• Energy Research
• 12. Responsible consumption close
• 3. Good health close
• GB close
• IT close
• DE close
• EU close

The adenine nucleotide translocation in mitochondria has previously been established as an exchange between exogenous and endogenous adenine nucleotides across the inner membrane. The specificity and the control of the exchange are examined with the following major results: The adenine nucleotide translocation is relatively specific for exogenous ADP and ATP, AMP being nearly inactive. Among other nucleotides tested, only dADP and dATP exchange with a noticeable activity. In the controlled state ADP exchanges 2–4 times faster than ATP. If simultaneously added, ADP and ATP compete for the exchange, with ADP being about tenfold more active than ATP. The specificity of the exit of adenine nucleotides in the exchange is similar to the specificity of the entrance with the difference that ADP and ATP are released with equal activity in proportion to their intramitochondrial content. AMP is released only after a slow conversion to ADP. Therefore the short time exchange is limited by the endogenous content of ADP plus ATP. The exchange is influenced by the metabolic state of the mitochondria. The ATP exchange is more variable than the ADP exchange. Two effects are elucidated: (a) the influence of the metabolic state on the relative content of AMP which inhibits both the ADP and ATP exchange (b) the coupling of the energy transfer system which inhibits only the ATP exchange. An example for case (a) is the inhibition of the ADP and ATP exchange by arsenate and an example for case (b) is the strong increase of the ATP exchange on uncoupling. The following effects are relevant to the mechanism of the control of the exchange by ATP. The stimulation of the ATP exchange by uncoupler has the same concentration dependence as the uncoupling of oxidative phosphorylation (Km [CCP] = 0.08 μM, where CCP = carbonyl‐cyanide‐phenylhydrazone). Oligomycin does not abolish the uncoupler effect on the ATP exchange. “Endogenous uncoupling” on aging of mitochondria also stimulates the ATP exchange. Valinomycin plus K+ only slightly stimulate the ATP exchange. Anaerobiosis stimulates the ATP exchange to a smaller extent than uncoupling.In competition with ADP the effects of energy transfer on ATP exchange are more strongly revealed. On uncoupling the more than tenfold preference for ADP is fully abolished. It is concluded that basically the exchange for ADP and ATP has equal specificity in forward and reverse reaction. In the controlled state a superimposed force makes the specificity asymmetric and inhibits the entrance of ATP. This control of the ATP exchange is concluded to be based on the anionic character of the adenine nucleotides. Thus the ATP4‐ex–ADP3‐in exchange is inhibited unless the charge difference is compensated for by an uncoupler stimulated H+ movement across the membrane. Furthermore an electric potential gradient appears to be effective in the controlled state which is abolished on uncoupling.

The adenine nucleotide translocation in mitochondria has previously been established as an exchange between exogenous and endogenous adenine nucleotides across the inner membrane. The specificity and the control of the exchange are examined with the following major results: The adenine nucleotide translocation is relatively specific for exogenous ADP and ATP, AMP being nearly inactive. Among other nucleotides tested, only dADP and dATP exchange with a noticeable activity. In the controlled state ADP exchanges 2–4 times faster than ATP. If simultaneously added, ADP and ATP compete for the exchange, with ADP being about tenfold more active than ATP. The specificity of the exit of adenine nucleotides in the exchange is similar to the specificity of the entrance with the difference that ADP and ATP are released with equal activity in proportion to their intramitochondrial content. AMP is released only after a slow conversion to ADP. Therefore the short time exchange is limited by the endogenous content of ADP plus ATP. The exchange is influenced by the metabolic state of the mitochondria. The ATP exchange is more variable than the ADP exchange. Two effects are elucidated: (a) the influence of the metabolic state on the relative content of AMP which inhibits both the ADP and ATP exchange (b) the coupling of the energy transfer system which inhibits only the ATP exchange. An example for case (a) is the inhibition of the ADP and ATP exchange by arsenate and an example for case (b) is the strong increase of the ATP exchange on uncoupling. The following effects are relevant to the mechanism of the control of the exchange by ATP. The stimulation of the ATP exchange by uncoupler has the same concentration dependence as the uncoupling of oxidative phosphorylation (Km [CCP] = 0.08 μM, where CCP = carbonyl‐cyanide‐phenylhydrazone). Oligomycin does not abolish the uncoupler effect on the ATP exchange. “Endogenous uncoupling” on aging of mitochondria also stimulates the ATP exchange. Valinomycin plus K+ only slightly stimulate the ATP exchange. Anaerobiosis stimulates the ATP exchange to a smaller extent than uncoupling.In competition with ADP the effects of energy transfer on ATP exchange are more strongly revealed. On uncoupling the more than tenfold preference for ADP is fully abolished. It is concluded that basically the exchange for ADP and ATP has equal specificity in forward and reverse reaction. In the controlled state a superimposed force makes the specificity asymmetric and inhibits the entrance of ATP. This control of the ATP exchange is concluded to be based on the anionic character of the adenine nucleotides. Thus the ATP4‐ex–ADP3‐in exchange is inhibited unless the charge difference is compensated for by an uncoupler stimulated H+ movement across the membrane. Furthermore an electric potential gradient appears to be effective in the controlled state which is abolished on uncoupling.

