• Energy Research
• Open Access close
• Closed Access close
• Open Source close
• Embargo close
• Netherlands Research Portal close

Dried, milled perennial ryegrass samples were processed using chemical and physical treatments and the extracted cellulose products were analysed for yield, crystallinity by X-ray Diffraction (XRD) and for purity using Thermogravimetric Analysis (TGA), Pyrolysis-Gas Chromatography/Mass Spectrometry (Py-GC/MS) and Fourier Transform Infrared (FTIR) spectroscopy. Extraction protocols examined the use of chemical chelation, acid and alkaline hydrolysis, along with physical degradation methods. Highest product yields were obtained using single step chemical protocols followed by physical processing, however, these products had low crystallinity and higher amorphous fraction content. Multistep chemical processing to completely remove hemicellulose and lignin with an alkali refluxing step, delivered lower yielding cellulose products of greater crystallinity and purity. In combination, the four instrumental techniques highlighted removal of amorphous fractions, providing rapid, accurate compositional data on the extracted cellulose products.

Dried, milled perennial ryegrass samples were processed using chemical and physical treatments and the extracted cellulose products were analysed for yield, crystallinity by X-ray Diffraction (XRD) and for purity using Thermogravimetric Analysis (TGA), Pyrolysis-Gas Chromatography/Mass Spectrometry (Py-GC/MS) and Fourier Transform Infrared (FTIR) spectroscopy. Extraction protocols examined the use of chemical chelation, acid and alkaline hydrolysis, along with physical degradation methods. Highest product yields were obtained using single step chemical protocols followed by physical processing, however, these products had low crystallinity and higher amorphous fraction content. Multistep chemical processing to completely remove hemicellulose and lignin with an alkali refluxing step, delivered lower yielding cellulose products of greater crystallinity and purity. In combination, the four instrumental techniques highlighted removal of amorphous fractions, providing rapid, accurate compositional data on the extracted cellulose products.

Charcoal has a large share in the Brazilian market. The production is carried out by pyrolysis of biomass at different temperatures, between 300 and 500 °C. In this study, the corn cob pyrolysis was investigated using thermogravimetric analysis (TGA) and Fourier Transform Infrared Spectroscopy (FTIR). Samples after pyrolysis were compared with raw biomass to evaluate changes in fuel characteristics. In DTG curves a reduction in the number of degradation peaks in the carbonized material was observed. The FTIR spectra allowed to identify the aromatic ring of the lignin in the charcoals structure, indicating the presence of this compound even in charcoals produced with a temperature of 500 °C. It can be concluded that the temperature of 400 °C was enough to completely degrade the hemicellulose and cellulose of the biomass, resulting the final product (charcoal) less reactive or thermally more resistant than the in natura corn cob.

Charcoal has a large share in the Brazilian market. The production is carried out by pyrolysis of biomass at different temperatures, between 300 and 500 °C. In this study, the corn cob pyrolysis was investigated using thermogravimetric analysis (TGA) and Fourier Transform Infrared Spectroscopy (FTIR). Samples after pyrolysis were compared with raw biomass to evaluate changes in fuel characteristics. In DTG curves a reduction in the number of degradation peaks in the carbonized material was observed. The FTIR spectra allowed to identify the aromatic ring of the lignin in the charcoals structure, indicating the presence of this compound even in charcoals produced with a temperature of 500 °C. It can be concluded that the temperature of 400 °C was enough to completely degrade the hemicellulose and cellulose of the biomass, resulting the final product (charcoal) less reactive or thermally more resistant than the in natura corn cob.

