• Energy Research
• Closed Access close
• Open Source close
• 13. Climate action close
• 2. Zero hunger close
• GB close
• DE close
• FR close

The Severn Estuary has the world's second largest tide range and a barrage across the estuary, located just seawards of Cardiff in Wales and Weston in the South West England, has been proposed for over half a century, with the objective of extracting large amounts of tidal energy. A Severn Barrage, as previously proposed by the Severn Tidal Power Group (STPG), would be the largest renewable energy project for tidal power generation in the world, if built as proposed, and would generate approximately 5% of the UK's electricity needs. However, concerns have been raised over the environmental impacts of such a barrage, including potential increase in flood risk, loss of intertidal habitats etc. In addressing the challenges of maximizing the energy output and minimizing the environmental impacts of such a barrage, this research study has focused on using a Continental Shelf model, based on the modified Environmental Fluid Dynamics Code (EFDC) with a barrage operation module (EFDC_B), to investigate both the far and near field hydrodynamic impacts of a barrage for different operating scenarios. Three scenarios have been considered to simulate the Severn Barrage, operating via two-way generation and using different combinations of turbines and sluices. The first scenario consisted of 216 turbines and 166 sluices installed along the barrage; the second consisted of 382 turbines with no sluices; and the third consisted of 764 turbines and no sluices. The specification of the sluice gates and turbines are the same for all scenarios. The model results indicate that the third scenario has the best mitigating effects for the far-field and near-field flood risks caused by a barrage and produces the most similar results of minimum water depth and maximum velocity distributions to those obtained from simulating the natural conditions of the estuary, i.e. the current conditions. The results also show that the flow patterns around the barrage are closest to those for the existing natural conditions with minimal slight changes in the estuary. Thus, the results clearly indicate that the environmental impacts of a Severn Barrage can be minimized if the barrage is operated for two-way generation and under the third scenario. Although it appears that the energy output for the third scenario is less than that obtained for the other two scenarios, if very low head (VLH) turbines are used, then the third scenario could generate more energy as more turbines could be cited along the barrage structure. Therefore, the study shows that a Severn Barrage, operating in two-way generation and with 764 turbines (ideally VLH turbines), would be the best option to meet the needs of maximizing the energy output, but having a minimal impact on environmental changes in the estuary and far-field.

Abstract The rapid increase in energy demand and the limited resources of fossil fuel as well as the environmentally damaging effects, drive the world to find new options for sustainable electricity generation, which is represented by renewable energies. Concentrating solar power (CSP) is one of the most promising technologies in the field of electricity generation to tackle this issue with a competitive cost in the future. This paper presents an investigation of the potential of implementation of CSP plants in Libya. The socio-economic context, current energy situation of the country and different types of CSP plants are discussed. Moreover, an assessment of site parameters required for CSP plants including solar resources, land use and topography, water resources and grid connections are investigated in detail. In addition, thermo-economic simulation of a 50 MW parabolic trough power plant is performed. The simulation is conducted based on meteorological data measured by the weather station installed at the Centre for Solar Energy Research and Studies (CSERS) in Tajoura city. The performance results are compared with the reference plant Andasol-1 in Spain. Even though the proposed plant is located on the North coast where solar resources are at their minimum compared with other regions of the country, the outcome of the study proves that Libya is not only suitable but it can be economically competitive in the implementation of CSP technology.

Abstract Social acceptance of innovative technologies is a key element of an effective transition towards more sustainable energy economies. However, innovative technologies like genetic modification also tend to spark controversy and backlash. So far, efforts to inform the public about any risks and benefits of novel technologies not only have struggled to foster acceptance but also neglect the interdependent foundations of consumer decision-making. Through a controlled experiment with German consumers (N = 322), we examine whether consumer support and rejection of genetic modification in bioenergy crops is influenced by the statements and actions of actors throughout the supply chain. In specific, we show that the decision of energy companies to sell and support GM bioenergy positively impacts consumer decisions to support. To ensure that decision outcomes were specifically impacted by the expressions of corporate actors, we controlled for the content and valence of information by random assignment to one of three treatments in which participants received positive, negative, or balanced (risks and benefits) information. We find that negative messaging diminished support and increased rejection relative to the other treatments. Lastly, the statements and actions of corporate actors also exerted an indirect influence on consumer decisions through their interactions with social trust and labels, e.g. greater support by farmers had a positive influence only for those who are more generally trustworthy. Given these results, we anticipate more attention to the importance of actors such as farmers and energy companies for the social acceptance of novel technologies in the energy sphere.

