• Energy Research
• Closed Access close
• Open Source close
• 13. Climate action close
• 11. Sustainability close
• 15. Life on land close
• GB close
• RO close

The Severn Estuary has the world's second largest tide range and a barrage across the estuary, located just seawards of Cardiff in Wales and Weston in the South West England, has been proposed for over half a century, with the objective of extracting large amounts of tidal energy. A Severn Barrage, as previously proposed by the Severn Tidal Power Group (STPG), would be the largest renewable energy project for tidal power generation in the world, if built as proposed, and would generate approximately 5% of the UK's electricity needs. However, concerns have been raised over the environmental impacts of such a barrage, including potential increase in flood risk, loss of intertidal habitats etc. In addressing the challenges of maximizing the energy output and minimizing the environmental impacts of such a barrage, this research study has focused on using a Continental Shelf model, based on the modified Environmental Fluid Dynamics Code (EFDC) with a barrage operation module (EFDC_B), to investigate both the far and near field hydrodynamic impacts of a barrage for different operating scenarios. Three scenarios have been considered to simulate the Severn Barrage, operating via two-way generation and using different combinations of turbines and sluices. The first scenario consisted of 216 turbines and 166 sluices installed along the barrage; the second consisted of 382 turbines with no sluices; and the third consisted of 764 turbines and no sluices. The specification of the sluice gates and turbines are the same for all scenarios. The model results indicate that the third scenario has the best mitigating effects for the far-field and near-field flood risks caused by a barrage and produces the most similar results of minimum water depth and maximum velocity distributions to those obtained from simulating the natural conditions of the estuary, i.e. the current conditions. The results also show that the flow patterns around the barrage are closest to those for the existing natural conditions with minimal slight changes in the estuary. Thus, the results clearly indicate that the environmental impacts of a Severn Barrage can be minimized if the barrage is operated for two-way generation and under the third scenario. Although it appears that the energy output for the third scenario is less than that obtained for the other two scenarios, if very low head (VLH) turbines are used, then the third scenario could generate more energy as more turbines could be cited along the barrage structure. Therefore, the study shows that a Severn Barrage, operating in two-way generation and with 764 turbines (ideally VLH turbines), would be the best option to meet the needs of maximizing the energy output, but having a minimal impact on environmental changes in the estuary and far-field.

Abstract The rapid increase in energy demand and the limited resources of fossil fuel as well as the environmentally damaging effects, drive the world to find new options for sustainable electricity generation, which is represented by renewable energies. Concentrating solar power (CSP) is one of the most promising technologies in the field of electricity generation to tackle this issue with a competitive cost in the future. This paper presents an investigation of the potential of implementation of CSP plants in Libya. The socio-economic context, current energy situation of the country and different types of CSP plants are discussed. Moreover, an assessment of site parameters required for CSP plants including solar resources, land use and topography, water resources and grid connections are investigated in detail. In addition, thermo-economic simulation of a 50 MW parabolic trough power plant is performed. The simulation is conducted based on meteorological data measured by the weather station installed at the Centre for Solar Energy Research and Studies (CSERS) in Tajoura city. The performance results are compared with the reference plant Andasol-1 in Spain. Even though the proposed plant is located on the North coast where solar resources are at their minimum compared with other regions of the country, the outcome of the study proves that Libya is not only suitable but it can be economically competitive in the implementation of CSP technology.

Abstract Two office layouts with high and low levels of thermal control were compared, respectively traditional cellular and contemporary open plan offices. The traditional Norwegian practice provided every user with control over a window, blinds, door, and the ability to adjust heating and cooling. Occupants were expected to control their thermal environment to find their own comfort, while air conditioning was operating in the background to ensure the indoor air quality. In contrast, in the British open plan office, limited thermal control was provided through openable windows and blinds only for occupants seated around the perimeter of the building. Centrally operated displacement ventilation was the main thermal control system. Users’ perception of thermal environment was recorded through survey questionnaires, empirical building performance through environmental measurements and thermal control through semi-structured interviews. The Norwegian office had 35% higher user satisfaction and 20% higher user comfort compared to the British open plan office. However, the energy consumption in the British practice was within the benchmark and much lower than the Norwegian office. Overall, a balance between thermal comfort and energy efficiency is required, as either extreme poses difficulties for the other.

