• Energy Research
• 2016-2025close
• 7. Clean energy close
• 11. Sustainability close
• Transport Research close

Three data files are provided for Case Study 1 in the openENTRANCE project: Full_potential.V9.csv, metaData.Full_Potential.csv, and acheivable_NUTS2_summary.csv. The data covers 10 residential devices on the NUTS2 level for the EU27 + UK +TR + NO + CH from 2020-2050. The devices included are storage heater, water heater with storage capabilitites, air conditiong, heat circulation pump, air-to-air heat pump, refreigeration (includes refrigerators and freezers), dish washer, washing machine, and tumble drier. Full_potential.V9.csv shows the NUTS2 level unadjusted loads for residential storage heater, water heater, air conditiong, circulation pump, air-to-air heat pump, refreigeration (includes refrigerators and freezers), dish washer, washing machine, and tumble drier using representative hours from 2020-2050. The loads provided here have not been adjusted with the direct load participation rates (see paper for more details). More details on the dataset can be found in the metaData.Full_Potential.csv file. The acheivable_NUTS2_summary.csv shows the NUTS2 level acheivable direct load control potentials for the average hour in the respective year (years - 2020, 2022,2030,2040, 2050).

A 2016 Honda Civic with a 4-cylinder 1.5-liter L15B7 turbocharged engine and continuously variable transmission (CVT) was benchmarked. The test method involved installing the engine and its CVT in an engine dynamometer test cell with the engine wiring harness tethered to its vehicle parked outside the test cell. Engine and transmission torque, fuel flow, key engine temperatures and pressures, and onboard diagnostics (OBD)/CAN bus data were recorded. The paper published as part of this work documents the test results for idle, low, medium and high load engine operation, as well as motoring torque, wide-open throttle torque and fuel consumption during transient operation using both EPA Tier 2 and Tier 3 test fuels. Particular attention is given to characterizing enrichment control during high load engine operation. Results have been used to create complete engine fuel consumption and efficiency maps and estimate CO2 emissions using EPA’s ALPHA full vehicle simulation model, over regulatory drive cycles. Within the published paper, the design and performance of the 1.5-liter Honda engine are compared to several other past, present, and future downsized-boosted engines and potential advancements were evaluated.

Introduction. The article presents an analysis of researches on the operation of public transport vehicles with an electric drive. Electric buses have been tested in megacities, and despite the advantages, problems were identi- fied both in the selection of the charging type, technological features and with the availability and operation of the charging infrastructure. The operation process is associated with a number of technical restrictions, which in prac- tice make it difficult to select routes for the electric bus operation. The aim of the study is to develop an algorithm for selecting a rational regular urban route for the electric bus operation and to test it on the example of the route network of Tyumen.Materials and methods. A structural diagram of the factors influencing the selection of the route for the electric bus operation has been formed. As a result of processing expert assessments, the most significant factors were identified. The diagram of the interconnections of these factors is identified and limitations for the algorithm are for- mulated based on the theory of systems analysis. The algorithm for selecting the rational regular urban route for the electric bus operation has been developed. It enables creating the simulation model for selecting a rational regular urban route for the operation of an electric bus.Results. The diagram of factors influencing the selection of a rational regular urban route for the operation of an electric bus, taking into account their mutual relations, has been formed. The algorithm and simulation model for se- lecting a rational regular urban route for the operation of an electric bus has been developed. Several urban routes in Tyumen were assessed for the rationality of the introduction of electric buses.Discussion and conclusions. Evaluation of five regular urban routes in Tyumen using the developed algorithm and the simulation model revealed three rational routes, and also showed the inefficiency of the other two. It due to the discrepancy between the duration of the charging session and breaks in operation, as well as the insufficient charge level of the traction battery to ensure the required autonomous movement of the vehicle. In the course of the continuation of these studies, the developed algorithm will be supplemented with the stage of economic assess- ment of routes for the operation of electric buses.

This research presents a 100% renewable energy (RE) scenario by 2050 with a high share of electric vehicles on the grid (V2G) developed in Ecuador with the support of the EnergyPLAN analysis tool. Hour-by-hour data iterations were performed to determine solutions among various features, including energy storage, V2G connections that spanned the distribution system, and long-term evaluation. The high participation in V2G connections keeps the electrical system available; meanwhile, the high proportions of variable renewable energy are the pillar of the joint electrical system. The layout of the sustainable mobility scenario and the high V2G participation maintain the balance of the electrical system during most of the day, simplifying the storage equipment requirements. Consequently, the influence of V2G systems on storage is a significant result that must be considered in the energy transition that Ecuador is developing in the long term. The stored electricity will not only serve as storage for future grid use. Additionally, the V2G batteries serve as a buffer between generation from diversified renewable sources and the end-use stage.

Car-sharing services are developing at an ever-increasing pace. Taking into account the reduction of carbon dioxide emissions and pursuit of the sustainable development of transport, implementing electric cars in car-sharing fleets is being proposed. On the one hand, these types of vehicles are referred to as emission-free, but on the other hand, their environmental friendliness is questionable due to the emission of carbon dioxide during the production of energy to power them. Although many scientific papers are devoted to the issue of reducing emissions through car sharing, there is a research gap concerning the real production of carbon dioxide by car-sharing vehicles during car-sharing trips. To fill this research gap, the objective of the article was to analyze the actual level of carbon dioxide emissions from combustion and electric vehicles from car-sharing systems produced when renting rides. The test results showed that the electric car turned out to be significantly less emitting. The use of electric vehicles in car-sharing fleets can reduce carbon dioxide emissions from 14% to 65% compared to using cars with internal combustion engines. However, the key role during car-sharing trips is played by the driving style of the drivers, which has been omitted from the literature to date. This should be properly regulated by service providers and focus on the proper use of energy from electric vehicle batteries, especially at low temperatures. The article provides support for operators planning to modernize their fleet of vehicles and fills the research gap concerning car-sharing emissions.

