• Energy Research
• 2021-2025close
• 6. Clean water close
• 12. Responsible consumption close
• 13. Climate action close
• Bioresource Technology close

Large-size woody biomass is a valuable renewable resource to replace fossil fuels in biorefinery processes. The preprocessing of wood chips and briquettes is challenging to manage, especially in an industrial setting, as it generates a significant amount of dust and noise and occasionally causes unexpected accidents. As a result, a substantial amount of resources, energy, labor, and space are needed. The thermochemical conversion behavior of large-size woody biomass was studied to reduce energy consumption for chipping. Large-size wood was 1.5 m in length, 0.1 m in breadth, and stacked 90 cm in height. This strategy has many benefits, including increased effectiveness and reduced CO2 emissions. The target of this paper presents the thermochemical process, and large-size wood was chosen because it provides high-quality product gas while reducing the preprocessing fuel cost. This review examines the benefits of thermochemical conversion technologies for assessing the likelihood of carbon neutrality.

The rapidly evolving global warming is triggering all levels of actions to reduce industrial carbon emissions, while capturing carbon dioxide of industrial origin via microalgae has attracted increasing attention. This article attempted to offer preliminary analysis on the carbon capture potential of microalgal cultivation. It was shown that the energy consumption-associated with operation and nutrient input could significantly contribute to indirect carbon emissions, making the microalgal capture of carbon dioxide much less effective. In fact, the current microalgae processes may not be environmentally sustainable and economically viable in the scenario where the carbon footprints of both upstream and downstream processing are considered. To address these challenging issues, renewable energy (e.g., solar energy) and cheap nutrient source (e.g., municipal wastewater) should be explored to cut off the indirect carbon emissions of microalgae cultivation, meanwhile produced microalgae, without further processing, should be ideally used as biofertilizer or aquafeeds for realizing complete nutrients recycling.

As one of the most abundant biomass resources, crop stalks are great potential feedstock available for anaerobic digestion (AD) to produce biogas. However, the specific physical properties and complex chemical structures of crop stalks form strong barriers to efficient AD bioconversion. To overcome these problems, many efforts have been made over the past few years. This paper reviewed recent research in the evolving field of anaerobic bioconversion of crop stalks and was focused on three critical aspects affecting AD performance: various pretreatment methods and their effects on the improvement of crop stalk biodegradability, determination of specific AD operation parameters for crop stalks, and development of AD technologies. Finally, recommendations on the future development of crop stalk AD were proposed.

In this study, the anaerobic digestion model M-ADM1 was integrated with the gasification model T-ANN to form a set of integrated models that can efficiently simulate the biomass AD-GS integration technology. Biogas slurry is used as feedstocks to prepare biogas slurry fertilizer. Solid residue is used feedstocks for gasification reactions. Biogas and syngas from the gasification of solid residue are used for energy. In this process, carbon emission is regarded as an important index for the comprehensive evaluation and optimization of AD-GS integration process. This study found that when the anaerobic digestion duration was 0 to 15 days, the carbon emission reduction increased rapidly. The amount of carbon emission reduction peaks on day 15. The value of carbon emission reduction is 0.1828 gCO2eq. In addition, when FEAG reached the maximum value at 15 days of anaerobic digestion, the decreasing trend of FEAG rate change value started to become significant.

This study reports the effects of polar (acetone/methanol) and non-polar (chloroform/hexane) solvents on lipid yield, fatty acids methyl esters (FAMEs) composition, and biodiesel properties of microalgae. The lipids yield extracted by hexane and chloroform (100.01 and 94.33 mg/g) were higher than by methanol and acetone (40.12 and 86.91 mg/g). The polarity of solvents also affected FAMEs composition of microalgal lipids. Total saturated fatty acids and unsaturated fatty acids of extracted lipids were 61.53% and 38.47% by chloroform and 38.85% and 61.15% by methanol. Moreover, polar and non-polar solvents affected the biodiesel properties such as cetane number and oxidative stability. In addition, higher ratio of chloroform to methanol and higher temperature increased the lipid yield and saturation degree of lipids, through ultrasound-assisted lipid extraction method. Overall, the results revealed that the lipids yield, FAMEs composition, and biodiesel quality of microalgal biomass can be significantly affected by solvents polarity and extraction conditions.