Abstract Specification by central government of the heating levels which are to be maintained in British school buildings has recently been altered. This paper is concerned with examining the nature of changes that have been made by comparing present requirements with their counterparts during the preceding one hundred years. Attention is focused on the apparently contradictory implications of these changes for those charged with responsibility for maintaining heating levels in school buildings while, at the same time, conserving fuel. It is suggested that the new statutory requirements present those who are responsible with a duty which may, in practical terms, prove difficult or costly to discharge. Although discussion is specifically restricted to British school buildings, issues are raised which are pertinent to attempts to integrate regulation of heating with control of fuel consumption in other types of non-domestic buildings both in Britain and abroad.

Abstract The housing growth programme could offer an opportunity for accelerating the deployment of decentralised renewable energy systems (DRES) in the UK. The Government hopes to leverage private sector investment into DRES as part of new housing projects. The aim of this paper is to assess whether current regulatory and funding frameworks are sufficient to achieve this. The question is explored by drawing on the experience of developers, local authorities, energy utilities and service companies operating in the largest housing growth region in the UK–Thames Gateway. Their experience suggests that the current low intervention approach will be insufficient to generate the shift required in both industries. In order to be more successful economic and regulatory instruments should focus on producers (house-builders and energy providers) rather than consumers (households). Tighter regulation is needed to ensure that producers have a responsibility to install DRES as part of new developments, to enable connection to the grid, to ensure a sustained financial return from investment and revenue is spent on the expansion of new renewable energy infrastructure. This regulatory framework must be under-pinned by substantial funds focused on producers. Greater intervention is needed if DRES is to be included in new housing development.

Abstract Post-combustion solvent-based carbon capture is a promising technology that potentially can offset the greenhouse gas emissions from fossil-driven power generation systems. The challenge is that CO2 absorption (similar to other CCS technologies) imposes energetic penalties, and constrains the operational flexibility. In this paper, we build upon our recent contributions in the field (Sharifzadeh et al., 2016; Sharifzadeh and Shah, 2016), and study the dynamic response of such process to the electricity load changes in the power plant. The key research question is to investigate if the steady-state integrated process design and control framework applied in the previous studies, can also ensure controllability under a wide range of disturbances. The present study considers the mutual interactions between the power plant and capture process. Other features of interest include the implications of key design and operational decisions such as reboiler temperature, solvent circulation flow rate, solvent concentration and the rate of power load change or CO2 setpoint tracking for flexible process operation. The results suggest that the capture process exhibits a high degree of flexibility and the integrated design and control framework could be the key enabler for the commercialization of post-combustion solvent-based carbon capture.

Abstract Decentralised energy in the UK is rare. Cities in the north of England however lead the UK in terms of sustainable, low-carbon, local/district heating, through the implementation of combined-heat-and-power (CHP) facilities; substantial schemes are installed in several cities, including Barnsley and Sheffield. This paper presents the results from extensive experimental and theoretical feasibility studies, in which the merits of these were explored. Barnsley has a number of biomass-fuelled community energy generators, where pollutant monitoring and mathematical modelling were conducted to assess combustion characteristics and overall system performance. Measured pollutant levels were within the relative emission limits, though emission concentrations (CO, CO2, NO and particles) in the flue gas from the coal boiler were higher than the wood pellet boiler. Sheffield already has a citywide district energy network, centred around a sustainably-sourced waste-to-energy facility; an expansion of this scheme was investigated here. This focuses mainly on the link to a 30 MW wood-fired CHP plant, which could be a significant provider of additional thermal capacity (low-grade heat) to an expanded network. Through identifying heat sources and sinks – potential suppliers and end-users – key areas were identified where a connection to the heat network would be feasible.

This study builds a holistic, transparent life cycle assessment model of a variety of aqueous mineral carbonation processes using a hybrid process model and economic input–output life cycle assessment approach (hybrid EIO-LCA). The model allows for the evaluation of the tradeoffs between different reaction enhancement processes while considering the larger lifecycle impacts on energy use and material consumption. A preliminary systematic investigation of the tradeoffs inherent in mineral carbonation processes is conducted to provide guidance for the optimization of the life-cycle energy efficiency of various proposed mineral carbonation processes. The life-cycle assessment of aqueous mineral carbonation suggests that a variety of alkalinity sources and process configurations are capable of net CO2 reductions. The total CO2 storage potential for the alkalinity sources considered in the U.S. ranges from 1.8% to 23.7% of U.S. CO2 emissions, depending on the assumed availability of natural alkalinity sources and efficiency of the mineral carbonation processes.