• Energy Research
• Closed Access close
• Open Source close
• Embargo close
• Netherlands Research Portal close

Dried, milled perennial ryegrass samples were processed using chemical and physical treatments and the extracted cellulose products were analysed for yield, crystallinity by X-ray Diffraction (XRD) and for purity using Thermogravimetric Analysis (TGA), Pyrolysis-Gas Chromatography/Mass Spectrometry (Py-GC/MS) and Fourier Transform Infrared (FTIR) spectroscopy. Extraction protocols examined the use of chemical chelation, acid and alkaline hydrolysis, along with physical degradation methods. Highest product yields were obtained using single step chemical protocols followed by physical processing, however, these products had low crystallinity and higher amorphous fraction content. Multistep chemical processing to completely remove hemicellulose and lignin with an alkali refluxing step, delivered lower yielding cellulose products of greater crystallinity and purity. In combination, the four instrumental techniques highlighted removal of amorphous fractions, providing rapid, accurate compositional data on the extracted cellulose products.

In this study, levulinic acid (LA) was produced from rice straw biomass in co-solvent biphasic reactor system consisting of hydrochloric acid and dichloromethane organic solvent. The modified protocol achieved a 15% wt LA yield through the synergistic effect of acid and acidic products (auto-catalysis) and the designed system allowed facile recovery of LA to the organic phase. Further purification of the resulting extractant was achieved through traditional column chromatography, which yielded a high purity LA product while recovering ∼85% wt. Upon charcoal treatment of the resultant fraction generated an industrial grade target molecule of ∼99% purity with ∼95% wt recovery. The system allows the solvent to be easily recovered, in excess of 90%, which was shown to be able to be recycled up to 5 runs without significant loss of final product concentrations. Overall, this system points to a method to significantly reduce manufacturing cost during large-scale LA preparation.

The influence of ethanol on the degradation kinetics of linear alkyl benzene sulfonate (LAS) and organic matter was investigated using batch experiments with different initial LAS concentrations (8.3 mg L-1 to 66.9 mg L-1) and biomass immobilized on sand. Data were fitted with a substrate inhibition model. Concentrations of 2.4 mg LAS L-1 and 18.9 mg LAS L-1 (without and with ethanol) provided the maximum LAS utilization rate by the biomass (Sbm). For LAS degradation, ethanol addition favored a lower decrease in the specific substrate utilization rate (robs), even at the LAS concentration usually reported as inhibitory (> 14.4 mg L-1). For organic matter degradation, robs was higher with ethanol. Higher biomass differentiation was observed at higher LAS concentrations. With ethanol, microbial selection occurred at LAS concentrations near Sbm. At higher LAS concentrations, the dominance and diversity values did not change significantly with ethanol, whereas without ethanol, their behaviors were irregular.

New transparent optodes for life-time based microscopic imaging of O₂ were developed by spin-coating a μm-thin layer of a highly luminescent cyclometalated iridium(III) coumarin complex in polystyrene onto glass cover slips. Compared to similar thin-film O₂ optodes based on a ruthenium(II) polypyridyl complex or a platinum(II) porphyrin, the new planar sensors have i) higher brightness allowing for much shorter exposure times and thus higher time resolution, ii) more homogeneous and smaller pixel to pixel variation over the sensor area resulting in less noisy O₂ images, and iii) a lower temperature dependency simplifying calibration procedures. We used the new optodes for microscopic imaging of the spatio-temporal O₂ dynamics at the base of heterotrophic biofilms in combination with confocal imaging of bacterial biomass and biofilm structure. This allowed us to directly link biomass distribution to O₂ distribution under both steady state and non-steady state conditions. We demonstrate that the O₂ dynamics in biofilms is governed by a complex interaction between biomass distribution, mass transfer and flow that cannot be directly inferred from structural information on biomass distribution alone.

Microalgae are promising sources of valuable compounds: carotenoids, polyunsaturated fatty acids, lipids, etc. To overcome the feasibility challenge due to low yield and attain commercial potential, researchers merge technologies to enhance algal bioprocess. In this context, nanomaterials are attractive for enhancing microalgal bioprocessing, from cultivation to downstream extraction. Nanomaterials enhance biomass and product yields (mainly lipid and carotenoids) through improved nutrient uptake and stress tolerance during cultivation. They also provide mechanistic insights from recent studies. They also revolutionize harvesting via nano-induced sedimentation, flocculation, and flotation. Downstream processing benefits from nanomaterials, improving extraction and purification. Special attention is given to cost-effective extraction, showcasing nanomaterial integration, and providing a comparative account. The review also profiles nanomaterial types, including metallic nanoparticles, magnetic nanomaterials, carbon-based nanomaterials, silica nanoparticles, polymers, and functionalized nanomaterials. Challenges and future trends are discussed, emphasizing nanomaterials' role in advancing sustainable and efficient microalgal bioprocessing, unlocking their potential for bio-based industries.