© 2020 Elsevier Ltd Free cooling of buildings uses the nocturnal outdoor air as a heat sink via a ventilation process. This could be performed by storing the night coolness for use during the daytime as appropriate. Due to the latent heat capacity, phase change material (PCM) could play anessential role in the effective operation of the free cooling systems by shifting the daytime peak load to the night. However, there is a scarceness on the technology application in hot climates. This paper presents results of a parametric investigation into the application of PCMs as thermal energy storage (TES) to provide sustainable cooling to buildings in hot arid climate by making use of the night-time free cooling. The proposed TES medium comprises an arrangement of metallic modules filled with RT28HC PCM. Numerous geometrical configurations and operational parameters have been assessed. A transient CFD simulation has been employed using ANSYS Fluent software. Validation of the numerical results with experimental data has shown a good agreement. The results have demonstrated that the temperature difference between the PCM and the air, at appropriate air flow rate would have a significant impact on the performance of the system. A free cooling system based on the proposed arrangement has the potential to meet around 42% of a typical building cooling load and has the ability to save up to 67% of building cooling energy load in summer season compared to conventional air-conditioning systems in hot arid climates.

© 2020 Elsevier Ltd Free cooling of buildings uses the nocturnal outdoor air as a heat sink via a ventilation process. This could be performed by storing the night coolness for use during the daytime as appropriate. Due to the latent heat capacity, phase change material (PCM) could play anessential role in the effective operation of the free cooling systems by shifting the daytime peak load to the night. However, there is a scarceness on the technology application in hot climates. This paper presents results of a parametric investigation into the application of PCMs as thermal energy storage (TES) to provide sustainable cooling to buildings in hot arid climate by making use of the night-time free cooling. The proposed TES medium comprises an arrangement of metallic modules filled with RT28HC PCM. Numerous geometrical configurations and operational parameters have been assessed. A transient CFD simulation has been employed using ANSYS Fluent software. Validation of the numerical results with experimental data has shown a good agreement. The results have demonstrated that the temperature difference between the PCM and the air, at appropriate air flow rate would have a significant impact on the performance of the system. A free cooling system based on the proposed arrangement has the potential to meet around 42% of a typical building cooling load and has the ability to save up to 67% of building cooling energy load in summer season compared to conventional air-conditioning systems in hot arid climates.

Decarbonizing the building sector is extremely important to mitigating climate change as the sector contributes 40% of the overall energy consumption and 36% of the total greenhouse gas emissions in the world. Net-zero energy buildings are one of the promising decarbonization attempts due to their potential of decreasing the use of energy and increasing the total share of renewable energy. To achieve a net-zero energy building, it is necessary to decrease the energy demand by applying efficiency enhancement measures and using renewable energy sources. Net-zero energy buildings can be classified into four models (Net-Zero Site Energy buildings, Net-Zero Emissions buildings, Net-Zero Source Energy buildings, and Net-Zero Cost Energy buildings). A variety of technical, financial, and environmental factors should be considered during the decision-making process of net-zero energy building development, justifying the use of multi-criteria decision analysis methods for the design of net-zero energy buildings. This paper also discussed the contributions of renewable energy generation (hydropower, wind energy, solar, heat pumps, and bioenergy) to the development of net-zero energy buildings and reviewed its role in tackling the decarbonization challenge. Cost-benefit analysis and life cycle assessment of building designs were reviewed to shape the priorities of future development. It is important to develop a universal decision instrument for optimum design and operation of net-zero energy buildings.

