• Energy Research
• 6. Clean water close
• EG close

Siderophores are low molecular weight secondary metabolites produced by microorganisms under low iron stress as a specific iron chelator. In the present study, a rhizospheric bacterium was isolated from the rhizosphere of sesame plants from Salem district, Tamil Nadu, India and later identified as Bacillus subtilis LSBS2. It exhibited multiple plant-growth-promoting (PGP) traits such as hydrogen cyanide (HCN), ammonia, and indole acetic acid (IAA), and solubilized phosphate. The chrome azurol sulphonate (CAS) agar plate assay was used to screen the siderophore production of LSBS2 and quantitatively the isolate produced 296 mg/L of siderophores in succinic acid medium. Further characterization of the siderophore revealed that the isolate produced catecholate siderophore bacillibactin. A pot culture experiment was used to explore the effect of LSBS2 and its siderophore in promoting iron absorption and plant growth of Sesamum indicum L. Data from the present study revealed that the multifarious Bacillus sp. LSBS2 could be exploited as a potential bioinoculant for growth and yield improvement in S. indicum.

Bioplastics are alternatives of conventional petroleum-based plastics. Bioplastics are polymers processed from renewable sources and are biodegradable. This study aims at conducting an environmental impact assessment of the bioprocessing of agricultural wastes into bioplastics compared to petro-plastics using an LCA approach. Bioplastics were produced from potato peels in laboratory. In a biochemical reaction under heating, starch was extracted from peels and glycerin, vinegar and water were added with a range of different ratios, which resulted in producing different samples of bio-based plastics. Nevertheless, the environmental impact of the bioplastics production process was evaluated and compared to petro-plastics. A life cycle analysis of bioplastics produced in laboratory and petro-plastics was conducted. The results are presented in the form of global warming potential, and other environmental impacts including acidification potential, eutrophication potential, freshwater ecotoxicity potential, human toxicity potential, and ozone layer depletion of producing bioplastics are compared to petro-plastics. The results show that the greenhouse gases (GHG) emissions, through the different experiments to produce bioplastics, range between 0.354 and 0.623 kg CO2 eq. per kg bioplastic compared to 2.37 kg CO2 eq. per kg polypropylene as a petro-plastic. The results also showed that there are no significant potential effects for the bioplastics produced from potato peels on different environmental impacts in comparison with poly-β-hydroxybutyric acid and polypropylene. Thus, the bioplastics produced from agricultural wastes can be manufactured in industrial scale to reduce the dependence on petroleum-based plastics. This in turn will mitigate GHG emissions and reduce the negative environmental impacts on climate change.

The environmental control and management of municipal solid waste (MSW) dumping sites is considered one of the sensitive challenges faced by executive municipalities. This is especially true in Makkah due to the gradual increase in urban population and visitors, with an overall MSW generation of about one million tons per year. Consequently, the geo-environmental evaluation of the Kaakia dumping site shed light on the potential environmental threats, in terms of ambient air quality levels and meteorological parameters, in addition to geophysical inspection. An air quality survey discussed the major trends of ambient air pollutants (SO2, NO2, CO, O3, CH4, and PM10) downwind from the Kaakia dumping site. It indicated the presence of a significant increase in sporadic plumes of Methane concentration. The maximum hourly averages ranged between 22.9–26.6 µg/m3 for SO2, 44.4–64.0 µg/m3 for NO2, 0.86–1.38 mg/m3 for CO, 150.2–158.8 µg/m3 for O3, 5.09–5.9 ppm for CH4, and 955–994 µg/m3 for PM10. The ground penetrating radar (GPR) geophysical survey indicated the subsurface sequence of three geological layers, as confirmed by nearby bores of the investigated site: (1) a surface layer formed of alluvial sediments of sand, which were 2.5–3.1 m thick; (2) a second layer represented by sand and gravel, with a thickness of 4.6–6.5 m; and (3) a third layer equivalent to saturated alluvial sediments mixed with rock fragments that extended to a depth of 13 m. The signals of the GPR were attenuated at the base of the conducted profiles due to the percolation of generated leachate to the subsurface sequence and contaminated groundwater aquifer.

Abstract The main purpose of salinity gradient solar ponds (SGSPs) is to store the maximum possible solar thermal energy. A well-established salinity and temperature gradients are the main points to achieved optimum storage efficiency. In this work, a high-fidelity model is developed using computational fluid dynamics (CFD) to simulate the SGSP behavior under hot climate regions. The model is able to simulate the double convective effect by solving Navier-Stokes and energy equations, simultaneously. Brines with different salinities (i.e. 10%,15, and 25%) are used to investigate their role on the developed salinity/temperature gradients. Simulation results show the successful establishment of the three zones (i.e. upper convective, non-convective, and lower convective) with relatively stable salinity and temperature gradients. However, injecting the lower convective zone (or storage zone) with 10% saline brine results in preserving the highest storage temperature of around 79.2°C after flow time of six hours.