Abstract Specification by central government of the heating levels which are to be maintained in British school buildings has recently been altered. This paper is concerned with examining the nature of changes that have been made by comparing present requirements with their counterparts during the preceding one hundred years. Attention is focused on the apparently contradictory implications of these changes for those charged with responsibility for maintaining heating levels in school buildings while, at the same time, conserving fuel. It is suggested that the new statutory requirements present those who are responsible with a duty which may, in practical terms, prove difficult or costly to discharge. Although discussion is specifically restricted to British school buildings, issues are raised which are pertinent to attempts to integrate regulation of heating with control of fuel consumption in other types of non-domestic buildings both in Britain and abroad.

Abstract This paper describes the point of view of a gas utility regarding systems for cooling and heating by solid sorption. Indeed, the context is favorable to the emergence of such systems first, of course, due to the regulatory constraints on certain refrigerant fluids, but also for their specific technical characteristics (the storage capacity, for example). The gas utilities have in fact shown an increasingly keen interest in all types of sorption systems, as a way of diversifying natural gas utilization, particularly in the summer. After a review of that context, this paper highlights the advantages of solid sorption and describes the criteria for choosing an installation in air conditioning and cooling production applications. Finally, it discusses the difficulties likely to be encountered in developing sorption systems, as well as the prospects for the future.

The leafy seadragon certainly is among evolution's most "beautiful and wonderful" species aptly named for its extraordinary camouflage mimicking its coastal seaweed habitat. However, limited information is known about the genetic basis of its phenotypes and conspicuous camouflage. Here, we revealed genomic signatures of rapid evolution and positive selection in core genes related to its camouflage, which allowed us to predict population dynamics for this species. Comparative genomic analysis revealed that seadragons have the smallest olfactory repertoires among all ray-finned fishes, suggesting adaptations to the highly specialized habitat. Other positively selected and rapidly evolving genes that serve in bone development and coloration are highly expressed in the leaf-like appendages, supporting a recent adaptive shift in camouflage appendage formation. Knock-out of bmp6 results in dysplastic intermuscular bones with a significantly reduced number in zebrafish, implying its important function in bone formation. Global climate change-induced loss of seagrass beds now severely threatens the continued existence of this enigmatic species. The leafy seadragon has a historically small population size likely due to its specific habitat requirements that further exacerbate its vulnerability to climate change. Therefore, taking climate change-induced range shifts into account while developing future protection strategies.

Cogeneration of heat and electricity is an important pillar of energy and climate policy. To plan the production and distribution system of combined heat and power (CHP) systems for residential heating, suitable methods for decision support are needed. For a comprehensive feasibility analysis, the integration of the location and capacity planning of the power plants, the choice of customers, and the network planning of the heating network into one optimization model are necessary. Thus, we develop an optimization model for electricity generation and heat supply. This mixed integer linear program (MILP) is based on graph theory for network flow problems. We apply the network location model for the optimization of district heating systems in the City of Osorno in Chile, which exhibits the “checkerboard layout” typically found in many South American cities. The network location model can support the strategic planning of investments in renewable energy projects because it permits the analysis of changing energy prices, calculation of break-even prices for heat and electricity, and estimation of greenhouse gas emission savings.

Abstract The housing growth programme could offer an opportunity for accelerating the deployment of decentralised renewable energy systems (DRES) in the UK. The Government hopes to leverage private sector investment into DRES as part of new housing projects. The aim of this paper is to assess whether current regulatory and funding frameworks are sufficient to achieve this. The question is explored by drawing on the experience of developers, local authorities, energy utilities and service companies operating in the largest housing growth region in the UK–Thames Gateway. Their experience suggests that the current low intervention approach will be insufficient to generate the shift required in both industries. In order to be more successful economic and regulatory instruments should focus on producers (house-builders and energy providers) rather than consumers (households). Tighter regulation is needed to ensure that producers have a responsibility to install DRES as part of new developments, to enable connection to the grid, to ensure a sustained financial return from investment and revenue is spent on the expansion of new renewable energy infrastructure. This regulatory framework must be under-pinned by substantial funds focused on producers. Greater intervention is needed if DRES is to be included in new housing development.

Abstract Post-combustion solvent-based carbon capture is a promising technology that potentially can offset the greenhouse gas emissions from fossil-driven power generation systems. The challenge is that CO2 absorption (similar to other CCS technologies) imposes energetic penalties, and constrains the operational flexibility. In this paper, we build upon our recent contributions in the field (Sharifzadeh et al., 2016; Sharifzadeh and Shah, 2016), and study the dynamic response of such process to the electricity load changes in the power plant. The key research question is to investigate if the steady-state integrated process design and control framework applied in the previous studies, can also ensure controllability under a wide range of disturbances. The present study considers the mutual interactions between the power plant and capture process. Other features of interest include the implications of key design and operational decisions such as reboiler temperature, solvent circulation flow rate, solvent concentration and the rate of power load change or CO2 setpoint tracking for flexible process operation. The results suggest that the capture process exhibits a high degree of flexibility and the integrated design and control framework could be the key enabler for the commercialization of post-combustion solvent-based carbon capture.