• Energy Research
• Restricted close
• Open Source close

It has long been established that mature forests are mosaics of patches in different development phases but it has seldom explicitly been taken into account in ecological studies. We demonstrate here that these development phases, which are related to the population dynamics of trees, play an important role in the distribution of fauna based on observations on frugivorous birds. In an area close to the Calakmul Biosphere Reserve in Mexico, we studied the abundance of large forest bird species in relation to forest development phases, with a methodology that seems promising for ecological diagnosis and prognosis in forest management planning. Fine-scale forest mapping and bird counts were carried out in two block-transects of 40 m x 3000 m. Tree sampling in a sub-transect was used to generate population characteristics of trees, Large bird species preferred mature or senescent forest patches, whereas relatively young, growing forest patches were avoided. Important large tree species such as Manilkara zapota, Thouinia paucidentata, Guaiacum sanctum and Esenbeckia pentaphylla, characteristic of older forest patches, showed skewed size distributions indicating stress or overexploitation. The population of M. zapota, a key fruiting species that accounted for 26.5% of the total woody biomass, was most heavily affected by stress. A future collapse in the population of M. zapota, a decrease of the total area of older forest, and a decline in the abundance of large birds is likely if stress on the system continues at this level. (C) 2008 Elsevier B.V. All rights reserved.

The influence of compost on the growth of bean plants irrigated with As-contaminated waters and its influence on the mobility of As in the soils and the uptake of As (as NaAs(III)O2) by plant components was studied at various compost application rates (3·10(4) and 6·10(4) kg ha(-1)) and at three As concentrations (1, 2 and 3 mg kg(-1)). The biomass and As and P concentrations of the roots, shoots and beans were determined at harvest time, as well as the chlorophyll content of the leaves and nonspecific and specifically bound As in the soil. The bean plants exposed to As showed typical phytotoxicity symptoms; no plants however died over the study. The biomass of the bean plants increased with the increasing amounts of compost added to the soil, attributed to the phytonutritive capacity of compost. Biomass decreased with increasing As concentrations, however, the reduction in the biomass was significantly lower with the addition of compost, indicating that the As phytotoxicity was alleviated by the compost. For the same As concentration, the As content of the roots, shoots and beans decreased with increasing compost added compared to the Control. This is due to partial immobilization of the As by the organic functional groups on the compost, either directly or through cation bridging. Most of the As adsorbed by the bean plants accumulated in the roots, while a scant allocation of As occurred in the beans. Hence, the addition of compost to soils could be used as an effective means to limit As accumulation in crops from As-contaminated waters.

We present a total of 191 and 203 data points of the elastic neutron-protonspin correlation parameters Aookk and Aoosk , respectively. Both observables were measured in a large angular interval. The observable Aookk was measured from 0.312 to 1.10 GeV and Aoosk from 0.80 to 1.10 GeV. The SATURNE II polarized beam of free neutrons obtained from the break-up of polarized deuterons was scattered on the polarized Saclay frozen-spin proton target. The beam polarization was oriented either along the beam direction or sideways, the target polarization was oriented longitudinally. Data are compared with phase-shift analyses predictions and with the PSI, LAMPF and SATURNE II results. Present results provide an important contribution to any future theoretical or phenomenological analysis.

In this paper a grid-tied photovoltaic (PV) cascaded H-bridge (CHB) inverter with embedded storage units is proposed. The multi-input single-output inverter architecture allows a distributed maximum power point tracking (DMPPT) approach, thus mitigating the mismatch effects. The energy storage units (ESUs) embedded at each dc-link provides more flexibility to the power circuit compensating for the inherent variability of the PV sources. The proposed power system ensures a continuous power supply to the grid also in case of PV power fluctuations due to irradiance conditions as well as to the MPPT. In particular, the presence of a storage element allows a voltage sweep on the PV source to be implemented, thus guaranteeing the maximization of PV energy harvesting, with no detrimental effect on the power delivery to the utility network. The numerical results, carried out on a single-phase nineteen-level PV CHB inverter, reveal the improved performance of the proposed design and control technique.

Abstract The kinetics of methane hydrate decomposition was studied using a semibatch stirred-tank reactor. The decomposition was accomplished by reducing the pressure on a hydrate slurry in water to a value below the three-phase equilibrium pressure at the reactor temperature. The data were obtained at temperatures from 274 to 283 K and pressures from 0.17 to 6.97 MPa. The stirring rates were high enough to eliminate mass-transfer effects. Analysis of the data indicated that the decomposition rate was proportional to the particle surface area and to the difference in the fugacity of methane at the equilibrium pressure and the decomposition pressure. The proportionality constant showed an Arrhenius temperature dependence. An estimate of the hydrate particle diameters in the experiments permitted the development of an intrinsic model for the kinetics of hydrate decomposition.

The safeguard of power equipments is assuming a major role in the deregulated electricity market, where a malfunctioning power system could be responsible for serious damages to a large number of system operators having access to the shared energy resource. In this context thermal monitoring of power cables represents a key issue in evaluating the risks associated with a given load management policy especially during emergency conditions. In particular this demands for reliable assessment models that should be able to predict the transient thermal behaviour when the load exceeds the nameplate value. In this connection the application of both simplified and detailed power cable thermal models is often complicated by the presence of uncertainties affecting the tolerances of the input data. The effect of these uncertainties could influence the final solution to a considerable extent. A comprehensive tolerance analysis is therefore required in order to incorporate the effect of data uncertainties into the thermal modelling process. To address this problem, in the paper the employment of interval mathematic is proposed. Several numerical results are presented and discussed in order to assess the effectiveness of the proposed methodology which offer a rough qualitative insight of the solution in a very short time, comparable to the time required for a deterministic numerical simulation.

This work presents a crude bioethanol fueled integrated power system for backup and off-grid applications. The system is based on ethanol steam reformation to hydrogen that is used in polymer electrolyte fuel cells to produce electricity. We introduce the system design and overall system specifications, and report the experimental process of defining specifications for the produced hydrogen quality, a key variable affecting the final system cost, efficiency and durability. Results from development of individual subsystems are also presented together with discussion on the complete system integration.

In this article is presented the preliminary evaluation of the performance of radiation transmission of glass block, used in support of photovoltaic cells, investigating different internal surface points of the block, which are subject to different shading during daylight hours. The aim is to establish how the edging setting, the only opaque element, can reduce the amount of light radiation during the day, introducing in this way a reduction of efficiency of the entire generation system. The generation system can be based on traditional photovoltaic cells or on the most suitable dye sensitized solar cells. An experimental measurement setup employing a microprocessor-based instrument has been created and a set of measures have been carried out. The measures prove that the shading effect at different irradiation angles do not affect significantly the lighting over the PV cell.