• Energy Research
• 12. Responsible consumption close
• 2. Zero hunger close
• 15. Life on land close
• IT close
• CA close
• Energies close

Nowadays, heating using wood, briquettes, or pellets is a curious replacement to fossil fuels such as coal, oil, or gas. Unfortunately, the combustion of biofuels, especially in low-power boilers with unstable operating conditions, releases a lot of gas pollutants (e.g., carbon monoxide (CO), nitric oxide (NO), and various organic compounds) that are usually generated due to the incomplete product combustion. The combustion of biofuel in grate boilers with top-down ignition is a new approach, popular in society (mainly used for coal fuels), which improves the combustion process and reduces the amount of pollutants emitted. This study evaluated the impact of ignition techniques on the emission level of gas pollutants during the combustion of wood logs, briquettes, and pellets of pine in grate-based charging boilers. The combination of top ignition mode with pinewood logs allowed us to achieve a reduction of 6% in CO and sulfur dioxide (SO2) emission into the atmosphere. However, the combination of top-down ignition mode with pellets and briquettes produced, in fully operational conditions, 1- to 18-fold higher levels of CO and SO2 respectively, than bottom-up ignition, after an initial period of low level CO and SO2 emissions. During the tests (mainly with ignition from top), substantial emissions of NO were observed of up to 400 mg·m−3 at 10% O2. Therefore, further research is required to decrease emission related to the content of nitrogen in biomass. In this respect, research of impact on the combustion temperature of such emissions is needed.

Coal will continue to be the main energy source in China for the immediate future, although the environmental pollution and ecological impacts of each stage in the full life cycle of coal mining, transportation, and combustion generate large quantities of external costs. The Late Permian coals in southwestern (SW) China usually contain high amounts of fluorine (F), arsenic (As), and ash, which together with high-F clays cause abnormally high levels of endemic fluorosis, As poisoning, and lung cancer in areas where coal is mined and burned. In this paper, we estimate the external costs of the life cycle of coal. The results show that the externalities of coal in SW China are estimated at USD 73.5 billion or 284.3 USD/t, which would have accounted for 6.5 % of the provincial GDP in this area in 2018. The external cost of human health accounts for 87.2% of the total external costs, of which endemic skeletal fluorosis diseases and related lung cancers have the most important impact. Our study provides a more precise estimate of externalities compared with its counterparts in other provinces in China. Therefore, several policy recommendations would be proposed to internalize the external cost.

In this study, our aim was to explore the potential energy savings obtainable from the recycling of 1 tonne of Construction and Demolition Waste (C&DW) generated in the Metropolitan City of Naples. The main fraction composing the functional unit are mixed C&DW, soil and stones, concrete, iron, steel and aluminium. The results evidence that the recycling option for the C&DW is better than landfilling as well as that the production of recycled aggregates is environmentally sustainable since the induced energy and environmental impacts are lower than the avoided energy and environmental impacts in the life cycle of recycled aggregates. This LCA study shows that the transition to the Circular Economy offers many opportunities for improving the energy and environmental performances of the construction sector in the life cycle of construction materials by means of internal recycling strategies (recycling C&DW into recycled aggregates, recycled steel, iron and aluminum) as well as external recycling by using input of other sectors (agri-food by-products) for the manufacturing of construction materials. In this way, the C&D sector also contributes to realizing the energy and bioeconomy transition by disentangling itself from fossil fuel dependence.

The increasing demand for energy and commodities has led to escalating greenhouse gas emissions, the chief of which is represented by carbon dioxide (CO2). Blue hydrogen (H2), a low-carbon hydrogen produced from natural gas with carbon capture technologies applied, has been suggested as a possible alternative to fossil fuels in processes with hard-to-abate emission sources, including refining, chemical, petrochemical and transport sectors. Due to the recent international directives aimed to combat climate change, even existing hydrogen plants should be retrofitted with carbon capture units. To optimize the process economics of such retrofit, it has been proposed to remove CO2 from the pressure swing adsorption (PSA) tail gas to exploit the relatively high CO2 concentration. This study aimed to design and numerically investigate a vacuum pressure swing adsorption (VPSA) process capable of capturing CO2 from the PSA tail gas of an industrial steam methane reforming (SMR)-based hydrogen plant using NaX zeolite adsorbent. The effect of operating conditions, such as purge-to-feed ratio and desorption pressure, were evaluated in relation to CO2 purity, CO2 recovery, bed productivity and specific energy consumption. We found that conventional cycle configurations, namely a 2-bed, 4-step Skarstrom cycle and a 2-bed, 6-step modified Skarstrom cycle with pressure equalization, were able to concentrate CO2 to a purity greater than 95% with a CO2 recovery of around 77% and 90%, respectively. Therefore, the latter configuration could serve as an efficient process to decarbonize existing hydrogen plants and produce blue H2.

