• Energy Research
• 2021-2025close
• ES close
• Transport Research close

This research presents a 100% renewable energy (RE) scenario by 2050 with a high share of electric vehicles on the grid (V2G) developed in Ecuador with the support of the EnergyPLAN analysis tool. Hour-by-hour data iterations were performed to determine solutions among various features, including energy storage, V2G connections that spanned the distribution system, and long-term evaluation. The high participation in V2G connections keeps the electrical system available; meanwhile, the high proportions of variable renewable energy are the pillar of the joint electrical system. The layout of the sustainable mobility scenario and the high V2G participation maintain the balance of the electrical system during most of the day, simplifying the storage equipment requirements. Consequently, the influence of V2G systems on storage is a significant result that must be considered in the energy transition that Ecuador is developing in the long term. The stored electricity will not only serve as storage for future grid use. Additionally, the V2G batteries serve as a buffer between generation from diversified renewable sources and the end-use stage.

The increasing use of power electronic inverters in electrical drives is leading to the unexpected inception of partial discharges (PD) within the insulation system of electric machine stator windings. Unfortunately, the short rise and fall times of such voltages, below 100 nanoseconds in most cases, create high-magnitude conducted and radiated interferences that affect the measurements. Detecting partial discharges in these systems with inductive or electromagnetic sensors turns to be an important challenge, especially when interference and partial discharges share the same bandwidth. In this work, the authors propose a technique to detect the occurrence of PD in such systems, even when they are masked by disturbances. The proposed technique combines an analog high-pass filter stage and a digital band-pass to select a proper spectral interval. The resulting signal is converted to the base-band, where two metrics based on the peak-to-average power ratio are proposed. Experimental results obtained with the signals acquired with two antennas show that both proposed metrics exhibit a significant increase, about ten times greater, when the applied voltage exceeds the PD inception voltage. These contributions define new markers for the detection of PD events created by pulsed voltages with overlapped overshoots with promising results.

Modern ports tend to focus on freight transport and cruise traffic. The fishing sector is often the forgotten sector in terms of sustainability and port planning, despite the fact that fishing is a sector of great importance and interest; though it is currently obsolete in many respects. Literature on sustainability and green ports in the context of fishing ports is practically non-existent; however, it is necessary in order to implement a sustainable fishing infrastructure. For this reason, the aim of this study is, within the green ports framework as outlined by the European Commission and using an innovative end-to-end tool methodology, to determine the reality of the conditions of the port environment in fishing ports. Furthermore, this study establishes a possible green ports scenario for Spanish fishing ports and carries out an analysis of a specific case study within the Spanish port system: the Port of Vigo. It is concluded that the key fishing features of the Port of Vigo should, in order to expand its sustainability strategies, are: growth expectations, closely related to the evolution of the goods unloaded in the Port of Vigo and the possible growth that this may have in the future; legislation and current trends in terms of sustainability; and diversification, the Port of Vigo has realistic options to diversify the business beyond the traditional fishing activities.

Floating offshore multi-wind turbines (FOMWTs) are an interesting alternative to the up-scaling of wind turbines. Since this is a novel concept, there are few numerical tools for its coupled dynamic assessment at the present time. In this work, a numerical framework is implemented for the simulation of multi-rotor systems under environmental excitations. It is capable of analyzing a platform using leaning towers that handle wind turbines with their own features and control systems. This tool is obtained by coupling the seakeeping hydrodynamics solver SeaFEM with the single wind turbine simulation tool OpenFAST. The coupling of SeaFEM provides a higher fidelity hydrodynamic solution, allowing the simulation of any structural design using the finite element method (FEM). Additionally, a methodology is proposed for the extension of the single wind solver, allowing for the analysis of multi-rotor configurations. To do so, the solutions of the wind turbines are computed independently using several OpenFAST instances, performing its dynamic interaction through the floater. This method is applied to the single turbine Hywind concept and the twin-turbine W2Power floating platform, supporting NREL 5-MW wind turbines. The rigid-body response amplitude operators (RAOs) are computed and compared with other numerical tools. The results showed consistency in the developed framework. An agreement was also obtained in simulations with aerodynamic loads. This resulting tool is a complete time-domain aero–hydro–servo–elastic solver that is able to compute the combined response and power generation performance of multi-rotor systems.

Public transport is a cornerstone in the transition towards sustainable cities. Moreover, greenhouse gas emissions can be further reduced through powertrain electrification. In this context, plug-in electric hybrid buses emerge as a suitable and flexible solution. They can switch between an electric motor and a combustion engine during operation. An optimal electric drive assignment strategy allows achieving a high electric range and reduced tailpipe emissions. In this work, we look for optimal strategies for maximizing the distance traversed in electric mode and minimizing the total emissions, for real routes including green corridors where the combustion engine cannot be used. Contrary to existing works, this approach does not only focus on the improvement of the bus performance in terms of energy consumption, but also on the environmental benefits and livability of cities. This challenge is solved using two multi-objective state-of-the-art evolutionary algorithms, and a novel heuristic, GreenK. Two real- world scenarios are analyzed, namely bus routes M6 in Badalona, and 18 in Grudziadz. Results show a significant reduction in emissions of up to 21% with respect to the strategy found by GreenK, meaning 24 kg less pollutants emitted daily and over 22.5% electric range increase, compared to the currently deployed solution

AbstractOcean ecosystems are at the forefront of the climate and biodiversity crises, yet we lack a unified approach to assess their state and inform sustainable policies. This blueprint is designed around research capabilities and cross-sectoral partnerships. We highlight priorities including integrating basin-scale observation, modelling and genomic approaches to understand Atlantic oceanography and ecosystem connectivity; improving ecosystem mapping; identifying potential tipping points in deep and open ocean ecosystems; understanding compound impacts of multiple stressors including warming, acidification and deoxygenation; enhancing spatial and temporal management and protection. We argue that these goals are best achieved through partnerships with policy-makers and community stakeholders, and promoting research groups from the South Atlantic through investment and engagement. Given the high costs of such research (€800k to €1.7M per expedition and €30–40M for a basin-scale programme), international cooperation and funding are integral to supporting science-led policies to conserve ocean ecosystems that transcend jurisdictional borders.

This article presents the creation of bathymetric cartography for San Andrés, Providencia, Santa Catalina, and the Colombian Caribbean to find suitable areas for implementing an ocean thermal energy conversion (OTEC) system. The methodology to obtain the bathymetry uses data collection, digitization, and interpolation. The data are processed using the Surfer® software; in this way, the digital terrain model (DTM) maps are generated for each sector. The objective is to find the minimum distance to reach a depth of 1000 m since this is the distance where a temperature difference of 20 ∘C is obtained. Thus, it is possible to identify suitable areas to locate an onshore or offshore plant in Santa Marta, Barranquilla, southwestern and northwestern San Andrés, the western part of Santa Catalina, and the southwestern part of Providencia.