The COVID-19 pandemic has tremendously affected the whole of human society worldwide. Travel patterns have greatly changed due to the increased risk perception and the governmental interventions regarding COVID-19. This study aimed to identify contributing factors to the changes in public and private transportation mode choice behavior in China after COVID-19 based on an online questionnaire survey. In the survey, travel behaviors in three periods were studied: before the outbreak (before 27 December 2019), the peak (from 20 January to 17 March 2020), and after the peak (from 18 March to the date of the survey). A series of random-parameter bivariate Probit models was developed to quantify the relationship between individual characteristics and the changes in travel mode choice. The key findings indicated that individual sociodemographic characteristics (e.g., gender, age, ownership, occupation, residence) have significant effects on the changes in mode choice behavior. Other key findings included (1) a higher propensity to use a taxi after the peak compared to urban public transportation (i.e., bus and subway); (2) a significant impact of age on the switch from public transit to private car and two-wheelers; (3) more obvious changes in private car and public transportation modes in more developed cities. The findings from this study are expected to be useful for establishing partial and resilient policies and ensuring sustainable mobility and travel equality in the post-pandemic era.

The purpose of this work was to develop and validate a 48 V lithium-ion battery model for integration into EPA’s ALPHA vehicle simulation model and that can also be used within Gamma Technologies, LLC (Westmont, IL) GT-DRIVE™ vehicle simulations. These vehicle models allow simulation of energy flows and CO2 emissions for mild hybrid electric vehicles over EPA regulatory drive cycles and during real-world driving. The battery model is a standard equivalent circuit model with two-time constant resistance-capacitance (RC) blocks. Resistances and capacitances were calculated using test data from an 8 Ah, 0.4 kWh, 48 V (nominal) lithium-ion battery obtained from a Tier 1 automotive supplier, A123 Systems, and developed specifically for 48 V MHEV applications. The A123 Systems battery has 14 pouch-type lithium ion cells arranged in a 14 series and 1 parallel (14S1P) configuration. The RC battery model was validated using battery test data generated by a hardware-in-the-loop (HIL) system that simulated the impact of mild hybrid electric vehicle (MHEV) operation on the A123 systems 48 V battery pack over U.S. regulatory drive cycles. The HIL system matched charge and discharge data originally generated by Argonne National Laboratory (ANL) during chassis dynamometer testing of a 2013 Chevy Malibu Eco 115 V MHEV. All validation testing was performed at the Battery Test Facility (BTF) at the U.S. EPA National Vehicle and Fuel Emissions Laboratory (NVFEL) in Ann Arbor, Michigan. The simulated battery voltages, currents, and state of charge (SOC) of the HIL tests were in good agreement with vehicle test data over a number of different drive cycles and excellent agreement was achieved between RC model simulations of the 48 V battery and HIL battery test data.

Vehicle data consist of electric vehicle performance data collected directly from the vehicle during standard operations. Data were collected using onboard data loggers that were either installed by the project team or preinstalled by the original equipment manufacturer. Data recorded by the data loggers were made accessible via an online web portal or an application programming interface. Different data loggers were used (HEM, ViriCiti, and Geotab), and the method for each vehicle is defined in the vehicle attributes file. Some systems collected data on a “trip-level” basis, in which each row of a table represents a single trip (the period between a key-on and key-off event), whereas other data were collected on a per-day basis, in which each row represents a single day of operation. Data were collected over a range of data collection periods, depending on the project. Data have been anonymized by removing information or decreasing information resolution as necessary so that fleets are not identifiable. Due to the wide range of vehicle types represented and variation in data collection, data parameters and frequencies differ between vehicles and fleets The **Performance Data Daily/Trip Data Dictionaries** contain definitions for each available parameter associated with a vehicle’s operations, aggregated at either a daily or trip level. The parameters available will vary from vehicle to vehicle, but every possible parameter will be defined. The **Vehicle Attributes Data Dictionary** contains definitions for each available parameter associated with a vehicle’s physical and functional attributes and fleet context. The **Vehicle Attributes** table contains specific vehicle characteristics, coded to an anonymous Vehicle ID. This Vehicle ID can be used as a key between vehicle data and vehicle attribute tables. The **Vehicle Data** tables contain the data from each vehicle’s operations, aggregated at either a daily or trip level, coded to an anonymous Vehicle ID. This Vehicle ID can be used as a key between vehicle data and vehicle attribute tables. Data is being uploaded quarterly through 2023 and subject to change until the conclusion of the project.

The EV Shuttle Bus Pilot dataset contains data and analysis from Hocking-Athens-Perry Community Action's demonstration of an electric bus on routes of their rural Athens Public Transit system. The vehicle used in the demonstration was a Ford E-450 cutaway equipped with an electric drivetrain, a 127-kWh battery system by Motiv Power Systems, and a cabin upfit by Turtle Top. Data gathered include route assignments, running time and distance, fuel economy, and charge cycles. A comparison of the vehicle's observed duty cycle with duty cycle modeling from other rural transit fleets in the National Transit Database is included to help better understand the rural adoption potential for this fleet technology.