Consumer interest in food products, including fresh vegetables, with health promoting properties is rising. In fresh vegetables, these properties include vitamins, minerals, dietary fiber, and secondary compounds, which collectively impart a large portion of the dietary, nutritional or health value associated with vegetable intake. Many, including farmers, aim to increase the health-promoting properties of fresh vegetables on the whole but they face at least three obstacles. First, describing crop composition in terms of its nutrition-based impact on human health is complex and there are few, if any, accepted processes and associated metrics for assessing and managing vegetable composition on-farm, at the origin of supply. Second, data suggest that primary and secondary metabolism can be 'in conflict' when establishing the abundance versus composition of a crop. Third, fresh vegetable farmers are rarely compensated for the phytochemical composition of their product. The development and implementation of a fresh vegetable 'nutritional yield' index could be instrumental in overcoming these obstacles. Nutritional yield is a function of crop biomass and tissue levels of health-related metabolites, including bioavailable antioxidant potential. Data from a multi-factor study of leaf lettuce primary and secondary metabolism and the literature suggest that antioxidant yield is sensitive to genetic and environmental production factors, and that changes in crop production and valuation will be required for fresh vegetable production systems to become more focused and purposeful instruments of public health.

Plants exhibit plasticity in response to their current environment and, in some cases, to that of the previous generation (i.e. maternal effects). However, few studies have evaluated both within- and between-generation plasticities and the extent to which they interact to influence fitness, especially in natural environments. The plasticity of adult traits to two generations of natural differences in light was determined for Campanulastrum americanum, a forest-edge herb that expresses annual and biennial life histories. Plasticity was found to an individual's light environment (within generation) and the maternal light environment (between generations). Responses to ambient light for size traits and timing of flowering were probably passive, whereas apparently adaptive responses were found for light acquisition traits. Maternal light influenced the expression of most adult traits but had the strongest effect when plants were germinated in natural environments. The transgenerational effects of light were consistent with adaptive plasticity for several traits. Plastic within-generation changes in flowering time may also result in adaptive between-generation effects by altering the offspring life history schedule. Finally, the results underscore the importance of conducting studies of within- and between-generation plasticity in natural populations, where the environmental context is relevant to that in which the traits evolved.

Algae production process is a key cost center in production of biofuels/bioproducts from microalgae. Decline in the growth of algae in outdoor ponds during non-optimal conditions is one of the hurdles for achieving consistently high algal production rates. An optimal controller can be used to overcome this limitation and provide reliable growth in outdoor conditions. A model predictive controller (MPC) was developed to optimize the algal growth, predicted by flux balance analysis, under natural disturbances, embedding within the cost function, the economic and environmental constraints associated with the process. The model, developed in MATLAB, was validated on a 30-L continuous algal culture under light, temperature and a combination of light and temperature disturbances. The MPC proved effective in minimization of a decrease in growth under these natural disturbances. The growth rates with MPC were observed to be 79-116% higher as compared to the non-MPC growth.

U radu je opisan princip rada kogeneracijskih postrojenja te neke dostupne tehnologije koje koriste krutu biomasu kao gorivo. Naglasak je stavljen na vodeno-parno postrojenje te na postrojenje koje koristi organsku radnu tvar, tzv. ORC postrojenje. Također, izrađeni su pojednostavljeni matematički modeli dinamike procesa za termouljni i vodeno-parni kotao s izgaranjem biomase na rešetki kako bi bilo moguće simulirati utjecaj vlažnosti biomase na parametre na izlazu iz kotla. Proveden je termodinamički proračun izgaranja te dimenzioniranje veličina u sustavu. Početni podatak bio je potreban toplinski tok koji se mora prenijeti na radni medij koji iznosi 5MW. Nakon toga uslijedila je simulacija utjecaja promjenjive vlažnosti na temperature na izlazu iz izmjenjivača te su tablično prikazani dobiveni podaci. Na kraju su opisani problemi koje prevelika ili premala količina vlage u biomasi može izazvati u postrojenjima te regulacijske mjere koje mogu taj učinak kompenzirati. This work describes the general principles of some commercially available cogeneration technologies that use solid biomass as a fuel. Emphasis is placed upon water-steam and ORC cogeneration plants. Also, simplified mathematical models of sintetic oil and water-steam boilers with combustion of solid biomass on a grid were made in order to simulate the impact of biomass moisture on working fluid exit temperatures. The thermodynamic calculation of boiler was made and plant dimensions were chosen. Initial data was the required heat flow that needs to be transferred between flue gases and working fluid with a value of 5MW. After that the simulation of variable moisture impact on working fluid exit temperatures was made and the results are shown in pictures. At the end, some problems that occur from variable moisture in plants were described and some regulatory measures proposed.