• Energy Research
• Restricted close
• Embargo close
• natural sciences close

AbstractThe protic ionic liquid (PIL) N‐butylimidazolium trifluoromethanesulfonate ([BIm][TfO]) was obtained for the first time and incorporated into a sol–gel‐derived di‐ureasil matrix with a concentration of X=5, 10, and 30 %, where X is the ratio of the mass of PIL per mass of poly(oxyethylene). Four years after their synthesis, the resulting quasi‐anhydrous electrolytes remained amorphous, homogeneous, flexible, and thermally stable below 200 °C. SEM/EDS data revealed the presence of the PIL at the surface of the xerogels with X>5 %, demonstrating that this type of morphological characterization is mandatory to avoid misleading ionic conductivity values. The highest ionic conductivity was produced in the washed sample with X=30 % (3.5×10−5 and 2.1×10−3 S cm−1 at 25 and 170 °C, respectively). The present family of electrolytes yielded higher conductivities than the N‐ethylimidazolium trifluoromethanesulfonate‐based analogues introduced earlier by our group and may thus be considered as promising candidates for applications in fuel cells.

The anaerobic digestion of outdoor cultivated Rhizoclonium biomass was investigated in this study. The influence of applying mechanical and biological pre-treatment methods prior to the biomass digestion on the overall methane yields was examined. The results show that the application of a combined biomass blending ( 20% compared to use of a mechanical size reduction method alone. The methane yields from Rhizoclonium biomass were however observed to be considerably lower than those of other algae species from the literature.

Sustainability is commonly assessed along environmental, societal, economic and technological dimensions. A crucial aspect of sustainability is that inter-generational equality must be ensured. This requires that sustainability is attained in the here and now as well as into the future. Therefore, what is perceived as 'sustainable' changes as a function of societal opinion and technological and scientific progress. A concept that describes the ability of systems to change is adaptive capacity. Literature suggests that the ability of systems to adapt is an integral part of sustainable development. This paper demonstrates that indicators measuring adaptive capacity are underrepresented in current urban water sustainability studies. Furthermore, it is discussed under which sustainability dimensions adaptive capacity indicators are lacking and why. Of the >90 indicators analysed, only nine are adaptive capacity indicators, of which six are socio-cultural, two technological, one economical and none environmental. This infrequent use of adaptive capacity indicators in sustainability assessments led to the conclusion that the challenge of dynamic and uncertain urban water systems is, with the exception of the socio-cultural dimension, not yet sufficiently reflected in the application of urban water sustainability indicators. This raises concerns about the progress towards urban water systems that can transform as a response variation and change. Therefore, research should focus on developing methods and indicators that can define, evaluate and quantify adaptive capacity under the economic, environmental and technical dimension of sustainability. Furthermore, it should be evaluated whether sustainability frameworks that focus on the control processes of urban water systems are more suitable for measuring adaptive capacity, than the assessments along environmental, economic, socio-cultural and technological dimensions.

The aim of this report is to demonstrate and evaluate the potential of tall wheatgrass (Elytrigia elongata) to avoid GHG emissions and obtain lower economic costs in marginal areas of Spain. Our research built scenarios based on experimental plots (2 and 3 years growth) in 3 locations of Spain with completely different climate conditions (provinces of Girona, Soria and Palencia). In our experiences, we achieved an adequate establishment and biomass production, and assumed a rank of biomass yields until the end of the life cycle that is usually accepted to be about 15 years in many other studies in United States, Argentina and Eastern Europe where tall wheatgrass is extensively cultivated in marginal areas for sheep livestock production. Using our experimental plots and statistical information for economic inputs costs, we built 5 different scenarios per region considering a large range of biomass yields of tall wheatgrass. The analysis included a comparison with annual grasses economic costs calculated for a wide range of biomass yields of a previous study. We estimated GHG emissions savings for tall wheatgrasses and used our previous study (which had GHG emissions savings as well). Savings were calculated replacing natural gas electricity with electricity from biomass combustion in real power plants in Spain. In a wide range of yields, the results suggest that marginal areas might present a better performance with tall wheatgrass compared to annual winter grasses (cereals whole plant cuttings), thus producing biomass yields with higher GHG savings and lower economic costs at the farm level. Proceedings of the 20th European Biomass Conference and Exhibition, 18-22 June 2012, Milan, Italy, pp. 217-229

ABSTRACTEnzymatic wheat gluten hydrolysis at high solid concentrations is advantageous from an environmental and economic point of view. However, increased wheat gluten concentrations result in a concentration effect with a decreased hydrolysis rate at constant enzyme‐to‐substrate ratios and a decreased maximum attainable degree of hydrolysis (DH%). We here identified the underlying factors causing the concentration effect. Wheat gluten was hydrolyzed at solid concentrations from 4.4% to 70%. The decreased hydrolysis rate was present at all solid concentrations and at any time of the reaction. Mass transfer limitations, enzyme inhibition and water activity were shown to not cause this hydrolysis rate limitation up to 50% solids. However, the hydrolysis rate limitation can be, at least partly, explained by a second‐order enzyme inactivation process. Furthermore, mass transfer impeded the hydrolysis above 60% solids. Addition of enzyme after 24 h at high solid concentrations scarcely increased the DH%, suggesting that the maximum attainable DH% decreases at high solid concentrations. Reduced enzyme activities caused by low water activities can explain this DH% limitation. Finally, a possible influence of the plastein reaction on the DH% limitation is discussed. Biotechnol. Bioeng. 2014;111: 1304–1312. © 2014 Wiley Periodicals, Inc.

