• Energy Research
• Closed Access close
• Restricted close
• 12. Responsible consumption close
• 2. Zero hunger close

In this study, pyrolysis of residual biomass from the agro-alimentary industry of Argentina was investigated. The studied biomasses were rice husk, peanut shell and wheat straw. The effect of pyrolysis temperature over solid (bio-char), liquid (bio-oil) and gas (bio-gas) fractions weight yields were evaluated for each biomass, in the range of 350-650 °C. The maximum yield of bio-oil was obtained at 550 °C for rice husk (45 wt%) and wheat straw (58 wt%), and at 500 °C for peanut shells (51 wt%). At those temperatures, the data recorded the smallest spread around the mean. Different characterization techniques of raw biomass were reported, namely, thermal behavior; proximate and ultimate analysis; content of Ca, Al, K, Si and Fe; and hemicellulose, cellulose and lignin composition. Bio-oils characterization included water content and chemical compounds identification. Furthermore, bio-char HHV and BET surface area were measured. Rice husk bio-oil showed 21% selectivity towards furans of which 75% corresponded to furfural and 5-HMF. Peanut shell bio-char presented the highest Higher Heating Value (7250 kcal/kg) and BET surface area (215 m2/g). In addition, co-pyrolysis reactions and the synergistic effects over obtained products completed this study. Co-pyrolysis bio-oils yields varied between 41 and 46 wt%, for all the mixtures. Bio-oil water content decreased up to 15% for rice husk mixed with peanut shell or wheat straw. Moreover, 5-HMF was detected in all bio-oils, and furfural selectivity was higher than 5% in the three mixtures investigated.

This paper presents a multi-objective optimization model for a long-term generation mix in Indonesia. The objective of this work is to assess the economic, environment, and adequacy of local energy sources. The model includes two competing objective functions to seek the lowest cost of generation and the lowest CO2 emissions while considering technology diffusion. The scenarios include the use of fossil reserves with or without the constraints of the reserve to production ratio and exports. The results indicate that Indonesia should develop all renewable energy and requires imported coal and natural gas. If all fossil resources were upgraded to reserves, electricity demand in 2050 could be met by domestic energy sources. The maximum share of renewable energy that can be achieved in 2050 is 33% with and 80% without technology diffusion. The least cost optimization produces lower generation costs than the least CO2 emissions, as well as the combined scenario. Total CO2 emissions in 2050 are five to six times as large as current emissions. The least CO2 emissions scenario can reduce almost half of the CO2 emissions of the least cost scenario by 2050. The proposed multi-objective optimization model leads some optimal solutions for a more sustainable electricity system.

Paper mill sludge (PMS) is a residual biomass that is generated at paper mills in large quantities. Currently, PMS is commonly disposed in landfills, which causes environmental issues through chemical leaching and greenhouse gas production. In this research, we are exploring the potential of fast pyrolysis process for converting PMS into useful bio-oil and biochar products. We demonstrate that by subjecting PMS to a combination of acid hydrolysis and torrefaction pre-treatment processes it is possible to alter the physicochemical properties and composition of the feedstock material. Fast pyrolysis of pretreated PMS produced bio-oil with significantly higher selectivity to levoglucosenone and significantly reduced the amount of ketone, aldehyde, and organic acid components. Pretreatment of PMS with combined 4% mass fraction phosphoric acid hydrolysis and 220 °C torrefaction processed prior to fast pyrolysis resulted in a 17 times increase of relative selectivity towards levoglucosenone in bio-oil product along with a reduction of acids, ketones, and aldehydes combined from 21 % to 11 %. Biochar, produced in higher yield, has characteristics that potentially make the solid byproduct ideal for soil amendment agent or sorbent material. This work reveals a promising process system to convert PMS waste into useful bio-based products. More in-depth research is required to gather more data information for assessing the economic and sustainability aspects of the process.

Abstract The Chinese government has taken measures to realize energy-savings and emission reductions, such as promoting innovations, adjusting the industrial structure, balancing regional development, and reforming markets. The aim of this paper is to assess the effects of these measures on China's CO2 emissions by using a newly proposed decomposition approach, which identified eight new factors related to the above realistic measures, i.e., energy saving and production technologies, industrial energy and production efficiencies, regional energy and production efficiencies, and pure energy and production efficiencies. The main findings indicate benefits from considerable technological progress in energy-saving and production during 2000–2016 period, and two technological factors contributed the most to emissions abatement and cumulatively reduced 5372.43 Mt and 1291.72 Mt CO2 emissions. The efforts of industrial restructuring promoted energy and production efficiency improvement, which further facilitated emission reduction. In contrast, the pure energy and production efficiency changes cumulatively led to 1080.26 Mt and 1135.85 Mt CO2 emissions growth during the whole sample period, suggesting that severe resource misallocation problems may exist in both the energy market and output market. Additionally, the Chinese government failed to narrow the technology gap between developed regions and underdeveloped regions, further restricting emission reduction.

