• Energy Research
• 7. Clean energy close
• US close
• DE close
• ES close

The ‘4 per mille Soils for Food Security and Climate’ was launched at the COP21 with an aspiration to increase global soil organic matter stocks by 4 per 1000 (or 0.4 %) per year as a compensation for the global emissions of greenhouse gases by anthropogenic sources. This paper surveyed the soil organic carbon (SOC) stock estimates and sequestration potentials from 20 regions in the world (New Zealand, Chile, South Africa, Australia, Tanzania, Indonesia, Kenya, Nigeria, India, China Taiwan, South Korea, China Mainland, United States of America, France, Canada, Belgium, England & Wales, Ireland, Scotland, and Russia). We asked whether the 4 per mille initiative is feasible for the region. The outcomes highlight region specific efforts and scopes for soil carbon sequestration. Reported soil C sequestration rates globally show that under best management practices, 4 per mille or even higher sequestration rates can be accomplished. High C sequestration rates (up to 10 per mille) can be achieved for soils with low initial SOC stock (topsoil less than 30 t C ha− 1), and at the first twenty years after implementation of best management practices. In addition, areas which have reached equilibrium will not be able to further increase their sequestration. We found that most studies on SOC sequestration only consider topsoil (up to 0.3 m depth), as it is considered to be most affected by management techniques. The 4 per mille number was based on a blanket calculation of the whole global soil profile C stock, however the potential to increase SOC is mostly on managed agricultural lands. If we consider 4 per mille in the top 1m of global agricultural soils, SOC sequestration is between 2-3 Gt C year− 1, which effectively offset 20–35% of global anthropogenic greenhouse gas emissions. As a strategy for climate change mitigation, soil carbon sequestration buys time over the next ten to twenty years while other effective sequestration and low carbon technologies become viable. The challenge for cropping farmers is to find disruptive technologies that will further improve soil condition and deliver increased soil carbon. Progress in 4 per mille requires collaboration and communication between scientists, farmers, policy makers, and marketeers.

Abstract Social acceptance of innovative technologies is a key element of an effective transition towards more sustainable energy economies. However, innovative technologies like genetic modification also tend to spark controversy and backlash. So far, efforts to inform the public about any risks and benefits of novel technologies not only have struggled to foster acceptance but also neglect the interdependent foundations of consumer decision-making. Through a controlled experiment with German consumers (N = 322), we examine whether consumer support and rejection of genetic modification in bioenergy crops is influenced by the statements and actions of actors throughout the supply chain. In specific, we show that the decision of energy companies to sell and support GM bioenergy positively impacts consumer decisions to support. To ensure that decision outcomes were specifically impacted by the expressions of corporate actors, we controlled for the content and valence of information by random assignment to one of three treatments in which participants received positive, negative, or balanced (risks and benefits) information. We find that negative messaging diminished support and increased rejection relative to the other treatments. Lastly, the statements and actions of corporate actors also exerted an indirect influence on consumer decisions through their interactions with social trust and labels, e.g. greater support by farmers had a positive influence only for those who are more generally trustworthy. Given these results, we anticipate more attention to the importance of actors such as farmers and energy companies for the social acceptance of novel technologies in the energy sphere.

Abstract New techniques for emissions reduction and energy efficiency are important challenges of the steel industry. Although great advantages have been reached in these fields, there are still new opportunities. One of them is the possible development of systems to recover energy from slags. The recent policies that encourage the use of renewable and alternative energies determine a favorable scenario for the development of new techniques of heat recovering. In this context, this article presents a new heat recuperation system for the slags produced in the factories of Arcelor–Mittal in Asturias (Spain) and study in detail the design of an innovative slags heat exchanger. To adjust its performance and to determine the influence of the geometric and flow design parameters, the heat exchanger has been simulated using numerical analysis software (CFD).

1.0 Introduction The residential module implements the following end uses and characteristics to simulate the power demand in a single family home: • Water heater • Lights • Dishwasher • Range • Microwave • Refrigerator • Internal gains (plug loads) • House (heating/cooling loads) The house model considers the following four major heat gains/losses that contribute to the building heating/cooling load: 1. Conduction through exterior walls, roof and fenestration (based on envelope UA) 2. Air infiltration (based on specified air change rate) 3. Solar radiation (based on CLTD model and using tmy data) 4. Internal gains from lighting, people, equipment and other end use objects. The Equivalent Thermal Parameter (ETP) approach is used to model the residential loads and energy consumption. The following sections describe the modeling assumptions for each of the above end uses and the details of power demand calculations in the residential module.

The operation of a building connects the building, its performance and its end-users. When a mismatch occurs between users' expectations and operations processes, then complaints can arise. The use of enhanced complaint handling processes is investigated to ascertain whether this can help diagnose performance problems. Two LEED Platinum-rated office buildings form the basis for a case study of the components that make up an enhanced complaint handling process. Some of the social dynamics of complaints in buildings are consequently discussed. It is found that an enhanced complaint handling approach could contribute to a form of ongoing commissioning that goes beyond primarily reactive or dismissive treatments of complaints. Le fonctionnement d'un immeuble etablit des rapports entre l'immeuble, ses performances et ses utilisateurs finaux. Lorsqu'un decalage se produit entre les attentes des utilisateurs et les processus d'exploitation, des plaintes peuvent alors s'elever. L'utilisation de processus ameliore...

This work evaluates, for the first time, the possibility of producing multifunctional alkali-activated composites combining ultra-low density, low thermal conductivity, high acoustic absorption, and good moisture buffering capacity. The composites were prepared using cork as a lightweight aggregate. This novel material might promote energy savings and tackle the CO2 emissions of the building sector, while simultaneously improve the comfort for inhabitants (e.g. humidity levels regulation and sound pollution reduction). The composites apparent density (as low as 168 kg/m3) and thermal conductivity (as low as 68 mW/m K) are amongst the lowest ever reported for alkali-activated materials (AAM) composites and foams, while their sound absorption ability is comparable to the best performing AAM foams reported to date, but in addition these eco-friendly composites also show good ability to passively adjust the humidity levels inside buildings. The multifunctional properties shown by the cork – AAM composites set them apart from other conventional building materials and might contribute to the global sustainability of the construction sector. Peer Reviewed