• Energy Research
• other engineering and technologies close
• 6. Clean water close
• 16. Peace & justice close

Abstract In this paper, coupled governing equations were proposed to simulate three-dimensional heat conduction and moisture transport in the nuclear waste repository. Because there will be a large temperature gradient near inner and outer boundaries of the bentonite buffer layer, and the heat driven moisture transport is introduced in the governing equation of moisture transport. By applying the Fourier and Laplace transforms, the governing equations were converted to the Bessel equations, and the Laplace-domain solutions to temperature and moisture distributions were derived through the inverse Fourier transform. The reliability of the proposed solutions was verified through comparative analysis with the line heat source model. These analytical solutions were applied to obtain the evolutions of temperature field and moisture distribution near the waste canister. Finally, a sensitivity study was performed to analyze the effects of relevant parameters on the heat driven moisture transport.

Energy is consumed at every stage of the cycle of water production, distribution, end use, and recycled water treatment. Understanding the nexus of energy and water may help to minimize energy and water consumption and reduce environmental emissions. However, the interlinkages between water and energy have not received adequate attention. To address this gap, this paper disaggregates and quantifies the energy consumption of the entire water cycle process in Beijing. The results of this study show that total energy consumption by water production, treatment and distribution, end use, and recycled water reuse amounts to 55.6 billion kWh of electricity in 2015, or about 33% of the total urban energy usage. While water supply amount increased by only 10% from 2005 to 2015, the related energy consumption increased by 215% due to water supply structural change. The Beijing municipal government plans to implement many water saving measures in the area from 2016 to 2020, however, these policies will increase energy consumption by 74 million kWh in Beijing. This study responds to the urgent need for research on the synergies between energy and water. In order to achieve the goal of low-energy water utilization in the future, water and energy should be integrated in planning and management.

Abstract The consumption of takeaway food is increasing worldwide. Single-use containers used for takeaway food represent a significant source of waste and environmental impacts due to their low recyclability. Consequently, it is important to identify the best available alternatives and improvement opportunities to reduce the environmental impacts of fast-food containers. For these purposes, this study estimates and compares for the first time the life cycle impacts of three most widely-used types of takeaway container: aluminium, polypropylene and extruded polystyrene. These are also compared to reusable polypropylene containers. The findings suggest that single-use polypropylene containers are the worst option for seven out of 12 impacts considered, including global warming potential. They are followed by the aluminium alternative with five highest impacts, including depletion of ozone layer and human toxicity. Overall, extruded polystyrene containers have the lowest impacts due to the lower material and electricity requirements in their manufacture. They are also the best option when compared to reused takeaway polypropylene containers, unless the latter are reused 3–39 times. The number of uses needed for the reusable “Tupperware” polypropylene food savers is even higher, ranging from 16 to 208 times, with terrestrial ecotoxicity being always higher than for extruded polystyrene, regardless of the number of uses. However, extruded polystyrene containers are currently not recycled and cannot be considered a sustainable option. If they were recycled in accordance with the European Union 2025 policy on waste packaging, most of their impacts would be reduced by >18%, while also reducing littering and negative effects on marine organisms. Most of the impacts of the other two types of container would also be reduced (>20%) through increased recycling. Implementing the European Union 2025 policy on recycling of waste packaging would reduce all the impacts by 2%–60%, including a 33% reduction in global warming potential. Based on 2025 million takeaway containers used annually in the European Union, the latter would save 61,700 t CO2 eq./yr, equivalent to the emissions of 55,000 light-duty vehicles. The outcomes of this study will be of interest to packaging manufacturers, food outlets, policy makers and consumers.

Mining and mineral processing industry adversely affects ecosystems and communities in nearby areas, including high freshwater consumption and scarcity. That is why the emerging global trend is to use sea water in flotation to recover valuable minerals from finely disseminated base metals ores. Recent studies investigate sea water flotation of copper, molybdenum, nickel sulphides and pyrite, while flotation of sphalerite, the main valuable mineral for zinc production, remains uncovered. This paper examines the feasibility of sphalerite flotation by conventional collectors in artificial sea water using a bubble-particles technique and frothless flotation tests. Potassium isopropyl xanthate (PIPX) and sodium isopropyl dithiophosphate (SIDTP) were used as collectors, and copper sulphate was introduced as the activator, while zinc sulphate and sodium sulphide were used as depressants. We examined the most common size fractions of sphalerite: medium (−74 + 44 μm) and fines (−44 μm). The findings showed the feasibility of sphalerite flotation in artificial sea water. We also established correlations between the rate of bubble-particle attachment and the sphalerite flotation recovery resulting in the growth of flotation recovery with the increase of the bubble-particle attachment rate. The results can be used as guidelines in choosing flotation reagents for sphalerite flotation in sea water. Another practical application of the results is the potential for sustainable development of the industrial sector, ecosystems and societies due to the replacement of fresh water by sea water, although further technological and environmental studies are required.

