• Energy Research
• engineering and technology close
• 3. Good health close
• JP close
• KR close

Comfort temperature and sleep quality involving 20 participants were determined in two cases: Case A (arbitrary, controlled air-conditioner setting) and Case B (adjustment of 3 °C higher than the setting of Case A with cool bed linen). Data of indoor thermal comfort and electricity consumption were collected every night throughout the measurement period. Questionnaires on thermal comfort and sleep quality were distributed twice a night for a duration of three nights for each case; the first night was for respondents’ adaptation and the following two nights were for measurement. The sleep quality of the respondents was objectively measured using a commercially available activity tracker. Results found that most respondents were thermally comfortable in both cases, with 39% lower energy consumption reported for Case B compared to Case A. The thermal conditions of Case B were found to be more tolerable than those of Case A. Most respondents reported to have a calm and satisfied sleep for both cases. Comfort temperature and Sleep Efficiency Index (SEI) were found to be maintained in both cases.

Abstract To elucidate the gas generation mechanism due to electrolyte decomposition in commercial lithium-ion cells after long cycling, we developed a device which can accurately determine the volume of generated gas in the cell. Experiments on LixC6/Li1−xCoO2 cells using electrolytes such as 1 M LiPF6 in propylene carbonate (PC), dimethyl carbonate (DMC), ethyl methyl carbonate (EMC), and diethyl carbonate (DEC) are presented and discussed. In the nominal voltage range (4.2–2.5 V), compositional change due mainly to ester exchange reaction occurs, and gaseous products in the cell are little. Generated gas volume and compositional change in the electrolyte are detected largely in overcharged cells, and we discussed that gas generation due to electrolyte decomposition involves different decomposition reactions in overcharged and overdischarged cells.

Gallium arsenide was anodically oxidized in a mixture of ethylene glycol and tartaric acid as an electrolyte. The numbers of Ga and As atoms in the anodic oxide films and in the used electrolytes were measured by radioactivation analysis. During the anodic oxidation, GaAs dissolved into the electrolyte. The numbers of Ga and As atoms that dissolved into the electrolytes was proportional to the anodic voltage, and the number of Ga atoms in the electrolyte was about five times more than that of As atoms. The composition of the anodic oxide films varied with depth. However, the atomic profiles measured by Auger electron spectroscopy displayed As atoms much less than Ga atoms throughout the anodic oxide films, because Ga oxides were lost from the anodic oxide films into the vacuum during the Auger electron spectroscopy, accompanying sputtered thin film removal.

Abstract Rice husk (RH), an agricultural waste, is abundantly available in rice producing countries like China, India, Bangladesh, Brazil, US, Cambodia, Vietnam, Myanmar, and South East Asia. Despite the massive amount of annual production worldwide, so far RHs have been recycled only for low-value applications. In recent years, many rice mills in rice producing countries have started using RH for the energy production for mill operations as well as household lighting in rural regions. Burning of RHs produces the rice husk ash (RHA). The disposal in landfills or open fields can be problematic and may cause a serious environmental and human health related problems due to the low bulk density of RHA. Several ways are being thought of for disposing RHA by making its commercial use. The amorphous silica forms the main component (83–90%) of RHA. The amorphous silica rich RHA has wide range of applications. High-value applications and current research investigations such as the use of RHA in manufacturing of silica gels, silicon chip, synthesis of activated carbon and silica, production of light weight construction materials and insulation, catalysts, zeolites, ingredients for lithium ion batteries, graphene, energy storage/capacitor, carbon capture, and in drug delivery vehicles are presented. Use of RHA in potential future applications is also discussed. It is suggested that the amorphous silica rich RHA could become a potential resource of low cost precursor for the production of value-added silica based materials for practical applications.

The New Energy and Industry Technology Development Organization (NEDO) road map (Japan, 2017) has proposed that a polymer electrolyte fuel cell (PEFC) system, which operates at a temperature of 90 °C and 100 °C, be applied for stationary and mobility usage, respectively. This study suggests using a thin polymer electrolyte membrane (PEM) and a thin gas diffusion layer (GDL), at the same time, to achieve better power-generation performance, at a higher temperature than usual. The focus of this paper is to clarify the effect of separator thickness on the distribution of temperature at the reaction surface (Treact), with the relative humidity (RH) of the supply gasses and initial operation temperature (Tini), quantitatively. In this study, separator thickness is investigated in a system using a thin PEM and a thin GDL. Moreover, this study investigates the difference between the maximum temperature and the minimum temperature obtained from the distribution of Treact as well as the relation between the standard deviation of Treact − Tini and total voltage, to clarify the effect of separator thickness. The impact of the flow rates of the supply gases on the distribution of Treact is not large, among the investigated conditions. It is noticed that the temperature distribution is wider when a separator thickness of 2.0 mm is selected. On the other hand, it is observed that the temperature increases along with the gas flow through the gas channel, by approximately 2 °C, when using a separator thickness between 1.5 mm and 1.0 mm. The impact of the RH on the distributions of Treact − Tini is larger at Tini = 100 °C, when a separator thickness of 1.0 mm is selected. It is revealed that the wider temperature distribution provides a reduction in power-generation performance. This study proposes that the thin separators, i.e., with a thickness of 1.5 mm and 1.0 mm, are not suitable for higher temperature operation than usual.

Abstract Sodium-promoted vanadium oxide catalysts supported on MCM-41 and TiO 2 (anatase) were investigated for the partial oxidation of ethanol to acetaldehyde. The catalysts were prepared by incipient wetness impregnation with a vanadium oxide content of 6 wt.%. The experimental characterization was performed by X-ray diffraction (XRD), N 2 adsorption, temperature-programmed reduction (TPR), and diffuse reflectance UV–vis. Temperature-programmed oxidation (TPO) was also used to identify carbon deposits on the spent catalysts. The presence of sodium plays a strong role in the dispersion and reducibility of the vanadium species as detected by TPR analysis and optical absorption spectroscopy. While sodium addition increases the dispersion of the VO x species, its presence also decreases their reducibility. Additionally, TPO of the spent catalysts revealed that an increase in the Na loading decreases the carbon deposition during reaction. In the case of the catalysts supported on MCM-41, these modifications were mirrored by a change in the activity and selectivity to acetaldehyde. Additionally, on the VO x /TiO 2 catalysts the catalytic activity decreased with increasing sodium content in the catalyst . A model in which sodium affects dispersion, reducibility and also acidity of the supported-vanadia species is proposed to explain all these observations.

Pathogens represent a significant threat to human health leading to the emergence of strategies designed to help manage their negative impact. We examined how spiritual beliefs developed to explain and predict the devastating effects of pathogens and spread of infectious disease. Analysis of existing data in studies 1 and 2 suggests that moral vitalism (beliefs about spiritual forces of evil) is higher in geographical regions characterized by historical higher levels of pathogens. Furthermore, drawing on a sample of 3140 participants from 28 countries in study 3, we found that historical higher levels of pathogens were associated with stronger endorsement of moral vitalistic beliefs. Furthermore, endorsement of moral vitalistic beliefs statistically mediated the previously reported relationship between pathogen prevalence and conservative ideologies, suggesting these beliefs reinforce behavioural strategies which function to prevent infection. We conclude that moral vitalism may be adaptive: by emphasizing concerns over contagion, it provided an explanatory model that enabled human groups to reduce rates of contagious disease.