• Energy Research
• other engineering and technologies close
• US close
• GB close
• BE close

The classical approach to load modeling is to divide the load by customer class and then identify and model the load components corresponding to each customer class. This work explores an alternative way to break down the load using readily available data. Namely, using historical usage data and historical weather data the load can be first divided into temperature-dependent and temperature-independent portions. A simple thermal model of the structure(s) served by the electrical circuit forms the theoretical and mathematical basis of this separation. During summer peaking conditions, the temperature-dependent load is generally composed of air conditioners, which must be modeled properly in order to analyze delayed voltage recovery or other dynamic phenomenon. Once the temperature-dependent fraction of the load has been characterized, the size of compressor, fan, and pump motors can be inferred by the customer class.

The hydraulic balance of heating network is considered as a pre-condition for the implementation of low temperature district heating (LTDH). Its imbalance result into high energy consumption and heat-losses in the network. In this study, a novel hydraulic model is presented which investigates hydraulic imbalance in the LTDH network, using real weather and hourly monitored operational heating data from an existing boiler based building. Analysis of delta t in space-heating system shows that the delta t is maximum when the outside air temperature is lowest and it decreases with increase in outside air temperature. Furthermore, the hydraulic imbalance is analysed for four different control scenarios with the aim to find an optimum scenario with minimum pumping power, energy consumption and heat-losses in the LTDH network. Results show that the hydraulic imbalance is due to the absence of flow-limiters and balancing valves on the return pipe and thermostatic radiator valves (TRVs) alone are unable to maintain hydraulic balance in the space-heating system of buildings. Moreover, the control scenario with variable flow-rate and fixed supply water temperature from the sub-station is found to be optimum. Compared to the constant flow-rate scenario, the pumping power, energy consumption and heat-losses in the LTDH network are reduced by approximately 2%, 63% and 14%, respectively.

Improving access to sustainable energy services and reducing the carbon footprint and deforestation of developing countries presents a substantial challenge to the development industry. This paper aims to critically assess two prevalent business models emerging to meet this challenge: financial institution–technology provider partnerships and the one-stop-shop, pay-as-you-go (PAYG) model. The authors find that collaborations between financial institutions and energy providers need to address grey areas such as product quality standards, marketing, and post-sales services, and incorporate feedback loops to continually evaluate the performance of the partnership. Pay-as-you-go presents an intriguing business case to leapfrog more traditional energy access programmes. However, more robust results from the field need to be reported before the PAYG movement can claim success. Ultimately, collaborative and integrated actions by all stakeholders are needed to achieve universal energy access.

The steady-state phase distribution and the structural parameters have been taken as the input for the nuclear physics calculation in the ADS windowless spallation target. The distribution of the extreme large power density of the heat load is imported back as the source term in the energy equation. Then temperature distribution is obtained based on the flow process and heat transfer. The preliminary results show that the temperature distribution reaches the steady-state and its shape is like the broken wings of the butterfly. This is very important for the further design and optimization of the ADS windowless spallation target. So the two-way coupling simulation of the heat transfer process is successfully performed between the computational fluid dynamics and the nuclear physics simulation.

Recent geomorphic evidence from the inner shelf and shoreface to the east of Long Island's barrier island system indicates that reworking of glacial outwash deposits at the inner shelf-shoreface transition, as sea level rises, may be supplying much of the sediment needed to maintain barrier islands to the west. A conceptual model describing sediment dispersal from outwash source areas was developed from this hypothesis. It was reasoned that outwash sediments ranging from silts to coarse gravels would be subject to differential transport paths across and along the shoreface upon reworking. Coarser grain sizes would move onshore toward the intertidal beach, whereas finer sediments would move offshore. Sand of intermediate grain size would be concentrated in the surf zone an move alongshore in wave-generated longshore currents. To test this model, 400 samples from the beach and shoreface of Long Island were analyzed for grain-size frequency distribution and each grain-size class was examined for frequency of occurrence in the cross-shore and alongshore directions. On a spatially averaged basis, grain-size classes displayed peak abundance in specific zones across the shoreface as predicted by the model, but alongshore trends could not be recognized among the "noisy" data. Therefore, empirical orthogonal functions (EOF) were used to examine uncorrelated (orthogonal) modes of variability in the occurrence of each grain-size class in the alongshore direction. The first function, representing more than 60% of the variability among the data, showed that grain sizes subject to longshore transport in the surf zone i crease in frequency in the alongshore direction relative to coarser grain sizes. Results also show that peak concentrations of coarse sediments correspond to zones subject to frequent overwashing. It is concluded that EOF analysis of individual grain-size classes holds promise for extracting trends from noisy data sets. End_of_Article - Last_Page 318------------

In this study, feasibility of selected nutrient sequestration during hydrothermal carbonization (HTC) was tested for three different HTC temperatures (180, 230, and 300 °C). To study the nutrient sequestration in solid from liquid solution, sugar and salt solutions were chosen as HTC feedstock. Glucose was used as carbohydrate source and various salts e.g., ammonium hydrophosphate, potassium chloride, potassium sulfate, and anhydrous ferric chloride were used as source of nitrogen and phosphorus, potassium, and iron, respectively. Solid hydrochar was extensively characterized by means of elemental, ICP-OES, SEM-EDX, surface area, pore volume and size, and ATR-FTIR to determine nutrients’ sequestration as well as hydrochar quality variation with HTC temperatures. The spherical mesoporous hydrochars produced during HTC have low surface area in the range of 1.0–3.5 m2 g?1. Hydrochar yield was increased about 10% with the increase of temperature from 180 °C to 300 °C. Nutrient sequestration was also increased with HTC temperature. In fact, around 71, 31, and 23 wt% nitrogen, iron, and phosphorus were sequestered at 300 °C, respectively. Potassium sequestration was very low throughout the HTC and maximum 5.2% was observed in solid during HTC.

Electric power planners in developing countries have the opportunity to anticipate air conditioning-induced demand peaks, rather than merely react to them, as has happened in the United States. Demand-side management activities targeting future air conditioning installations therefore may be warranted, based on economic efficiency considerations, the U.S. experience, and worldwide trends in air conditioning usage. The feasibility of such anticipatory efforts is likely to hinge on local parameters, including domestic energy supplies, foreign exchange and capital constraints, rates of load growth, evidence of impacts on load profiles, and familiarity with demand-side planning concepts.

A mathematical model of the LiAl/LiCl, KCl/FeS cell has been used to study the behavior of the system during relaxation and charging. The effects of state of charge, cell temperature, and current density are presented, and the influence of a period of relaxation on the subsequent charging operation is investigated. In addition, factors that can have a significant impact on the charging characteristics are identified.

Short-term generation scheduling is an important function in daily operational planning of power systems. It is defined as optimal scheduling of power generators over a scheduling period while respecting various generator constraints and system constraints. Objective of the problem includes costs associated with energy production, start-up cost and shut-down cost along with profits. The resulting problem is a large scale nonlinear mixed-integer optimization problem for which there is no exact solution technique available. The solution to the problem can be obtained only by complete enumeration, often at the cost of a prohibitively computation time requirement for realistic power systems. This paper presents a hybrid algorithm which combines Lagrangian Relaxation (LR) together with Evolutionary Algorithm (EA) to solve the problem in cooperative and competitive energy environments. Simulation studies were carried out on different systems containing various numbers of units. The outcomes from different algorithms are compared with that from the proposed hybrid algorithm and the advantages of the proposed algorithm are briefly discussed.