• Energy Research
• Open Access close
• Restricted close
• engineering and technology close
• RU close
• UA close
• EC close

The most severe failures in power grids are often characterized as cascading failures where an initial event triggers consequent failures all along the grid often leading to blackouts. Upon identifying a failure and its cascade potential, timely control actions should be performed by the grid operators to mitigate the effect of the cascade. These actions have to be delivered to one or more control devices, creating a dependency between the power grid and its control network. This paper examines the dependency of the operation of the power grid on the control network. Different from literature studies on failure control, our dependency model captures the impact of networking parameters. We formulate an algorithmic model that describes the impact of this dependency on cascade control. Based on this model, we propose an efficient cascade control algorithm using load shedding with consideration of delays in the communication network for power grids. Finally, we evaluate the impact of the power-communication network dependency with uncontrolled grids, ideal/simple control grids and our proposed control scheme. The results demonstrate that the proposed algorithm can significantly reduce the failure of power lines while sustaining larger power demand for users.

This paper reports the generalized results of computer simulation of physical processes at a rotor-disk film evaporating plant. Optimization of the operation mode cannot be achieved without establishing patterns in the course of physical processes. We have proposed a computer model of hydrodynamics that accounts for all the features, initial and boundary conditions. The results of computer simulations make it possible to adequately assess the effectiveness of using a rotor-disk film evaporating plant (RDFVP) for the concentration of heat-labile materials. We have established patterns in the course of physical processes within a structure of RDFVP by using computer simulation of hydrodynamics in the programming environment ANSYS and applying a k-e turbulence model. The result of simulation is the derived velocity fields of the concentrated fluid (w max =0.413 m/s) and the gas phase (w max =8.176 m/s), as well as the magnitude of values for shear stress τ=0.94·10 -6 Pa. It was established that the gas heat-carrier is characterized by the highly-turbulent flows with maximum values for kinetic energy TKE max =8.985·10 -1 m 2 /s 2 . The reliability of results is ensured by the correctness, completeness, and adequacy of physical assumptions when stating the problem and while solving it using the computer aided design system ANSYS. It has been established that the proposed structure is an effective alternative to equipment for the concentration of solutions. The data obtained could be used when designing heat-and-mass-exchange equipment for the highly efficient dehydration of thermolabile materials

The problems of environmental pollution in the conditions of high dust content in the air during the development of coal mines in the territory of the Czech Republic are considered. A mechanism for making managerial decisions was developed using an integrated approach using the new technological process Nastup Tušimice (DNT) aimed at eliminating pollutant emissions and managing workers in dusty conditions in mining operations. The recommendations of active and passive measures aimed at reducing dustiness in the process of coal mining have also been developed.

The paper investigates the local thickness distribution of a wall liquid film in a curvilinear channel. The research technique on experimental water-air stand with a curvilinear working channel is described. The results of measurements of the local thickness of the liquid film on the upper and lower walls of the channel for two flow velocities are obtained at various flow rates. © Published under licence by IOP Publishing Ltd. This work was supported by the grant Russian Foundation for Basic Research No. 17–38–50069.

Bridges in Ukraine are one of the most important components of the infrastructure, requiring attention from government agencies and constant funding. The object of the study was the methodology for quantifying the condition of bridge components. The Artificial Neural Network-based (ANN) tool was developed to quantify the technical condition of bridge components. The literature analysis showed that in most cases the datasets were obtained during the inspection of bridges to solve the problems of assessing the current technical condition. The lack of such a database prompted the creation of a dataset on the basis of the Classification Tables of the Operating Conditions of the Bridge Components (CT). Based on CTs, five datasets were formed to assess the condition of the bridge components: bridge span, bridge deck, pier caps beam, piers and abutments, approaches. The next step of this study was creating, training, validating and testing ANN models. The network with ADAM loss function and softmax activation showed the best results. The optimal values of MAPE and R2 were achieved at the 100th epoch with 64 neurons in the hidden layer and were equal to 0.1% and 0.99998, respectively. The practical application of the ANN models was carried out on the most common type of bridge in Ukraine, namely, a road beam bridge of small length, made of precast concrete. The novelty of this study consists of the development of a tool based on the use of ANN model, and the proposal to modify the methodology for quantifying the condition of bridge components. This will allow minimizing the uncertainties associated with the subjective judgments of experts, as well as increasing the accuracy of the assessment.

