• Energy Research
• Restricted close
• IN close
• RU close
• VBN close

The oleaginous alga Chlorella protothecoides accumulates lipid in its biomass when grown in nitrogen-restricted conditions. To assess the relationship between nitrogen provision and lipid accumulation and to determine the contribution of photosynthesis in mixotrophic growth, C. protothecoides was grown in mixo- and heterotrophic nitrogen-limited continuous flow cultures. Lipid content increased with decreasing C/N, while biomass yield on glucose was not affected. Continuous production of high lipid levels (57% of biomass) was possible at high C/N (87-94). However, the lipid production rate (2.48 g L(-1) d(-1)) was higher at D=0.84 d(-1) with C/N 37 than at D=0.44 d(-1) and C/N 87 even though the lipid content of the biomass was lower (38%). Photosynthesis contributed to biomass and lipid production in mixotrophic conditions, resulting in 13-38% reduction in CO2 production compared with heterotrophic cultures, demonstrating that photo- and heterotrophic growth occurred simultaneously in the same population.

Abstract The aim of the present study was to assess the influence of substrate concentration on the fermentative hydrogen production from sweet sorghum extract, in a continuous stirred tank bioreactor. The reactor was operated at a Hydraulic Retention Time (HRT) of 12 h and carbohydrate concentrations ranging from 9.89 to 20.99 g/L, in glucose equivalents. The maximum hydrogen production rate and yield were obtained at the concentration of 17.50 g carbohydrates/L and were 2.93 ± 0.09 L H 2 /L reactor/d and 0.74 ± 0.02 mol H 2 /mol glucose consumed, corresponding to 8.81 ± 0.02 L H 2 /kg sweet sorghum, respectively. The main metabolic product at all steady states was butyric acid, while ethanol production was high at high substrate concentrations. The experiments showed that hydrogen productivity depends significantly on the initial carbohydrate concentration, which also influences the distribution of the metabolic products.

Improper management of pig manure has resulted in environmental problems such as surface water eutrophication, ground water pollution, and greenhouse gas emissions. This study develops and compares 14 alternative manure management scenarios aiming at energy and nutrient extraction. The scenarios based on combinations of thermal pretreatment, anaerobic digestion, anaerobic co-digestion, liquid/solid separation, drying, incineration, and thermal gasification were compared with respect to their energy, nutrient and greenhouse gas balances. Both sole pig manure and pig manure mixed with other types of waste materials were considered. Data for the analyses were obtained from existing waste treatment facilities, experimental plants, laboratory measurements and literature. The assessment reveals that incineration combined with liquid/solid separation and drying of the solids is a promising management option yielding a high potential energy utilization rate and greenhouse gas savings. If maximum electricity production is desired, anaerobic digestion is advantageous as the biogas can be converted to electricity at high efficiency in a gas engine while allowing production of heat for operation of the digestion process. In conclusion, this study shows that the choice of technology has a strong influence on energy, nutrient and greenhouse gas balances. Thus, to get the most reliable results, it is important to consider the most representative (and up-to-date) technology combined with data representing the area or region in question.

Six hydrothermal liquefaction experiments on Nannochloropsis salina and Spirulina platensis at subcritical and supercritical water conditions (220–375 °C, 20–255 bar) were carried out to explore the feasibility of extracting lipids from wet algae, preserving nutrients in lipid-extracted algae solid residue, and recycling process water for algae cultivation. GC–MS, elemental analyzer, FT-IR, calorimeter and nutrient analysis were used to analyze bio-crude, lipid-extracted algae and water samples produced in the hydrothermal liquefaction process. The highest bio-crude yield of 46% was obtained on N. salina at 350 °C and 175 bar. For S. platensis algae sample, the optimal hydrothermal liquefaction condition appears to be at 310 °C and 115 bar, while the optimal condition for N. salina is at 350 °C and 175 bar. Preliminary data also indicate that a lipid-extracted algae solid residue sample obtained in the hydrothermal liquefaction process contains a high level of proteins.

Traditional fire stoves are characterized by low efficiency. In this experimental study, the combustion chamber of the stove is augmented by two devices. An electric fan can increase the air-to-fuel ratio in order to increase the system’s efficiency and decrease air pollution by providing complete combustion of wood. In addition, thermoelectric generators (TEGs) produce power that can be used to satisfy all basic needs. In this study, a water-based cooling system is designed to increase the efficiency of the TEGs and also produce hot water for residential use. Through a range of tests, an average of 7.9 W was achieved by a commercial TEG with substrate area of 56 mm × 56 mm, which can produce 14.7 W output power at the maximum matched load. The total power generated by the stove is 166 W. Also, in this study a reasonable ratio of fuel to time is described for residential use. The presented prototype is designed to fulfill the basic needs of domestic electricity, hot water, and essential heat for warming the room and cooking.

Abstract Biogas production is one of the number of tools that may be used to alleviate the problems of global warming, energy security and waste management. Biogas plants can be difficult to sustain from a financial perspective. The facilities must be financially optimized through use of substrates with high biogas potential, low water content and low retention requirement. This research carried out in laboratory scale batch digesters assessed the biogas potential of energy crops (maize and grass silage) and solid manure fractions from manure separation units. The ultimate methane productivity in terms of volatile solids (VS) was determined as 330, 161, 230, 236, 361 L/kg VS from raw pig slurry, filter pressed manure fiber (FPMF), chemically precipitated manure fiber (CPMF), maize silage and grass silage respectively. Methane productivity based on mass (L/kg substrate) was significantly higher in FPMF (55 L/kg substrate), maize silage (68 L/kg substrate) and grass silage (45–124 L/kg substrate (depending on dry solids of feedstock)) as in comparison to raw pig slurry (10 L/kg substrate). The use of these materials as co-substrates with raw pig slurry will increase significantly the biomethane yield per unit feedstock in the biogas plant.

This paper presents a comparison of three variable-speed wind turbine simulators used for a 2 MW wind turbine short-term transient behaviour study during a symmetrical network disturbance. The simulator with doubly fed induction generator (DFIG) analytical model, the simulator with a finite element method (FEM) DFIG model and the wind turbine simulator with an analytical model of DFIG are compared. The comparison of the simulation results shows the influence of the different modelling approaches on the short-term transient simulation accuracy. Copyright © 2005 John Wiley & Sons, Ltd.

This review outlines the current status and recent developments in the technology of microalgal culturing in enclosed photobioreactors. Light distribution and mixing are the primary variables that affect productivities of photoautotrophic cultures and have strong impacts on photobioreactor designs. Process monitoring and control, physiological engineering, and heterotrophic microalgae are additional aspects of microalgal culturing, which have gained considerable attention in recent years.