This study focused on the effects of plant compositions on removal rates of pollutants in microcosms through investigating rhizosphere microbial populations, photosynthetic efficiency and growth characteristics. Mixed-culture groups improved the removal efficiency of TN and TP significantly but exhibited lower COD removal rates. Total plant biomasses were improved as the species richness increased, but the N/P content in the plants was mainly affected by the type of species. The mixed-culture groups showed lower photosynthesis rates and oxygen supply generated from roots under high irradiation. Microbial communities of the cultured groups in the rhizosphere exhibited significant differences. According to principal component analysis (PCA), the fungi were the typical microbes of SPA, SPAB, and SPABC, resulted in improvement in nutrient accumulation. These results demonstrated that a mixed culture strategy can represent the overyielding of biomass, promote the photo-protection mechanism, and will further increase the removal rates of pollutants in a constructed wetland.

Yard waste is either dumped or is being openly burned to get rid of it, instead of using it as a valuable renewable energy source. In this study, hydrothermal carbonization of yard waste was conducted to valorize it as a solid bio fuel, using a batch reactor. The effect of process parameter on yield, energy and physicochemical properties of the valorized solid bio fuel (hydrochar) was examined in this study by varying reaction temperature (160-200 °C for 2 h) and reaction time (2-24 h at 200 °C). The calorific value of hydrochar was within a range of 17.72-24.59 MJ/kg as compared to 15.37 MJ/kg for untreated yard waste. Hydrochar mass yield decreased from 78.6% at operating temperature - time of 160 °C -2 h to 45.6% at 200 °C -24 h. The plot of atomic ratios (H/C and O/C) demonstrates improvement in the coalification process which was mainly governed by decarboxylation and dehydration reactions. The grindability of the prepared hydrochar was comparable to that of coal. Hydrochar produced at lower reaction condition (160-200 °C at 2 h) have better flowability as compared to that produced at higher reaction condition (4-24 h at 200 °C). The reaction time longer than 12 h has a minimal effect on the yield, energy and physicochemical properties of hydrochar. Increasing reaction time and temperature improved the ignition and burnt temperature of hydrochar. All reaction condition has an energy ratio (energy output to energy input) of more than one making HTC process a net energy producer.

A brief review of energy use patterns in three economic sectors; namely, residential, industrial and transport sectors is provided in this paper. The transport sector is the largest energy-consuming sector in Thailand, followed by the industrial and residential sectors, respectively. In order to reduce both imported energy and environmental emissions, energy conservation programs would be implemented. This paper forecasts the growth in energy demand and corresponding emissions to the year 2020 for those three sectors by using a model based on the end-use approach. The energy savings from the energy conservation strategies, such as energy efficiency improvement and energy demand management, are assessed and also the implications on electricity generation expansion planning are examined. The integrated resource planning (IRP) model is used to find the least-cost electricity generation expansion plans. Energy conservation options, including energy efficiency improvement programs, are introduced in the residential and industrial sectors. Public transportation and engine technology improvements are introduced in the transport sector. The effects of energy conservation options are analyzed using a scenario-based approach. The results of analysis reveal that the improvement of public transportation can reduce future energy requirements and CO2 emissions in 2020 by 635 thousand ton of oil equivalent (toe) and 2024 thousand ton of CO2 equivalent, respectively. If all options are simultaneously implemented, the potential of energy savings and CO2 mitigation in 2020 are estimated to be 1240 thousand toe and 3622 thousand ton of CO2 equivalent, respectively.

In July 2010, the LISS Immigrant panel was presented a questionnaire to measure the ecological footprint of the respondent. The questionnaire calculates the ecological footprint by taking account of the space, resources and energy people use in relation to the biocapacity of the earth.More information on this Ecological Footprint measure by Prof. W. Rees and Dr. M. Wackernagel can be found on the website: www.footprintnetwork.org.

The crucial role evaluation can play in the co-development of project design and its implementation will be addressed through the analysis of a case study, the Green Communities (GC) project, funded by the Italian Ministry of Environment within the EU Interregional Operational Program (2007-2013) "Renewable Energy and Energy Efficiency". The project's broader goals included an attempt to trigger a change in Italian local development strategies, especially for mountain and inland areas, which would be tailored to the real needs of communities, and based on a sustainable exploitation and management of the territorial assets. The goal was not achieved, and this paper addresses the issues of how GC could have been more effective in fostering a vision of change, and which design adaptations and evaluation procedures would have allowed the project to better cope with the unexpected consequences and resistances it encountered. The conclusions drawn are that projects should be conceived, designed and carried out as dynamic systems, inclusive of a dynamic and engaged evaluation enabling the generation of feedbacks loops, iteratively interpreting the narratives and dynamics unfolding within the project, and actively monitoring the potential of various relationships among project participants for generating positive social change.