This research presents a 100% renewable energy (RE) scenario by 2050 with a high share of electric vehicles on the grid (V2G) developed in Ecuador with the support of the EnergyPLAN analysis tool. Hour-by-hour data iterations were performed to determine solutions among various features, including energy storage, V2G connections that spanned the distribution system, and long-term evaluation. The high participation in V2G connections keeps the electrical system available; meanwhile, the high proportions of variable renewable energy are the pillar of the joint electrical system. The layout of the sustainable mobility scenario and the high V2G participation maintain the balance of the electrical system during most of the day, simplifying the storage equipment requirements. Consequently, the influence of V2G systems on storage is a significant result that must be considered in the energy transition that Ecuador is developing in the long term. The stored electricity will not only serve as storage for future grid use. Additionally, the V2G batteries serve as a buffer between generation from diversified renewable sources and the end-use stage.

Abstract CBM reservoirs are extremely vulnerable to damage due to their complex pore structure. So, changing pore structures in CBM reservoirs is of vital importance for reducing reservoirs damage. Organic solvents have been considered as additives into fracturing fluids to enhance production because they can enhance the pore connectivity and loosening macromolecular network structure. It is thus of great interests to investigate how organic solvents (ethanol and ethylene glycol ether) change micropore structures and fluid distribution. In this study, samples were selected from different wells completed in No. 3 coal seam, Zhaozhuang minefield. Low-pressure nitrogen adsorption (LP-N2GA) experiments were conducted on coal samples to evaluate the changes in pore-structure parameters including specific surface area (SSA), pore diameter, and pore volume. NMR experiments were conducted on coal samples to evaluate the changes in fluid distribution. Analyzing the LP-N2GA results suggests ethylene glycol ether and ethanol can effectively increase SSA, pore diameter, and opening degree of pores in coal samples. Comparative analysis of NMR results indicates that ethylene glycol ether consistently reduces the irreducible water saturation (Swir) in samples. The average value of Swir of raw samples is 0.8670 and the average value of Swir of samples treated with ethylene glycol ether value is 0.7644. Considering the pore-structure alterations, this study demonstrates that ethylene glycol ether is more preferable for enhancing recovery from CBM reservoirs compared with ethanol.

The production process of nitroaromatic hazardous compounds, with the generation of acidic wastewater, represents a significant danger for the health and safety of the workers and the environment. The present study is focused on the development of an efficient installation to treat acidic wastewater resulting from the synthesis process of nitroaromatic compound, considering workers safety and environmental criteria. In this research, a detailed study of the different alternatives that can be used for effective and safe treatment of acidic wastewater was performed. The analysis of several technological schemes for the acidic wastewaters neutralization and the selection of the most feasible alternative from a technical-economic point of view were carried out. The simulation and mathematical modeling developed in this research represent a significant advance in the knowledge of this process for working in a much more secure form. The technological scheme of the process was defined, and the design of the main and auxiliary equipment as well as the piping system was carried out using different computational programs. Finally, this paper proposes a technological design for the treatment of acidic wastewater generated by the production process of nitroaromatic compound, which represents the basic criteria for the further design, construction, and equipment installation of the plant.

This study aims to identify potential hydropower sites and calculate the theoretical potential hydropower capacity based on watershed modelling of the Mindanao River Basin (MRB) in the Philippines for the sustainable development of a previously unstudied region. The Soil and Water Assessment Tool (SWAT) was applied to delineate the watershed of the MRB and simulate the river discharges with inputs from observed precipitation and global gridded precipitation datasets. Observed weather data, such as temperature, humidity, and solar radiation, from four meteorological stations in the Philippines were also used as inputs for SWAT modelling. Simulated discharges were calibrated at three river gauges on the Nituan, Libungan and Pulangi Rivers. However, due to limited river discharge records, model validations were conducted in proxy basins: the calibrated model parameters in river A were used in the watershed modelling of proxy river B. Of the delineated 107 sub-basins in the MRB watershed, only 33 were identified as having potential sites for hydropower development. These potential sub-basins hosted a total of 154 potential sites with an estimated monthly average power capacity of 5,551.35 MW for all 33 sub-basins. The estimated theoretical power capacity of 15,266.22 MW for all sites in the MRB is approximately equivalent to the Philippines’ total available power capacity in 2017 of 15,393 MW. These sites were classified into 16 mini-scale hydropower sites, 114 small-scale hydropower sites and 24 medium-scale hydropower sites based on the simulated river discharges and potential power capacities. Based on these results, hydropower development could be an alternative to strengthen the exploration of renewable energy resources and improve the energy situation in Mindanao; hydropower development could also have mitigation effects on frequent floods in flat, low-lying downstream areas.