• Energy Research
• Closed Access close
• Restricted close
• Open Source close
• 12. Responsible consumption close
• 6. Clean water close

This paper reports the real-time behavior of the leakage current flowing on glass-type insulator strings of a 230-kV substation tower during washing. Monitoring of two insulator strings in the tower is achieved by use of a pair of optical-fiber sensors that detect samples of the leakage current waveforms and transmit those samples to a processing module via an optical link. It is observed that leakage current during washing may reach high peak levels, and the effectiveness of the washing can be inferred by the degree of leakage current after drying of the insulator strings. Direct monitoring of the leakage current can thus be used as an important guideline for proper washing procedures during this type of intervention as well as for determining the effectiveness of the procedure.

Abstract In this work, energy analysis is carried out to account for inputs and outputs of energy and GHG emissions associated with the biodiesel production system. Jojoba oil is obtained by cultivation of the jojoba plant, harvesting of seeds followed by extraction of oil, which is then converted to biodiesel by the process of transesterification. Energy efficiency is expressed in terms of the net energy balance (NEB) and the net energy ratio (NER). The use of the byproducts (husk, cake or meal, waste residues and glycerin) are also included as a part of the system boundary. The results show that the NEB and NER values are calculated at 46724.1 MJ/ha (28.9 MJ/L biodiesel produced) and 2.16, respectively. At the same time, the total amount of GHG emissions are estimated at 2.28 kg-CO2eq/L biodiesel produced (66.0 g CO2eq/MJ biodiesel produced). Nevertheless, if manure is used as fertilizer for jojoba plant cultivation, the primary energy input will fall by 9.52% (to 22.49 MJ/L of biodiesel).

Abstract An outlook into the country profile at the existing electricity generation with crude oil production at the present level with accompanying gas flares cause CO 2 emission as well as the industrial, human activities and the grid electricity distribution has been accounted for. The estimation of solar radiation levels as well as its productivity in terms of photovoltaics (PV׳s), concentrated solar powers (CSP) and chimney towers have been paid for others renewable energies; wind, tidal and geothermal productivity. A selection of possible site for installation according to the given geographical hazard and the maximum solar radiation could be collected. An overview for futuristic demands and possible solar energy supply that could be generated has reviewed. Furthermore, the desalination of underground or polluted water to support the solar system as well as the needed plantation to preserve a clean and green environment and low dust climate is presented.

Abstract The combination of biomass gasification with fuel cells, especially high temperature Solid Oxide Fuel Cells (SOFCs) promises sustainable and highly efficient (decentralized and modular) energy conversion systems. This review encompasses the components of biomass integrated gasification–SOFC technology including biomass characteristics, the thermochemical conversion in gasifiers and the factors affecting the gasification process, the cleaning technologies for raw producer gas and its conditioning and finally the integration of gasifier with SOFCs. The influence of impurities present in biomass producer gas such as particulates, tar, H 2 S, HCl and alkali compounds based on recent experimental studies and their tolerance limits towards SOFCs are presented. Even though analysis based on the probable tolerance limits of impurities towards SOFCs and a comprehensive overview of the cleaning technologies for producer gas impurities indicate that producer gas cleaning at various temperatures using current technologies to meet SOFC requirements is possible, more experimental studies are still needed to acquire the detailed information on the tolerance limits of impurities for SOFCs. The recent theoretical modeling and experimental studies of biomass integrated gasification–SOFC systems are also presented.

Abstract Most refrigeration plants for cooling mines use cold water. This is becoming uneconomical as mines get deeper and pumping costs increase. This Paper proposes an air cycle refrigeration system for use in deep mines to provide underground refrigeration without the use of water.

