• Energy Research
• Closed Access close
• engineering and technology close
• Chinese Academy of Sciences close

Cu2CdSn(S,Se)(4) is an important candidate material for thin film solar cell absorber layers. In this work, low-cost Cu2CdSnS4 nanocrytal thin film with a stannite structure has been successfully fabricated by a butyldithiocarbamate-based ethanol solution approach. The selenized Cu2CdSn(S,Se)(4) thin film shows large densely packed grains and has a suitable band gap value of 1.01 eV. The Cu2CdSn(S,Se)(4) thin film solar cell with a proof-of-concept power conversion efficiency of 3.1% was fabricated. (C) 2014 Elsevier B.V. All rights reserved.

Response of aquatic organisms to eutrophication have been well reported, while less studies are available for the recovery of eutrophic lakes following a reduction in the external loading, especially for systems where nitrogen is reduced but the phosphorus concentration is maintained high due to internal loading. Diatoms are nitrate (NO3-N) opportunists but can also use ammonium (NH4-N). They may, therefore, be more sensitive to nitrogen reduction than other algae that typically prefer NH4-N. We document the variations of nutrients and diatoms in subtropical, eutrophic Lake Taihu over 28 yr during which a reduction of the external loading resulted from lake management. According to the results of change point analysis, data on environmental variables were divided into two periods (P1: 1992-2006; P2: 2007-2019) with two different seasons (WS: Winter-Spring; SA: Summer-Autumn), respectively. Compared with P1-WS, the concentration of NH4-N decreased significantly whereas NO3-N showed no significant change in P2-WS. In contrast, NH4-N concentrations were low and showed no significant changes in P1-SA and P2-SA and NO3-N decreased significantly in the latter period. Accordingly, NO3-N: NH4-N mass ratios in P1-SA and P2-WS were all significantly higher than those in P2-SA and P1-WS, respectively. The biomass of WS diatom increased significantly and the timing of the peak biomass shifted from P1-SA to P2-WS since 2007. The SEM analysis showed that NO3-N was retained as a statistically significant predictor for diatom biomass in P1-SA and significant effects of windspeed, zooplankton and NH4-N on diatom biomass in P2-WS. Windspeed and zooplankton have further changed the biomass of diatoms in the case of declining inorganic nitrogen. We conclude that the magnitude of vernal suppression or stimulation of diatom assemblages has increased, concomitant with the variations of NH4-N and NO3-N: NH4-N mass ratios. Diatoms response to NH4-N or NO3-N is apparently changing in response to water temperature in this eutrophic shallow lake. Thus, parallel reductions in external nitrogen loading, along with variations in dominant inorganic nitrogen, will stimulate the growth of diatom and therefore increase the total biomass of phytoplankton in still high internal phosphorus loading, which is should be regarded as a good sign of restoration measures.

Robust mitigation options will play significant role in achieving the target of limiting global change to below 1.5 °C above pre-industrial levels by 2100. To support cooperation for mitigation development, we establish a real options-based model to evaluate the rational decisions of exercising the abandon option for carbon capture and storage-enhanced oil recovery (CCS-EOR) projects under oil market and geological uncertainties. Three possible cooperative mechanisms (fixed carbon dioxide (CO2) price, oil-indexed CO2 price, and joint venture contracts) among CO2-EOR stakeholders are evaluated. The results show that the conflicts in profit maximization targets for different stakeholders in cooperative mitigation are to a great extent unable to be avoided. A joint venture business model is preferred in cooperative mitigation as it can effectively weaken such conflicts. And it is more reasonable to provide incentives to the downstream of the CO2-EOR chain than compensating the adoption cost of carbon capture technologies in the upstream. From a global perspective, the inefficient cooperation can be a main barrier that hinders the development of deep-cutting options. Global mitigation strategies should not only focus on promoting technology progress but also the design of innovative business models to balance the benefits among stakeholders. A joint venture business model is recommended in both the developed and developing countries for seizing the early mitigation opportunities.

AbstractThe change in the phenology of plants or animals reflects the response of living systems to climate change. Numerous studies have reported a consistent earlier spring phenophases in many parts of middle and high latitudes reflecting increasing temperatures with the exception of China. A systematic analysis of Chinese phenological response could complement the assessment of climate change impact for the whole Northern Hemisphere. Here, we analyze 1263 phenological time series (1960–2011, with 20+ years data) of 112 species extracted from 48 studies across 145 sites in China. Taxonomic groups include trees, shrubs, herbs, birds, amphibians and insects. Results demonstrate that 90.8% of the spring/summer phenophases time series show earlier trends and 69.0% of the autumn phenophases records show later trends. For spring/summer phenophases, the mean advance across all the taxonomic groups was 2.75 days decade−1 ranging between 2.11 and 6.11 days decade−1 for insects and amphibians, respectively. Herbs and amphibians show significantly stronger advancement than trees, shrubs and insect. The response of phenophases of different taxonomic groups in autumn is more complex: trees, shrubs, herbs and insects show a delay between 1.93 and 4.84 days decade−1, while other groups reveal an advancement ranging from 1.10 to 2.11 days decade−1. For woody plants (including trees and shrubs), the stronger shifts toward earlier spring/summer were detected from the data series starting from more recent decades (1980s–2000s). The geographic factors (latitude, longitude and altitude) could only explain 9% and 3% of the overall variance in spring/summer and autumn phenological trends, respectively. The rate of change in spring/summer phenophase of woody plants (1960s–2000s) generally matches measured local warming across 49 sites in China (R = −0.33, P < 0.05).