Many aquatic species with stylar polymorphisms have the capacity for clonal and sexual reproduction and are sensitive to the balance of the two reproductive modes when there are a limited number of mating morphs within a population. This study asked how the clonal and sexual reproductive modes perform in populations that contain only a single morph and where fitness gain through sexual reproduction is rare. In clonal aquatic Nymphoides montana, polymorphic populations normally contain two mating morphs in equal frequencies. Populations are sexually fertile and appear to be maintained by pollen transfer between the two partners. However, in a monomorphic population of N. montana where mating opportunities are unavailable, female and male function is impaired and clonality maintains the population. Here, the consequences of intraspecific variation in sexuality were explored between monomorphic and polymorphic N. montana populations in eastern Australia.Comparative measurements of male and female fertility, total dry mass and genotypic diversity using ISSR markers were made between populations with variable sexuality.Very few seeds were produced in the monomorphic population under natural and glasshouse conditions due to dysfunctional pollen and ovules. Stigma-anther separation was minimal in the monomorphic population, which may be a consequence of the relaxed selective pressures that regulate the maintenance of sexual function. However, clonal reproduction was favoured at the expense of sexual reproduction in the monomorphic population; this may facilitate the establishment of sterility throughout the population via resource reallocation or pleiotropic effects. The ISSR results showed that the monomorphic population was one large, single genotype, unlike the multi-genotypic fertile polymorphic populations. Evolutionary loss of sex in a clonal population in which a mating morph is absent was evident; under these conditions clonal growth may assure reproduction and expand the population via spreading stolons.

Many aquatic species with stylar polymorphisms have the capacity for clonal and sexual reproduction and are sensitive to the balance of the two reproductive modes when there are a limited number of mating morphs within a population. This study asked how the clonal and sexual reproductive modes perform in populations that contain only a single morph and where fitness gain through sexual reproduction is rare. In clonal aquatic Nymphoides montana, polymorphic populations normally contain two mating morphs in equal frequencies. Populations are sexually fertile and appear to be maintained by pollen transfer between the two partners. However, in a monomorphic population of N. montana where mating opportunities are unavailable, female and male function is impaired and clonality maintains the population. Here, the consequences of intraspecific variation in sexuality were explored between monomorphic and polymorphic N. montana populations in eastern Australia.Comparative measurements of male and female fertility, total dry mass and genotypic diversity using ISSR markers were made between populations with variable sexuality.Very few seeds were produced in the monomorphic population under natural and glasshouse conditions due to dysfunctional pollen and ovules. Stigma-anther separation was minimal in the monomorphic population, which may be a consequence of the relaxed selective pressures that regulate the maintenance of sexual function. However, clonal reproduction was favoured at the expense of sexual reproduction in the monomorphic population; this may facilitate the establishment of sterility throughout the population via resource reallocation or pleiotropic effects. The ISSR results showed that the monomorphic population was one large, single genotype, unlike the multi-genotypic fertile polymorphic populations. Evolutionary loss of sex in a clonal population in which a mating morph is absent was evident; under these conditions clonal growth may assure reproduction and expand the population via spreading stolons.

In this study, levulinic acid (LA) was produced from rice straw biomass in co-solvent biphasic reactor system consisting of hydrochloric acid and dichloromethane organic solvent. The modified protocol achieved a 15% wt LA yield through the synergistic effect of acid and acidic products (auto-catalysis) and the designed system allowed facile recovery of LA to the organic phase. Further purification of the resulting extractant was achieved through traditional column chromatography, which yielded a high purity LA product while recovering ∼85% wt. Upon charcoal treatment of the resultant fraction generated an industrial grade target molecule of ∼99% purity with ∼95% wt recovery. The system allows the solvent to be easily recovered, in excess of 90%, which was shown to be able to be recycled up to 5 runs without significant loss of final product concentrations. Overall, this system points to a method to significantly reduce manufacturing cost during large-scale LA preparation.

In this study, levulinic acid (LA) was produced from rice straw biomass in co-solvent biphasic reactor system consisting of hydrochloric acid and dichloromethane organic solvent. The modified protocol achieved a 15% wt LA yield through the synergistic effect of acid and acidic products (auto-catalysis) and the designed system allowed facile recovery of LA to the organic phase. Further purification of the resulting extractant was achieved through traditional column chromatography, which yielded a high purity LA product while recovering ∼85% wt. Upon charcoal treatment of the resultant fraction generated an industrial grade target molecule of ∼99% purity with ∼95% wt recovery. The system allows the solvent to be easily recovered, in excess of 90%, which was shown to be able to be recycled up to 5 runs without significant loss of final product concentrations. Overall, this system points to a method to significantly reduce manufacturing cost during large-scale LA preparation.