Food waste generation and its consequent environmental impacts are increasing due to rapid urbanization, the global population, and associated food demand. Microbial fuel cells (MFCs) are a sustainable technology through which this food waste can be treated and used to produce bioelectricity. This study used two MFC configurations, a two-stage anaerobic up-flow leachate reactor MFC and a single-stage MFC, comparing the potential to treat solid fruit waste and fruit waste leachate. The two-stage MFC showed a higher potential to remove substrate at a shorter time compared to single-stage MFC. In 30 days, the two-stage anaerobic up-flow leachate reactor had a power density of 221 mW/m2. It was able to remove more total solids (by 95 %), volatile solids (by 70 %), total chemical oxygen demand (by 83 %), soluble chemical oxygen demand (by 87 %), and carbohydrates (by 33 %) compared to the single-stage MFC. However, the single-stage MFC showed higher coulombic efficiency (by 86.7 %) compared to the two-stage MFC. The efficiency of single-stage MFC improved by adding buffer and maintaining a neutral pH level of the substrate. The results of this study emphasize the importance of reactor design and demonstrate that MFC can be a viable technology to generate bioenergy from food waste.

In this study, Pennisetum giganteum (PG) was investigated as lignocellulosic feedstock to be pretreated by the acidic and basic deep eutectic solvents (DESs) to generate monomeric sugars. The basic DESs showed excellent efficiency of delignification and saccharification. ChCl/MEA can remove 79.8 % lignin and reserve 89.5 % cellulose. As a result, 95.6 % glucose and 88.0 % xylose yield were obtained, significantly enhanced 9.4 and 15.5 times in contrast with those of the unpretreated PG. The 3D microstructures of raw and pretreated PG were constructed for the first time to better investigate the pretreatment effect on its structure. The increasing porosity (20.5 %) and the reducing CrI (42.2 %) contributed in enhancing enzymatic digestion. Moreover, the recyclability of DES indicated that at least 90 % DES was recovered and 59.5 % lignin still can removed with 79.8 % glucose were obtained after five recycling cycles. Meanwhile, 51.6 % lignin was recovered throughout the recycling process.

In this study, fuel ethanol production from food waste using enzymatic hydrolysis and fermentation was evaluated from techno-economic viewpoint. The plant was designed with a capacity of 10 t/d food waste and a lifetime of 15-year. The total capital cost, annual operation cost and annual net profits of the plant were US$ 367,552, US$ 155,959 and US$ 74,995.57, respectively. The plant was economically viable as long as the internal rate of return remained below 29.8%. The shortest payback time was 5 years with discount rate of 5%. The price of fuel ethanol and food waste treatment fee were the most important variables for the economic performance of the plant by sensitivity analysis. This work could provide the basic knowledge for techno-economic analysis of food waste treatment and promote the industrial production of fuel ethanol.

Fungal pellet is an emerging material to collect oleaginous microalgae, but rare studies have noticed that harvested water is available resource for the next round of cultivation. To systematically optimize regrowth performances of microalgae Chlorella vulgaris, separated water after harvesting by fungi Aspergillus oryzae was prepared under different N/P ratios. The results showed that chlorophylls and enzymes were significantly affected by the proportion of N and P. Although nutrient deficiency was functioned as a stress factor to restrict carbohydrate and protein synthesis, lipid content was obviously increased by 12.69%. The percentage of saturated fatty acids associated with oxidation stability increased, while this part in fresh wastewater accounted for only 36.96%. The favorable biomass concentration (1.37 g/L) with the highest lipid yield (0.42 g/L) appeared in N/P of 6:1. More strikingly, suitable conditions could save 52.4% of cultivation costs. These experiments confirmed that reusing bioflocculated water could be effectively utilized for biodiesel production.