• Energy Research
• Closed Access close
• Embargo close
• 7. Clean energy close
• 13. Climate action close
• 6. Clean water close
• FR close

Summary Past climatic fluctuations have played a major role in shaping the current plant biodiversity. Although harbouring an exceptional biota, oceanic islands have received little attention in studies on species demographic history and past vegetation patterns. We investigated the impact of past climatic changes on the effective population size of a tree (Coffea mauritiana) that is endemic to Reunion Island, located in the south‐western Indian Ocean (SWIO). Demographic changes were inferred using summary statistics calculated from genomic data. Using ecological niche modelling and the current distribution of genetic diversity, the paleodistribution of the species was also assessed. A reduction in the effective population size of C. mauritiana during the last glaciation maximum was inferred. The distribution of the species was reduced on the western side of the island, due to low rainfall. It appeared that a major reduction in rainfall and a slight temperature decrease prevailed in the SWIO. Our findings indicated that analyses on the current patterns of intraspecific genetic variations can efficiently contribute to past climatic changes characterisation in remote islands. Identifying area with higher resilience in oceanic islands could provide guidance in forest management and conservation faced to the global climate change.

This paper presents the direct power control (DPC) of asymmetrical six-phase permanent magnet synchronous generator (A6PMSG) which supplied the isolated load via two PWM rectifiers. The study concerns the method of control by the converter (DPC). The proposed method is around two hysteresis controllers that enable the adjustment of active and reactive power. The research in this paper is verified by MATLAB SIMULINK software. It has been demonstrated through the simulation results that the proposed strategy can be an attractive and practical solution to multi-phase machines applications.

Abstract The hybrid pneumatic power system (HPPS) proposed in this research replaces the battery’s electric-chemical energy with flow work and optimizes the management and utilization of the energy. This power system is able to keep the internal-combustion engine working at its optimal condition and turn its waste energy into effective mechanical energy and so enhance the thermal efficiency of the whole system. Using computer simulation software ITI-SIM, this study simulates the overall dynamic characteristics of the system in accordance with the regulated running-vehicle test-mode ECE47, and, with experimental verification and analysis, proves that this system can meet the requirements of the standard running-car mode. As for recycling the waste energy, the experimental results show that this design could offset the shortcomings of the low-density of pneumatic power and so effectively enhance the efficiency of the whole system.

In this paper, we present the conjugate heat transfer analysis in a 167-kVA dry-type transformer using the parallel version of the computational fluid dynamics code Fluent 6.0. The renormalization group kappa-epsiv model is proposed to compute the turbulent aspect of the convective airflow inside the transformer metal tank for Air Natural/Air Natural cooling conditions. An experimental approach was used to assess Joule losses in the low-/high-voltage windings and eddy-current losses in the magnetic core. The resulting mathematical model was solved using 14 compute nodes on a distributed machine.

The fast decay in PEM fuel cells of a highly active, high performance, but unstable Fe/N/C catalyst like our NC_Ar + NH3 follows a chemical, not an electrochemical, demetallation mechanism for its ORR active FeN4 sites in the catalyst micropores.

Abstract Theoretical analysis of the interaction between concentrated solar radiation and a honeycomb matrix or a bed of particles cooled by a gas is presented. The computation and the experimental results show evidence of overheating of the solid near the irradiated surface. To prevent the upper surface from this phenomenon and to reduce the radiative heat losses, we propose to use selective semi-transparent porous absorbers. The first results about coatings on silica are presented.

Abstract This paper gives an experimental investigation of the effect of climatic conditions on the performance and degradation of crystalline silicon photovoltaic modules under Saharan environment in Adrar region in the south of Algeria. The first part of this study is focused on the analysis and assessment of UDTS 50 PV modules degradation after a long term outdoor exposure to these conditions (more than 12 years). The visual inspection of 62 PV modules has allowed to observe and determine the degradation modes such as, EVA discoloration, delamination, busbar corrosion, cracking of solar cell, glass breakage, AR coating and solder bond. The degradation evaluation of three modules with different defects was also performed, using (I-V/P-V) characteristics and the degradation rates of the parameters (Pmax, Imp, Vmp, Isc, Voc, FF) at Standard test conditions (STC) in order to compare with the nominal data delivered by the manufacturer of photovoltaic panels. Finally, the combination of the partial shading effect and the presence of EVA browning defect was examined to assess the changes in I-V and P-V curves caused by the drop in electrical parameters.

AbstractCellulose and lignin nanoparticles are high‐value‐added products obtained from lignocellulosic biomasses through several steps of cellulose purification and lignin extraction. These steps drastically reduce the potential feedstock revenue when carried out as stand‐alone methodologies. To increase biomass yields, we describe here a strategy to design a biorefinery focused on producing cellulose and lignin nanoparticles as main products, but also aim to recover and benefit from other biomass components using only water‐based processes. Sequential pressurized liquid extractions and diluted acid and alkaline treatments were carried out to fractionate elephant grass biomass, yielding (for every 100 g of biomass): 30 g of cellulose pulp (converted to 9 g of cellulose nanocrystals and 9 g of cellulose nanofibers); 10 g of lignin (used to produce 8.5 g of stable colloidal lignin nanoparticles by probe‐sonication in water); 7.5 g of extractives (e.g. sterols and phenolics) and 23 g of xylose (converted to 4.1 g of furfural). Alternatively, to allow for the flexible use of the cellulose fraction in the proposed biorefinery, 22 g of glucose could be produced by enzymatic hydrolysis. The results demonstrate that water‐based processes are suitable for a holistic use of biomass, providing a comprehensive set of high‐value‐added co‐products that are renewable and cost‐effective chemical, cosmetic, food, polymer and pharmaceutical solutions.

Abstract This work presents a numerical study on the performance of a stand-alone adsorption cooling system based on the silica gel/water couple driven by hybrid photovoltaic/thermal (PVT) collectors. This system is intended for the conservation of perishable agricultural products which require air-conditioned premises to preserve them. The weather conditions are those of North Africa (Algiers). Considering the above, this paper aims at analyzing the PVT-Adsorption system with energy storage to guarantee a stabilized production and increase the solar coverage. trnsys was used to simulate the system taking into account hourly series of irradiation and ambient temperature covering one year. The performance study reveals that the DualSun PVT hybrid collectors used provide optimal annual production and that the adsorption cooling system offers more reliable production during summer. The temperature difference between the inside and outside of the cooled enclosure balances supply and demand. The loss analysis of the storage device indicates that losses depend, on the one hand, on the interior/exterior temperature difference of the storage tank with more significant values during the summer season. On the other hand, the losses also depend on the volume of the storage tank which was optimized in order to limit the heat exchange with the surroundings.