the exchange, with ADP being about tenfold more active than ATP. The specificity of the exit of adenine nucleotides in the exchange is similar to the specificity of the entrance with the difference that ADP and ATP are released with equal activity in proportion to their intramitochondrial content. AMP is released only after a slow conversion to ADP. Therefore the short time exchange is limited by the endogenous content of ADP plus ATP. The exchange is influenced by the metabolic state of the mitochondria. The ATP exchange is more variable than the ADP exchange. Two effects are elucidated: (a) the influence of the metabolic state on the relative content of AMP which inhibits both the ADP and ATP exchange (b) the coupling of the energy transfer system which inhibits only the ATP exchange. An example for case (a) is the inhibition of the ADP and ATP exchange by arsenate and an example for case (b) is the strong increase of the ATP exchange on uncoupling. The following effects are relevant to the mechanism of the control of the exchange by ATP. The stimulation of the ATP exchange by uncoupler has the same concentration dependence as the uncoupling of oxidative phosphorylation (Km [CCP] = 0.08 μM, where CCP = carbonyl‐cyanide‐phenylhydrazone). Oligomycin does not abolish the uncoupler effect on the ATP exchange. “Endogenous uncoupling” on aging of mitochondria also stimulates the ATP exchange. Valinomycin plus K+ only slightly stimulate the ATP exchange. Anaerobiosis stimulates the ATP exchange to a smaller extent than uncoupling.In competition with ADP the effects of energy transfer on ATP exchange are more strongly revealed. On uncoupling the more than tenfold preference for ADP is fully abolished. It is concluded that basically the exchange for ADP and ATP has equal specificity in forward and reverse reaction. In the controlled state a superimposed force makes the specificity asymmetric and inhibits the entrance of ATP. This control of the ATP exchange is concluded to be based on the anionic character of the adenine nucleotides. Thus the ATP4‐ex–ADP3‐in exchange is inhibited unless the charge difference is compensated for by an uncoupler stimulated H+ movement across the membrane. Furthermore an electric potential gradient appears to be effective in the controlled state which is abolished on uncoupling.

This report reflects upon the concept of social innovation and the way it is used in the energy sector. It does so by bringing together theoretical investigations and empirical knowledge. We aim to clarify the concept of social innovation in the energy sector by reviewing the literature and reflecting over a number of social innovation projects in Europe. The analysis of the projects against various contextual factors and their goals reveals the significant potential of social innovation on accelerating the energy transition while tackling societal problems. Energy production, energy efficiency and energy literacy are the main domains to which socially innovative activities contribute the most. High competences of project leadership and management observed though projects are often small in scale and context-dependent. This indicates that successful socially innovative energy initiatives require advanced bottom-up governance structures even if that may imply limitations for scaling up. This setting may complicate top-down support as legal, financial or even cultural policy-making must be tailor-made and reinvent or adjust continuously. Nevertheless, social innovative activities are expected to further proliferate the following years and move towards a sound environmental, cultural, political, economic and social direction, as knowledge creation and diffusion of technological and governance innovations accompanied with policy support are on the rise. JRC.C.7-Knowledge for the Energy Union

The energy considered as waste heat in industrial furnaces owing to inefficiencies represents a substantial opportunity for recovery by means of thermal energy storage (TES) implementation. Although conventional systems based on sensible heat are used extensively, these systems involve technical limitations. Latent heat storage based on phase change materials (PCMs) results in a promising alternative for storing and recovering waste heat. Within this scope, the proposed PCM-TES allows for demonstrating its implementation feasibility in energy-intensive industries at high temperature range. The stored energy is meant to preheat the air temperature entering the furnace by using a PCM whose melting point is 885 °C. In this sense, a heat transfer model simulation is established to determine an appropriate design based on mass and energy conservation equations. The thermal performance is analysed for the melting and solidification processes, the phase transition and its influence on heat transference. Moreover, the temperature profile is illustrated for the PCM and combustion air stream. The obtained results prove the achievability of very high temperature levels (from 700 to 865 °C) in the combustion air preheating in a ceramic furnace; so corroborating an energy and environmental efficiency enhancement, compared to the initial condition presenting an air outlet at 650 °C.

We present the architecture and design of the IANOS scheduling framework. The goal of the new Grid scheduling system is to provide a general job submission framework allowing optimal positioning and scheduling of HPCN applications. The scheduling algorithms used to calculate best-suited resources are based on an objective cost function that exploits information on the parameterization of applications and resources. This standard-based, interoperable scheduling framework comprises four general web services and three modules. The middleware is complemented with one client and one admin console. The implementation is based on proposed Grid and Web services standards (WSRF, WS-Agreement, JSDL, and GLUE). It is agnostic to a specific Grid middleware. The beta version of IANOS has been tested and integrated with UNICORE. The validation of IANOS is in progress by running different types of HPCN applications on a large-scale Grid testbed.

With the aim to fully exploit the by-products obtained after the industrial extraction of starch from sweet potatoes, a cascading approach was developed to extract high-value molecules, such as proteins and pectins, and to valorize the solid fraction, rich in starch and fibrous components. This fraction was used to prepare new biocomposites designed for food packaging applications. The sweet potato residue was added to poly(3-hydroxybutyrate-co-3-hydroxyvalerate) in various amounts up to 40 wt % by melt mixing, without any previous treatment. The composites are semicrystalline materials, characterized by thermal stability up to 260 °C. For the composites containing up to 10 wt % of residue, the tensile strength remains over 30 MPa and the strain stays over 3.2%. A homogeneous dispersion of the sweet potato waste into the bio-polymeric matrix was achieved but, despite the presence of hydrogen bond interactions between the components, a poor interfacial adhesion was detected. Considering the significant percentage of sweet potato waste used, the biocomposites obtained show a low economic and environmental impact, resulting in an interesting bio-alternative to the materials commonly used in the packaging industry. Thus, according to the principles of a circular economy, the preparation of the biocomposites closes the loop of the complete valorization of sweet potato products and by-products.

This deliverable includes the methodology in EnergyPROSPECTS for an in-depth study of energy citizenship. It features the criteria used for selecting the cases for indepth study, the list of cases selected for in-depth study as well as key research foci and empirical research questions.

AbstractEuropean climate is associated with variability and changes in the mid-latitude atmospheric circulation. In this study, we aim to investigate potential future change in circulation over Europe by using the EURO-CORDEX regional climate projections at 0.11° grid mesh. In particular, we analyze future change in 500-hPa geopotential height (Gph), 500-hPa wind speed and mean sea level pressure (MSLP) addressing different warming levels of 1 °C, 2 °C and 3 °C, respectively. Simple scaling with the global mean temperature change is applied to the regional climate projections for monthly mean 500-hPa Gph and 500-hPa wind speed. Results from the ensemble mean of individual models show a robust increase in 500-hPa Gph and MSLP in winter over Mediterranean and Central Europe, indicating an intensification of anticyclonic circulation. This circulation change emerges robustly in most simulations within the coming decade. There are also enhanced westerlies which transport warm and moist air to the Mediterranean and Central Europe in winter and spring. It is also clear that, models showing different responses to circulation depend very much on the global climate model ensemble member in which they are nested. For all seasons, particularly autumn, the ensemble mean is much more correlated with the end of the century than most of the individual models. In general, the emergence of a scaled pattern appears rather quickly.