• Energy Research
• 2021-2025close
• ES close
• EU close
• NL close

AbstractDecarbonising the energy system requires high shares of variable renewable generation and sector coupling like power to heat. In addition to heat supply, heat pumps can be used in future energy systems to provide flexibility to the electricity system by using the thermal storage potential of the building stock and buffer tanks to shift electricity demand to hours of high renewable electricity production. Bridging the gap between two methodological approaches, we coupled a detailed building technology operation model and the open-source energy system model Balmorel to evaluate the flexibility potential that decentral heat pumps can provide to the electricity system. Austria in the year 2030 serves as an example of a 100% renewable-based electricity system (at an annual national balance). Results show that system benefits from heat pump flexibility are relatively limited in extent and concentrated on short-term flexibility. Flexible heat pumps reduce system cost, CO2 emissions, and photovoltaics and wind curtailment in all scenarios. The amount of electricity shifted in the assessed standard flexibility scenario is 194 GWhel and accounts for about 20% of the available flexible heat pump electricity demand. A comparison of different modelling approaches and a deterministic sensitivity analysis of key input parameters complement the modelling. The most important input parameters impacting heat pump flexibility are the flexible capacity (determined by installed capacity and share of control), shifting time limitations, and cost assumptions for the flexibility provided. Heat pump flexibility contributes more to increasing low residual loads (up to 22% in the assessed scenarios) than decreasing residual load peaks. Wind power integration benefits more from heat pump flexibility than photovoltaics because of the temporal correlation between heat demand and wind generation.

The EU has set out to reduce negative impacts from electricity generation on the environment, human health and towards our dependence on fossil fuels. As the fastest growing renewable source of electricity, photovoltaics plays an important role in the energy transition. The manufacturing of photovoltaic modules requires materials classified as critical, making them prone to supply disruptions. Although these materials are essential to the EU economy, they are not sufficiently recovered at the end of a photovoltaic module’s life. An alternative intermediate solution could be to extend the lifespan of existing modules, to slow down demand for these materials in the future. The aim of this study was to analyse the theoretical options and practical examples of product life extension strategies for photovoltaics. The R-Ladder was used as a guiding framework, which provided examples of life extension strategies. These include Reuse, Repair, Refurbishment, Remanufacture and Repurpose. Aspects for each of these strategies were analysed to find potential benefits and challenges related to four aspects: economics, environment, energy, and materials. The approach of this study includes a literature review to identify the life extension strategies discussed specifically for photovoltaics in the context of the circular economy. This was followed by a multi-case study on practical applications of Reuse, Repair and Repurposing of photovoltaic modules. Findings from literature and the case study were further supplemented with the insights from six experts. These experts had diverse backgrounds in research, manufacturing, and procurement to offer a variety of insights and perspectives on life extension strategies for photovoltaics. Finally, two scenarios were created for possible life extension pathways for used photovoltaic modules to illustrate the potential impacts compared to a commonplace premature replacement scenario. Economics and module performance are key factors in decision-making and acquisition of a photovoltaic ...

AbstractElevated CO2 concentration has been reported to decrease grain nutrient concentrations and thus worsen nutritional deficiency and hidden hunger. One nutritional aspect is mineral content, yet mineral bioavailability can be limited by the presence of phytic acid. Given that future climate scenarios predict elevated global temperature driven by elevated atmospheric CO2 concentrations, we used Temperature by Free‐Air CO2 Enrichment (T‐FACE) field experiments to investigate whether elevated temperature alters the effects of elevated CO2 on grain mineral concentrations, grain mineral yields, and their bioavailability in a range of wheat and rice genotypes. We found that the negative effects of elevated CO2 were compensated for by positive effects of elevated temperature. As a result, the combined elevated CO2 and elevated temperature increased concentrations of some minerals by up to ~15% in both rice and wheat relative to control conditions. Moreover, the combined elevated CO2 and elevated temperature did not significantly change total yields of some minerals despite lower grain yields. The combined CO2 and temperature elevation increased phytic acid concentration in rice by 18.1% but decreased it in wheat by 3.5%. The mineral bioavailability, estimated as the mole ratio of phytic acid to minerals in rice and wheat grains, was limited by the combined CO2 and temperature elevation in only a few cases. Our results indicate that under future climate conditions of elevated temperature and CO2, the nutritional quality of rice and wheat with respect to minerals may remain unchanged.

At the 1972 Stockholm Conference, participating States expressed concern about the extent and consequences of air pollution, laying the groundwork for international legal cooperation to address it. The Action Plan for the Human Environment included the need to promote scientific observation of the atmosphere, and the principles set out in the Stockholm Declaration served, as in other areas of environmental international law, to articulate the response to the threats identified. Since that meeting, the evolution of international legal protection of the atmosphere has been marked by the implementation of three international regimes. The European regime on transboundary air pollution, inaugurated in 1979, was the first model of international cooperation in this field, and influenced subsequent developments in the regimes on ozone layer protection and climate change. Taking into account the foundational impetus that the Stockholm Conference provided for the development of these regimes, this paper analyses the evolution of international legal protection of the atmosphere in the fifty years since the Conference was held

With the aim to fully exploit the by-products obtained after the industrial extraction of starch from sweet potatoes, a cascading approach was developed to extract high-value molecules, such as proteins and pectins, and to valorize the solid fraction, rich in starch and fibrous components. This fraction was used to prepare new biocomposites designed for food packaging applications. The sweet potato residue was added to poly(3-hydroxybutyrate-co-3-hydroxyvalerate) in various amounts up to 40 wt % by melt mixing, without any previous treatment. The composites are semicrystalline materials, characterized by thermal stability up to 260 °C. For the composites containing up to 10 wt % of residue, the tensile strength remains over 30 MPa and the strain stays over 3.2%. A homogeneous dispersion of the sweet potato waste into the bio-polymeric matrix was achieved but, despite the presence of hydrogen bond interactions between the components, a poor interfacial adhesion was detected. Considering the significant percentage of sweet potato waste used, the biocomposites obtained show a low economic and environmental impact, resulting in an interesting bio-alternative to the materials commonly used in the packaging industry. Thus, according to the principles of a circular economy, the preparation of the biocomposites closes the loop of the complete valorization of sweet potato products and by-products.

This deliverable includes the methodology in EnergyPROSPECTS for an in-depth study of energy citizenship. It features the criteria used for selecting the cases for indepth study, the list of cases selected for in-depth study as well as key research foci and empirical research questions.

AbstractEuropean climate is associated with variability and changes in the mid-latitude atmospheric circulation. In this study, we aim to investigate potential future change in circulation over Europe by using the EURO-CORDEX regional climate projections at 0.11° grid mesh. In particular, we analyze future change in 500-hPa geopotential height (Gph), 500-hPa wind speed and mean sea level pressure (MSLP) addressing different warming levels of 1 °C, 2 °C and 3 °C, respectively. Simple scaling with the global mean temperature change is applied to the regional climate projections for monthly mean 500-hPa Gph and 500-hPa wind speed. Results from the ensemble mean of individual models show a robust increase in 500-hPa Gph and MSLP in winter over Mediterranean and Central Europe, indicating an intensification of anticyclonic circulation. This circulation change emerges robustly in most simulations within the coming decade. There are also enhanced westerlies which transport warm and moist air to the Mediterranean and Central Europe in winter and spring. It is also clear that, models showing different responses to circulation depend very much on the global climate model ensemble member in which they are nested. For all seasons, particularly autumn, the ensemble mean is much more correlated with the end of the century than most of the individual models. In general, the emergence of a scaled pattern appears rather quickly.