It is now recognized that analytical chemistry must also be a target for green principles, in particular chromatographic methods which typically use relatively large volumes of hazardous organic solvents. More generally, high performance liquid chromatography (HPLC) is employed routinely for quality control of complex mixtures in various industries. Acetonitrile and methanol are the most commonly used organic solvents in HPLC, but they generate an impact on the environment and can have a negative effect on the health of analysts. Ethanol offers an exciting alternative as a less toxic, biodegradable solvent for HPLC. In this work we demonstrate that replacement of acetonitrile with ethanol as the organic modifier for HPLC can be achieved without significantly compromising analytical performance. This general approach is demonstrated through the specific example analysis of a complex plant extract. A benchmark method employing acetonitrile for the analysis of Bidens pilosa extract was statistically optimized using the Green Chromatographic Fingerprinting Response (GCFR) which includes factors relating to separation performance and environmental parameters. Methods employing ethanol at 30 and 80°C were developed and compared with the reference method regarding their performance of separation (GCFR) as well as by a new metric, Comprehensive Metric to Compare Liquid Chromatography Methods (CM). The fingerprint with ethanol at 80°C was similar to or better than that with MeCN according to GCFR and CM. This demonstrates that temperature may be used to replace harmful solvents with greener ones in HPLC, including for solvents with significantly different physiochemical properties and without loss in separation performance. This work offers a general approach for the chromatographic analysis of complex samples without compromising green analytical chemistry principles.

Abstract This paper aims to investigate sustainable waste management solutions for the city of Rio de Janeiro in Brazil, based on a life cycle approach. The Life Cycle Assessment (LCA) was performed by using the LCA-IWM methodology. The model was adapted to the Brazilian solid waste context and to the local characteristics, including waste composition, electricity mix and regulations. The annual amount of waste generated was the functional unit adopted. Eight municipal solid waste management strategies were evaluated. Scenarios including mixed waste collection and source separated collection as well as materials recovery and energy from waste were investigated. Scenarios were ranked based on the LCA results. Sensitivity analysis was carried out by varying the electricity mix. The results indicate that the current situation of municipal solid waste (MSW) in Rio de Janeiro presents the worst performance in terms of aggregated environmental burdens, indicating the urgency for implement new strategies toward a more environmentally friendly and sustainable MSW management system. It is noted that the better LCA performances were obtained in scenarios with high separately collection rates. Among them, the scenario based on recyclables recovery and anaerobic digestion shows to be a promising strategy to improve environmental sustainability. Sensitivity analysis demonstrates that the ranking of scenarios was not affected by changes in the electricity mix. From the results, the investment in source separated waste collection and materials recovery is the most environmentally friendly MSW strategy for Rio de Janeiro. In addition, scenarios with an emphasis in materials recovery presented higher environmental benefits than the alternatives focused on energy generation.

Abstract A new formulation for the evaporation, flashing, condensation processes taking place in the effects of thermal desalination systems which simulates the operation of both forward and parallel/cross configurations is coupled with an exergo-economic model based on the SPECO method. The thermo-economic model uses accurate properties for the seawater, brine, pure water and vapour and is solved with an equation solver which does not require the development of a specific solution algorithm as in most previous studies. This flexible model is used to analyze the influence of the number of effects N and the temperature difference ΔT e between effects on the technical and economic performance of multi-effect desalination systems with ejector vapour compression. In particular, it is shown that the performance calculated by an earlier black-box approach is not attainable by technically and economically realistic systems. It is also shown that for each feed configuration and a given number of effects there exists an optimum value of ΔT e which minimizes the cost of the produced potable water. This last result forms the basis of a procedure that combines black-box results with the optimum value of ΔT e and can be used to select the appropriate system for any specific application.

Abstract: The dynamics of reformation and replacement of gas hydrates were studied under nonequilibrium conditions. It was found that the reformation of gas hydrates is largely affected by the state of the gas‐water system and the restarting temperature. This suggests that the effects are caused by changes in the structure of the aqueous solution at a molecular level. Pure samples of CH4 gas hydrate were synthesized from ice crystals and the dissociated solution using the reformation method. Replacement of CO2 gas hydrate is achieved within a short duration in the solid‐phase sample of CH4 gas hydrate, if the pressure and temperature is precisely controlled in a pressure vessel.