• Energy Research
• Closed Access close
• Restricted close
• Open Source close
• Embargo close
• 7. Clean energy close
• 13. Climate action close
• AU close
• FR close

Microalgae have tremendous potential for producing liquid renewable fuel. Many methods for converting microalgae to biofuel have been proposed; however, an economical and energetically feasible route for algal fuel production is yet to be found. This paper presents a review on the comparison of the most promising conversion pathways of microalgae to liquid fuel: hydrothermal liquefaction (HTL), wet extraction and non-destructive extraction. The comparison is based on important assessment parameters of product quality and yield, nutrient recovery, GHG emissions, energy and the cost associated with the production of fuel from microalgae, in order to better understand the pros and cons of each method. It was found that the HTL pathway produces more oil than the wet extraction pathway; however, higher concentrations of unwanted components are present in the HTL oil produced. Less nutrients (N and P) can be recovered in HTL compared to wet extraction. HTL consumes more fossil energy and generates higher GHG emissions than wet extraction, while the production cost of fuel from HTL pathway is lower than wet extraction pathway. There is considerable uncertainty in the comparison of the energy consumption and economics of the HTL pathway and the wet extraction pathway due to different scenarios analysed in the assessment studies. To be able to appropriately compare methodologies, the conversion methods should be analysed from growth to upgradation of oil utilising sufficiently similar assumptions and scenarios. Based on the data in available literature, wet oil extraction is the more appropriate system for biofuel production than HTL. However, the potential of alternative extraction/conversion technologies, such as, non-destructive extraction, need to be further assessed.

Microalgae have tremendous potential for producing liquid renewable fuel. Many methods for converting microalgae to biofuel have been proposed; however, an economical and energetically feasible route for algal fuel production is yet to be found. This paper presents a review on the comparison of the most promising conversion pathways of microalgae to liquid fuel: hydrothermal liquefaction (HTL), wet extraction and non-destructive extraction. The comparison is based on important assessment parameters of product quality and yield, nutrient recovery, GHG emissions, energy and the cost associated with the production of fuel from microalgae, in order to better understand the pros and cons of each method. It was found that the HTL pathway produces more oil than the wet extraction pathway; however, higher concentrations of unwanted components are present in the HTL oil produced. Less nutrients (N and P) can be recovered in HTL compared to wet extraction. HTL consumes more fossil energy and generates higher GHG emissions than wet extraction, while the production cost of fuel from HTL pathway is lower than wet extraction pathway. There is considerable uncertainty in the comparison of the energy consumption and economics of the HTL pathway and the wet extraction pathway due to different scenarios analysed in the assessment studies. To be able to appropriately compare methodologies, the conversion methods should be analysed from growth to upgradation of oil utilising sufficiently similar assumptions and scenarios. Based on the data in available literature, wet oil extraction is the more appropriate system for biofuel production than HTL. However, the potential of alternative extraction/conversion technologies, such as, non-destructive extraction, need to be further assessed.

Abstract— The odd nucleoside 4‐thiouridine, which is present in position 8 of 70% of E. coli tRNAs, possesses unusual spectroscopic properties which make it suitable for intramolecular energy transfer studies. Both its luminescence excitation spectrum and the action spectrum (230–380 nm) for the 8–13 link formation have been established in native E. coli tRNA at room temperature. The spectra are identical and present a new unexpected peak around 260 nm. At this wavelength, they are amplified by a factor of nine as compared with the absorption and excitation spectra of the free nucleoside in aqueous solution.The origin of this new peak is discussed and it is concluded that energy transfer does occur from the common nucleosides to the 4‐thiouridine residue. Using the values of the nucleosides to 4‐thiouridine distances inferred from the sets of atomic coordinates obtained on yeast tRNAphe crystals, a satisfactory account of our finding can be obtained assuming singlet‐singlet energy transfer. The efficiency of the mechanism is probably favoured by a good overlap between the emission spectra of the common nucleosides and the absorption spectrum of 4‐thiouridine.

Abstract— The odd nucleoside 4‐thiouridine, which is present in position 8 of 70% of E. coli tRNAs, possesses unusual spectroscopic properties which make it suitable for intramolecular energy transfer studies. Both its luminescence excitation spectrum and the action spectrum (230–380 nm) for the 8–13 link formation have been established in native E. coli tRNA at room temperature. The spectra are identical and present a new unexpected peak around 260 nm. At this wavelength, they are amplified by a factor of nine as compared with the absorption and excitation spectra of the free nucleoside in aqueous solution.The origin of this new peak is discussed and it is concluded that energy transfer does occur from the common nucleosides to the 4‐thiouridine residue. Using the values of the nucleosides to 4‐thiouridine distances inferred from the sets of atomic coordinates obtained on yeast tRNAphe crystals, a satisfactory account of our finding can be obtained assuming singlet‐singlet energy transfer. The efficiency of the mechanism is probably favoured by a good overlap between the emission spectra of the common nucleosides and the absorption spectrum of 4‐thiouridine.

