• Energy Research
• 2016-2025close
• Open Access close
• Embargo close

AbstractThe fluid flow characteristics in shale fractures are of great significance for shale gas reservoir evaluation and exploitation. In this study, artificial tension fractures in shale were used to simulate the hydraulic fractures formed by fracturing, and a gas flow test under different pressure gradients was conducted. The nonlinear gas flow and stress‐dependent permeability characteristics were analyzed. The experimental results show the following: (a) CO2 flow in shale fractures exhibits strong nonlinearity. Forchheimer's law, which considers gas compressibility, satisfactorily describes the nonlinear relationship between the flow rate and the pressure gradients in shale fractures. (b) The permeability sensitivity of shale fractures under stress is very strong, and the exponential relationship better describes the pressure dependency of the permeability for the tested shale samples. The permeability of the shale fractures is similar when measured parallel or perpendicular to bedding. Furthermore, the pressure dependence of fractures in shale obeys the Walsh permeability model. (c) As the effective stress increases, the nonlinear flow behavior appears earlier. Based on the Reynolds number and the nonlinear coefficient, a friction factor model is proposed. (d) The normalized transmissivity exhibits a strong correlation with the Reynolds number. CO2 flow through shale fractures is generally dominated by transitional flow. The critical Reynolds number ranges from 1.8 to 102.88 and decreases with increasing effective stress.

Abstract The ability of the Distributed Generation (DG) to solve problems such as power system deregulation and power demand problems appropriate to its purpose, which is to inject electricity in a distributed manner at a point close to the load, causes the distributed generation to become the latest trend in electricity generation technology. Proper position of distributed generation is necessary in order to achieved maximum benefit from DG, which could be due to an incorrect allocation of DG sources to the power network would not only result in increased power losses, but could also jeopardize the operation of the system. This paper introduces an ACO-algorithm for optimal location of DGs using a real network in one of a rural area of Malaysia. The method is used to determine the effectiveness of DG by comparing the losses of power and the improvement of the voltage profile. As for the confirmation to the ACO method, another method known as brute force method is use to compare the data gain as validation purposes.

Hydrothermal liquefaction (HTL) is an effective way to treat solid wastes with high moisture content. The co-hydrothermal liquefaction (co-HTL) experiments of oily scum and poplar sawdust biochar at the different hydrothermal temperatures were performed in this work. The changes of the appearance and components of the liquid products were comprehensively studied. The results showed that the addition of biochar into oily scum significantly reduced the moisture content of the residue hydrochars obtained after co-HTL. As the hydrothermal temperature increased, the liquid products obtained from co-HTL turned clearer and lighter in color, and the recovery rate of the liquid products significantly increased. The co-HTL of bi-ochar and oily scum could effectively improve the liquid quality and enhance the recovery rate of hydrochars. The carbon numbers of the liquid products obtained from co-HTL were concentrated in C5-C11, which were main compositions of gas-oline. This work can provide basic data and theoretical reference for oily scum efficient treatment and engineering practice.

While a firm knows the carbon price with certainty under a tax, it must form an expectation about future allowance prices to identify its cost-effective abatement investment under a capand-trade program. We illustrate graphically how errors in forming this expectation increase the costs of irreversible pollution abatement investment under cap-and-trade relative to a tax. We describe empirical “cost-effectiveness anomalies” in allowance markets that may be attributed to cap-and-trade's inherent uncertainty. We model investment under simulated US carbon tax and cap-and-trade policies and find that allowance price uncertainty can increase resource costs 20 percent for a given quantity of emission abatement.