Abstract Simultaneous production of 3-biofuels (hydrogen, ethanol and methane) as by-products of the biodegradation of petrochemical wastewater containing MEG via anaerobic packed bed baffled reactor (AnPBBR), was extensively investigated. A four-chambered reactor supported by polyurethane sheets, was operated at a constant hydraulic retention time (HRT) of 36 h and different organic loading rates (OLRs) of 0.67, 1, 2 and 4 gCOD/L/d. The maximum specific H 2 and CH 4 production rates of 438.07 ± 43.02 and 237.80 ± 21.67 ml/L/d were respectively achieved at OLR of 4 gCOD/L/d. The residual bio-ethanol significantly increased from 57.15 ± 2.31 to 240.19 ± 34.69 mg/L at increasing the OLR from 0.67 to 4 gCOD/L/d, respectively. The maximum MEG biodegradability of 98% was attained at the lowest OLR. Compartment-wise profiles revealed that the maximum H 2 and ethanol production were achieved at HRT of 9 h (1st compartment), while the CH 4 production was peaked at HRTs of 27 and 36 h (last two compartments). Kinetic studies using Stover–Kincannon and completely stirred tank reactor (CSTR) in series models were successfully applied to the AnPBBR overall and compartment-to-compartment performance, respectively. The economic evaluation strongly revealed the potentials of using AnPBBR for simultaneous treatment and bio-energy production from petrochemical wastewater as compared to the classical anaerobic baffled reactor (ABR). Microbial analysis using Illumina MiSeq sequencing showed a diversity of bacterial community in AnPBBR. Proteobacteria (36.62%), Firmicutes (20.85%) and Bacteroidetes (3.44%) were the most dominant phyla.

The variability of ground thermal conductivity, based on underground conditions, is often ignored during the design of ground-source heat pump systems. This study shows a field evidence of such site-scale variations through thermal response tests in eight borehole heat exchangers aligned at a site on a terrace along the foothills of mountains in northern Japan. Conventional analysis of the overall ground thermal conductivity along the total installation length finds that the value at one borehole heat exchanger is 2.5 times that at the other seven boreholes. History matching analysis of underground distributed temperature measurements generates vertical partial ground thermal conductivity data for four depth layers. Based on the moving line heat source theory, the partial values are generally within a narrow range expected for gravel deposits. Darcy velocities of groundwater are estimated to be 74–204 m/y at the borehole with high conductivity, increasing in the shallow layers above a depth of 41 m. In contrast, the velocities at the other seven boreholes are one-to-two orders of magnitude smaller with no trend. These high and low velocity values are considered for the topography and permeability. However, the relatively slow groundwater velocities might not apparently increase the partial conductivity.

Today, the global food security is one of the most pressing issues for humanity, and, according to Food and Agriculture Organisation (FAO), the increasing demand for food is likely to grow by 70% until 2050. In this current condition and future scenario, the agricultural production is a critical factor for global food security and for facing the food security challenge, with specific reference to many African countries, where a large quantities of rice are imported from other continents. According to FAO, to face the Africa’s inability to reach self-sufficiency in rice, it is urgent “to redress to stem the trend of over-reliance on imports and to satisfy the increasing demand for rice in areas where the potential of local production resources is exploited at very low levels” The present study was undertaken to design a new method for land evaluation based on soil quality indicators and remote sensing data, to assess and map soil suitability for rice crop. Results from the investigations, performed in some areas in the northern part of the Nile Delta, were compared with the most common approaches, two parametric (the square root, Storie methods) and two qualitative (ALES and MicrioLEIS) methods. From the qualitative point of view, the results showed that: (i) all the models provided partly similar outputs related to the soil quality assessments, so that the distinction using the crop productivity played an important role, and (ii) outputs from the soil suitability models were consistent with both the satellite Sentinel-2 Normalize Difference Vegetation Indices (NDVI) during the crop growth and the yield production. From the quantitative point of view, the comparison of the results from the diverse approaches well fit each other, and the model, herein proposed, provided the highest performance. As a whole, a significant increasing in R2 values was provided by the model herein proposed, with R2 equal to 0.92, followed by MicroLES, Storie, ALES and Root as R2 with value equal to 0.87, 0.86, 0.84 and 0.84, respectively, with increasing percentage in R2 equal to 5%, 6% and 8%, respectively. Furthermore, the proposed model illustrated that around (i) 44.44% of the total soils of the study area are highly suitable, (ii) 44% are moderately suitable, and (iii) approximately 11.56% are unsuitable for rice due to their adverse physical and chemical soil properties. The approach herein presented can be promptly re-applied in arid region and the quantitative results obtained can be used by decision makers and regional governments.

Solid waste management (SWM) is one of the most critical global challenges nowadays. It has a severe negative effect on the triple bottom line of sustainability. Construction and demolition waste (CDW) contributes about 50% of the total global annual generated SW. In the particular case of the Middle East and North Africa (MENA) region including Egypt, the SW problem has become a major challenge, and the need to find sustainable solutions is overwhelming. However, the region faces several challenges that hinder the development of an effective and efficient SWM system. This has resulted in the predominance of unsustainable SWM practices such as indiscriminate disposals. The aim of this paper is to investigate the escalating problem of SW in the MENA region, while focusing on CDW in Egypt as a part of the total generated SW, by reviewing the most recent research papers, and technical and governmental reports on the SW problem. The main challenges towards effective and efficient SWM systems and recommendations for improvement are gathered in this study based on the explored literature. Findings from this study are expected to be beneficial to local and central governments, academics, construction industry practitioners, and policymakers contending with the problems of SW in the MENA region and especially CDW in Egypt.