• Energy Research
• Closed Access close
• Open Source close
• DE close
• FR close

Abstract Additional experimental data concerning the kinetics of Ni-Mo codeposition were obtained by investigating cathodic polarization using a rotating disc electrode. The Ni-Mo alloys were deposited from an ammonium citrate bath. The alloy deposition was controlled by activation in the case of low values of the cathode potential and by diffusion in the case of higher values. The hydrogen discharge was found to be diffusion controlled. The inductive influence of nickel results in depolarization of the reduction of molybdenum which cannot be deposited separately. An increase in the disc rotation speed caused an increase in the maximum cathode efficiency and in the molybdenum content of the alloy.

Abstract The objective of this work is to evaluate the surge characteristics of an axial compressor operating under surge conditions, by using a hybrid BDF/harmonic balance method. During a surge event, a large amount of backflow occurs in the compressor. Consequently, the airflow oscillates along the axial direction at a low frequency, which can considerably damage the compressor. In this paper, a numerical investigation is performed to examine the effects of the system volume and average mass flow on the surge characteristics of a transonic high speed single stage axial compressor (stage 35) designed and evaluated at the NASA Glenn Center. The results show that the oscillation frequency of the airflow in the compressor generally ranges from 14.32–26.04 Hz during surge conditions, and both the system volume and average mass flow considerably influence the surge characteristics. For a constant average mass flow, as the system volume decreases, the oscillation frequency of the airflow in the compressor increases slightly, while the oscillation amplitude of the exit static pressure decreases significantly, and the maximum static pressure at the outlet remains nearly constant. In the case of a constant system volume, with the decrease in the average mass flow, the oscillation frequency of the airflow in the compressor gradually decreases, and the oscillation amplitude of the exit pressure increases significantly. With a further decrease in the average mass flow, the oscillation frequency stabilizes at a certain point and does not change thenceforth. Furthermore, the surge frequency obtained using the numerical method shows a same tendency with the Helmholtz frequency, but there is a considerable difference between them.

Abstract In this work, we intend to solve the equations governing two laminar isothermal or non-isothermal coaxial plane jets with variable density in an ambient fluid at rest in order to study the initial conditions influence (i.e. the nozzles ejection conditions) on the jet characteristic parameters. A finite difference method is developed to solve the dimensionless Navier–Stokes and energy equations resulting from some assumptions. The discussion about the results relates primarily to the concentration core length according to the nozzles thicknesses ratios. The influences of the gas velocity and temperature resulting from the external nozzle are also examined. This made it possible to deduce correlations of practical use between these parameters in order to apply them in engineering processes.

Abstract The price effect of the rising share of renewable electricity, which is called ‘merit-order-effect’, leads to noticeable changes in the German power industry and debates about the electricity market design. This paper estimates the merit-order-effect induced by variable renewable energy in the German-Austrian electricity sector with a multivariate regression model. The research focus lies on the impact of the estimated effects on the marketability of variable renewable electricity generation. The results show a systematic decline of the average market revenues for wind and photovoltaic plants in the period from January 2011 to December 2013. Current market data shows a continuation of this trend into 2016. According to the German long term goals for the use of renewables, wind and solar power will play a crucial role in the future electricity generation mix. If investments in these technologies will be profitable without any regulatory remuneration mechanisms in addition to the market revenues, depends on the further cost degression and the development of the merit-order-effect.

Abstract Social acceptance of innovative technologies is a key element of an effective transition towards more sustainable energy economies. However, innovative technologies like genetic modification also tend to spark controversy and backlash. So far, efforts to inform the public about any risks and benefits of novel technologies not only have struggled to foster acceptance but also neglect the interdependent foundations of consumer decision-making. Through a controlled experiment with German consumers (N = 322), we examine whether consumer support and rejection of genetic modification in bioenergy crops is influenced by the statements and actions of actors throughout the supply chain. In specific, we show that the decision of energy companies to sell and support GM bioenergy positively impacts consumer decisions to support. To ensure that decision outcomes were specifically impacted by the expressions of corporate actors, we controlled for the content and valence of information by random assignment to one of three treatments in which participants received positive, negative, or balanced (risks and benefits) information. We find that negative messaging diminished support and increased rejection relative to the other treatments. Lastly, the statements and actions of corporate actors also exerted an indirect influence on consumer decisions through their interactions with social trust and labels, e.g. greater support by farmers had a positive influence only for those who are more generally trustworthy. Given these results, we anticipate more attention to the importance of actors such as farmers and energy companies for the social acceptance of novel technologies in the energy sphere.