Abstract In this paper, a finned heat pipe assisted passive heat sink based on a newly emerging high performance phase change material (PCM), the low melting point metal (LMPM), was developed for thermal buffering of high power electronics which works intermittently with heat generation rate up to 1000 W (10 W/cm2). Firstly, thermal performances of the PCM heat sink under different thermal shocks (from 200 W to 1000 W) were experimentally evaluated, in comparison with that of an organic PCM which has similar melting point. It was found that, the former one can prolong the working duration 1.4–2.4 times that of the latter one. Then, the performance of the heat sink was improved through reducing the contact thermal resistance and by increasing the fin number. Furtherly, an air cooling radiator was configured to accelerate the solidification process of the PCM module, which makes it capable of maintaining its highest temperature below 85 °C under 1000 W periodic thermal shock (10 min on and 15 min off). Moreover, energy dispersive spectrometer (EDS) analysis was conducted to verify the compatibility of the LMPM PCM and the structural materials. Finally, a simplified numerical model was developed and validated for the currently constructed finned heat pipe assisted LMPM PCM heat sink, which can be much helpful for future practical thermal design and optimization of this kind of thermal buffering module.

Abstract In order to obtain a comprehensive understanding of the influence of both inherent minerals and carbon crystalline structure parameters on coke reactivity index (CRI), 30 industrial metallurgical cokes were selected and their mineral composition were quantitatively determined by X-ray diffractometer (XRD) and TOPAS software, the influence of inherent minerals was further investigated by the TGA. The mineral catalysis index (MCI) and carbon crystalline structure parameters were correlated with the CRI. The results show that: (1) CRI can be expressed as function of MCI with R2 equal to 0.6548: CRI = 7.7037MCI + 6.8564; (2) Main crystalline minerals in cokes include mullite, quartz and cristobalite (the sum is more than 80%), oldhamite, anhydrite and hedenbergite also exist in coke with small amount. The reactivity index improved linearly, from 0.049 increased to 0.059 (increased 20.41%) with addition of 8% CaS, which indicate that CaS has an apparent catalytic effect on coke gasification; (3) Both carbon structure and MCI have a significant influence on coke’s CRI. When MCI

The influence of elemental sulfur (S(0)) amendment on methylmercury (MeHg) accumulation in rice and the chemical form of Hg in the rhizosphere were investigated under waterlogged conditions in Hg-contaminated soil (the majority of the Hg (˜70%) in forms similar to HgS). Different levels of S(0) addition increased the MeHg accumulation in rice. After a sequential extraction analysis of the chemical forms of Hg in the rhizosphere, the results showed that S(0) addition increased the organic bound Hg and decreased the residual Hg in the soils. An Hg LIII XANES further showed that S(0) addition increased the proportion of Hg in the form of RS-Hg-SR and decreased the proportion of Hg in the form of HgS, indicating that S(0) input may reactivate the non-bioavailable Hg in the rhizosphere and improve the net Hg methylation. These findings suggest that the application of S fertilizers to Hg-contaminated paddy soils may increase the MeHg concentration in the edible parts of crops, which may lead to more potential health problems in humans depending on the crop type. However, our study also suggests that S(0) addition could be an effective measure for mobilizing the insoluble Hg and accelerating the phytoremediation process in Hg-contaminated paddy soils.

Abstract The slag behaviors on the bottom cone are crucial characteristics that relate to the slag blockage in a gasifier. The slag flow and heat transfer model on the bottom cone was built to calculate the slag flow velocity, slag thickness and heat flux density. The results shown the slag flow velocity decreased and the slag thickness increased with the increasing cone angle. The slag heat flux density decreased with the increasing cone angle, and specially, the heat transfer rate of the overall bottom cone decreased significantly with the increasing cone angle. The flow slag residence time model was established to calculate the residence time distribution (RTD) of molten slag, and the results shown the mean residence time decreased with the increasing cone angle. In addition, this study preliminary analyzed the blockage possibility, and the results shown the slag thickness was significantly influenced by the critical temperature interval.