• Energy Research
• 12. Responsible consumption close
• 11. Sustainability close
• UA close
• Russian close

The analysis of scientific works shows that the development of technology is ahead of the level of development of energy management. There are no clear comparisons of the energy efficiency of electrical technologies and heat technologies. Objective indicators of energy efficiency in various technologies of dehydration of raw materials not developed yet. In that article assumed that objective results for comparing energy efficiency in the processing of raw materials is obtained by the basis of system analysis of the entire energy conversion chain from fuel to finished product. The purpose of the work is experimentally proving the objectivity of this hypothesis. To achieve this goal, it is proposing to use the indicator of the energy share of fuel in the finished product and the amount of moisture removed when burning 1 kg of fuel, which does not depend on fluctuations in energy prices, which can vary and differ for different countries. The most important result of the work is the comparison of these parameters with the data for innovative equipment samples developed by the authors. The significance of the results obtained is that the evaporating devices developed by the authors are not inferior in efficiency to traditional ones, and make it possible to obtain concentrates up to 90 ° brix. Thus, for fuels with an oil equivalent of 40 MJ per 1 kg, traditional dryers can remove no more than 3 kg of moisture, cryoconcentrators – 20 kg.

The article considers mathematical approach to environmental quality management to improve the ecological comfort of living for the population. The problem of environmental management is described using a multi-factor model of quality of the environment with the weight coefficients of the importance of its components: atmospheric air, acoustic impact, soil, water resources, and green spaces, accessibility of natural and recreational areas. The values of weight coefficients of importance of influencing factors for environmentally comfortable living are determined by the method of expert assessment. A multi-factor model is used for detailed assessment of the ecological quality of the urban environment. The proposed quantitative approach also allows to compare the environmental comfort of the different residential districts or to study the dynamics of environmental comfort of specific urban area. Much attention is paid to scientific and methodological principles of management and the formation of the concept of «environmental quality». The strategy of environmental management with ecological foundation of various practical solution is shown. The plan of measures on organization of optimal management of quality of the environment to improve comfort of living for the population of the residential microdistrict of Tiraspol is presented. Graphical scheme of the results of integral analysis of various environmental indicators and assessments for improving the comfort of the environment is given. Realization of environmental quality management of the urban areas on the basis of a multi-factor model contributes to the gradual change of dangerous ecological conditions of environmental factors, to increase a comfort of the territory taking into account the real preferences and needs of the population.

The issues of improving the efficiency of methanol usage as a promising marine power plant fuel with low carbon content are discussed. The main aim of the research is an analysis of characteristics of advanced marine gas turbine power plants with the combined thermodynamic and thermochemical regeneration of waste heat. The possible methanol conversion at the expense thermochemical heat regeneration of marine engines recoverable resources has been revealed. The analysis of parameters influences of the waste heat recoverable resources, as well as restrictions related to the engine system of gas fuel injection, on the efficiency of methanol conversion has been carried out. It was demonstrated that the simulation of methanol steam conversion processes results in the pressure increase in the reactor, which, in its turn, causes a shift of conversion efficiency process towards higher temperature area. The calculation scheme of steam injection gas turbine plant with the joint thermodynamic and thermochemical regeneration of waste heat is demonstrated. The results of mathematical simulation of the processes in regeneration plant under the 3.4 MW constant capacity and heat exchanger thermal ratio of 0.85 were obtained. The cycle optimization has been based on the efficiency of plant under the conditions of variation of water/methanol ratio and gas temperatures in thermochemical regenerator. The efficiency increase constituted 4% relative to characteristics of the base engine operating on methanol. The estimation of carbon content in produced syngas has shown that thermochemical regeneration of methanol conversion by using the waste heat can reduce the energy efficiency by 1.5 times.

The aim of this article was to analyze the profitability of using a multi-motor electric drive instead of a single-motor electric drive in a city vehicle to ensure the reduction of the electrical energy losses. To achieve the goal a mathematical model was used to calculate the energy losses in the singlemotor and multi-motor electric drives of a bus with a different number of traction induction motors. The calculation was carried out for the steady-state driving modes with different speeds and transient acceleration modes. The change in the load torque of the vehicle's motors due to the change in the rolling friction force of the wheels with a different number of passengers carried was taken into account. The novelty of the work is that the use of a multi-motor electric drive shown for the first time allowed the reduction in the energy losses in the traction induction electric motors when the vehicle is moving at a constant speed and during acceleration with a different number of passengers carried. Moreover, to obtain energy saving, the number of motors used in a multi-motor electric drive should vary depending on the speed and acceleration, as well as on the total load torque of the multi-motor drive. The formula was obtained analytically for the calculation of the number of motors of a multi-motor electric drive, which would ensure energy saving compared to a single-motor electric vehicle.

The market trends of food products of long-term storage, instant cooking and functional purpose are analyzed. The problems of energy technologies for the production of such concentrates were identified. The aim of the study is to develop energy technology systems that guarantee a high degree of raw material target components preservation during energy costs reducing. To achieve this aim the hypotheses of the implementation of innovative projects, based on the technology of address energy delivery to the elements of food raw materials were formulated. Physical, parametric and mathematical models of evaporators and dryers with electromagnetic energy sources were presented. The results of a study of the drying kinetics on a belt plant with combined infrared and microwave generators were analyzed. The most significant results of the work are: mathematical models of heat and mass transfer processes under the electromagnetic energy action, a complex of kinetic dependences during plant material drying, samples of innovative equipment for dehydration of food raw materials using microwave and infrared energy sources. The significance of the obtained results lies in the fact that energy-intensive drying is excluded from traditional technologies for the concentrate production. Implementation of innovative projects for the concentrate production from food raw materials in the extractors and evaporators reduces energy expenditures by 1.5–2 times from 39.5 MJ per kg of removed moisture to 11.4 MJ. High quality products are ensured, since more than 80% of the volatile aromatic and flavoring compounds that are lost in the spray dryer are fully preserved.