• Energy Research
• Restricted close
• Embargo close
• 13. Climate action close
• 11. Sustainability close
• 6. Clean water close
• DK close
• FR close

Abstract Anaerobic digestion of animal by-products was investigated in batch and semi-continuously fed, reactor experiments at 55 °C and for some experiments also at 37 °C. Separate or mixed by-products from pigs were tested. The methane potential measured by batch assays for meat- and bone flour, fat, blood, hair, meat, ribs, raw waste were: 225, 497, 487, 561, 582, 575, 359, 619 dm 3 kg −1 respectively, corresponding to 50–100% of the calculated theoretical methane potential. Dilution of the by-products had a positive effect on the specific methane yield with the highest dilutions giving the best results. High concentrations of long-chain fatty acids and ammonia in the by-products were found to inhibit the biogas process at concentrations higher than 5 g lipids dm −3 and 7 g N dm −3 respectively. Pretreatment (pasteurization: 70 °C, sterilization: 133 °C, and alkali hydrolysis (NaOH) had no effect on achieved methane yields. Mesophilic digestion was more stable than thermophilic digestion, and higher methane yield was noticed at high waste concentrations. The lower yield at thermophilic temperature and high waste concentration was due to ammonia inhibition. Co-digestion of 5% pork by-products mixed with pig manure at 37 °C showed 40% higher methane production compared to digestion of manure alone.

Abstract With drastic fossil fuel depletion and environmental deterioration concerns, a move towards a more sustainable bioenergy-based economy is essential. Lately, the application of microwave (MW) irradiation for waste processing has been attracting interest globally. MW-assisted heating possesses several advantages such as the provision of high microwave energy into dielectric materials with deeper penetration for internal heat generation, showing beneficial features in improving the heating rate and reducing the reaction time. Consequently, the most recent literature regarding the applications of MW-assisted heating for biomass pretreatment as well as biofuel and bioenergy production was reviewed and consolidated in this study. An impressive increase in the product yield and improvement of the product properties are reported, with the use of MW-assisted heating in several conversion routes to produce biofuels. Despite being a promising technology for biofuel production, some major fundamental data of MW-assisted heating have not been comprehensively identified. Therefore, the feasibility of this technology for large-scale implementation is still subpar. Understanding the interaction between the feedstock and the microwave electromagnetic field, and the optimization of several operational and mechanical parameters are the two main keystones that would propel the industrialization of MW heating in the near future. This provides key insights leading to increased feasibility and more advanced application of MW heating.

Climaps.eu is an online atlas providing data, visualizations and commentaries about climate adaptation debate. It contains 33 issue-maps and 5 issue-stories. Each of the maps focuses on one issue in the adaptation debate and provides.The atlas is addressed to climate experts (negotiators, NGOs and companies concerned by global warming, journalists…) and to citizens willing to engage with the issues of climate adaptation.It employs advanced digital methods to deploy the complexity of the issues related to climate adaptation and information design to make this complexity legible.

Cassava pulp is a major by-product produced in a cassava starch factory, containing 50–60% of starch (dry basis). Therefore, in this study we are considering its potential as a raw material substrate for the production of methane. To ensure sufficient amounts of nutrients for the anaerobic digestion process, the potential of co-digestion of cassava pulp (CP) with pig manure (PM) was further examined. The effect of the co-substrate mixture ratio was carried out in a semi-continuously fed stirred tank reactor (CSTR) operated under mesophilic condition (37 °C) and at a constant OLR of 3.5 kg VS m−3 d−1 and a HRT of 15 days. The results showed that co-digestion resulted in higher methane production and reduction of volatile solids (VS) but lower buffering capacity. Compared to the digestion of PM alone, the specific methane yield increased 41% higher when co-digested with CP in concentrations up to 60% of the incoming VS. This was probably due to an increase in available easily degradable carbohydrates as the CP ratio in feedstock increased. The highest methane yield and VS removal of 306 mL g−1 VSadded and 61%, respectively, were achieved with good process stability (VFA:Alkalinity ratio < 0.1) when CP accounted for 60% of the feedstock VS. A further increase of CP of the feedstock led to a decrease in methane yield and solid reductions. This appeared to be caused by an extremely high C:N ratio of the feedstock resulting in a deficiency of ammonium nitrogen for microbial growth and buffering capacity.

Renewable energy has been prioritized in Danish energy policy since the early 1980s. This has led to the current situation where Denmark is one of the leading countries in the world in the field of wind energy utilization. The background for this success is a story about how a society can manage the development and diffusion of sustainable technologies so that they are simultaneously socially acceptable and environmentally benign. Consequently, this article describes the relationship between the organization of wind power and the protection of nature. The aim is to analyse which kinds of public planning and policy can promote wind power and nature protection in a situation where a conflict exists between these two issues. The discussion acknowledges that it has been a serious problem to balance these contrasting considerations. However, it also suggests that the problems seem solvable if technology development, the social organization relating to the use of the technology and proper planning are brought together to work in a spirit of local involvement. © 1998 John Wiley & Sons, Ltd. and ERP Environment

The anaerobic digestion of outdoor cultivated Rhizoclonium biomass was investigated in this study. The influence of applying mechanical and biological pre-treatment methods prior to the biomass digestion on the overall methane yields was examined. The results show that the application of a combined biomass blending ( 20% compared to use of a mechanical size reduction method alone. The methane yields from Rhizoclonium biomass were however observed to be considerably lower than those of other algae species from the literature.

Abstract This paper defines two electric grids for the area of Jutland in Denmark, namely the existing grid versus a “nature protection grid”, in which all 400 kV AC overhead lines are replaced by 150 kV lines. According to official Danish policies for laying underground cables, such a replacement makes it economically feasible on a long-term basis to replace all overhead lines with underground cables. The two grids are then tested against different energy demand and supply systems in a load-flow analysis. It is found that the “nature protection grid” is well suited for the implementation of sustainable energy systems exploiting both CHP and renewable energy sources such as wind power if certain strategies for the technical regulation of decentralised CHP units are used.

When biomass is thermally treated, the enrichment of carbon in the remaining “green coal” is correlated with the temperature and duration. Other properties related to the energetic properties of the torrefied biomass are closely related to chemical modifications and correlated to the material mass loss occurring during the thermal degradation. The possibility of using near infrared spectrometry has been investigated to predict the mass loss of Pinus sylvestris wood torrefied at temperatures ranging from 220°C to 300°C with durations varying from 1 minute to 10 hours. A first mass loss prediction model (NIR‐260) associated with the mean torrefaction temperature of 260°C was developed, and appeared suitable only for this temperature due to specific chemical reactions rate. A second model (NIRS‐All), using all available data was constructed and showed an accurate mass loss prediction, for both low (220°C) and high temperatures (300°C). The main differences between NIRS‐260 and NIRS‐All models are mainly attributed to the thermal modification of hemicelluloses and cellulose fractions occurred during the wood torrefaction. The results showed near infrared spectrometry combined with multivariate calibration modeling have potential utility in an industrial context as a standardized continuous method to figure out the mass loss of biomass during torrefaction by a rapid characterization. Novelty Statement The novelty concerns the use of the Near Infrared Spectrometry (NIRS) combined with multivariate calibration modeling as a standardized method for determining the mass loss biomass during torrefaction by a rapid and nondestructive characterization. A model was constructed and showed an accurate mass loss prediction, for both low (220°C) and high temperatures (300°C). Near infrared spectrometry have potential utility in an industrial context as a standardized continuous method.