• Energy Research
• US close
• IN close
• AU close

AbstractLichtablenkungseffekte können bei der interferometrischen Beobachtung von Grenzschichten zu großen Fehlern bei der Ableitung der Konzentrationsprofile führen, sofern nicht Korrekturen bei der Interpretation vorgenommen werden.

Abstract. The impact of multiphase reactions involving nitrogen dioxide (NO2) and aromatic compounds was simulated in this study. A mechanism (CAPRAM 2.4, MODAC Mechanism) was applied for the aqueous phase reactions, whereas RACM was applied for the gas phase chemistry. Liquid droplets were considered as monodispersed with a mean radius of 0.1 µm and a liquid content (LC) of 50 µg m-3. The multiphase mechanism has been further extended to the chemistry of aromatics, i.e. reactions involving benzene, toluene, xylene, phenol and cresol have been added. In addition, reaction of NO2 with dissociated hydroxyl substituted aromatic compounds has also been implemented. These reactions proceed through charge exchange leading to nitrite ions and therefore to nitrous acid formation. The strength of this source was explored under urban polluted conditions. It was shown that it may increase gas phase HONO levels under some conditions and that the extent of this effect is strongly pH dependent. Especially under moderate acidic conditions (i.e. pH above 4) this source may represent more than 75% of the total HONO/NO2 - production rate, but this contribution drops down close to zero in acidic droplets (as those often encountered in urban environments).

A promising technology for renewable energy is energy piles used to heat and cool buildings. In this research, the effects of bio-cementation via microbially induced calcite precipitation (MICP) using mixed calcium and magnesium sources and the addition of fibres on the thermal conductivity of soil were investigated. Firstly, silica sand specimens were treated with cementation solutions containing different ratios of calcium chloride and magnesium chloride to achieve maximum thermal conductivity improvement. Three treatment cycles were provided, and the corresponding thermal conductivity was measured after each cycle. It was found that using 100% calcium chloride resulted in the highest thermal conductivity. This cementation solution was then used to treat bio-cemented soil samples containing fibres, including polyethylene, steel and glass fibres. The fibre contents used included 0.5%, 1.0% and 1.5% of the dry sand mass. The results show that the glass fibre samples yielded the highest thermal conductivity after three treatment cycles, and SEM imaging was used to support the findings. This research suggests that using MICP as a soil improvement technique can also improve the thermal conductivity of soil surrounding energy piles, which has high potential to effectively improve the efficiency of energy piles.

We have investigated the microelectrical properties of CdTe thin films using scanning Kelvin probe force microscopy (SKPFM) and scanning spreading resistance microscopy (SSRM). Two films with the configurations of substrate and superstrate were subjected to the characterization studies. The electrical potential and resistance were properly mapped with the substrate film but not with the superstrate film because the underlying CdS/CdTe junction largely impacted the characterizations. The higher SKPFM potential on grain boundaries (GBs) of the substrate film than on the grain surface indicates positively charged GBs and upward band bending around the GB; therefore, the GBs are either depleted or inverted. The SSRM resistance mapping on this film shows nonuniformities and features that are associated with the grain structure and facets. However, the GBs do not exhibit distinct characteristic resistance. Comparing the low resistance channel along the GBs of high-performance CIGS films, the SSRM mapping of CdTe supports depletion of the GBs. In SSRM measurement, it is critical to adequately indent the probe to the film, and to apply a bias voltage larger than the onset voltage of the probe/film barrier, so that the contact resistance is minimized and that the local spreading resistance of CdTe film beneath the probe is measured.

Abstract The increasing energy demand in developing countries has jeopardised energy security, necessitating the employment of solar energy to augment conventional energy sources. It is important to assess the annual performance parameters of solar power plants to understand its place in energy generation. This study analyses the performance and economic viability of a large-scale solar power park located in India. A 50 MWp Solar Photovoltaic Power Park (SPPP) located at Sakunala, in the State of Andhra Pradesh, is one of the largest solar power park in India, and the site receives an average solar radiation of 5.5–6.0 kWh/m2/day. The design, performance analysis, economic feasibility, and greenhouse gas mitigation of the 50 MWp SPPP is presented. The energy yields, performance ratio (PR), capacity utilization factor (CUF), and losses are assessed based on the IEC 61724 standards for two consecutive years (2018–2019 and 2019–2020). The performance results obtained are compared with the PVsyst simulation results. The PR, CUF, and energy yields are estimated as 0.779, 0.24, and 107,326.4 MWh in 2018–2019 and 0.691, 0.22, and 96,707.336 MWh in the year 2019–2020, respectively. The PVsyst simulator evaluates the PR, CUF, and energy yields as 0.80, 0.24, and 106,022 MWh, respectively. Further, the effect of power curtailment policies on solar PV projects is also discussed and the effect of curtailment policy on the economy of the solar power park in terms of payback period and emissions are analysed. The performance of the SPPP is also compared with those of other PV plants installed all over the world.

Chromium (Cr) exposure during gestation causes malformations in animal experiments. In this multicenter case-control study, we initially involved 130 orofacial clefts (OFCs) and 260 controls to assess the association between Cr concentration and risk for OFCs. Then, umbilical cord serum (49 vs. 119) and cord tissue (84 vs. 142) were used to validate the association between Cr and OFCs. We found that maternal serum Cr concentrations in OFC cases were significantly higher than those in controls. Compared with the lowest tertile of maternal serum Cr concentration, the highest tertile of Cr increased the risk for OFCs [OR = 2.14 (1.14-4.05)]. In the validation cohort of umbilical cord serum and tissue, higher concentrations of Cr were associated with increased risks for OFCs in a dose-dependent manner (all Ps for trends <0.05). Cr concentrations in maternal serum and cord serum showed a positive correlation. The Cr concentration in cord serum was inversely correlated with egg and milk consumption frequencies, and the Cr concentration in cord tissue was positively associated with indoor coal burning. In conclusion, prenatal Cr exposure is a risk factor for OFCs, and indoor coal burning during pregnancy may be one of the sources of Cr exposure.