• Energy Research

In this paper the synthesis of self-organized Titania nanotubes (TNTs) by a facile potentiostatic anodization in a glycerol-based electrolyte is reported. The optimized TNTs were subsequently reduced through a cathodic reduction process to enhance its capacitive performance. FESEM and XRD were used to characterize the morphology and crystal structure of the synthesized samples. XPS analysis confirmed the reduction of Ti4+ to Ti3+ ions in the reduced Titania nanotubes (R-TNTs). The tube diameter and separation between the tubes were greatly influenced by the applied voltage. TNTs synthesized at voltage of 30 V for 60 min exhibited 86 nm and 1.1 µm of tube diameter and length, respectively and showed high specific capacitance of 0.33 mF cm−2 at current density of 0.02 mA cm−2. After reduction at 5 V for 30 s, the specific capacitance increased by about seven times (2.28 mF cm−2) at 0.5 mA cm−2 and recorded about 86% capacitance retention after 1000 continuous cycling at 0.2 mA cm−2, as compared to TNTs, retained about 61% at 0.01 mA cm−2. The charge transfer resistance drastically reduced from 6.2 Ω for TNTs to 0.55 Ω for R-TNTs, indicating an improvement in the transfer of electrons and ions across the electrode–electrolyte interface.

Biomass-promoting routes for the synthesis of activated carbon (AC) have recently received considerable attention due to the advantages of this method: it is simple, cost-effective, and ecofriendly. This method is also an alternative way to avoid the unsafe practice of waste incineration. We describe the preparation of activated carbon from palm kernel shell (PKS) – an abundant biomass that is available in Africa and Asia. We investigated the effect of process variables such as impregnation ratio (ratio of H3PO4 to PKS) and carbonisation temperature (500–700 °C) on yield, microstructure, morphology, pore structure, and adsorption properties to optimise these parameters. Nitrogen adsorption isotherm analysis indicated that the AC was predominantly microporous in nature. Under optimal conditions, an AC with the highest surface area of 1560 m2/g was obtained. The aqueous adsorption test showed that the AC had significant removal capacity for methylene blue and iodine. The higher iodine value is consistent with the structural properties of the adsorbent, while the lower methylene blue value is consistent with the limited mesopore width. Considering the chemical and surface properties and adsorption properties of the AC produced, PKS has been shown to be an excellent precursor material for AC, thus solving the disposal problems associated with this biomass. Significance: AC significantly promotes adsorption and offers a low-cost and cleaner production method. PKS could serve as a dependable precursor for the synthesis of porous AC. This study provides useful information on how H3PO4-impregnated PKS influences the porosity of the resulting AC. Differences in porosity, yield, and morphology and Brunauer–Emmet–Teller surface area are achievable using AC from PKS.