Introduction. The article presents an analysis of researches on the operation of public transport vehicles with an electric drive. Electric buses have been tested in megacities, and despite the advantages, problems were identi- fied both in the selection of the charging type, technological features and with the availability and operation of the charging infrastructure. The operation process is associated with a number of technical restrictions, which in prac- tice make it difficult to select routes for the electric bus operation. The aim of the study is to develop an algorithm for selecting a rational regular urban route for the electric bus operation and to test it on the example of the route network of Tyumen.Materials and methods. A structural diagram of the factors influencing the selection of the route for the electric bus operation has been formed. As a result of processing expert assessments, the most significant factors were identified. The diagram of the interconnections of these factors is identified and limitations for the algorithm are for- mulated based on the theory of systems analysis. The algorithm for selecting the rational regular urban route for the electric bus operation has been developed. It enables creating the simulation model for selecting a rational regular urban route for the operation of an electric bus.Results. The diagram of factors influencing the selection of a rational regular urban route for the operation of an electric bus, taking into account their mutual relations, has been formed. The algorithm and simulation model for se- lecting a rational regular urban route for the operation of an electric bus has been developed. Several urban routes in Tyumen were assessed for the rationality of the introduction of electric buses.Discussion and conclusions. Evaluation of five regular urban routes in Tyumen using the developed algorithm and the simulation model revealed three rational routes, and also showed the inefficiency of the other two. It due to the discrepancy between the duration of the charging session and breaks in operation, as well as the insufficient charge level of the traction battery to ensure the required autonomous movement of the vehicle. In the course of the continuation of these studies, the developed algorithm will be supplemented with the stage of economic assess- ment of routes for the operation of electric buses.

The research deals with the issue of slums, urban sprawl on agriculture land and its impact on the city of Baghdad. This topic needs close attention because it has become a problem facing the city of Baghdad through recruiting agricultural lands and converting them to residential homes in addition to the transgression on the state lands and building abuses. This research deals with the causes of slums, irregular urban sprawl and risks of excesses on land uses of land in Baghdad. In this research, we try to know the extent to which these problems have affected the city of Baghdad. The research methodology based on the descriptive methodology to clarify the factors affecting urban sprawl at the expense of agricultural land, using studies in government and service institutions and images from satellites to clarify the size of urban sprawl over periods after the 2003 war. Finally, a conclusion and future solutions were set to solve these problems.

The moisture origins and associated physical mechanisms for tornadoes of various climatic regions of the United States were investigated. The NOAA Air Resources Laboratory HYSPLIT model and a moisture attribution algorithm were used in conjunction with statistical analyses to explore these relationships on a climate scale (1981–2017). It was found that moisture sources of United States tornadic convection exhibit distinctive regionality. For example, moisture contributions to east coast tornadoes primarily emanate from the Atlantic Ocean as opposed to the Gulf of Mexico. Moisture sources of a class of non-significant severe thunderstorms also show regionality based on the location of storm occurrence with latitudinal differences to that of tornadic storms. Moisture increases for tornadic and non-significant severe storms were shown to be closely related to the respective air parcel's temperature, with underlying sea surface temperatures playing a less important role. Long-term trends of moisture uptake and horizontal advection were also explored using the Mann-Kendall test and linear regressions. Both statistical analyses demonstrate that the magnitude of advective fluxes and the rate of moisture increases have been rising since the 1980s, which can increase the complexity of forecasting downstream convection. The potential ramifications of these trends on storm development and prediction are discussed to conclude the article.