AbstractSome cases of occurrence of matrix effects (mostly ion suppression) in protein‐precipitated plasma samples, and their influence on the validity of plasma concentrations and pharmacokinetic parameters, are discussed. The comparison of matrix effects using either electrospray (TurboIonspray, TISP) or atmospheric pressure chemical ionization (APCI) indicated that APCI is less prone to matrix effects. Nevertheless, TISP is usually the first choice of ionization technique since unknown thermally labile metabolites might be present in the plasma samples causing erroneous results. A high impact of ion suppression on the plasma concentrations after intravenous (i.v.) administration was found, depending on the drug formulation (vehicle). Since ion suppression caused significantly lower plasma concentrations (by a factor of up to 5.5) after i.v. dosing, the area under the curve (AUC) was underestimated and the plasma clearance was consequently erroneously high, with an impact on drug candidate selection. By simple stepwise dilution (e.g. 10‐fold and 50‐fold) of the supernatant of protein‐precipitated plasma samples, including all calibration and quality control samples, the matrix effects were recognized and eliminated. Copyright © 2003 John Wiley & Sons, Ltd.

Endocrinological research on wild animals inhabiting remote areas has been hampered by the need to store plasma samples at subzero temperatures. In an attempt to remedy this logistical issue, we here investigate the use of ethanol as an alternative to freezing for the preservation of steroid and indoleamine hormones in avian plasma. Known quantities of the steroids 5alpha-dihydrotestosterone (DHT), testosterone, 17beta-estradiol, corticosterone, and the indoleamine melatonin were added to a stripped pool of chicken plasma. Samples were either immediately frozen at -40 degrees C, or treated with pure ethanol. Ethanol-treated samples were either immediately frozen, or-to simulate storage conditions at various field locations-left sitting at room temperature for one to two months, or incubated at 36 degrees C for one month before all treatment groups were frozen at -40 degrees C. All samples were then analyzed by radioimmunoassay. For DHT and estradiol there were no differences among treatment groups suggesting that ethanol-treatment is as effective as immediate freezing in preserving plasma steroid concentrations. For testosterone, corticosterone and melatonin ethanol-treated samples differed significantly from immediately frozen samples suggesting that caution is needed when comparing absolute concentrations of hormones between samples preserved in different ways. However, differences among ethanol-treated samples in general were small, demonstrating the feasibility of this preservation method in the field at remote locations.

Abstract— The odd nucleoside 4‐thiouridine, which is present in position 8 of 70% of E. coli tRNAs, possesses unusual spectroscopic properties which make it suitable for intramolecular energy transfer studies. Both its luminescence excitation spectrum and the action spectrum (230–380 nm) for the 8–13 link formation have been established in native E. coli tRNA at room temperature. The spectra are identical and present a new unexpected peak around 260 nm. At this wavelength, they are amplified by a factor of nine as compared with the absorption and excitation spectra of the free nucleoside in aqueous solution.The origin of this new peak is discussed and it is concluded that energy transfer does occur from the common nucleosides to the 4‐thiouridine residue. Using the values of the nucleosides to 4‐thiouridine distances inferred from the sets of atomic coordinates obtained on yeast tRNAphe crystals, a satisfactory account of our finding can be obtained assuming singlet‐singlet energy transfer. The efficiency of the mechanism is probably favoured by a good overlap between the emission spectra of the common nucleosides and the absorption spectrum of 4‐thiouridine.

Abstract An international workshop was held in Richland, Washington, United States of America, in October, 1980 to discuss progress on development of the acid digestion process for treating combustible nuclear waste. The workshop was attended by participants from nine member countries of the Nuclear Energy Agency of the Organization for Economic Cooperation and Development (OECD/NEA). The status of the acid digestion development programs of various countries is discussed in this paper. The acid digestion process has been developed and demonstrated on an engineering scale in several countries and appears to be especially applicable to treatment of combustible wastes containing high levels of transuranic contamination, where there is potential for recovering the transuranic radionuclides. Because the process takes place at a relatively low temperature, the plutonium contained in the residue is in a form that can be readily recovered using standard leaching techniques. The process is adaptable to a wide variety of combustible wastes, such as cellulosics, plastics, rubber materials, and ion exchange resin. While the process has been developed and demonstrated on an engineering scale primarily for transuranic contaminated wastes, the process is also adaptable to beta-gamma wastes such as reactor ion exchange resins.