The yeast Yarrowia lipolytica is an industrially relevant microorganism, which is able to convert low-value wastes into different high-value, bio-based products, such as enzymes, lipids, and other important metabolites. Waste cooking oil (WCO) represents one of the main streams generated in the food supply chain, especially from the domestic sector. The need to avoid its incorrect disposal makes this waste a resource for developing bioprocesses in the perspective of a circular bioeconomy. To this end, the strain Y. lipolytica W29 was used as a platform for the simultaneous production of intracellular lipids and extracellular lipases. Three different minimal media conditions with different pH controls were utilized in a small-scale (50 mL final volume) screening strategy, and the best condition was tested for an up-scaling procedure in higher volumes (800 mL) by selecting the best-performing possibility. The tested media were constituted by YNB media with high nitrogen restriction (1 g L−1 (NH4)2SO4) and different carbon sources (3% w v−1 glucose and 10% v v−1 WCO) with different levels of pH controls. Lipase production and SCO content were analyzed. A direct correlation was found between decreasing FFA availability in the media and increasing SCO levels and lipase activity. The simultaneous production of extracellular lipase (1.164 ± 0.025 U mL−1) and intracellular single-cell oil accumulation by Y. lipolytica W29 growing on WCO demonstrates the potential and the industrial relevance of this biorefinery model.

The campus of the Karlsruhe Institute of Technology (KIT) contains several waste heat streams. In an effort to reduce greenhouse gas emissions by optimizing thermal power consumption on the campus, researchers at the KIT are proposing a ‘DeepStor’ project, which will sequester waste heat from these streams in an underground reservoir during the summer months, when the heat is not required. The stored heat will then be reproduced in the winter, when the campus’s thermal power demand is much higher. This paper contains a preliminary geochemical risk assessment for the operation of this subsurface, seasonal geothermal energy storage system. We used equilibrium thermodynamics to determine the potential phases and extent of mineral scale formation in the plant’s surface infrastructure, and to identify possible precipitation, dissolution, and ion exchange reactions that may lead to formation damage in the reservoir. The reservoir in question is the Meletta Beds of the Upper Rhein Graben’s Froidefontaine Formation. We modeled scale- and formation damage-causing reactions during six months of injecting 140 °C fluid into the reservoir during the summer thermal storage season and six months of injecting 80 °C fluid during the winter thermal consumption season. Overall, we ran the models for 5 years. Anhydrite and calcite are expected mineral scales during the thermal storage season (summer). Quartz is the predicted scale-forming mineral during the thermal consumption period (winter). Within ~20 m of the wellbores, magnesium and iron are leached from biotite; calcium and magnesium are leached from dolomite; and sodium, aluminum, and silica are leached from albite. These reactions lead to a net increase in both porosity and permeability in the wellbore adjacent region. At a distance of ~20–75 m from the wellbores, the leached ions recombine with the reservoir rocks to form a variety of clays, i.e., saponite, minnesotaite, and daphnite. These alteration products lead to a net loss in porosity and permeability in this zone. After each thermal storage and production cycle, the reservoir shows a net retention of heat, suggesting that the operation of the proposed DeepStor project could successfully store heat, if the geochemical risks described in this paper can managed.

The control and improvement of energy-environmental quality in buildings are responsible for almost 40% of the emissions related to energy and processes, and are essential to achieve the commitment of the Paris Agreement and the Sustainable Development Goals (SDGs) United Nations (UN). This paper provides a support tool to planners and administrators of the territory for the identification of interventions aimed at the energy requalification of the existing Italian building heritage, mainly for residential use. The purpose of this tool is to reduce energy consumption by intervening on the building envelope with specific solutions that are identified through a matrix resulting from the study. In the first part of the study, an analysis was carried out on various factors such as the existing residential building, the building and construction types and the materials of the envelope typical of each construction period, which are critical for energy efficiency issues. In the second part of the study, the analysis of the state of the art of the insulating materials existing on the international and national market was carried out, in order to standardize the efficiency interventions of the building envelope. By exploiting the potential of the proposed matrix, and integrating it with Geographic Information System (GIS) technology, it would be possible to create a database containing information regarding the characteristics of the building envelope of the residential building stock and to identify a set of insulation interventions more suited to each specific case near Rome, Italy.

Biogas technology is an important alternative energy source worldwide. Blackwater and kitchen refuse represent ideal waste streams for bioenergy recovery through anaerobic co-digestion. Modeling of the biokinetics of anaerobic digestion on several aspects, such as microbial activity, substrate degradation, and methane production, from co-digestion of black water (BW) and kitchen refuse (KR) was the objective of this research. A mathematical model was developed towards a simulation based on mass balances on biomass, the organic substrate, and biogas. The model was implemented in INSEL and experimental data from the literature were used for model validation. The study shows that the simulation results fit well with the experimental data. The energy consumption and generation potential of anaerobic co-digestion of BW and KR were calculated to investigate if the produced biogas could supply the digester’s energy demand. This study can be used to pre-design anaerobic digestion systems in eco-districts.