• Energy Research
• 2021-2025close
• Closed Access close
• Restricted close
• Open Source close
• IT close
• FR close

Abstract Economically harvesting energy from a microbial fuel cell (MFC), increasing its electrical power production, and developing its role as a practical energy supply, needs a low-cost and high-performance design of the MFC compartments. According to this strategy, a novel monolithic membrane electrode assembly (MEA) was fabricated and evaluated as an air–cathode in a single-chamber MFC (SCMFC). The MEA was made of bacterial cellulose (BC), conductive multi-walled carbon nanotubes (CNT), and nano-zycosil (NZ). BC, as a nano-celluloses with oxygen barrier property, can maintain anaerobic conditions for the anode compartment. Binder-less CNT coating on BC avoids costly binders such as poly-tetra fluoro ethylene (PTFE) and Nafion and decreases the MEA charge transfer resistance. NZ, as a very cheap modifier, not only prevents the anolyte leakage but also provides more MEA’s active sites for the oxygen reduction reaction (ORR). The electrochemical performance of the MEA was compared to a PTFE- based gas diffusion electrode (GDE) in the SCMFC. The MEA cell provided a pulse power density of 1790 mW/m2, roughly twice as high as the pulse power density of GDE (920 mW/m2). SCMFC’s internal resistance decreased from 1.84 KΩ (with GDE) to 0.8 KΩ (with MEA). Also, the cell’s columbic efficiency increased from 4.2% (with GDE) to11.7% (with MEA). Additionally, the capacitance of the MEA (65 mF) was much higher than the value for GDE (0.73 mF). Thus, the MEA compared to the GDE showed higher performance in the SCMFC for electricity generation and wastewater treatment at a lower cost.

The fast decay in PEM fuel cells of a highly active, high performance, but unstable Fe/N/C catalyst like our NC_Ar + NH3 follows a chemical, not an electrochemical, demetallation mechanism for its ORR active FeN4 sites in the catalyst micropores.

AbstractCellulose and lignin nanoparticles are high‐value‐added products obtained from lignocellulosic biomasses through several steps of cellulose purification and lignin extraction. These steps drastically reduce the potential feedstock revenue when carried out as stand‐alone methodologies. To increase biomass yields, we describe here a strategy to design a biorefinery focused on producing cellulose and lignin nanoparticles as main products, but also aim to recover and benefit from other biomass components using only water‐based processes. Sequential pressurized liquid extractions and diluted acid and alkaline treatments were carried out to fractionate elephant grass biomass, yielding (for every 100 g of biomass): 30 g of cellulose pulp (converted to 9 g of cellulose nanocrystals and 9 g of cellulose nanofibers); 10 g of lignin (used to produce 8.5 g of stable colloidal lignin nanoparticles by probe‐sonication in water); 7.5 g of extractives (e.g. sterols and phenolics) and 23 g of xylose (converted to 4.1 g of furfural). Alternatively, to allow for the flexible use of the cellulose fraction in the proposed biorefinery, 22 g of glucose could be produced by enzymatic hydrolysis. The results demonstrate that water‐based processes are suitable for a holistic use of biomass, providing a comprehensive set of high‐value‐added co‐products that are renewable and cost‐effective chemical, cosmetic, food, polymer and pharmaceutical solutions.

Abstract This work presents a numerical study on the performance of a stand-alone adsorption cooling system based on the silica gel/water couple driven by hybrid photovoltaic/thermal (PVT) collectors. This system is intended for the conservation of perishable agricultural products which require air-conditioned premises to preserve them. The weather conditions are those of North Africa (Algiers). Considering the above, this paper aims at analyzing the PVT-Adsorption system with energy storage to guarantee a stabilized production and increase the solar coverage. trnsys was used to simulate the system taking into account hourly series of irradiation and ambient temperature covering one year. The performance study reveals that the DualSun PVT hybrid collectors used provide optimal annual production and that the adsorption cooling system offers more reliable production during summer. The temperature difference between the inside and outside of the cooled enclosure balances supply and demand. The loss analysis of the storage device indicates that losses depend, on the one hand, on the interior/exterior temperature difference of the storage tank with more significant values during the summer season. On the other hand, the losses also depend on the volume of the storage tank which was optimized in order to limit the heat exchange with the surroundings.

The solar energy produced by Scheffler parabola (10 m2) is not fully exploited by the solar distillation system of aromatic and medicinal plants. In this work, the optical losses in the primary and secondary reflectors, and the thermal losses at each part of this system (solar still, steam line, condenser) were determined. A thermal energetic and exergetic analysis were also performed for a solar distillation system of rosemary leaves. For average intensity radiation of 849.1W/m2 and 6 Kg of rosemary leaves during 4 h of distillation, exergy and optical efficiencies of the system achieved up to 26.62% and 50.97%, respectively. The thermal efficiency of the solar still, steam line, and condenser is about 94.80%, 94.30%, and 87.76%, respectively. The essential oil yield per unit of consumed energy and the total efficiency of the solar distillation system, taking into account the heat losses in the solar still, steam line, and condenser, as well as the optical losses in the two reflectors, is 6.18 mL/ kWh and 40.00%, respectively. The efficiency can be as high as 42.42 % if the steam line is insulated. Moreover, the comparison between the solar steam distillation and conventional steam distillation shows that solar distillation is much more efficient since it gives better results and especially it avoids the emission of 12.10 kg of CO2 during extraction.

SummaryMultithreaded applications facilitate the exploitation of the computing power of multicore architectures. On the other hand, these applications can become extremely energy‐intensive, in contrast with the need for limiting the energy usage of computing systems. In this article, we explore the design of techniques enabling multithreaded applications to maximize their performance under a power cap. We consider two control parameters: the number of cores used by the application, and the core power state. We target the design of an autotuning power‐capping technique with minimal intrusiveness and high portability, which is agnostic about the workload profile of the application. We investigate two different approaches for building the strategy for selecting the best configuration of the parameters under control, namely a heuristic approach and a model‐based approach. Through an extensive experimental study, we evaluate the effectiveness of the proposed technique considering two different selection strategies, and we compare them with existing solutions.

AbstractEmbedding sustainability in day‐to‐day operations necessitates employees' proactiveness beyond compliance with standardised management practices. Exchanging information on safety and environmental issues is acknowledged as a component of workers' proactive behaviours for sustainability embeddedness, which is hardly promoted by codified procedures. Accordingly, identifying leverages to stimulate information exchange is a primary objective for academics and practitioners. The study investigates drivers of information exchange on safety and environmental near misses by examining five situation‐related antecedents: rewards/reinforcements, organisational boundaries, social proactiveness, stakeholder salience and connectedness. The study relies on a mixed method approach, by combining social network analysis and a questionnaire survey conducted among four large Italian companies. The findings partially support the hypothesis of the study, highlighting rewards/reinforcements and connectedness as relevant antecedents of information exchange, while organisational boundaries only partially relate with information exchange. Surprisingly, stakeholder salience and social proactiveness do not emerge as significant drivers of information exchange. The study contributes to the debate on extra‐role pro‐sustainability behaviours and provides implications for managerial practice.