A complete surveillance strategy for wind turbines requires both the condition monitoring (CM) of their mechanical components and the structural health monitoring (SHM) of their load-bearing structural elements (foundations, tower, and blades). Therefore, it spans both the civil and mechanical engineering fields. Several traditional and advanced non-destructive techniques (NDTs) have been proposed for both areas of application throughout the last years. These include visual inspection (VI), acoustic emissions (AEs), ultrasonic testing (UT), infrared thermography (IRT), radiographic testing (RT), electromagnetic testing (ET), oil monitoring, and many other methods. These NDTs can be performed by human personnel, robots, or unmanned aerial vehicles (UAVs); they can also be applied both for isolated wind turbines or systematically for whole onshore or offshore wind farms. These non-destructive approaches have been extensively reviewed here; more than 300 scientific articles, technical reports, and other documents are included in this review, encompassing all the main aspects of these survey strategies. Particular attention was dedicated to the latest developments in the last two decades (2000–2021). Highly influential research works, which received major attention from the scientific community, are highlighted and commented upon. Furthermore, for each strategy, a selection of relevant applications is reported by way of example, including newer and less developed strategies as well.

This report reflects upon the concept of social innovation and the way it is used in the energy sector. It does so by bringing together theoretical investigations and empirical knowledge. We aim to clarify the concept of social innovation in the energy sector by reviewing the literature and reflecting over a number of social innovation projects in Europe. The analysis of the projects against various contextual factors and their goals reveals the significant potential of social innovation on accelerating the energy transition while tackling societal problems. Energy production, energy efficiency and energy literacy are the main domains to which socially innovative activities contribute the most. High competences of project leadership and management observed though projects are often small in scale and context-dependent. This indicates that successful socially innovative energy initiatives require advanced bottom-up governance structures even if that may imply limitations for scaling up. This setting may complicate top-down support as legal, financial or even cultural policy-making must be tailor-made and reinvent or adjust continuously. Nevertheless, social innovative activities are expected to further proliferate the following years and move towards a sound environmental, cultural, political, economic and social direction, as knowledge creation and diffusion of technological and governance innovations accompanied with policy support are on the rise. JRC.C.7-Knowledge for the Energy Union

High penetration of renewable energy sources into isolated microgrids (µGs) is considered a critical challenge, as µGs’ operation at low inertia results in frequency stability problems. To solve this challenge, virtual inertia control based on an energy storage system is applied to enhance the inertia and damping properties of the µG. On the other hand, utilization of a phase-locked loop (PLL) is indispensable for measuring system frequency; however, its dynamics, such as measurement delay and noise generation, cause extra deterioration of frequency stability. In this paper, to improve µG frequency stability and minimize the impact of PLL dynamics, a new optimal frequency control technique is proposed. A whale optimization algorithm is used to enhance the virtual inertia control loop by optimizing the parameters of the virtual inertia controller with consideration of PLL dynamics and the uncertainties of system inertia. The proposed controller has been validated through comparisons with an optimized virtual inertia PI controller which is tuned utilizing MATLAB internal model control methodology and with H∞-based virtual inertia control. The results show the effectiveness of the proposed controller against different operating conditions and system disturbances and uncertainties.

© 2020 Elsevier Ltd Free cooling of buildings uses the nocturnal outdoor air as a heat sink via a ventilation process. This could be performed by storing the night coolness for use during the daytime as appropriate. Due to the latent heat capacity, phase change material (PCM) could play anessential role in the effective operation of the free cooling systems by shifting the daytime peak load to the night. However, there is a scarceness on the technology application in hot climates. This paper presents results of a parametric investigation into the application of PCMs as thermal energy storage (TES) to provide sustainable cooling to buildings in hot arid climate by making use of the night-time free cooling. The proposed TES medium comprises an arrangement of metallic modules filled with RT28HC PCM. Numerous geometrical configurations and operational parameters have been assessed. A transient CFD simulation has been employed using ANSYS Fluent software. Validation of the numerical results with experimental data has shown a good agreement. The results have demonstrated that the temperature difference between the PCM and the air, at appropriate air flow rate would have a significant impact on the performance of the system. A free cooling system based on the proposed arrangement has the potential to meet around 42% of a typical building cooling load and has the ability to save up to 67% of building cooling energy load in summer season compared to conventional air-conditioning systems in hot arid climates.