In this study, air concentrations of BaP in two different seasons (winter 2015 and summer 2016) and BaP levels in ground vegetation from Tarragona County were used as control simulations performed with the WRF-CHIMERE air quality modelling system, in order to reproduce the incidence of that hazardous chemical in air and soils. The CTM was validated for the present climatology, showing a good ability to represent air and soil concentrations of BaP over the target domain (petrochemical, chemical, urban and background sites), particularly in the winter. Then, the variation of the BaP concentrations in air and soils were simulated for the time series 1996-2015 and for the climate change scenario RCP8.5 (2031-2050). While an increase is projected for the levels in air, particularly in chemical and remote sites where the variation can go up to 10%, in terms of soil deposition the findings are the opposite, with an evident decrease in soil BaP concentrations, particularly for background sites. Finally, a potential health effect of BaP for the local population (lung cancer) was assessed. Although according to the projections the EU threshold for BaP atmospheric incidence (1 ng m-3) will not be reached by 2050, there will be an increase in the life-time risk of lung cancer, particularly in the most populated areas within the simulation domain.

The aeroelastic behavior of a flexible plate subjected to a uniform axial flow is investigated in the presence of a rigid plane set parallel to the plate. It is shown that the ground effect reduces the flutter inflow velocity and strengthens the possibility of using the flag for extracting energy from winds and currents. The numerical analysis is carried out assuming that both the unsteady potential incompressible flow and the plate can be described with 2D models, i.e., a lumped vortex panel method and a nonlinear Euler-Bernoulli beam model, respectively, without losing the essential features of the fluid-structure interaction. Asymmetry of post-critical behavior (limit-cycle oscillations) and sensitivity of the results to the main flag parameters (distance from the ground, mass ratio and damping) are also considered, including also the energy distribution over the identified proper orthogonal modes. The investigated reduction of the flutter velocity in ground effect has been also confirmed with experimental tests relative to a polypropylene flag with and without the rigid panel mimicking the presence of the ground.

Landfill gas (LFG) tends to escape from the landfill surface even when LFG collecting systems are installed. Since LFG leaks are generally a noticeable percentage of the total production of LFG, the optimisation of the collection system is a fundamental step for both energy recovery and environmental impact mitigation. In this work, we suggest to take into account the results of direct measurements of gas fluxes at the air-cover interface to achieve this goal.During the last 5 years (2004-2009), 11 soil gas emission surveys have been carried out at the Municipal Solid Waste landfill of Legoli (Peccioli municipality, Pisa Province, Italy) by means of the accumulation chamber method. Direct and simultaneous measurements of CH(4) and CO(2) fluxes from the landfill cover (about 140,000 m(2)) have been performed to estimate the total output of both gases discharged into the atmosphere. Three different data processing have been applied and compared: Arithmetic mean of raw data (AMRD), sequential Gaussian conditional simulations (SGCS) and turning bands conditional simulations (TBCS). The total amount of LFG (captured and not captured) obtained from processing of direct measurements has been compared with the corresponding outcomes of three different numerical models (LandGEM, IPCC waste model and GasSim).Measured fluxes vary from undetectable values (<0.05 mol m(-2) day(-1) for CH(4) and <0.02 mol m(-2) day(-1) for CO(2)) to 246 mol m(-2) day(-1) for CH(4) and 275 mol m(-2) day(-1) for CO(2). The specific CH(4) and CO(2) fluxes (flux per surface unit) vary from 1.8 to 7.9 mol m(-2) day(-1) and from 2.4 to 7.8 mol m(-2) day(-1), respectively.The three different estimation methodologies (AMRD, SGCS and TBCS) used to evaluate the total output of diffused CO(2) and CH(4) fluxes from soil provide similar estimations, whereas there are some mismatches between these results and those of numerical LFG production models. Isoflux maps show a non-uniform spatial distribution, with high-flux zones not always corresponding with high-temperature areas shown by thermographic images.The average value estimated over the 5-year period for the Legoli landfill is 245 mol min(-1) for CH(4) and 379 mol min(-1) for CO(2), whereas the volume percentage of CH(4) in the total gas discharged into the atmosphere varies from 29% to 51%, with a mean value of 39%. The estimated yearly emissions from the landfill cover is about 1.29 x 10(8) mol annum(-1) (2,100 t year(-1)) of CH(4) and 1.99 x 10(8) mol annum(-1) (8,800 t year(-1)) of CO(2). Considering that the CH(4) global warming potential is 63 times greater than that of CO(2) (20 a time horizon, Lashof and Ahuja 1990), the emission of methane corresponds to 130,000 t annum(-1) of CO(2).The importance of these studies is to provide data for the worldwide inventory of CH(4) and CO(2) emissions from landfills, with the ultimate aim of determining the contribution of waste disposal to global warming. This kind of studies could be extended to other gas species, like the volatile organic compounds.