• Energy Research
• Open Access close
• Restricted close
• Open Source close
• 11. Sustainability close
• IT close
• DE close
• BE close

Climate change is a global problem, which affects the various geographical regions at different levels. It is also associated with a wide range of human health problems, which pose a burden to health systems, especially in regions such as Africa. Indeed, across the African continent public health systems are under severe pressure, partly due to their fragile socioeconomic conditions. This paper reports on a cross-sectional study in six African countries (Ghana, Nigeria, South Africa, Namibia, Ethiopia, and Kenya) aimed at assessing their vulnerabilities to climate change, focusing on its impacts on human health. The study evaluated the levels of information, knowledge, and perceptions of public health professionals. It also examined the health systems’ preparedness to cope with these health hazards, the available resources, and those needed to build resilience to the country’s vulnerable population, as perceived by health professionals. The results revealed that 63.1% of the total respondents reported that climate change had been extensively experienced in the past years, while 32% claimed that the sampled countries had experienced them to some extent. Nigerian respondents recorded the highest levels (67.7%), followed by Kenya with 66.6%. South Africa had the lowest level of impact as perceived by the respondents (50.0%) when compared with the other sampled countries. All respondents from Ghana and Namibia reported that health problems caused by climate change are common in the two countries. As perceived by the health professionals, the inadequate resources reiterate the need for infrastructural resources, medical equipment, emergency response resources, and technical support. The study’s recommendations include the need to improve current policies at all levels (i.e., national, regional, and local) on climate change and public health and to strengthen health professionals’ skills. Improving the basic knowledge of health institutions to better respond to a changing climate is also recommended. The study provides valuable insights which may be helpful to other nations in Sub-Saharan Africa.

Abstract. The impact of multiphase reactions involving nitrogen dioxide (NO2) and aromatic compounds was simulated in this study. A mechanism (CAPRAM 2.4, MODAC Mechanism) was applied for the aqueous phase reactions, whereas RACM was applied for the gas phase chemistry. Liquid droplets were considered as monodispersed with a mean radius of 0.1 µm and a liquid content (LC) of 50 µg m-3. The multiphase mechanism has been further extended to the chemistry of aromatics, i.e. reactions involving benzene, toluene, xylene, phenol and cresol have been added. In addition, reaction of NO2 with dissociated hydroxyl substituted aromatic compounds has also been implemented. These reactions proceed through charge exchange leading to nitrite ions and therefore to nitrous acid formation. The strength of this source was explored under urban polluted conditions. It was shown that it may increase gas phase HONO levels under some conditions and that the extent of this effect is strongly pH dependent. Especially under moderate acidic conditions (i.e. pH above 4) this source may represent more than 75% of the total HONO/NO2 - production rate, but this contribution drops down close to zero in acidic droplets (as those often encountered in urban environments).

The construction industry is considered as one of the least productive, highest energy consuming, and least digitized industries. The Lean Management (LM) philosophy became a significant way for eliminating non-value-added activities and wastes during a building’s lifecycle. However, studies have shown that philosophies are not efficient by themselves to solve the issues of the construction industry. They need to be supported with the appropriate technologies and tools. Therefore, the integrated use of Building Information Modelling (BIM) with LM or Value Engineering (VE) were proposed in the literature. Nonetheless, it was also seen that BIM can provide more insights and improvements when BIM is integrated with data analysis tools to analyze BIM data. In the literature, the synergies between these concepts are generally addressed pairwise, and there is no comprehensive framework which identifies their relationships. Therefore, this study aims to develop a maturity framework that facilitates the adoption of LM, VE, BIM, and Big Data Analytic (BDA) concepts to address long-standing productivity and digitalization issues in the Architecture, Engineering, and Construction (AEC) industry. Design Science Research (DSR) methodology and its three-cycle view (relevance, rigor, and design cycle) were applied to build the proposed maturity framework. Two interviews were performed to identify and observe research problem in relevance cycle. In the rigor cycle, a comprehensive literature review was performed to create a base for the development of the maturity framework. In addition to the developed base of the framework, lean processes were added to this cycle. In the design cycle, the developed framework was evaluated and validated by five experts through face-to-face interviews. The importance of employer’s requirements to adopt the proposed methodologies, the negative impact of change orders, the importance of pre-construction phases to facilitate value creation and waste elimination, and the usage of common data environment with BIM were identified as the prominent application and adaptation issues.

Abstract The work discusses a problem of harvesting and upgrading of ultra-low grade heat with thermochemical energy storage technology for space and domestic water heating in residential area. The laboratory scale prototype, operating on the principle of an open packed bed sorption reactor and using moist air as a heat/mass transfer fluid, is experimented. The range of experimental air temperature was set to 17–40 °C, which corresponds to the typical range of domestic waste thermal energy. The tested sorbent was a salt-in-matrix composite material composed of a silica gel containing 43 wt.% of calcium chloride (CaCl2) salt. Hygrothermal behavior and energy performances of the prototype control volume filled with 245 g of material, representing the reactive front of a thermal wave, were analyzed at constant inlet hydration conditions (water vapor pressure of 12.5 mbar). The average temperature lift was recorded as 9–13 °C, representing the amplification of a supplied heat on 23% – 75% depending on the inlet temperature. The average specific thermal power inside the material bed was measured to be 168–267 W kg-1. The apparent energy density, based on the prototype control volume, ranged between 1.0 and 1.6 GJ m-3. Taking into account the heat of water vaporization, the coefficient of performance of the process was determined to be 0.96–1.57.

Predicting the potential habitat of species under both current and future climate change scenarios is crucial for monitoring invasive species and understanding a species' response to different environmental conditions. Frequently, the only data available on a species is the location of its occurrence (presence-only data). Using occurrence records only, two models were used to predict the geographical distribution of two destructive invasive termite species, Coptotermes gestroi (Wasmann) and Coptotermes formosanus Shiraki. The first model uses a Bayesian linear logistic regression approach adjusted for presence-only data while the second one is the widely used maximum entropy approach (Maxent). Results show that the predicted distributions of both C. gestroi and C. formosanus are strongly linked to urban development. The impact of future scenarios such as climate warming and population growth on the biotic distribution of both termite species was also assessed. Future climate warming seems to affect their projected probability of presence to a lesser extent than population growth. The Bayesian logistic approach outperformed Maxent consistently in all models according to evaluation criteria such as model sensitivity and ecological realism. The importance of further studies for an explicit treatment of residual spatial autocorrelation and a more comprehensive comparison between both statistical approaches is suggested.

Abstract This literature review was built upon recently published articles on Life Cycle Assessments (LCAs) of agricultural biogas plants, to: enhance understanding of the relevant literature in the field and the related question by readers worldwide. It was designed to highlight methodological issues and impact indicators, which best represent this research field; consequently, they should be considered in performing environmental assessments of agro-biogas derived energy systems. The literature review highlighted the wide variability of environmental results due to the ways the feedstock mixtures were produced, managed, and supplied; and due to the regions in which the anaerobic digesters were located and operated. Differences were found to be related to the aim and function of the study and to the methodological approach used, especially for the development of the environmental impact assessments. Other differences resulted from the ways the energy produced was utilised, whether it was used as an input to the natural gas national grid, and/or if it was used within the production system. The authors of this review concluded that, although much progress has been made, many unsolved challenges and methodological choices must be addressed to further improve the robustness of LCA in relation to AD and to related approaches.