Decarbonizing the building sector is extremely important to mitigating climate change as the sector contributes 40% of the overall energy consumption and 36% of the total greenhouse gas emissions in the world. Net-zero energy buildings are one of the promising decarbonization attempts due to their potential of decreasing the use of energy and increasing the total share of renewable energy. To achieve a net-zero energy building, it is necessary to decrease the energy demand by applying efficiency enhancement measures and using renewable energy sources. Net-zero energy buildings can be classified into four models (Net-Zero Site Energy buildings, Net-Zero Emissions buildings, Net-Zero Source Energy buildings, and Net-Zero Cost Energy buildings). A variety of technical, financial, and environmental factors should be considered during the decision-making process of net-zero energy building development, justifying the use of multi-criteria decision analysis methods for the design of net-zero energy buildings. This paper also discussed the contributions of renewable energy generation (hydropower, wind energy, solar, heat pumps, and bioenergy) to the development of net-zero energy buildings and reviewed its role in tackling the decarbonization challenge. Cost-benefit analysis and life cycle assessment of building designs were reviewed to shape the priorities of future development. It is important to develop a universal decision instrument for optimum design and operation of net-zero energy buildings.

According to the renewable energy directive 2009/28/EC, the European Union Member States should increase by 2020 the use of renewable energy to 20% of gross final energy consumption and to reach a mandatory share of 10% renewable energy in the transport sector. This study aims to quantify the impact of 2020 bioenergy targets on the land use in the EU, based on the projections of the National Renewable Action Plans in four scenarios: Scenario 1. Bioenergy targets according to NREAPs; Scenario 2. Bioenergy targets according to NREAPs, no second generation biofuels; Scenario 3. Bioenergy targets according to NREAPs, reduced import of biofuels and bioliquids; Scenario 4. Bioenergy targets according to NREAPs, high imports of biofuels and bioliquids. This study also considers the credit for co-products generated from biofuel production. The analysis reveals that the land used in the EU for bioenergy would range between 13.5 Mha and 25.2 Mha in 2020. This represent between 12.2% and 22.5% of the total arable land used and 7.3% and 13.5% of the Utilised Agricultural Area (UAA). In the NREAPS scenario, about 17.4 Mha would be used for bioenergy production, representing 15.7% of arable land and 9.4% of UAA. The increased demand from biofuels would lead to an increased generation of co-products, replacing conventional fodder for animal feed. Considering the co-products, the land used for bioenergy would range between 8.8 Mha and 15.0 Mha in 2020 in the various scenarios. This represent between 7.9% and 13.3% of the total arable land used in the EU and 4.7% and 8.0% of the UAA. In the NREAPS scenario, when co-products are considered, about 10.3 Mha would be used for biofuels, bioliquids and bioenergy production, representing 9.3% of arable land and 5.6% of agricultural land. This study further provides detailed data on the impact on land use in each Member State.

According to the renewable energy directive 2009/28/EC, the European Union Member States should increase by 2020 the use of renewable energy to 20% of gross final energy consumption and to reach a mandatory share of 10% renewable energy in the transport sector. This study aims to quantify the impact of 2020 bioenergy targets on the land use in the EU, based on the projections of the National Renewable Action Plans in four scenarios: Scenario 1. Bioenergy targets according to NREAPs; Scenario 2. Bioenergy targets according to NREAPs, no second generation biofuels; Scenario 3. Bioenergy targets according to NREAPs, reduced import of biofuels and bioliquids; Scenario 4. Bioenergy targets according to NREAPs, high imports of biofuels and bioliquids. This study also considers the credit for co-products generated from biofuel production. The analysis reveals that the land used in the EU for bioenergy would range between 13.5 Mha and 25.2 Mha in 2020. This represent between 12.2% and 22.5% of the total arable land used and 7.3% and 13.5% of the Utilised Agricultural Area (UAA). In the NREAPS scenario, about 17.4 Mha would be used for bioenergy production, representing 15.7% of arable land and 9.4% of UAA. The increased demand from biofuels would lead to an increased generation of co-products, replacing conventional fodder for animal feed. Considering the co-products, the land used for bioenergy would range between 8.8 Mha and 15.0 Mha in 2020 in the various scenarios. This represent between 7.9% and 13.3% of the total arable land used in the EU and 4.7% and 8.0% of the UAA. In the NREAPS scenario, when co-products are considered, about 10.3 Mha would be used for biofuels, bioliquids and bioenergy production, representing 9.3% of arable land and 5.6% of agricultural land. This study further provides detailed data on the impact on land use in each Member State.