Abstract An international workshop was held in Richland, Washington, United States of America, in October, 1980 to discuss progress on development of the acid digestion process for treating combustible nuclear waste. The workshop was attended by participants from nine member countries of the Nuclear Energy Agency of the Organization for Economic Cooperation and Development (OECD/NEA). The status of the acid digestion development programs of various countries is discussed in this paper. The acid digestion process has been developed and demonstrated on an engineering scale in several countries and appears to be especially applicable to treatment of combustible wastes containing high levels of transuranic contamination, where there is potential for recovering the transuranic radionuclides. Because the process takes place at a relatively low temperature, the plutonium contained in the residue is in a form that can be readily recovered using standard leaching techniques. The process is adaptable to a wide variety of combustible wastes, such as cellulosics, plastics, rubber materials, and ion exchange resin. While the process has been developed and demonstrated on an engineering scale primarily for transuranic contaminated wastes, the process is also adaptable to beta-gamma wastes such as reactor ion exchange resins.

Abstract An international workshop was held in Richland, Washington, United States of America, in October, 1980 to discuss progress on development of the acid digestion process for treating combustible nuclear waste. The workshop was attended by participants from nine member countries of the Nuclear Energy Agency of the Organization for Economic Cooperation and Development (OECD/NEA). The status of the acid digestion development programs of various countries is discussed in this paper. The acid digestion process has been developed and demonstrated on an engineering scale in several countries and appears to be especially applicable to treatment of combustible wastes containing high levels of transuranic contamination, where there is potential for recovering the transuranic radionuclides. Because the process takes place at a relatively low temperature, the plutonium contained in the residue is in a form that can be readily recovered using standard leaching techniques. The process is adaptable to a wide variety of combustible wastes, such as cellulosics, plastics, rubber materials, and ion exchange resin. While the process has been developed and demonstrated on an engineering scale primarily for transuranic contaminated wastes, the process is also adaptable to beta-gamma wastes such as reactor ion exchange resins.

The Nigerian government is committed to sustaining rice production to meet national demand. Nevertheless, political tension and climate-induced stressors remain crucial constraints in achieving policy targets. This study examines whether climate change and political instability significantly threaten rice production in Nigeria. First, we employed nonparametric methods to estimate the country's rainfall and temperature trends between 1980Q1 and 2015Q4. Second, we employed the autoregressive distributed lag (ARDL) technique to examine the effects of climate change and political instability on rice production. The results show that while temperature has an increasing pattern, rainfall exhibits no significant trend. The findings from the ARDL estimate reveal that rice production responds negatively to temperature changes but is less sensitive to changes in rainfall. In addition, political instability adversely affects rice production in Nigeria. We argue that Nigeria's slow growth in rice production can be traced back to the impact of climate change and political tension in rice farming areas. As a result, reducing the overall degree of conflict to ensure political stability is critical to boosting the country's self-sufficiency in rice production. We also recommend that farmers be supported and trained to adopt improved rice varieties less prone to extreme climate events while supporting them with irrigation facilities to facilitate rice production.

The Nigerian government is committed to sustaining rice production to meet national demand. Nevertheless, political tension and climate-induced stressors remain crucial constraints in achieving policy targets. This study examines whether climate change and political instability significantly threaten rice production in Nigeria. First, we employed nonparametric methods to estimate the country's rainfall and temperature trends between 1980Q1 and 2015Q4. Second, we employed the autoregressive distributed lag (ARDL) technique to examine the effects of climate change and political instability on rice production. The results show that while temperature has an increasing pattern, rainfall exhibits no significant trend. The findings from the ARDL estimate reveal that rice production responds negatively to temperature changes but is less sensitive to changes in rainfall. In addition, political instability adversely affects rice production in Nigeria. We argue that Nigeria's slow growth in rice production can be traced back to the impact of climate change and political tension in rice farming areas. As a result, reducing the overall degree of conflict to ensure political stability is critical to boosting the country's self-sufficiency in rice production. We also recommend that farmers be supported and trained to adopt improved rice varieties less prone to extreme climate events while supporting them with irrigation facilities to facilitate rice production.

Abstract This paper describes the point of view of a gas utility regarding systems for cooling and heating by solid sorption. Indeed, the context is favorable to the emergence of such systems first, of course, due to the regulatory constraints on certain refrigerant fluids, but also for their specific technical characteristics (the storage capacity, for example). The gas utilities have in fact shown an increasingly keen interest in all types of sorption systems, as a way of diversifying natural gas utilization, particularly in the summer. After a review of that context, this paper highlights the advantages of solid sorption and describes the criteria for choosing an installation in air conditioning and cooling production applications. Finally, it discusses the difficulties likely to be encountered in developing sorption systems, as well as the prospects for the future.